Instability and waves during generalized Newtonian fluid film flow down a vertical wall

The problem of linear stability of a non-Newtonian fluid film flowing down a vertical plane under the action of gravity is considered. The linear stability of steady-state flow with a plane free boundary and the nonlinear waves that arise if this flow is unstable are investigated. The results obtained for two rheological models, the power-law and Eyring fluids, are compared.     

Stability of the rigid state of a generalized Newtonian fluid

The equations of thermal vibrational convection of a generalized Newtonian fluid are presented in the case of high-frequency vibration. A condition of quasi-equilibrium of the generalized Newtonian fluid is formulated: its particular case is the condition for rigid (quasi-solid) state. The rigid state stability is investigated for the infinite inclined layer of the nonlinearly viscous Williamson fluid. It is shown that, when heated from below, the rigid state may lose stability for layers oriented almost vertically or horizontally. High-frequency vibration stabilizes the fluid equilibrium state.     

Creeping flow of an ellis fluid past a Newtonian fluid sphere

Upper and lower bounds on the drag offered to a Newtonian fluid sphere placed in an Ellis model fluid in creeping flow have been found using variational principles. For a solid sphere, the bounds are in good agreement with those reported by earlier investigators.     

Shear flow over a porous particle

Linear axisymmetric Stokes flow over a porous spherical particle is investigated. An exact analytic solution for the fluid velocity components and the pressure inside and outside the porous particle is obtained. The solution is generalized to include the cases of arbitrary three-dimensional linear shear flow as well as translational-shear Stokes flow. As the permeability of the particle tends to zero, the solutions obtained go over into the corresponding solutions for an impermeable particle. The problem of translational Stokes flow around a spherical drop (in the limit a gas bubble or an impermeable sphere) was considered, for example, in [1,2]. A solution of the problem of translational Stokes flow over a porous spherical particle was given in [3]. Linear shear-strain Stokes flow over a spherical drop was investigated in [2].Translated from Izvestiya Rossiiskoi Akademii Nauk, Mekhanika Zhidkosti i Gaza, No. 3, pp. 113–120, May–June, 1995.     

Turbulent flow around a rotating cylinder in a quiescent fluid

 Hot-wire measurements have been carried out in the turbulent flow around a rotating circular cylinder in still air for Reynolds numbers Re=∣U _w ∣D/ν=1.5×10⁴ to 10⁵. The experimental results confirm the analysis derived by asymptotic theory for high Reynolds numbers. Two different ways of deriving the friction law from the experiments (via shear stress and via velocity distribution) resulted practically in the same law. It is shown, that in spite of the curvature of the streamlines the universal logarithmic velocity distribution is still valid near the wall. Received: 8 August 1996/Accepted: 24 April 1998     

Shear flow over a rotating plate

A shear flow interacts with a rotating boundary. The three dimensional Navier-Stokes equations reduce to a set of ninth order, nonlinear, ordinary differential equations which are partially decoupled. Universal similarity velocity profiles are found by numerical integration. If the shear is high enough, reverse flow occurs and the mean drag may be negative. The solution is a rare exact similarity solution of the Navier-Stokes equations.     

Unsteady MHD mixed convection flow over an impulsively stretched permeable vertical surface in a quiescent fluid

The unsteady mixed convection flow of an incompressible laminar electrically conducting fluid over an impulsively stretched permeable vertical surface in an unbounded quiescent fluid in the presence of a transverse magnetic field has been investigated. At the same time, the surface temperature is suddenly increased from the surrounding fluid temperature or a constant heat flux is suddenly imposed on the surface. The problem is formulated in such a way that for small time it is governed by Rayleigh type of equation and for large time by Crane type of equation. The non-linear coupled parabolic partial differential equations governing the unsteady mixed convection flow under boundary layer approximations have been solved analytically by using the homotopy analysis method as well as numerically by an implicit finite difference scheme. The local skin friction coefficient and the local Nusselt number are found to decrease rapidly with time in a small time interval and they tend to steady-state values for t*≥5. They also increase with the buoyancy force and suction, but decrease with injection rate. The local skin friction coefficient increases with the magnetic field, but the local Nusselt number decreases. There is a smooth transition from the unsteady state to the steady state.     

Multiple-relaxation-time lattice Boltzmann model for generalized Newtonian fluid flows

The generalized Newtonian fluid, as an important kind of non-Newtonian fluids, has been widely used in both science and engineering. In this paper, we present a multiple-relaxation-time lattice Boltzmann model for generalized Newtonian fluid, and validate the model through a detailed comparison with analytical solutions and some published results. The accuracy and stability of the present model are also studied, and compared with those of the popular single-relaxation-time lattice Boltzmann model. Finally, the limit and potential of the multiple-relaxation-time lattice Boltzmann model are briefly discussed.     

Newtonian and Power-Law fluid flow in a T-junction of rectangular ducts

The aim of the present study is the numerical investigation of the shear-thinning and shear-thickening effects of flow in a T-junction of rectangular ducts. The employed CFD code incorporates the SIMPLE scheme in conjunction with the finite volume method with collocated arrangement of variables. The code enables multi-block computations in domains with multiple apertures, thus coping with the two-block, two-outlet layout of the current 3D computational domain. The shear-thinning and shear-thickening behaviours of the flow are covered by changing the index n of the Power-Law model within a range from 0.20 to 1.25, and the subsequent effects are investigated by means of different flow parameters namely the Reynolds (Re) number and the boundary conditions at the outlets. Results exhibit the extent of the effect of the Re number on the velocity profiles at different positions in the domain for both Newtonian and non-Newtonian cases. Similarly, the trend of the effect of shear-thinning and shear-thickening behaviours on the flow rate ratio between inlet and outlets, in the case of equal pressure imposed on outlets, is shown.     

On flow and stability of a Newtonian fluid past a rotating plane

An exact solution is given for the steady flow of a Newtonian fluid occupying the halfspace past the plane z=0 uniformly rotating about a fixed normal axis (Oz). This solution is obtained in a velocity field of the form considered by Berker [2] and can be deduced as a limiting case, as h+, of the solution to the problem relative to the strip 0zh imposing at z=h either the adherence boundary conditions or the free surface conditions. Furthermore, the stability of this flow, subject to periodic disturbances of finite amplitude, is studied using the energy method and the result is compared with those corresponding to stability of flows in the strip 0zh.

---

Sommario In questa nota si mostra che-oltre alla calssica soluzione di von Karman [1] — esiste, per opportuni valori del gradiente di pressione all'infinito, una soluzione esatta per il moto stazionario di un fluido Newtoniano posto nel semispazio limitato dal piano z=0 uniformemente rotante attorno ad un asse ad esso perpendicolare (Oz). Tale soluzione, ottenuta sulla scia del lavoro di Berker [2], si può dedurre anche come limite, per h+, della soluzione del problema relativo alla striscia 0zh quando sul piano z=h si assegnano o le condizioni di aderenza o le condizioni di frontiera libera. Si studia poi la stabilità di tale moto rispetto a perturbazioni spazialmente periodiche di ampiezza finita col metodo dell'energia e si confronta il risultato ottenuto con quelli relativi alla stabilità dei moti nella striscia 0zh.

     

Wave regimes on a film of generalized Newtonian fluid flowing down a vertical plane

The flow of a thin film of generalized Newtonian fluid down a vertical wall in the gravity field is considered. For small flow-rates, in the long-wave approximation, an equation describing the evolution of the surface perturbations is obtained. Depending on the signs of the coefficients, this equation is equivalent to one of four equations with solutions significantly different in evolutionary behavior. For the most interesting case, soliton solutions are numerically found.     

Instability of a hypersonic flow over a wedge in the Newtonian approximation

At the present time, there are a number of works in the literature that treat unsteady hypersonic flows in the Newtonian approximation [1–4]. Since the angle of incidence of the shock wave _s coincides in the zero-order approximation with the angle of inclination of the bodys [1], the latter is usually used in the boundary conditions on the shock. However, in the zero-order approximation _b can be used with the same justification. Both approaches are equally justified and give similar results for a steady flow. For unsteady flows the results can differ radically. It will be shown below that for an investigation of a flow over a fixed wedge with constant conditions in the free stream a steady-state pattern is obtained in the first case and a solution growing in time, in the second case.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 4, pp. 158–160, July–August, 1976.     

Newtonian heating in stagnation point flow of Burgers fluid

The Newtonian heating effects in the stagnation point flow of a Burgers fluid are addressed in this paper. The boundary layer flow problems are stated in the spatial domain from zero to infinity. The solution expressions for the velocity and the temperature are obtained and examined for the influential variables. The tabulated values show comparison with the previous results. It is observed that the obtained results are in good agreement with the existing results in limiting sense.     

Unsteady stagnation-point flow of a Newtonian fluid in the presence of a magnetic field

The unsteady stagnation-point flow of a viscous fluid impinging on an infinite plate in the presence of a transverse magnetic field is examined and solutions are obtained. It is assumed that the infinite plate at y=0 is making harmonic oscillations in its own plane. A finite difference technique is employed and solutions for small and large frequencies of the oscillations are obtained for various values of the Hartmann's number.     

Possible flow regimes of a Newtonian fluid in pipes made of active material

A numerical study is made in the quasione-dimensional inertialess approximation of axisymmetric flow of a Newtonian fluid in a pipe of finite length made of nonlinear active material capable of reducing the corresponding deformations in response to an increase in the tensile stresses. This property is possessed, in particular, by the walls of the smallest arterial vessels, which are equipped with muscle layers. Data are given on the general laws of the exchange of flow regimes in dependence on the mean pressure, the length of the pipe, and certain theological parameters.Translated from Izvestiya Akademii Nauk SSSR, Mekhanika Zhidkosti i Gaza, No. 3, pp. 88–93, May–June, 1985.The author is grateful to S. A. Regirer for useful discussions.     

Micropolar fluid flow over a shrinking sheet

An analysis is carried out for the steady two-dimensional flow of a micropolar fluid over a shrinking sheet in its own plane. The shrinking velocity is assumed to vary linearly with the distance from a fixed point on the sheet. The features of the flow and heat transfer characteristics are analyzed and discussed. It is found that the solution exists only if adequate suction through the permeable sheet is introduced. Moreover, stronger suction is necessary for the solution to exist for a micropolar fluid compared to a classical Newtonian fluid. Dual solutions are obtained for certain suction and material parameters.     

Shear flow over cylindrical rods attached to a substrate

Shear flow over a periodic array of cylindrical rods attached to a substrate is studied as a model of flow over a nanomat consisting of aligned carbon nanotubes. The objectives are to evaluate the macroscopic slip velocity, compute the hydrodynamic load exerted at the rod side surface and tip, and estimate the flow-induced deflection. The hydrodynamic traction and macroscopic slip velocity are computed by solving the equations of Stokes flow for a doubly periodic square or hexagonal arrangement using a boundary-element method. The results illustrate the dependence of the slip velocity on the surface coverage expressed by the ratio of the rod radius to separation, and confirm the occurrence of hydrodynamic screening due to surrounding rods confining the traction near the exposed tip of each rod. An estimate for the flexural stiffness of nanotubes is made using available information on the flow-induced deflection. Computations for shear flow past an isolated attached rod are carried out using a highly accurate boundary-element method coupled with a finite-element method for solving the Euler–Bernoulli beam equation, and an iterative procedure involving a boundary-element implementation coupled with a boundary-value formulation involving ordinary differential equations for describing large beam deformation. The results illustrate the precise shape of deflected rods.     

Mixed convection boundary layer flow over a horizontal circular cylinder with Newtonian heating

The steady mixed convection boundary layer flow over a horizontal circular cylinder, generated by Newtonian heating in which the heat transfer from the surface is proportional to the local surface temperature, is considered in this study. The governing boundary layer equations are first transformed into a system of non-dimensional equations via the non-dimensional variables, and then into non-similar equations before they are solved numerically using a numerical scheme known as the Keller-box method. Numerical solutions are obtained for the skin friction coefficient Re ^1/2 C _f and the local wall temperature θ _w (x) as well as the velocity and temperature profiles with two parameters, namely the mixed convection parameter λ and the Prandtl number Pr.     

Performance of iterative methods for Newtonian and generalized Newtonian flows

We consider the use of accelerated gradient-type iterative methods for solution of Newtonian and certain non-Newtonian (power-law and Bingham models) viscous flow problems. The formulations are based on penalty and mixed finite element methods, and such factors as the effect of the penalty parameter, asymmetry, continuation and preconditioning are examined.     

Magnetohydrodynamic flow of a power-law fluid over a stretching sheet

Magnetohydrodynamic flow of an electrically conducting power-law fluid over a stretching sheet in the presence of a uniform transverse magnetic field is investigated by using an exact similarity transformation. The effect of magnetic field on the now characteristics is explored numerically, and it is concluded that the magnetic field tends to make the boundary layer thinner, thereby increasing the wall friction.