Flow-injection system for determination of critical micelle concentrations of ionic and nonionic surfactants

A practical technique is presented for the rapid, accurate determination of the critical micelle concentrations (CMCs) of ionic and nonionic surfactants. The precision, speed and instrumental simplicity of a flow-injection system are combined with a gradient chamber and flow-through conductance and absorbance detection to produce a system capable of determining the CMC of surfactant solutions in less than 30 min. The exponential response gradients from the resulting system are monitored by a chart recorder and simple manual calculations yield the CMC. The validity of the technique is verified by determination of the CMC values for both ionic (cetyltrimethylammonium bromide and chloride and sodium dodecyl sulfate) and nonionic (Brij-35, Brij-56, Brij-99, Triton X-100) surfactants. The proposed technique does not require the extensive solution preparation, repetitive measurements, complex instrumentation and data manipulation typical of other methods for determining CMCs.     

Determination of critical micelle concentrations of ionic and nonionic surfactants based on relative viscosity measurements by capillary electrophoresis

The critical micelle concentration (CMC) can be obtained by measuring the distinct physical properties of surfactant molecules in the monomeric and micellar states. In this study, two linear increments of relative viscosity with distinct slopes were obtained when increasing surfactant concentrations from dilute solution to above the CMC, which was then determined by the intersection of the two linear extrapolations. Using a capillary electrophoresis (CE) instrument and Poiseuille’s law, the viscosities of surfactants at a series of concentrations covering the monomeric and micellar regions could be obtained by measuring the hydrodynamic flow rates of the corresponding surfactant solutions. We applied this method to determine the CMC values of various types of surfactants including anionic, cationic, zwitterionic, and nonionic surfactants. The resulting CMC values were all in good agreement with those reported in literature. Using this method, the multiple-stage micellization process of a short-chain surfactant was revealed. We have also demonstrated that the CE-based viscometer was applicable to the study of CMC variation caused by organic or electrolyte additives.     

Effect of glycerol on micelle formation by ionic and nonionic surfactants at 25 degrees C

The effect of glycerol on the micellization of the cationic surfactant cetyltrimethylammonium bromide (CTAB) and of the ethoxylated nonionic surfactant Brij 58 has been investigated by various experimental techniques. For both surfactants the critical micellar concentration (cmc), determined by surface tension measurements, is almost unaffected by the presence of glycerol in the mixture; only at high glycerol concentrations (>/=20% w/w) does the cmc significantly increase. The area per surfactant molecule at the air-solution interface, A, increases with increasing glycerol weight percentage, w(g). Fluorescence quenching measurements indicate that the presence of glycerol induces a lowering of the aggregation number of both surfactants. The glycerol intradiffusion coefficient has been measured by the pulsed-gradient spin-echo NMR technique as a function of glycerol content at constant surfactant concentration. It is almost unaffected by the presence of the surfactants, indicating that no direct glycerol-surfactant interaction occurs in the mixture. The surfactant intradiffusion coefficient has been also measured. In the case of CTAB, it increases with increasing glycerol concentration, a reflection of the decreased aggregation number. For Brij 58, in spite of the lowering of the aggregation number, the surfactant intradiffusion coefficient decreases with increasing glycerol concentration, suggesting an increase of the intermicellar interaction. The experimental evidence shows that for both surfactants the micellization is affected by the presence of glycerol through an indirect, solvent-mediated mechanism. In the case of CTAB, the main effect of glycerol is a lowering of the medium dielectric constant, which enhances the electrostatic interactions in solution. In the case of Brij 58, the results can be interpreted in terms of a salting-out effect according to which glycerol competes with the surfactant for water molecules, causing a dehydration of the surfactant ethoxylic headgroup.     

Determination of critical micelle concentration of surfactants by capillary electrophoresis

Capillary electrophoresis (CE) has been proven to be a convenient and useful technique for the determination of the critical micelle concentration (CMC) of a surfactant in an electrophoretic system under operating conditions. In this review, methodological approaches to the determination of the CMC of surfactants by CE technique are described. The practical requirements for making such measurements and the CMC values of surfactants determined by CE methods are presented. In addition, difficulties and uncertainty, as well as misconceptions that may arise in the CMC determination are discussed.     

Effect of sorbitol and inositol on the critical micelle concentration of nonionic surfactants in water and in aqueous urea

Summary The critical micelle concentrations (cmc) of non-ionic surfactants in water and in aqueous urea with or without hexahydric alcohols, sorbitol and inositol, were determined. In water the cmc's of the surfactants were decreased by the addition of the hexahydric alcohols. In addition, there was a remarkable difference in the decreasing ability between these two hexahydric alcohols. Inositol decreased the cmc's more markedly than sorbitol. In aqueous urea the effect of these hexahydric alcohols on the cmc's and the difference in the decreasing ability between the two alcohols were less than those in water. These results were explained in terms of the effect of the hexahydric alcohols on the structure of water.

---

Zusammenfassung Es wurde die kritische Mizellbildungskonzentration nichtionogener Tenside in Wasser sowie in wäßrigen Harnstofflösungen mit und ohne Zusatz von Inosit und Sorbitol bestimmt. In Wasser wird die cmc bei Zusatz der hexahydrischen Alkohole vermindert; Inosit wirkt dabei stärker als Sorbit. In wässrigen Harnstofflösungen ist der Einfluß auf die cmc und der Unterschied zwischen den zwei Alkoholen geringer als in Wasser. Die Ergebnisse werden über die Beeinflussung der Struktur des Wassers durch die Alkohole gedeutet.

---

---

With 5 figures and 2 tables     

Determination of critical micelle concentration of non-ionic surfactants by electrocapillary curves

A method is described for the determination of the critical micelle concentration of non-ionic surfactants by measurement of their effect on the electrocapillary curves for a dropping mercury electrode. The method was compared with the iodine-solubilization, surface tension, and polarographic maximum suppression methods.     

Ionic strength effects on the critical micellar concentration of ionic and nonionic surfactants: the binding model

We have recently investigated the aggregation behavior of zwitterionic n-dodecyl phosphocholine in the presence of high salt. As double logarithmic Corrin-Harkins plots of the critical micellar concentration versus the salt concentration were not linear, here we re-examine those data in the context of the binding model of surfactant aggregation, as previously developed by us for ionic surfactants. We have also re-examined plenty of data available in the literature on the salt-dependent aggregation of neutral surfactants. The use of double-logarithmic plots allowed us to show that the binding model is of general applicability. Indeed, it permits unified treatment of ionic and uncharged aggregation without requiring the introduction of linear terms in the salt concentration, as needed in the empirical Corrin-Harkins treatment of nonionic surfactants. The use of this model could be of help in a broad range of surfactant-based applications in the presence of high salt.     

Polarographic determination of critical micelle concentration of anionic surfactants

Summary Critical micelle concentrations of four anionic surfactants were determined by DC polarographic desorption waves of the surfactants without supporting electrolyte. The linear plot obtained between the potentials of the desorption waves and the logarithmic concentrations of the surfactant had an inflection point which corresponded to the CMC. The CMC values obtained are in good agreement with those in the literature.

---

Zusammenfassung Es wurden die kritischen Mizellbildungskonzentrationen (KMK) von anionischen Tensiden durch Gleichstrompolarographie in Abwesenheit von Leitelektrolyten bestimmt.

     

Determination of the critical premicelle concentration, first critical micelle concentration and second critical micelle concentration of surfactants by resonance Rayleigh scattering method without any probe

The purpose of this work is to determine the values of critical premicelle concentration (CPMC), first critical micelle concentration (FCMC) and second critical micelle concentration (SCMC) of surfactants using a common spectrofluorophotometer by recording resonance Rayleigh scattering (RRS) signal without any probe. The plot of the RRS intensities at the maximum scattering wavelength (I(RRS)(max)) versus surfactant concentrations (c) was constructed to obtain the I(RRS)(max)-c curve. From the inflexions in I(RRS)(max)-c curve, the CPMC, FCMC and SCMC values of a surfactant can be obtained sensitively. The FCMC of some anionic, cationic and nonionic surfactants such as sodium dodecyl sulfate (SDS), sodium dodecyl benzene sulfonate (SDBS), cetyltrimethylammonium bromide (CTAB), cetylpyridinium chloride (CPC), Tween-20, and Tween-80 were determined by RRS method and the values are in good agreement with those obtained from conductivity and surface tension measurements and literature values. The CPMC and SCMC of SDS and CTAB were also determined by RRS method respectively and the values conform to literature values too. Furthermore, RRS method can also be used to determine the FCMC of an amphiphilic macromolecule-hemoglobin, whose structure resembles a surfactant. From the experimental results, it is concluded that RRS method can be applied to the simultaneous determination of the CPMC, FCMC and SCMC values in a sensitive, accurate and no probe way.     

Electrolyte effect on mixed micelle and interfacial properties of binary mixtures of cationic and nonionic surfactants

In the present work, the adsorption behavior at the liquid-air interface and micellization characteristics of mixtures of cetyltrimethylammonium bromide (CTAB) and p-(1,1,3,3-tetramethylbutyl) polyoxyethylene (TritonX-100) in aqueous media containing different concentrations of NaBr were investigated by surface tension and potentiometry measurements. From plots of surface tension (gamma) as a function of solution composition and total surfactant concentration, we determined the critical micelle concentration (CMC), minimum surface tension at the CMC (gamma(CMC)), surface excess (Gamma(max)), and mean molecular surface area (A(min)). On the basis of regular solution theory, the compositions of the adsorbed film (Z) and micelles (X(M)) were estimated, and then the interaction parameters in the micelles (beta(M)) and in the adsorbed film phase (beta(sigma)) were calculated. For all mole fraction ratios, the results showed synergistically enhanced ability to form mixed micelles as well as surface tension reduction. Furthermore beta was calculated by considering nonrandom mixing and head group size effects. It was observed that, for both the planar air/aqueous interface and micellar systems, the nonideality decreased as the amount of electrolyte in the aqueous medium was increased. This was attributed to a decrease of the surface charge density caused by increasing the concentration of bromide ions.     

Critical aggregation concentration in mixed solutions of anionic polyelectrolytes and cationic surfactants

We have examined the polymer/surfactant interaction in mixed aqueous solutions of cationic surfactants and anionic polyelectrolytes combining various techniques: tensiometry, potentiometry with surfactant-selective electrodes, and viscosimetry. We have investigated the role of varying polymer charge density, polymer concentration, surfactant chain length, polymer backbone rigidity, and molecular weight on the critical aggregation concentration (Cac) of mixed polymer/surfactant systems. The Cac of these systems, estimated from tensiometry and potentiometry, is found to be in close agreement. Different Cac variations with polymer charge density and surfactant chain length were observed with polymers having persistence lengths either smaller or larger than surfactant micelle size, which might reflect a different type of molecular organization in the polymer/surfactant complexes. The surfactant concentration at which the viscosity starts to decrease sharply is different from the Cac and probably reflects the polymer chain shrinkage due to surfactant binding.     

Light scattering and electrophoretic studies of mixed micelles of ionic and nonionic surfactants

Summary Light scattering and electrophoretic studies have been made of the mixed micelles formed in the systems ofn-dodecyl nonaoxyethylene ether/sodium dodecyl sulfate (NaC₁₂S), andi-octylphenyl nonaoxyethylene ether/NaC₁₂S as a function of the mole ratio of nonionic/ionic surfactants. In the former system the micellar molecular weight increases simply with increasing nonionic content, while in the latter system it rises abruptly when the nonionic content exceeds about 50% by mole. This behaviour would be interpreted by a difference in hydrocarbon-chain attraction between these two systems. The degree of ionic dissociation, , of NaC₁₂S in the mixed micelles increases as the content of the nonionic surfactant increases. This tendency is in accordance with the previous result obtained by pNa and vapor pressure depression data. The value of is closely related to the charge density, , on the surface of the micelle; increasing with decreasing . The micellar charge for NaC₁₂S alone, estimated from electrophoretic data, is much larger than that calculated from light scattering data by using the equation derived byMysels. For this discrepancy, a plausible explanation would be made by the different surfaces of the micelle measured by these two techniques.With 1 figure and 2 tables     

Prediction of critical micelle concentration of cationic surfactants using connectivity indices

Relationship for predicting Logcmc for cationic surfactants having chloride as counterion from only molecular connectivity indices was found. It is suggested that the index ⁰χ^ν includes some information about hydrophobicity while indices ⁴χ _pc and ⁴cⁿ_pc{^{4}\chi^{\nu}_{pc}} include some information about hydrophilicity of the cationic surfactants studied. The structures of 23 compounds used for the correlation are quite diverse.     

Flow-injection chemiluminescence method for determination of critical micelle concentration of surfactants

In this study, chemiluminescence (CL) behaviour of Luminol-H₂O₂ in the presence of the different concentrations of four surfactants, cetyltrimethylammonium bromide (CTAB), cetylpyridinium bromide (CPB), sodium dodecyl sulphate (SDS) and polyoxyethylene dodecyl ether (Brij-35), was investigated. A novel method for the direct determination of critical micelle concentration (CMC) of the surfactants using flow-injection CL is described. Under the optimum conditions, the luminescence intensity of the Luminol-H₂O₂ system increased gradually with increasing concentration of the surfactants before the CMC, but rapidly reached to the emission maximum at the CMC, followed by a decrease after the CMC. The concentrations of the surfactants corresponding to the luminescence maximum are in agreement with the literature CMC values. The main factors affecting the determination of CMC are discussed. The mechanistic studies show that the luminescence peaks observed in the experiment were mainly because of the protective effect of the micelle against the transition of the excited species and the retarding effect of the micelle structures on the CL reaction rate.