On the pH hysteresis of electroosmotic mobility with capillary zone electrophoresis in silica capillary

Summary A porous gel model of silica-solution interface was proposed to explain the pH hysteresis effect on the electroosmotic mobility with capillary zone electrophoresis in silica capillaries. It is speculated that, under acidic preconditionings of the capillaries, a porous gel layer is formed at the silica-solution interface, and the magnitudes of potential and electroosmotic mobility are then reduced due to the penetration of electrolyte counterions to the gel layer. On the other hand, under basic preconditionings, a fresh silica surfaces is created by dissolution of silica in alkaline conditions, and this would result in higher values of potential and electroosmotic mobility. The Guoy-Chapman-Stern-Grahame model was employed to simulate the pH-dependence of electroosmotic mobility for the silica capillaries with a gelling surface and with a fresh surface. The predicted data were compared with the experimental results and shown to support the explanation.     

调控双电层电渗流数值研究

在通道壁面垂直施加一个调控电场可以改变双电层电荷密度和Zeta电位势,实现对电渗流的调控.采用电场Poisson方程、动量守恒的Navier-Stokes方程、电解质离子输运的Nernst-Planck方程和液体混合反应的组分浓度输运方程,本文对微通道壁面离散布置调控电极的情况进行了数值分析.数值算例包括单电极、双电极...     

A non‐gassing electroosmotic pump with sandwich of poly(2‐ethyl aniline)‐Prussian blue nanocomposite and PVDF membrane

Low voltage, non‐gassing electroosmotic pump (EOP) was assembled with poly(2‐ethyl aniline) (EPANI)‐Prussian blue nanocomposite electrode and commercially available hydrophilic PVDF membranes. The nanocomposite material combines excellent oxidation/reduction capacity of EPANI with exceptional stability by shuttling of proton between Prussian blue nanoparticles and EPANI redox matrix. The flow rate was highly dependent on the electrode composition but it was linear with applied voltage. The flow rate at 5 V for different nanocomposite, EPANI, EPANI‐A, EPANI‐B, and EPANI‐C were 127.29, 187.41, 148.51, and 95.47 µL/min cm², respectively, which increases substantially with increase in the Prussian blue content. The obtained best electro osmotic flux was 43 µL/min/V/cm² for EPANI‐A. It was higher than most of the EOP assembled using polyquinone and polyanthraquinone redox polymers. The assembled EOP remained exceptionally stable until the electrode charge capacity was fully utilized. The best EOP produces a maximum stall pressure of 1.2 kPa at 2 V. These characteristics make it suitable for a variety of microfluidic/device applications.     

On‐chip pressure generation using a gel membrane fabricated outside of the microfluidic network

On‐chip generation of pressure gradients via electrokinetic means can offer several advantages to microfluidic assay design and operation in a variety of applications. In this article, we describe a simple approach to realizing this capability by employing a polyacrylamide‐based gel structure fabricated within a fluid reservoir located at the terminating end of a microchannel. Application of an electric field across this membrane has been shown to block a majority of the electroosmotic flow generated within the open duct yielding a high pressure at the channel–membrane junction. Experiments show the realization of higher pressure‐driven velocities in an electric field‐free separation channel integrated to the micropump with this design compared to other similar micropumps described in the literature. In addition, the noted velocity was found to be less sensitive to the extent of Debye layer overlap in the channel network, and therefore more impressive when working with background electrolytes having higher ionic strengths. With the current system, pressure‐driven velocities up to 3.6 mm/s were realized in a 300‐nm‐deep separation channel applying a maximum voltage of 3 kV at a channel terminal. To demonstrate the separative performance of our device, a nanofluidic pressure‐driven ion‐chromatographic analysis was subsequently implemented that relied on the slower migration of cationic analytes relative to the neutral and anionic ones in the separation channel likely due to their strong electrostatic interaction with the channel surface charges. A mixture of amino acids was thus separated with resolutions greater than those reported by our group for a similar analysis previously.