多环架光电稳定系统及分析

提出一种多环架高精度光电稳定系统方案。通过对其进行运动学分析，并结合伺服控制原理，证明该方案优于常规的二环架光电稳定系统。     

多环架视轴稳定跟踪结构的运动学分析

根据视轴稳定跟踪的运动学原理,分析多环架结构的运动特点,指出结构形式的选择依据。采用PIOGRAM图方法,对两轴、三环两轴以及四环两轴结构分别进行讨论,通过角度和角速度的变换关系对环架自锁、跟踪盲区等现象作了运动学阐述,最终得出了各自适用的载体以及目标运动环境。该研究方法同样适用于其他多轴结构,对多环架结构的几何误差分析等也具有参考价值。     

分子拓扑学方法估算多环芳香烃类化合物的电离能

在构建多环芳烃类化合物分子的邻接矩阵主对角元时,结合烷基极化效应指数考虑分子图顶点的性质,以分子碎片C、CH、CH2、CH3等的相对能量作主元,用分子拓扑学方法构建了多环芳香烃类化合物新的邻接矩阵.研究结果发现,新的邻接矩阵特征根与多环芳香烃类化合物的电离能有良好的相关性Ipi=4.756+2.870OMOi,R=0.9853,s=0.1765,n=446.用这种新方法估算多环芳香烃类化合物的电离能,所用参数少且为分子结构性参数,稳定可靠,计算简便,结果较满意.     

特殊结构的多臂量子环的持续电流

提出了中臂弯曲的多臂量子环模型,且是上臂最短和下臂最长的不等臂量子环.研究发现：总磁通为零时,持续电流随半导体环增大发生非周期性振荡,并与电极的磁矩方向及隧穿电子的自旋方向相关,下臂因为最长而获得最小的平均持续电流.AB磁通增强时,持续电流会发生周期性振荡,各臂之间明显出现相互制约的现象.各臂持续电流之间的差异与臂长和磁通分布相关,Rashba自旋轨道耦合具有改变持续电流相位和相位差的效应.在一定条件下,两种波函数所对应的持续电流是可分离的. 关键词： 多臂量子环 持续电流 Rashba自旋轨道耦合     

燃煤过程中多环芳烃污染物生成排放的影响因子研究

区分出影响燃煤过程中多环芳烃有机污染物生成排放的外因条件和内在因素。外因条件包括：锅炉燃烧温度及排烟温度;内在因素包括：炉前煤显微煤岩组成、挥发份及发热量。研究结果为煤燃烧有机污染控制提供了重要的基础信息和理论依据。     

非旋波耦合条件下微波控制的光学双稳与多稳

研究了在非旋波耦合条件下微波场建立的原子相干对光学双稳与多稳的控制.通过改变微波场的初始相位,可以有效地控制双稳与多稳的存在与否、迟滞环宽度和阈值强度的高低.旋波和非旋波耦合在物理上可视为双色激发,耦合的能级分裂成无穷多个子能级,原来的裸态跃迁变成无穷多个不同频率的跃迁.这些跃迁的相干叠加决定了介质的非线性吸收与色散,相干叠加的结果取决于微波场的相位. 关键词： 原子相干 非旋波耦合 光学双稳与多稳 相位控制     

HXD中XH拉伸振动的振动跃迁偶极矩方向的理论研究

本文利用局域模研究了“重轻”体系简单分子XH伸缩振动的实验振动光谱. 键偶极方法进一步为实验光谱分析提供了帮助(假设XH伸缩振动的跃迁偶极矩沿着XH键方向排列). 通过局域模和多维简正模对HOD,HND^-,HCD,HSD,HPD^-和HSiD的XH伸缩振动的理论计算, XH伸缩振动的局部1D图片可以用于分析跃迁偶极矩倾斜角度. 在HOD分子中,OH伸缩振动的跃迁偶极矩远离OH键并且向远离OD键的方向倾斜;在HSD,HND^-,HPD^-,HCD和HSiD分子中的XH伸缩振动远离OH键,但朝向OD键,表明键偶极近似法不能很好地适用于“重轻体系”分子,重原子X可以影响跃迁偶极矩方向. 利用分子中原子理论分析了偶极矩的变化.     

Predicting the ignition delay of turbulent methane jets using Conditional Source-term Estimation

A predictive simulation of the autoignition process of non-premixed methane in a turbulent jet configuration was performed. Closure for the chemical source-term was obtained using Conditional Source-term Estimation with Laminar Flamelet Decomposition (CSE-LFD). The ambient oxidizer conditions – the high pressure and moderate temperatures characteristic of compression ignition engines – were chosen with the intent to validate the combustion model used under engine-relevant conditions. Validation was obtained by comparison of the predicted ignition delay to experimental results obtained from a shock-tube facility at several initial temperatures. Overall, the combination of full chemistry that has been carefully tuned to predict autoignition of premixed methane–air mixtures under similar temperature/pressure conditions with the CSE-LFD model is able to successfully predict the autoignition delay time of methane–air jets well within the scatter in the experimental data.     

多模态控制在步进电机位置伺服系统中的应用研究

针对步进电机伺服系统的响应速度慢、稳态误差低的问题,提出了一种多模态控制策略。根据误差大小调节两种控制策略对被控对象的作用权值,使最终的控制量连续输出,实现控制策略无扰动、平滑的切换。半实物仿真实验结果表明,该控制策略较好地综合了模糊控制和模糊PID控制的优势,系统反应速度快,震荡小,抗干扰能力强,同时一定程度上改善了低频振荡和高频失步的问题,具有实际应用价值。     

Estimation of emissivities in a two-dimensional irregular geometry by inverse radiation analysis using hybrid genetic algorithm

An inverse radiation analysis is presented for estimating the wall emissivities for an absorbing, emitting, scattering media in a two-dimensional irregular geometry with diffusely emitting and reflecting opaque boundaries from the measured temperatures. The finite-volume method was employed to solve the radiative transfer equation for 2D irregular geometry. The hybrid genetic algorithm which contains local optimization algorithm was adopted to estimate wall emissivities by minimizing an objective function, while reducing computation time. It was found that an increase in the standard deviation in measurements significantly deteriorated the estimation of wall emissivities. Thus, a very accurate measurement was required in inverse radiation for better estimation of wall emissivities, especially, in a high temperature environment.     

Estimation of the Reliability of a Stress–Strength System from Poisson Half Logistic Distribution

This paper discussed the estimation of stress-strength reliability parameter R=P(Y<X) based on complete samples when the stress-strength are two independent Poisson half logistic random variables (PHLD). We have addressed the estimation of R in the general case and when the scale parameter is common. The classical and Bayesian estimation (BE) techniques of R are studied. The maximum likelihood estimator (MLE) and its asymptotic distributions are obtained; an approximate asymptotic confidence interval of R is computed using the asymptotic distribution. The non-parametric percentile bootstrap and student’s bootstrap confidence interval of R are discussed. The Bayes estimators of R are computed using a gamma prior and discussed under various loss functions such as the square error loss function (SEL), absolute error loss function (AEL), linear exponential error loss function (LINEX), generalized entropy error loss function (GEL) and maximum a posteriori (MAP). The Metropolis–Hastings algorithm is used to estimate the posterior distributions of the estimators of R. The highest posterior density (HPD) credible interval is constructed based on the SEL. Monte Carlo simulations are used to numerically analyze the performance of the MLE and Bayes estimators, the results were quite satisfactory based on their mean square error (MSE) and confidence interval. Finally, we used two real data studies to demonstrate the performance of the proposed estimation techniques in practice and to illustrate how PHLD is a good candidate in reliability studies.     

高精度光链路授时时延估算

授时系统中信号单程传输时延的估算直接影响到授时的精度, 环路时延测试是估算单程传输时延的方法之一。在光缆授时系统中光纤的色散特性将导致不同波长光信号在同一光链路中的传输时延存在差异, 基于G.652光纤的色散特性, 提出的时延差精确估算方法, 能够得到这种传输时延的差异。仿真显示来回链路工作波长在1.55 μm附近时, 此方法能够很好地补偿时延差, 从而精确估算信号传输时延。     

非共面几何条件下102eV电子碰撞He单电离反应的三体耦合效应

在前人工作的基础上,通过引入有效索末菲参数考虑三体耦合效应,计算了非共面几何（垂直平面与垂直动量转移平面）条件下,102eV的电子碰撞He单电离反应的全微分截面,将其计算结果与3C、DWB2、我们前期的理论结果及实验数据进行了比较。     

阵列幅相误差条件下的目标方位估计

本文研究了一种改进的MUSIC法，可在一定阵列幅相误差条件下对多目标实现高分辨方位估计，有效地改善了原算法的参数估计性能，具有稳健性高、适用范围广以及工程实现简单等特点，通过大量的计算机仿真和水池实验表明，该方法具有较好的多目标分辨能力和方位估计精度，工程应用前景良好。     

各高速摄影仪跟踪测量数据时间一致性检验方法及准确分析

提出了各高速摄影测量仪跟踪测量数据时间一致性检验方法,并经实战任务数据处理分析,证明该方法行之有效.它不仅解决了跟踪设备时间一致性问题,同时也提高了卫星运载工具在起飞段的漂移量数据处理准确.     

可调谐激光晶体S因子和声子能量的估算

本文采用了一种特别的多模电-声子耦合模型,利用室温光谱数据估算可调谐激光晶体的黄昆-里斯(Huang-Rhys)S因子,并与单模耦合模型的结果作了比较.最后,还讨论了S因子与晶场强度及基质晶体价键特性之间的关系.