共查询到20条相似文献,搜索用时 140 毫秒
1.
2.
介绍了二端口器件放大器的噪声对相位噪声的影响,并从理论上对相位噪声和噪声系数之间的关系式进行了推导。 相似文献
3.
在稳频激光的光纤传输中,光纤本身引入的相位噪声影响到激光频率的稳定性,造成激光光谱的展宽。介绍了光纤相位噪声的测量及如何通过反馈控制在光纤远端消除这一噪声。建立了消除光纤相位噪声的实验系统,测量了一段30 m裸光纤引入的相位噪声,并采用反馈控制在光纤的远端消除这一噪声,将光纤造成的1 kHz谱线展宽减小到1 Hz以下。还分析了将相位检测中解调出来的噪声电压转换成相位噪声的问题。 相似文献
4.
本文采用速率方程与量子统计方法分析了光纤激光放大器的工作原理与工作特性,所得结果与已报导的实验结果基本相符。同时,此理论还为新的光纤放大器的设计提供了理论依据。 相似文献
5.
光纤放大器的放大及噪声特性的量子分析 总被引:1,自引:1,他引:0
本文利用热库理论推导出N个稀土离子和单模场相互作用的约化密度算符的主方程,从而得了光纤放大器的光子放大方程,同时,对集总式光纤放大器的量子噪声也进行了研究,发现理想的光纤放大器可以达到了量子噪声极限。若考虑探测器中光电子的离散特性,最小的噪声因子为2,即3dB。 相似文献
6.
7.
微波放大器用高灵敏度相位噪声测试系统 总被引:1,自引:1,他引:0
该系统是在二端口器件相位噪声测试原理电路的基础上加入载波抑制电路和调相校准信号形成电路而组成,具有合适的激励源和先进的测试终端。该系统工作在3cm波段,能测定连续波工作状态下及脉冲工作状态下被测放大管的剩余相位噪声,在偏离载波频率1KHz处的本底噪声小于-130dBc/Hz。 相似文献
8.
研究了铒镱共掺单频光纤放大器中100 Hz~1 kHz频段内的相位噪声,并通过实验证明该尖峰噪声为泵浦电源产生的相位噪声。从铒镱共掺光纤放大器的功率传输方程出发、结合泵浦激光的热传递函数,数值分析了泵浦功率、泵浦波长、增益光纤长度对100 Hz~1 kHz频段内相位噪声的影响。通过二级光放大结构对输出激光的相位噪声进行测量,并将实验结果与数值仿真结果进行对比,证明了理论模型的可靠性。该研究优化了主谐振功率放大结构铒镱共掺单频光纤放大器的相位噪声特性、并为提高相干合成时的合束效率提供指导。以上所得结果普遍适用于主谐振功率放大结构的光纤放大器。 相似文献
9.
10.
11.
本文利用Optiamplifier光放大器设计软件对拉曼放大器的泵浦光源种类、泵浦光源波长、泵源数目及功率的大小,及采用何种光纤等方面进行了仿真实验,最后从成本、实用角度出发采用三泵源实现了1530~1600nm放大带宽、平坦增益等性能指标。 相似文献
12.
13.
This paper presents a design of a low power CMOS ultra-wideband (UWB) low noise amplifier (LNA) using a noise canceling technique with the TSMC 0.18 μm RF CMOS process. The proposed UWB LNA employs a current-reused structure to decrease the total power consumption instead of using a cascade stage. This structure spends the same DC current for operating two transistors simultaneously. The stagger-tuning technique, which was reported to achieve gain flatness in the required frequency, was adopted to have low and high resonance frequency points over the entire bandwidth from 3.1 to 10.6 GHz. The resonance points were set in 3 GHz and 10 GHz to provide enough gain flatness and return loss. In addition, the noise canceling technique was used to cancel the dominant noise source, which is generated by the first transistor. The simulation results show a flat gain (S21>10 dB) with a good input impedance matching less than –10 dB and a minimum noise figure of 2.9 dB over the entire band. The proposed UWB LNA consumed 15.2 mW from a 1.8 V power supply. 相似文献
14.
介绍了利用CATV分析仪,通过测量光放大器引起的系统载噪比劣化来推算光放大器噪声系数的方法,给出了噪声系数与载噪比劣化之间的关系。根据实验测量数据得到的噪声系数曲线与掺饵光纤放大器专用设计软件的数值模拟结果一致。 相似文献
15.
This paper presents a high-gain wideband low-noise IF amplifier aimed for the ALMA front end system using 90-nm LP CMOS technology.A topology of three optimized cascading stages is proposed to achieve a flat and wideband gain.Incorporating an input inductor and a gate-inductive gain-peaking inductor,the active shunt feedback technique is employed to extend the matching bandwidth and optimize the noise figure.The circuit achieves a flat gain of 30.5 dB with 3 dB bandwidth of 1-16 GHz and a minimum noise figure of 3.76 dB.Under 1.2 V supply voltage,the proposed IF amplifier consumes 42 mW DC power.The chip die including pads takes up 0.53 mm~2,while the active area is only 0.022 mm~2. 相似文献
16.
17.
介绍了一种基于0.18-um CMOS工艺、适用于超宽带无线通信系统接收前端的低噪声放大器。在3.1~10.6GHz的频带范围内对它仿真获得如下结果:最高增益12dB;增益波动小于2dB;输入端口反射系数S11小于-10dB;输出端口反射系数S22小于-15dB;噪声系数NF小于4.6dB。采用1.5V电源供电,功耗为10.5mW。与近期公开发表的超宽带低噪声放大器仿真结果相比较,本电路结构具有工作带宽大、功耗低、输入匹配电路简单的优点。 相似文献
18.
采用变分法讨论了放大器噪声对色散管理光孤子脉冲参数的影响。讨论了ASE噪声对脉冲相位、脉冲中心时间和中心频率的影响,并且对比讨论了采用密集色散管理系统和降低平均色散值后,ASE噪声对脉冲的影响,结果表明:密集色散管理孤子系统和平均色散接近于零的色散管理系统更有利于降低放大器噪声对脉冲的扰动。 相似文献
19.
20.
In this paper we suggest an alternative method for the analysis of low frequency noise of transistors based on measurements of phase noise of a test oscillator. This method is demonstrated by experimental results obtained with a simple test oscillator with HEMT, and central frequency of 13.769 GHz. The main contribution to phase noise of the test oscillator comes from up conversion of transistor LF noise. This idea and the method can be used for the selection of transistors for high frequency application or for design of test circuit in RF IC manufacture. 相似文献