固溶体结构对Ca2-xSrxZn4Ti15O36∶Pr3+发光性质的影响

Ca_2-xSr_xZn₄Ti₁₅O₃₆∶Pr red long decay phosphor was synthesized by high temperature solid state reaction. Photoluminescence property and crystalline and unit cell parameters of the orthorhombic were investigated by fluorescence spectrophotometer and by powder X-ray diffraction, respectively. The emission intensity at 618 nm changes sharply when the concentration of Sr²⁺ (x) is less than 0.1 and the emission intensity reaches the maximum when x is equal to 0.007. There is an obviously broad excitation band at 270 nm when x is equal to 0.003 and it disappears gradually when x is over 0.01. The unit cell a parameter of Ca_2-xSr_xZn₄Ti₁₅O₃₆∶Pr decreases while c parameter increases with the increases of the concentration of the doped Sr²⁺. When x is over 0.1 the value of the unit cell parameters a and c become stable. TL peaks of Ca₂Zn₄Ti₁₅O₃₆∶Pr, Ca_1.993Sr_0.007Zn₄Ti₁₅O₃₆∶0.002Pr³⁺, 0.002Na⁺, are located at 62 ℃, 88 ℃, respectively, which indicates that there are deeper traps in Ca_1.993Sr_0.007Zn₄Ti₁₅O₃₆∶0.002Pr³⁺, 0.002Na⁺.     

复盐法制备无水氯化镁的热解机理及动力学研究

The complex compound (MgCl₂·C₆H₅NH₂·HCl·6H2O) was prepared by reaction of C₆H₅NH₂·HCl with MgCl₂·6H₂O. Reaction mechanism and kinetics of the compounds decomposition were studied by means of the TG-DTA-MS coupling technique and the TG-DTA technique. The results show that there are four steps in the complex′s thermal decomposition, the first two steps correspond to the loss of six crystal waters and the last two steps loss one Aniline hydrochloride. The first three steps belong to the R2 mechanism with 2-dimentional phase boundary reaction as the control step, and the last step belongs to the D3 with 3-dimensional diffusion (sphere Jander equ.) as the control step. The apparent active energy of four steps are, 127.4 kJ·mol^-1, 124.8 kJ·mol^-1, 142.3 kJ·mol^-1 and 329.0 kJ·mol^-1, respectively and the frequency factor are 1.28 × 10¹⁸ s^-1, 7.94 × 10¹⁵ s^-1, 5.98 × 10¹⁶ s^-1 and 4.39 × 10³⁴ s^-1, respectively.     

水溶液中新型四氮杂二乙酸基取代大环及其镧系配合物的热力学研究

The protonation constants of the macrocycle H₂L¹ (c-meso-2,4,4,11,13,13-hexamethyl-1,5,10,14-tetraazacyclooctadecane-N,N＂-diacetic acids)were determined potentiometricly and by computer fitting in 0.5 mol·L^-1 KNO₃ solution at 25±0.1℃, 30±0.1℃ and 40±0.1℃. The stability constants of the 1∶1 complexes of H₂L¹ with La³⁺, Nd³⁺, Sm³⁺, Eu³⁺, Gd³⁺, Dy³⁺, Yb³⁺ were determined by the same method at 40±0.1℃. The ΔH、 ΔS and ΔG of the coodination reaction of H₂L¹ with H⁺ in the aqueous solution were found.     

L-苏糖酸锰的制备及标准生成焓

The pink powder of manganese L-threonate was obtained by extracting with alcohol the concentrated solution derived from the reaction between L-threonic acid solution prepared by double decomposition reaction of calcium L-threonate with oxalic acid and superfluous manganese oxide at 80℃ for certain time. The composition of the new compound was determined by chemical and elemental analyses and its formula fits Mn(C₄H₇O₅)₂·H₂O, the IR spectra indicated that Mn²⁺ in the compound coordinates to oxygen atom of the carboxyl group, while the proton of the carboxyl group is dissociated, it was assumed that the coordination number of Mn²⁺ was 4. The results of TG-DTG showed that the compound have fairish stability, the intermediate and final product of the thermal de-composition of the compound are Mn(C₄H₇O₅)₂ and MnO₂, respectively. The constant volume combustion energy of the compound, Δ_cE, were determined by a precise rotating-bomb calorimeter at 298.15K, it was (-3384.30±1.21)kJ·mol^-1, its standard enthalpy of Combustion,Δ_cH_m^?,and standard enthalpy of formation,Δ_fH_m^? , were calculated. They are (-3383.07±1.21)kJ·mol^-1 and (-2 571.68±1.63)kJ·mol^-1, respectively.     

缬沙坦类似物合成中间产物的捕获(Ⅱ)

In this article we mainly discuss the effect of anion of Lewis acid on the structure of the intermediate in synthesis of valsartan analogue. The crystal belongs to monoclinic system with space group P2₁/c, and a=1.099 9(3) nm, b=1.913 4(5) nm, c=0.977 8(3) nm, β=104.806(4)°, V=1.989 5(9) nm³, D_c=1.708 g·cm^-3, Z=18. CCDC: 629931.     

五元体系Li+/Cl-，CO32-，SO42-，B4O72--H2O 298 K相关系实验研究

Zabuye saline lake, Tibet, China, is unrivalled in the world for its high concentration of chloride, sulfate, carbonate and borate of lithium, sodium and potassium. Always at the later stage of the evaporation of brines, most sodium and potassium salts are crystallized out, so the main components of brines can be described with the Li⁺, Mg²⁺/Cl^-, SO₄^2-, CO₃^2-, B₄O₇^2--H₂O system. As a part of study on the equilibrium of this complex system, the equilibrium solubilities and phase diagram of the quinary system Li⁺/Cl^-，CO₃^2-，SO₄^2-，B₄O₇^2--H₂O at 298 K were studied by isothermal dissolution equilibrium method. In the 3-dimentional solubility diagram or its projection diagram saturated with solid LiCl, there are four crystallization fields, four univariant curves and one invariant point. At the invariant point, the saturated solid salts are LiCl·H₂O, Li₂B₄O₇·3H₂O, Li₂CO₃and Li₂SO₄·H₂O. No double salt or solid solution is formed.     

Ion chromatographic and spectrometric determination of water-soluble compounds in airborne particulates, and their correlations in an industrial area in Attica, Greece

In the time period from June 2005 to May 2006 in 42 sampling campaigns 84 filter samples of airborne particulate matter, coarse (PM_10–2.5) and fine (PM_2.5), were collected using a Gent stacked filter unit in the coastal industrial area of Aspropyrgos in Attica, Greece. The average PM₁₀ (PM_10–2.5 + PM_2.5) concentration was found to be 66 μg · m⁻³, exceeding more than 1.6 times the annual limit of 40 μg · m⁻³. The samples were analysed for Cl⁻, NO₃ ⁻, SO₄ ²⁻, Ca²⁺, Mg²⁺, Na⁺, K⁺ and NH₄ ⁺ using ion chromatography. The data were compared with results obtained with other spectrometric methods, such as inductively coupled plasma-atomic emission spectrometry, atomic absorption spectrometry, energy dispersive X-ray fluorescence and reflectometry. The determined average ionic content comprised about 44% of the PM₁₀ mass. The ionic composition, as well as the possible matrix compounds in both fractions were evaluated by dividing the sampling period into summer and winter season. In the PM_10–2.5/PM_2.5 fraction in summer time the concentrations of Ca²⁺, Mg₂₊ and NO₃ ⁻ were enriched in the coarse fraction. In winter time all species were enriched in the coarse fraction, especially Ca²⁺, Cl⁻ and NO₃ ⁻. NH₄ ⁺ was constantly higher in the fine fraction in summer as well as in winter time. Factor analysis was applied to obtain correlations between cations and anions leading to matrix compounds in both fractions. From the evaluation of the results obtained, some of the local air pollution sources could be identified. Correspondence: Klaus-Michael Ochsenkühn, Laboratory for Trace Element Studies, Institute of Physical Chemistry, NCSR “Demokritos”, Aghia Paraskevi 15310, Athens, Greece     

Al and Ti secondary neutral and secondary ion emission from oxide samples in the high-frequency sputtering mode of HF-plasma SNMS

A strong Al⁺ and a minor Ti⁺ peak without a proportional increase of the O⁺ signal in SNMS high-frequency sputtering mode (HFM) time profiles of an insulating μm-thick oxide layer on Ti-48Al-2Cr-2Nb led us to check for a possible contribution of positive secondary ions (SI⁺). SI⁺ and SI^– (negative secondary ions) can be detected in ion energy spectra. This is shown using Al⁺, O^–, AlO^–, and AlO₂ ^– ions sputtered from massive Al₂O₃. Similarly, and depending on stoichiometry, also Ti⁺ from mixed sintered, microscopically inhomogeneous Al₂O₃-TiO₂-SiO₂ pellets has been identified to be partly SI⁺. The subtraction of an assumed contribution of ionized secondary neutrals (SN⁺) suggests that SI⁺ may form several 10% of the detected ions obtained in the HFM sputtering and plasma processes. However, the positive surface potential of some 10 V being necessary to cause detectable SI⁺ contributions does not build up on μm-thin insulating layers. Therefore, we have to conclude that the Al⁺ and Ti⁺ peaks in the sputter time profiles of the μm-thick oxide layer on Ti-48Al-2Cr-2Nb which are accompanied by an O⁺ deficiency cannot have been caused by SI⁺. Instead, their more probable origin is the inhomogeneous Al₂O₃ interlayer itself. Together with the residues of a topmost TiO₂ layer which has strongly been depleted in O by preferential sputtering, the relative O⁺ deficiency may be explained without assuming SI⁺ contributions. Received: 22 February 1999 / Revised: 1 July 1999 / Accepted: 6 July 1999     

纳米BaFe12O19永磁铁氧体的制备、结构和磁性的研究

In this paper, the nanometer permanent magnetic BaFe₁₂O₁₉ powder was synthesized by a novel method of independent nucleation and crystallization steps and subsequent heat treatment,during the synthesis, Ba(NO₃)₂, Fe(NO₃)₂ and NH₄HCO₃·NH₂COONH₄ were used as starting materials. The effect of crystallization process and heat treatment conditions on the particle size, microstructure and magnetic properties of powder was studied by using XRD, TEM and vibration sample magnetometometer techniques.XRD results showed that the hematite, α-Fe₂O₃, was the main phase in the powder at heat treatment temperatures below 650℃ and its amount in the powder was decreased with increasing temperature and small amount of α-Fe₂O₃ was still remained after being heated at 900℃ for 8hrs. BaFe₁₂O₁₉ was formed about 650℃ and its amount increased in the powder as temperature raised and the higher temperature was needed to attain considerable amount of BaFe₁₂O₁₉ and ideal nanometer BaFe₁₂O₁₉ particle in the powder. The temperature between 40℃～60℃ in the crystallization process was favor to the formation of good BaFe₁₂O₁₉ crystal and to the good magnetic properties of the powder. TEM showed that the particle size in the powder increased with the enhancement of the temperature and the powder crystallized at 40℃ and heated at 800℃ for 8hrs afterwards had a very homogenous particle size distribution, and that the powder heated at 900℃ for 8hrs with the same crystalline condition as the former had a typical hexagonal shape and a chain aggregation. Specific saturation and residential magnetizations and coercive force of the powder increased mono-tonically with the increase of temperature, and reached 39.86A·m²·kg^-1, 23.96A·m²·kg^-1, 480kA·mg^-1 at 900℃, respectively.     

Characteristics of Pd/Nafion electrodes prepared by an impregnation-reduction method in sensing hydrogen

The influences of reductant concentration and Pd loading on the response and recovery times and the sensitivity in detecting hydrogen of Pd/Nafion electrodes prepared by an impregnation-reduction method were investigated in this study. The Pd/Nafion electrodes with a Pd loading of 6.90 mg/cm², obtained at 0.006 M Pd(NH₃)₄Cl₂ and 0.06 M NaBH₄, show the maximum sensitivity of 0.0519 μA/ppm in the H₂ concentration range 0–4410 ppm. However, The Pd/Nafion electrodes with a Pd loading of 11.42 mg/cm², obtained at 0.01 M Pd(NH₃)₄Cl₂ and 0.06 M NaBH₄, show the fastest response and recovery speed in sensing hydrogen. Generally, the response time decreases with an increase of the hydrogen concentration, but the recovery time increases with an increase of the hydrogen concentration. A sensing model is also proposed to illustrate the sensing phenomenon. Electronic Publication