Modification of rubber surface by UV surface grafting

Rubber surface is subjected to ultraviolet radiation (UV) in the presence of allylamine and radiation sensitizer benzophenone (BP). Fourier transform infrared spectral studies reveal the presence of allylamine on the surface. The presence of irregular needle shapes on the surface as observed in scanning electron micrographs also confirms the polymerized allylamine on the surface. Allylamine coatings have been further confirmed from atomic force microscopy (AFM) analysis. Thermogravimetric analysis (TGA) reveals that allylamine coating on the rubber surface lowers the thermal degradation rate. The contact angle between the water and rubber surface decreases for the modified rubber surface confirming the surface modification due to UV surface grafting.     

Anisotropy analysis of the surface stress and surface energy in Cu surfaces with the modified embedded atom method

Taking Cu as an example, the surface stress and surface energy in three low index surfaces and two families of representative surfaces and belong to [0 0 1]- and -rotating axis respectively, have been calculated using MEAM. For the three low index surfaces, the decrease in the surface energy is small after relaxation, while the surface stresses in the surface planes τ_xx and τ_yy show opposite changes (decreasing and increasing) for inward and outward relaxations. The resulting relaxation direction is related to the normal stress τ_zz before relaxation. For the surfaces of the and families, with the increasing angle α (between the and (1 0 0) planes, and between and (0 0 1) planes, respectively), the surface stress and surface energy go through an oscillatory change. The surface stress and surface energy are symmetric about the planes (1 0 0), (1 1 0) and (0 1 0) at α=0^°, 45^° and 90^°, and about the planes (0 0 1) and (1 1 0) at α=0^° and 90^° respectively, due to crystal symmetry.     

Rubinowicz transform of the MTPO surface integrals

The surface integral of the modified theory of physical optics is reduced to a line integral by using the Rubinowicz transform for the incident scattered fields by an arbitrary aperture in a black surface. The integral theorem of Kirchhoff is applied to the scattering geometry and the diffracted fields are expressed in terms of a line integral along the contour of the diffracting edge.     

Tuning the lifetime of the surface plasmon upon sputtering

The lifetime of the surface plasmon in sputtered Ag ultrathin films on Cu(111) was investigated by high‐resolution electron energy loss spectroscopy measurements. The linewidth of the surface plasmon was found to follow a square‐root dependence on the fluence. Such finding allows the tuning of the lifetime of the plasmonic excitation upon sputtering and has general implications in plasmon‐based spectroscopies and in plasmon‐mediated processes across the films and at their surfaces. (© 2009 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Adhesion of silver nanoparticles on the montmorillonite surface

Adhesion of silver nanoparticles on the montmorillonite substrate was investigated using molecular modeling (force field calculations) and experiment (infrared spectroscopy, high-resolution transmission electron microscopy). Modeling revealed the preferred orientation of silver nanoparticles on the silicate substrate and showed the strong dependence of total energy and stability of nanocomposite structure on two factors: (1) the mutual crystallographic orientation of nanoparticle and substrate structure and (2) the size and thickness of the nanoparticle. The size of silver single crystalline domains calculated by modeling was in good agreement with the experimental observations. Molecular modeling in confrontation with high-resolution transmission electron microscopy analysis showed the prediction possibility as to the nanoparticles structure and stability of nanocomposite.     

Investigation of the 4H-SiC surface

The silicon carbide (SiC) surface is more complex than that of silicon and can be carbon-terminated or silicon-terminated, and can exist as several reconstructions. Investigations of the surface structure as a function of temperature, under ultrahigh vacuum (UHV) conditions using scanning tunneling microscopy (STM) and low energy electron diffraction (LEED), are presented. The 4H-SiC surface can be passivated using a silicon deposition/evaporation technique to reconstruct the surface. This has a significant effect on the electrical behaviour of metal contacts to the silicon carbide surface, critical in any electronic device. Atomic resolution STM studies of the 4H-SiC surface have revealed step features and micropipe defects in unprecedented detail. STM has also been used to image clusters of metal deposited on the 4H-SiC surface. The effect of annealing on the behaviour of these nickel clusters is also presented. The surface of the silicon carbide is extremely important in the fabrication of silicon carbide electronic devices and this paper presents a discussion of the SiC surface with particular reference to its impact on SiC device applications in power electronics.     

Nonlinear surface photoeffect in multi-color laser field: effect of the finite width of the surface potential barrier

Received: 20 September 1998     

GaAs surface passivation by ultra-thin epitaxial GaP layer and surface As-P exchange

The GaAs surface passivation effects of epitaxially grown ultra-thin GaP layers and surface As-P exchange have been investigated. Optical properties of passivated and unpassivated InGaAs/GaAs near-surface quantum wells (QWs) grown by metal organic vapor phase epitaxy (MOVPE) are studied by low-temperature continuous-wave and time-resolved photoluminescence (PL). By optimizing the growth conditions, smooth surface morphologies and significant improvement of optical properties were observed for both passivation methods. Passivation improved the PL intensity more than two orders of magnitude and notably increased the PL decay time.     

Conductive nanodots on the surface of irradiated CaF2

CaF₂(111) single crystal surfaces have been irradiated with fast heavy ions under oblique angles resulting in chains of nanosized hillocks. In order to characterize these nanodots with respect to their conductivity we have applied non‐contact atomic force microscopy using a magnetic tip. Measurements in ultra high vacuum as well as under ambient conditions reveal a clearly enhanced electromagnetic interaction between the magnetic tip and the nanodots. The dissipated energy per cycle is comparable to the value found for metals, indicating that the interaction of the ion with the target material leads to the creation of metallic Ca nanodots on the surface. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Restructuring of the surface region in SrTiO3

 The combination of x-ray diffraction analysis with surface sensitive techniques reveals a chemical inhomogeneity in the surface region of monocrystals of SrTiO₃ prepared under low and high partial pressure of oxygen at elevated temperatures. A solid state reaction leads to the formation of a multilayer-type structure. For oxidized crystals we observe AO-rich Ruddlesden-Popper phases at the surface and Magnelli phases of Ti in deeper layers of the surface region. The order of the layered structure is reversed for the reduced crystals with Ti-oxides of different oxidation levels at the surface and Ruddlesden-Popper phases in lower parts of the surface region. It is argued that this restructuring influences the electrical properties of SrTiO₃. Received: 12 July 1996/Accepted: 24 July 1996     

Impact of laser produced X-rays on the surface of gold

In the paper an attempt has been made to use the laser-induced plasma as an X-ray source for the growth of nanostructures on the surface of gold. For this purpose, an Nd:YAG laser operated at second harmonics (λ = 532 nm, E = 400 mJ) is used to produce plasma from analytical grade 5N pure Al, Cu and W targets. An analytical grade (5N pure) gold substrate was irradiated by X-rays generated from Al, Cu and W plasma under the vacuum ∼10⁻⁴ Torr. The surface was analyzed by two techniques, XRD and AFM. The aberrations in the XRD peaks show that there are significant structural changes in the exposed gold, in terms of decreased reflection intensities, increased dislocation line density, changes in the d-spacing and disturbance in the periodicity of the planes. AFM used to explore the topography of the irradiated gold reveals that regardless of the source, nm sized hillocks have been produced on the gold surface. The roughness of the surface has increased due to the growth of these hillocks.     

Laser-induced oxidation of the Si(111) surface

Pulsed laser induced oxidation of clean Si(111) surfaces has been studied by Auger electron spectroscopy and electron energy loss spectroscopy. The short duration time of the pulse has allowed a precise investigation of the first stages of the oxidation. About 1–2 oxide monolayers first grow in less than 10 s. Their stoichiometry evolves from SiO_x towards SiO₂ with increasing beam energy densities. Once this superficial layer has formed, no evolution is seen with further irradiation, suggesting that oxygen diffusion during the pulse duration cannot sustain the oxide growth.     

Thermal diffusion of potassium on the modified iron surface

The diffusion of potassium on the polycrystalline iron surface modified by adsorbed oxygen and nitrogen has been studied by means of AES. The migration of potassium atoms has been observed independently on the constitution of the iron surface in the temperature range between 300 and 450 °C. The final concentration of potassium on the iron surface increases with temperature from 300 to 400 °C, irrespective of what atoms accompany potassium on the surface. At 450 °C, the final level of potassium concentration is decreased. The profiles of the concentration on the surface along the line crossing the source of potassium were also acquired. Applying the diffusion model of finite source, the diffusion coefficient of potassium for oxygen-covered and nitrogen-covered surfaces were evaluated.     

Possibility of surface plasmon-polaritons amplification by direct current in two-interface systems with 2D Bragg structure on the surface

The method for calculation of the local field factor that describes electrodynamical properties of three-layered systems with 2D photonic crystal is proposed. Analytical calculations are performed in the frame of Green function method on the base of the effective susceptibility concept. The possibility of surface waves amplification by direct electrical current in the systems under consideration is studied. Numerical analysis clearly proves the presence of convective instability. It means that three-layered systems can be considered as a surface waves’ amplifier. Because of periodical structure the phase synchronism domain lies in the range of entirely accessible in practice values of wave vector and frequency. The experimental setup and real systems parameters for observation of surface waves amplification effect are discussed.     

Quantum oscillations and the Sermi surface of LuB12

To examine the Fermi surface of LuB₁₂, measurements of the de Haas-van Alphen (dHvA) effect were made at temperatures between 0.35 and 2 K in magnetic fields up to 12 Tesla. Oscillations in the susceptibility occurred above 5 Tesla in any field direction relative to the single crystal sample. From the Fourier transform of the data obtained, we conclude the Fermi surface of both conduction bands to have multiple extremal cross sections. For some of these orbits, the temperature dependence of the dHvA signal was investigated to determine the corresponding cyclotron mass. For a better understanding, a Full Potential Linearized Augmented Plane Wave-(FLAPW-) band structure calculation was carried out and the shapes of the Fermi surfaces were determined. In addition, we investigated the transverse magnetoresistance as a function of the field and the field direction. Its anisotropy, as well as the Shubnikov-de Haas (SdH) oscillations occurring in certain geometries, are in agreement with the results of the dHvA measurements.     

Diffusion in a surface: the atomic slide puzzle

We review measurements performed using scanning tunneling microscopy of the motion of impurity atoms in the Cu (001) surface. Like several other elements, the impurity that we have introduced, In, tends to embed itself in the first atomic layer of this surface. Via the motion of the embedded In atoms, we obtain direct information on the motion of the Cu atoms in the surface. In other words, we employ the In atoms as tracer particles to investigate the intrinsic motion in the first Cu layer. The peculiar statistics of the two-dimensional In diffusion allows us to conclude that the motion is assisted by a rapidly diffusing entity, which we identify as a surface vacancy, i.e. a single missing Cu atom in the outermost Cu layer. A comparison with model calculations of the statistics of the vacancy-assisted motion of terrace atoms shows that there must be an attractive interaction between an embedded In atom and a vacancy, which makes the In atom somewhat more mobile than a Cu surface atom. Such an attraction is indeed found in embedded-atom-method calculations. Nevertheless, the temperature dependence of the indium motion provides an accurate estimation of the sum E_form+E_act, representing the sum of the formation energy of a vacancy and the activation energy for the motion of vacancies through a clean Cu (001) surface. Received: 30 April 2001 / Accepted: 23 July 2001 / Published online: 3 April 2002     

Investigation into defects occurring on the polymer surface during the photolithography process

With a view to improving the realisation of polymer optical waveguide some features relevant to the photolithography process are analysed. This paper focuses on defects that occur on the surface of polymer layers involved in the process. For example, depending on the heat treatment or the deposited material, some worm-like defects appear on the polymer surface. When they occur, the waveguide surface roughness becomes too high (about one hundred nm and more). This means that the optical performance of the waveguides is too poor. In this document, we show the changes in temperature on polymer film surfaces which are coated with a thin inorganic layer and the occurrence of these defects is observed. This work confirms that the defect occurrence is clearly linked to the glass transition temperature. The paper reports that, in some cases, the adjustment of thermal properties by annealing can advantageously shift the glass transition, without changing the target optical properties.     

Anisotropic ac dissipation at the surface of mesoscopic superconductors

In this work we study the ac dissipation of mesoscopic superconductors at microwave frequencies using the time dependent Ginzburg-Landau equations. Our numerical simulations show that the ac dissipation is strongly dependent on the orientation of the ac magnetic field (h_ac) relative to the dc magnetic field (H_dc). When h_ac is parallel to H_dc we observe that each vortex penetration event produces a significant suppression of the ac losses because the imaginary part of the ac susceptibility as a function of H_dc increases before the penetration of vortices, and then it decreases abruptly after vortices have entered into the sample. In the second case, when h_ac is perpendicular to H_dc, we observe that the jumps in dissipation occur at the same values of H_dc but are much smaller than in the parallel configuration. The behavior of the dissipation in the perpendicular configuration is similar to previous results obtained in recent microwave experiments using mesoscopic lithographed squares of Pb [A.D. Hernández, O. Arés, C. Hart, D. Domínguez, H. Pastoriza, A. Butera, J. Low Temp. Phys. 135 (2004) 119].     

Wavelength dependence of second-harmonic generation at the copper surface

The wavelength dependence of the second-harmonic (SH) generation efficiency has been measured in copper. A strong enhancement of the SH generation has been observed at the onset of interband transitions. Above the absorption edge the second-order polarization is dominated by the nonlinear response of bound electrons.