近红外法分析二醛酸纤维丝束中的外油

研究了应用近红外漫反射技术测定二醋酸纤维丝束中的外油的新方法。在1100－2500nm范围内,采用偏最小二乘法（PLS）,对一系列标准样品与其近红外光谱进行回归,建立了二醋酸纤维丝束外油分析的数学模型,采用此模型进行二醋酸纤维丝束外油分析,具有分析速度法、样品制备简单等优点,且分析结果与传统分析方法有很好的一致性。     

烟用醋纤丝束气味的嗅觉测试方法研究

研究并建立了醋酸纤维素丝束（醋纤丝束）气味的感官分析方法。对丝束的主要气味物质丙酮和乙酸进行测定，嗅阈值分别为丙酮46mg／L，乙酸0．074mg／L。本法检测灵敏度高，能对正常丝束气味和混有其它物质的异常丝束气味进行准确辨别。用该法对厂家生产的醋纤丝束进行嗅味测试，结果显示质量合格的丝束气味强度为2～3，当强度大于4时应引起厂家高度重视。     

二醋酸纤维素 -聚乙二醇接枝共聚物的核磁共振表征

用^1H NMR和^13C NMR核磁共振技术研究了二醋酸纤维素和聚乙二醇的接枝反应,并确定了^1H NMR和^13C NMR谱中各谱峰的归属,为证明二醋酸纤维素和聚乙二醇的接枝反应提供了依据。     

近红外法分析二醋酸纤维丝束中的外油

研究了应用近红外漫反射技术测定二醋酸纤维丝束中的外油的新方法。在 1 1 0 0～ 2 50 0 nm范围内 ,采用偏最小二乘法 (PL S) ,对一系列标准样品与其近红外光谱进行回归 ,建立了二醋酸纤维丝束外油分析的数学模型。采用此模型进行二醋酸纤维丝束外油分析 ,具有分析速度快、样品制备简单等优点 ,且分析结果与传统分析方法有很好的一致性。     

邻苯二甲酸二甲酯胶束增溶过程的NMR研究

胶束的增溶作用，可通过X射线，紫外光谱以及核磁共振潜等进行研究.Eriksson等［‘］用NMR法研究了芳香烃在CTAB表面活性剂胶束溶液中的增溶作用.李干佐等问用NMR法研究了件二甲苯和末甲醇在SDS表面活性剂胶束溶液中的增溶作用.然而，关于既非亲油也非亲水的某些小的极性分子的     

油酸酰化胰岛素的制备及飞行质谱分析

采用二环己基碳二亚胺缩合法由油酸和苯并三唑合成了油酰苯并三唑,并利用FT-IR和1H NMR对产物进行了表征;利用油酰苯并三唑对胰岛素侧链氨基在非保护下进行化学修饰,制备得到油酰胰岛素,飞行时间质谱分析显示该修饰作用是成功的,并且单修饰是主要的,有少量二修饰物,没有三修饰产物.     

铜催化的多组分反应合成二芳基炔丙胺类衍生物

以醛、苯乙炔和二芳胺为原料, 三组分一锅法合成了一系列二芳基炔丙胺类化合物. 产物的结构通过1H NMR, 13C NMR和HRMS证实.     

1,6-二氢-S-四嗪催化重排及其反应的研究--Ⅱ. 与氯甲酸三氯甲酯反应

在4－二甲胺基吡啶的存在下，1，6－二氢－S－四嗪重排成3，6－二氢－S－四嗪，与双光气反应后再与不同的胺反应，合成了11种1，4－二取代产物，产物经元素分析、IR和^1H NMR确证。用UV和^1H NMR分析结果对反应机理进行了初步探讨。     

醇酸树脂的NMR分析

NMR用于涂料分析近年来已取得一些很有意义的结果本文探索NMR技术对长油醇酸树脂的定性定量分析。     

草酸对酚酞基聚芳醚砜超滤膜性能和结构的影响

以新型耐高温工程塑料一含酚酞侧基的聚芳醚砜（PES-C）为膜材料,N,N-二甲基乙酰胺（DMAc）为溶剂,通过改变铸膜液中添加荆草酸的含量,采用相转化法在平板刮膜机上制备了一系列超滤膜,考察了添加荆草酸含量对铸膜液粘度、凝胶速度、膜性能和结构的影响,研究了PES-C／DMAC体系中添加荆草酸作用的规律。     

Quantitative analysis of trace‐level benzene,toluene, ethylbenzene,and xylene in cellulose acetate tow using headspace heart‐cutting multidimensional gas chromatography with mass spectrometry

This study describes a method for the quantification of trace‐level benzene, toluene, ethylbenzene, and xylene in cellulose acetate tow by heart‐cutting multidimensional gas chromatography with mass spectrometry in selected ion monitoring mode. As the major volatile component in cellulose acetate tow samples, acetone would be overloaded when attempting to perform a high‐resolution separation to analyze trace benzene, toluene, ethylbenzene, and xylene. With heart‐cutting technology, a larger volume injection was achieved and acetone was easily cut off by employing a capillary column with inner diameter of 0.32 mm in the primary gas chromatography. Only benzene, toluene, ethylbenzene, and xylene were directed to the secondary column to result in an effective separation. The matrix interference was minimized and the peak shapes were greatly improved. Finally, quantitative analysis of benzene, toluene, ethylbenzene, and xylene was performed using an isotopically labeled internal standard. The headspace multidimensional gas chromatography mass spectrometry system was proved to be a powerful tool for analyzing trace volatile organic compounds in complex samples.     

The role of cellulose acetate as a matrix for aggregation of pseudoisocyanine iodide: absorption and emission studies

Films of pseudoisocyanine iodide in a cellulose acetate matrix were prepared by spin coating and characterized by UV/Vis absorption and fluorescence spectroscopies. The comparison with self-supported films of the same dye enabled analysing the role of the matrix in the aggregation of pseudoisocyanine iodide ([PIC]I). It was proved that cellulose acetate is a suitable support for [PIC]I J-aggregates, which form during spinning, as shown by a very sharp J-band in the absorption spectra. This indicates a perfect coherence between stacked monomers in the supported J-aggregates. It was possible to individualize the emission spectrum of [PIC]I J-aggregates in cellulose acetate, by decomposition of the steady-state fluorescence spectra of the films. The dependence on the excitation wavelength of the relative emission intensities of monomers and J-aggregates, for lambda(em) = 587 nm, lead to confirm that the latter species have an absorption maximum at approximately 500 nm in cellulose acetate. Finally, polarised absorption spectra of films obtained by the vertical spin coating technique showed that cellulose acetate allows a partial orientation of J-aggregates.     

Continuous cellulose fiber-reinforced cellulose ester composites. I. Manufacturing options

Thermoplastic fiber composites were prepared using high modulus lyocell (regenerated cellulose) fibers for reinforcement and cellulose acetate butyrate (CAB) as matrix. Choices were made with regard to fiber options (fabric versus continuous tow) and method of matrix deposition (prepregging by powder coating, film stacking, or solution impregnating). The results suggest that solution-prepregged fiber tow consolidated at circa 200°C produced unidirectional consolidated panels with tensile strength, modulus, and strain at failure values of approximately 250MPa,>20GPa and 3–4%, respectively, at fiber volume contents of approximately 60%. Modulus and ultimate tensile strength increased with fiber content, and modulus followed rule-of-mixture behavior. Adequate surface wetting and matrix-fiber adhesion were found with solution-prepregged composites. The unexpectedly low strain at failure (2 to <4%) was attributed to brittle matrix failure, and failure surfaces revealed that the fibers, for the most part, remained intact after the matrix had failed.     

Breath figure patterns prepared by spin coating in a dry environment

We introduce a novel method for fabricating breath figure patterns on a homopolymer film by spin coating of polymer solutions with various solvents. The homopolymers employed in this study were cellulose acetate butyrate, monocarboxylated end-functional polystyrene, and poly(methyl methacrylate). Breath figure patterns were generated even when a water-miscible solvent such as tetrahydrofuran (THF) was used as a solvent. We even succeeded in generating breath figure patterns by spin coating even under a dry environment (relative humidity less than 30%), when water was directly added into THF solution. With the combination of the spin coating method, pores with a few hundred nanometers to several micrometers have been generated. We found that the pore size becomes larger with increasing water content in THF solution and decreasing rotating speed. This is equivalent to increasing humidity and decreasing evaporation speed, respectively, in the conventional method, which is direct solvent evaporation under a humid environment. Thus, compared with the conventional method for making breath figure patterns, this method would be very convenient for fabricating large-scale films with various pore sizes.     

Trennung polyzyklisher aromatischer kohlenwasserstoffe durch hochdruckflössigkeitschromatographie: Vergleich einer bestimmung von benzo[a]pyren nach trennung an saäulen mit quervernetztem celluseacetat und einem reversed-phase system

Separation of polycyclic aromatic hydrocarbons by high-pressure liquid chromatography. Comparison of the determination of benzo(a)pyrene with separation on columns of cross-linked cellulose acetate and a reversed-phase system.

The behaviour of a new high-pressure liquid chromatographic support, i.e. a cross-linked cellulose acetate, as selective separation material for polycyclic aromatic hydrocarbons is discussed. The determination of benzo[a]pyrene is described by an example of separating a so-called benzpyrene fraction. The separation of the benzpyrene fraction was possible by combining column systems with aluminium oxide, cross-linked cellulose acetate or a reversed-phase system. By means of a fluore- scence detector 0.1-0.8 ng benzo[a]pyrene could be detected in 5μl injection volume.     

Characterization of cellulose acetates by nuclear magnetic resonance

An NMR method for determining the distribution of acetyl groups in cellulose acetates was developed. Treatment of cellulose acetates with acetyl-d₃ chloride gave products having simple spectra which could be analyzed quantitatively to give the distribution of acetyl groups in the original sample. The method was applied to studying (1) the hydrolysis of cellulose triacetate with ammonia, (2) the acetylation of cellulose acetate with acetyl chloride, and (3) the acetylation of cellulose acetate with acetic anhydride.     

Iminodiacetic acid/ethylcellulose as a chelating ion exchanger: Part 2. Determination of trace metals by inductively-coupled plasma atomic emission spectrometry

A chelate-forming cellulose, iminodiacetic acid/ethylcellulose (IDAEC), is applied to the collection of metals from ammonium citrate and acetate solutions. A method is devised for the i.c.p./a.e.s. determination of metal contaminants in magnesium by separation and preconcentration of the metals with IDAEC.     

Preparations of regioselectively methylated cellulose acetates and their 1H and 13C NMR spectroscopic analyses

Seven possible regioselectively methylated cellulose acetates (RS‐MCAs)—2,3,6‐tri‐O‐methyl cellulose acetate, 3,6‐di‐O‐methyl cellulose acetate, 2,6‐di‐O‐methyl cellulose acetate, 2,3‐di‐O‐methyl cellulose acetate, 6‐O‐methyl cellulose acetate, 3‐O‐methyl cellulose acetate, and 2‐O‐methyl cellulose acetate—were prepared for the first time from chemically synthesized cellulose derivatives obtained by cationic ring‐opening polymerization and then were analyzed by ¹H and ¹³C NMR spectroscopy. The chemical shifts of ring protons and carbons were influenced by substituent groups (methyl or acetyl) and clearly reflected the pattern of substituent distribution in anhydroglucose units. These data may conveniently be used for the determination of the substituent distribution of methyl cellulose. The synthesized RS‐MCAs also may be used for the elucidation of the structure–property relationship. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 4167–4179, 2002     

Dependence of the mobility of molecular probes in cellulose acetate solutions on complexation and the solution structure

The spin echo technique with a magnetic field pulse gradient was used to measure the translational diffusion coefficients D of molecular probes in solutions of cellulose acetates in dimethyl sulfoxide. A linear dependence of coefficient D on the extent of substitution of the cellulose acetate was established and the sensitivity of D to the supermolecular structure of the polymer solution was demonstrated.Translated from Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, No. 2, pp. 470–472, February, 1990.