连续波环形染料激光器的单向运转特性

本文讨论了连续波环形染料激光器的单向运转特性。采用改进的Ganiel速率方程模型,分析了在单向运转条件下泵浦光通量、染料分子密度等参量对激光光通量、激发单重态粒子集居数密度以及增益的影响;揭示了在连续波环形染料激光器中单向运转条件下存在粒子集居数密度的非对称性、激光光通量与激活介质内空间位置的相关性和增益峰值波长的扫描现象。本文给出了数值计算结果。     

Kerr-lens mode-locking of Nd:glass laser

We report what is to our best knowledge the first Kerr-lens mode-locking of a Nd:silicate glass laser. Pulses as short as 64 fs were generated. For a broadband inhomogeneously broadened laser, the formation of the soliton-like pulses requires a minimum amount of negative group velocity dispersion (GVD), and more negative GVD is needed to have stable, self-sustained mode locking.     

Nd：YAG激光器中的自锁模

本文报道在Nd:YAG激光器中首次获得的自锁模脉冲序列.自锁模是由于Nd:YAG棒中的自相位调制引起的.在主被动对撞锁模运转情况下,自锁模对脉冲波形有较大的影响.     

Investigation of kerr-lens mode-locking of a flashlamp-pumped Nd:YAG laser

In this paper, we report that mode-locked operation is realized in a flashlamp-pumped Nd:YAG laser with a nearly critical stable resonator, using LiF:F₂⁻ color center crystal as a modulation device. A single pulse train with the energy of 25 mJ and the pulse duration of 82 ps is obtained. Both the theoretical and experimental results have shown that the mode-locked operation has resulted from kerr-lens effect formed in combination with self-focusing within Nd:YAG and an aperture at a specific point, but not directly from the saturable absorption of LiF:F₂⁻ crystal.     

1.34μmNd：YAP激光器的被动锁模

演示了氙灯泵浦的Nd:YAP激光器在波长1.34μm处的被动锁模,利用染料BDN-3e溶解于二甲亚砜作为可饱和吸收体,获得了波长为1.34μm的被动锁模脉冲序列输出.锁模脉冲序列的总能量达到2.2mJ,每个脉冲的平均脉宽为120ps.     

带抗共振环的非稳腔对撞脉冲锁模Nd:YAP(Nd:YAL0_3)激光器

本文报道用Nd:YAP (Nd:YALO_3)激光介质在带抗共振环的平-凸非稳腔结构中,选用五甲川-1,2-二氯乙烷染料,实现对撞脉冲被动锁模,获得良好锁模脉冲波形的实验结果.在1Hz的重复频率下,锁模脉冲平均脉宽<10ps,输出脉冲系列平均能量80mJ,脉冲系列能量集中于中央的三个脉冲,锁模成功率100%.输出能量稳定性80±4mJ.     

Dual-wavelength asynchronous and synchronous mode-locking operation by a Nd:CLTGG disordered crystal

We have developed a diode-pumped passively mode-locked Nd³⁺:CLTGG laser operated at 1059 and 1061 nm with a semiconductor saturable absorber mirror (SESAM). The relative intensity of the two spectrum wavelengths is adjustable, allowing asynchronous and synchronous generation of the dual-wavelength pulses. In synchronous mode-locking regime, a total average output power of 383 mW was obtained with pulse duration of 3.5 ps and repetition rate of 42 MHz. The two spectral bands of 1059 and 1061 nm had the same intensities and areas, indicating 1:1 for the pulse energy ratio. It is desirable for efficiently generating a terahertz wave by difference-frequency generation.     

Investigation of Cr:YAG passive mode-locking in a pulsed Nd:YAG laser

Passive mode-locking of a pulsed Nd:YAG laser using a Cr⁴⁺:YAG saturable absorber was realized for the first time in a nearly critical stable resonator containing an antiresonant ring structure. The output energy and pulse duration are 13.5 mJ and 180 ps, respectively. The recovery time and saturable intensity for excited-state absorption of Cr⁴⁺:YAG under the action of strong laser pulses were calculated from rate equations.     

Steady-state mode-locking operation in a laser with a saturable absorber

It is shown that a simple correspondence exists between the form of radiation for a steady-state mode-locking operation and the well-known solution of the one-mode problem. The dependence of the amplitude and shape of the pulses on the amount of absorber is determined.Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Radiofizika, Vol. 15, No. 2, pp. 221–226, February, 1972.     

Q-switched operation of a Nd:YCOB laser

Q-switched operation of a Nd:YCOB laser is demonstrated. A Nd:YCOB crystal was end-pumped by laser diodes operating at a wavelength of 0.8 μm and with a peak power of 22 W, and Q-switching was achieved by the spinning disc technique. Pulses that were as short as 50 ns and with up to 0.5 mJ of energy were obtained. After optimization, a threshold of 0.5 mJ and a slope efficiency of 13% were achieved.     

Stable mode-locking operation in a Cr:forsterite laser with a five-mirror cavity

The experimental finding of more-stable mode-locking operation in a five-mirror cavity than in a conventional four-mirror cavity for a Cr:forsterite laser [IEEE J. Quantum Electron. 33, 1975 (1997)] was interpreted by ABCD-matrix formalism. Since the optimum cavity configuration operation for mode-locking operation was attainable in the middle of the stable cavity condition, we conclude that one can easily achieve KLM alignment and stable mode locking with a five-mirror cavity.     

Simultaneous Q-switching and mode-locking in the CW Nd: YAG laser

The theory of transient mode-locking for an active modulator in a laser with a homogeneously broadened line is presented. The theory is applied to simultaneously Q-switched and mode-locked Nd:YAG lasers and good agreement between theory and experiment is obtained. The main conclusion is that under usual Q-switched operating conditions the mode-locking process does not have sufficient time to build up to steady-state conditions. We also present a method to overcome this problem by allowing the laser to prelase before the Q-switch is opened. Mode-locked pulses whose width approaches the steady-state value are obtained. The transient mode-locking theory presented here also applies to actively mode-locking TEA CO₂ lasers and to other types of simultaneously pulsed and mode-locked lasers.     

High-average-power flashlamp-pumped Nd:Glass fiber-bundle laser

Flashlamp-pumped high-gain fiber-bundle lasers consisting of multimode phosphate glass fibers have been investigated. By optimizing the fiber number and the outcoupling reflectivity in dependence on the pump conditions, high single-pulse energies in excess of 1 J as well as high-average-power extraction up to 100 W at a pulse repetition frequency of 100 Hz could be obtained from slim fiber-bundle lasers. Fiber numbers in the range of 150–250 and reflectivities between 35% and 50% have been found to provide reliable performance.     

The acousto-optic Q-switched mode-locking Nd:YVO4 laser

Q-switched mode locking (QML) has been observed in acousto-optic Q-switched Nd:YVO₄ laser that contained no mode-locking components. It was found that QML was easily realized in a long cavity and the modulation depth was observed to increase with increased cavity length. The maximum modulation depth was as high as 90%. This phenomenon is explained by the introduction of gain-related effect in the gain medium. The longitudinal modes at higher frequency, than the central frequency of the gain profile, experience positive guiding, which results in mode locking of these modes.     

Pulsed laser synthesis of titanium silicides using a Q-Switched Nd: Glass laser

Titanium films 120 nm thick deposited on single-crystalline silicon (c-Si) as well as poly-Si/SiO₂/c-Si substrates were subjected to Nd: glass laser irradiation. Laser fluences of 1,1.5, and 2 J/cm² were used at the pulse duration of 30 ns. From RBS analysis it follows that on c-Si substrate titanium suicide is formed using one pulse of 1.5 J/cm² energy density. On the substrate with surface overlayers lower fluence (1 J/cm²) was sufficient. Under these conditions the sheet resistance of the samples decreased from the initial value 5 / to 2–3 /. The smaller threshold density of energy for suicide formation in Ti/polySi/SiO₂/c-Si structure is shown to be a consequence of the SiO₂ underlayer, which is a poorer heat conductor than silicon. The experimental results of the suicide synthesis are in semi-quantitative accordance with the numerical computations of the temperature vs time evolution and depth temperature distribution in our samples.     

Continuous-wave dual-wavelength operation of a diode-end-pumped Nd:GGG laser

A diode-end-pumped continuous-wave (CW) simultaneous dual-wavelength laser operation at 1062 and 1331 nm in a single Nd:GGG was demonstrated. A total output power of 1.08 W at the two fundamental wavelengths was achieved at the incident pump power of 18.2 W. The optical-to-optical conversion is up to 5.9% with respect to the incident pump power. To the best of our knowledge, this is first work on CW simultaneous dual-wavelength operation of a diode pumped Nd:GGG laser. The article is published in the original.)     

High-power passively Q-switched mode-locking Nd:GdVO4 laser with LT-InGaAs saturable absorber

The generation of passively Q-switched mode-locking (QML) pulse has been obtained from a diode-pumped Nd:GdVO₄ laser with a LT-InGaAs wafer as saturable absorber as well as output coupler. Under the incident pump power of 10 W, an average output power of QML was 1.8 W with a Q-switched repetition rate of 280 kHz. The pulse duration of Q-switched pulse is about 160 ns and mode-locked pulse within the Q-switched envelope had a repetition rate of 410 MHz. It is indicated that the present LT-InGaAs is a very promising device in the field of mode locking solid-state laser, and we are sure that it will be complete pure cw mode locking with single beam output easily after further optimizing in the parameter such as saturation fluence, modulation depth, recovery time and damage threshold in semiconductors.     

Picosecond laser oscillator with a cavity design for stable CW mode-locking operation

A detailed design of a picosecond laser oscillator is made by using optical resonance theory and semiconductor saturable absorber mirror continuous wave mode-locked technology. Mode parameters in the optical resonance including beam sizes on the laser crystal and mode locker are calculated. By theoretical calculations, 3.7 W output power is obtained at a pump power of 11 W and the optical to optical efficiency is 34% in the designed model of picosecond laser. Based on the detailed design, an experiment is proceeded and a picosecond laser oscillator of about 3.5 W output power with 10.6 W pump power is fabricated. The optical to optical efficiency of the laser is 33%, the pulse duration is about 20 ps, and the repetition rate is about 80.3 MHz. The oscillator presents long-term stability in the experiment.     

Theoretical and experimental investigations of a passively mode-locked Nd: Glass laser

The presented theoretical model for a mode-locked Nd-glass laser simultaneously takes into account dynamics of the mode-locking dye, amplification saturation and radiation background. A systematic variation of laser parameters gives insight into the pulse formation process and allows to improve the laser design. The calculations show that it should be possible to decrease considerably the duration of light pulses of a mode-locked Nd-glass laser. Using a new mode-locking dye with a switching time of τ=2.7×10⁻¹² s we obtained stable laser operation and a pulse duration of 1.7×10⁻¹²s.     

cw dual-wavelength operation of a diode-end-pumped Nd:YVO4 laser

A dual-wavelength continuous wave (cw) diode-end-pumped Nd:YVO₄ laser that generates simultaneous laser action at the wavelengths 1064 nm and 1342 nm is demonstrated. The optimum oscillation condition for the simultaneous dual-wavelength operation in a diode-end-pumped solid-state laser has been derived. The relationship between the laser cavity and the output stability is also studied. Experimental results show that the stability of the output power at the two wavelengths could be enhanced by use of a three-mirror cavity. Received: 26 August 1999 / Revised version: 11 October 1999 / Published online: 23 February 2000