Liquid crystal Fresnel lens display

A novel see-through display with a liquid crystal lens array was proposed.A liquid crystal Fresnel lens display(LCFLD) with a holographic screen was demonstrated.The proposed display system has high efficiency,simple fabrication,and low manufacturing cost due to the absence of a polarizer and color filter.     

Achromatic optical vortex lens

A vortex lens is a useful optical device having applications ranging from astronomy to microscopy. Current vortex masks operate across a narrow bandwidth. Two design schemes are proposed for creating a vortex across a bandwidth exceeding 100 nm in the visible region of the spectrum.     

Phase shifting grating-slit test utilizing a liquid crystal display

A quantified focal plane testing method, termed phase-shifting grating-slit test, is demonstrated by utilizing a micro liquid crystal display. In contrast to the setup in the Ronchi Test, an incoherent illuminating grating is used and an optical slit is located at the image plane of the tested lens to modulate the aberrated wavefront. With the micro liquid crystal display generating and phase shifting the incoherent illuminating grating with variable frequency, a higher measurement dynamic range can be achieved on demand.     

Novel cell parameter determination of a twisted-nematic liquid crystal display

In this paper a novel method is proposed to determine the cell parameters including the twist angle, optic retardation and rubbing direction of twisted-nematic liquid crystal displays （TNLCD） by rotating the TNLCD. It is a single-wavelength method. Because using subtraction equation of transmittance as curve fitting equation, the influence of the light from environment and the absorption by polarizer, the sample of TNLCD and analyser on the transmittance is eliminated. Accurate results can also be obtained in imperfect darkness. By large numbers of experiments, we found that not only the experimental setup is quite simple and can be easily adopted to be carried out, but also the results are accurate.     

Optically controllable bistable reflective liquid crystal display

This Letter demonstrates a photo-addressable, bistable reflective liquid crystal display that is based on a dye-doped liquid crystal (DDLC). Bistable bright and dark states can be attained using the 45 deg twisted nematic (TN) and photo-induced isotropic states (PHI) of the DDLC, respectively. Both the 45 deg TN and PHI states can exist stably for tens of hours, and each can be rapidly switched to the other by the isomerization effect using UV and green light. A bistable reflective liquid crystal display is simply fabricated, easily operated, and rapidly switched. It therefore has the potential to be used in portable information systems.     

Anomaly in a high-numerical-aperture diffractive focusing lens

We show an anomalous behavior in a diffractive lens in which the spot size at the focus reaches a minimum at a numerical aperture of ~0.5 and then increases significantly at higher values. Theoretical and experimental results are presented, along with a comparison with refractive aplanatic lenses, in which the anomaly does not appear to exist.     

Terahertz electrically controlled nematic liquid crystal lens

We report some preliminary results on the realization of terahertz (THz) nematic liquid crystal (LC) lens with electric tunable focal length. A LC cell with a single circular-hole electrode is driven by an AC voltage to yield the desired spatial distribution of the refractive index. The two-dimensional function of the phase delay introduced into THz wave depends on the AC voltage and the electrodes contacting the LC layer. This lens is operated at room temperature and its convergent optical characteristic is demonstrated at 118 μm. We realize the lens with a clear aperture of 1 mm. The lens matched with a bolometer array is capable of obtaining real-time THz images of a sample without any mechanical scanning.     

A fast-response in-plane switching liquid crystal display with a protrusion structure

The widespread use and application of in-plane switching liquid crystal displays （IPS-LCDs） is limited by their slow response. In this letter, a fast-response IPS-LCD with a protrusion structure is proposed. The gray-to-gray response time of the IPS-LCD is reduced by 20% to 30%. The difference in cell gap induced by the protrusion accounts for the faster response. Moreover, the viewing angle and ganmla shift of tile proposed IPS-LCD are simulated and found to be better than that of conventional IPS-LCDs.     

液晶显示器用玻璃微珠的研制

论述了液晶显示器（ＬＣＤ）用玻璃微珠的研制工艺。着重介绍了制造该类玻璃微珠的无碱玻璃、成珠工艺及微珠的精选分级的原理及工艺技术。     

Low voltage transflective blue-phase liquid crystal display with a non-uniform etching substrate

A transflective polymer-stabilized blue-phase liquid crystal display(BP-LCD) with a non-uniform etching substrate is proposed.In-plane switching(IPS) electrodes on the bottom substrate are put on the different gaps,and the bottom substrate between the electrodes is etched into different depths in transmissive(T) and reflective(R) regions.This structure can balance the optical phase retardation in the two regions and is helpful to achieve well-matched voltag-dependent transmittance and reflectance curves.This transflective display has high optical efficiency,a wide viewing angle,and low operating voltage(approximately 6 V).     

Microstructural and microspectral characterization of a vertically aligned liquid crystal display panel

The microstructural and microspectral characteristics of a vertically aligned liquid crystal display (VA-LCD) panel were obtained noninvasively for the first time. With 1?μm axial and 2?μm transversal resolutions, the cell gap profile beneath the patterned thin-film transistor of the VA-LCD panel can clearly be resolved. The thicknesses of the multiple thin-film layers and the embedded defects can also be unveiled. As far as spectral response is concerned, the light transmittance at the layer boundaries can be estimated from the measured reflectance, which is crucial information for the design of a highly transmissive panel. The color shift of the VA-LCD panel due to fabrication error was evaluated.     

Computer-generated holograms from 3D-objects written on twisted-nematic liquid crystal displays

In order to optimize computer-generated holograms (CGHs) for three-dimensional objects, an extension of the well known Gerchberg-Saxton algorithm is used. Optical reconstructions using an electrically addressed twisted-nematic liquid crystal display are presented. For arbitrary CGHs, reconstructing 3D-objects, we will discuss the problems and solutions associated with periodic replication of holograms.     

基于液晶空间光调制器的全息显示

在传统的纯相位全息显示系统中, 一般基于快速傅里叶变换(FFT)算法来计算相位全息图, 在FFT的计算中需要遵循Nyquist采样定理, 因此, 重建图像的尺寸往往受限于空间光调制器的固定采样率. 这个限制可以通过卷积算法或者两步菲涅耳衍射算法来解决, 但是需要使用多个FFT的计算, 导致计算量增大. 鉴于此, 提出了一种基于透镜的纯相位全息图计算方法. 在全息图的计算中, 通过透镜的成像原理建立一个采样率可变的虚拟全息面, 通过调节相应的距离参数使得在全息图的计算中可以任意调节原始图像的采样率, 摆脱了传统方法中液晶空间光调制器带宽积对重建图像尺寸的限制, 并且这种算法只需使用一次FFT就能达到变采样率的衍射计算, 大幅提高了全息图的计算速度. 数值模拟及光学实验结果证明了此方法可以在全息显示光学系统中清晰地重建不同尺寸的图像. 同时该系统可以有效地消除由空间光调制器的像素化结构带来的零级衍射.     

Polymer-stabilized blue phase liquid crystal display with slanted wall-shaped electrodes

A polymer-stabilized blue phase liquid crystal display (BPLCD) with slanted wall-shaped electrodes is proposed. Compared with the traditional BPLCD with wall-shaped electrodes, the electrodes of the proposed BPLCD are slightly angled to obtain phase retardation in the entire cell even at the position of electrodes. The proposed BPLCD demonstrates a relatively higher average transmittance and overall brightness than the traditional BPLCD.     

Homogeneous-aligned high-transmission and fast-response liquid crystal display with three-layer electrodes

A homogeneous-aligned, high-transmission, and fast-response liquid crystal display (LCD) with three-layer electrodes is proposed. The molecules of liquid crystals are more inclined to rotate above and between the pixel electrodes. This induces a much higher transmission than that of the cell driven by the fringe field switching method and a wide viewing angle simultaneously because of the combined fringe and in-plane electric fields. Furthermore, a trigger pulse voltage is applied between the top and common electrodes to forcibly align the liquid crystal molecules vertically to show the transient dark state, which results in a very fast turn-off time (～1 ms). With high degree of transmission and fast response time, this kind of LCD is a potential candidate for large LCD panels.     

用于彩色液晶显示器的色分离光栅的优化设计

利用光栅实现液晶显示器中的色分离可以提高液晶显示器对光能的利用率。为了提高光能利用率,对光栅台阶数进行了优化设计,经矢量衍射理论计算,优化后的多台阶色分离光栅的能量利用率达到了65.3%,与采用滤色片的方法相比,光能利用率提高了近一倍;与三台阶相比,光能利用率提高了9.3%。     

液晶显示器用导电粉的扫描电镜图像

液晶显示器用导电粉的形状、尺寸及偏差对于液晶显示屏的质量控制来说是非常重要的。论述了液晶显示器(LCD)用导电粉的作用和性能要求。给出了液晶显示器用导电粉的扫描电镜图像。该图像对观测导电粉的粒径分布、导电粉在导电点中的浓度和分析导电点缺陷、提高液晶显示器的产品质量具有一定的意义。     

含多层衍射光学元件的折/衍射混合头盔目镜

基于对多层衍射元件的衍射效率的理论分析,设计了用于头盔显示器的含有多层衍射元件的60视场折/衍射混合目镜系统。系统在设计波段和整个视场范围内衍射效率均在90 %以上,提高了光能利用率和像面对比度。目镜的出瞳距离为22 mm,出瞳直径为8 mm。调制传递函数（MTF）在25 lp/mm时全视场均在0.38以上,满足VGA分辨率要求。目镜中畸变为4.8%,垂轴色差最大为10 m。整个系统结构紧凑,镜头总长26.8 mm,最大直径16 mm,全系统质量仅8 g,实现了光学系统的轻小型化     

一种液晶透镜盒间隙的测试方法

针对当前液晶透镜盒间隙测试存在的难题, 文中提出采用线偏振干涉法测试方法, 采用光强均匀分布的单色光入射, 检偏器的偏光轴方向与起偏器的偏光轴垂直或者平行, 液晶透镜的液晶取向层的摩擦方向与起偏器偏振轴夹角为45°, 此时干涉条纹亮暗差别最明显. 利用液晶透镜中心保持预倾角不变的透过率以及其他位置透过率最大值来计算液晶透镜的盒间隙, 该方法简单、可靠, 因采用光学手段测试, 其精确度相对较高. 关键词： 液晶透镜 盒间隙 线偏振光干涉 透过率     

Colorimetric characterization of liquid crystal display using an improved two-stage model

An improved two-stage model of colorimetric characterization for liquid crystal display (LCD) was proposed. The model included an S-shape nonlinear function with four coefficients for each channel to fit the Tone reproduction curve (TRC), and a linear transfer matrix with black-level correction. To compare with the simple model (SM), gain-offset-gain (GOG), S-curve and three-one-dimensional look-up tables (3-1D LUTs) models, an identical LCD was characterized and the color differences were calculated and summarized using the set of 7 × 7 × 7 digital-to-analog converter (DAC) triplets as test data. The experimental results showed that the model was outperformed in comparison with the GOG and SM ones, and near to that of the S-curve model and 3-1D LUTs method.