Sample preparation for gas chromatographic analysis of organic solvents in aerosol cans

Summary A method for the sampling of chemical products from aerosol cans is described. An aerosol can is frozen in liquid nitrogen, followed by puncturing the can and allowing the propellant to distill off. The conditions for the smaple preparation have been optimized. Solvent content in the products were analysed by headspace gas chromatography-mass spectrometry.     

Headspace analysis of chlorinated organic solvents in aerosol cans by gas chromatography

Summary A gas chromatographic (GC) method for the analysis of chlorinated solvents in chemical products in aerosol cans is described. Conditions for the sampling of chemical products from aerosol cans were optimized, so that the recovery of the solvents was better than 90%. Chlorinated solvents were identified by headspace GC—electron capture detection (ECD) as well as by GC — mass spectrometry. Headspace analysis employing the standard additions method and GC-ECD was used for the quantitation of chlorinated solvents. Analysis of 159 acrosol products, for various uses, revealed that 9% of these did not comply with the Danish Aerosol Regulations. The results of the study further indicated that aerosol products for haircare, paints and paint removers, and many others, can be formulated without chlorinated solvents.     

A gas chromatographic-mass spectrometric method for trace analysis of chlorofluorocarbons and their replacement compounds in atmospheric samples

Summary The simultaneous determination of chlorofluorocarbons and their replacement compounds in ambient air samples requires the preconcentration of appropriate air volumes on suitable adsorbents. The performance of a dual-layer adsorption tube to be used in this type of analysis was evaluated in terms of breakthrough volumes (BTV) for the compounds of interest at ambient temperature. To verify the effectiveness of such adsorption tubes, real air samples were enriched at ambient temperature and were subsequently analyzed by capillary gas chromatography coupled with quadrupole mass spectrometry, operating in SIM mode. The results obtained confirmed the efficacy of the proposed method, in terms both of sensitivity and chromatographic separation efficiency.     

A rapid gas chromatographic method for the analysis of acidic fermentation products

Summary A rapid and simple method for the identification of acidic fermentation products is described. Methyl esters of volatile and non-volatile acids are separated on a single chromatographic column. Retention time data for a number of acids are tabulated.     

New clean-up method for gas chromatographic analysis of pyrethroid residues

Summary A fast and efficient method has been developed for clean-up of fenpropathrin and fluvalinate for gas chromatographic determination of their residues in crops, grain and soil. Charcoal (Darco-G-60) was used as adsorbent and the pyrethroids recovered by washing the adsorbent with hexane-acetone (9∶1). The method provides a clear filtrate with no interfering peaks in the chromatogram. Recoveries ranged 91.00–100%.     

Gas chromatographic analysis and aerosol mass spectrometer measurement of diesel exhaust particles composition

Aerosol particles have important effects on human health, climate, regional visibility, and the deposition of acidic and toxic substances. The aerosols also have significant pharmaceutical and industrial applications. Trials of gas chromatographic analysis of extracts composition of diesel exhaust particles and aerosol mass spectrometer measurement of diesel exhaust particles composition are introduced in this paper. Usually, organic fraction of automotive exhaust particles are concentrated to 1 mL by Kuderna-Danish concentrator after extracted into dichloromethane by soxhlet extraction. Then, these extracts are analyzed by GC/MS. In the extracts from the diesel exhaust particles, there are over several thousands of components, for example paraffinic hydrocarbons, aromatics, oxygenates and other hydrocarbons.     

Gas chromatographic method for the analysis of nitrochlorobenzene isomers

Summary An efficient, reproducible and rapid gas chromatographic method for the analysis of nitrochlorobenzenes has been described in this paper. The method uses FFAP as stationary phase and 3,4-dichloronitrobenzene as internal standard. The total analysis time of the method is less than 15 minutes with a coefficient of variation ranging from 0.41% to 1.19% for different levels of three isomers.     

Comparison of gas chromatographic hyphenated techniques for mercury speciation analysis

In this study, we evaluate advantages and disadvantages of three hyphenated techniques for mercury speciation analysis in different sample matrices using gas chromatography (GC) with mass spectrometry (GC-MS), inductively coupled plasma mass spectrometry (GC-ICP-MS) and pyrolysis atomic fluorescence (GC-pyro-AFS) detection. Aqueous ethylation with NaBEt(4) was required in all cases. All systems were validated with respect to precision, with repeatability and reproducibility <5% RSD, confirmed by the Snedecor F-test. All methods proved to be robust according to a Plackett-Burnham design for 7 factors and 15 experiments, and calculations were carried out using the procedures described by Youden and Steiner. In order to evaluate accuracy, certified reference materials (DORM-2 and DOLT-3) were analyzed after closed-vessel microwave extraction with tetramethylammonium hydroxide (TMAH). No statistically significant differences were found to the certified values (p=0.05). The suitability for water samples analysis with different organic matter and chloride contents was evaluated by recovery experiments in synthetic spiked waters. Absolute detection and quantification limits were in the range of 2-6 pg for GC-pyro-AFS, 1-4 pg for GC-MS, with 0.05-0.21 pg for GC-ICP-MS showing the best limits of detection for the three systems employed. However, all systems are sufficiently sensitive for mercury speciation in environmental samples, with GC-MS and GC-ICP-MS offering isotope analysis capabilities for the use of species-specific isotope dilution analysis, and GC-pyro-AFS being the most cost effective alternative.     

A fast derivatization procedure for gas chromatographic analysis of perfluorinated organic acids

A rapid and simple derivatization procedure has been developed for gas chromatographic determination of perfluorinated organic acids (PFCAs, C₆–C₁₂), using isobutyl chloroformate (IBCF) to convert the acids into the more volatile isobutyl esters, under catalysis by pyridine. The procedure was optimized in an acetonitrile medium and applied to GC techniques with electron-capture detection (GC-ECD) and mass spectrometry with electron-impact ionization (GC-EI-MS); for the sake of comparison, HPLC with electrospray-ionization MS (HPLC-ESI(−)-MS) was also tested. The LOD and LOQ values obtained for these three techniques were compared, and the lowest LODs were obtained with GC-ECD (0.06–1.80 μg mL⁻¹). The procedure was further optimized in an aqueous medium, obtaining the best results in a phosphate buffer (pH 2.5, 50 mmol L⁻¹), in which the LOD and LOQ values were measured for GC-ECD a GC-EI-MS. The lowest LODs were found for GC-EI-MS (0.030–0.314 μg mL⁻¹). The practical applicability was tested on Vltava river water samples.     

Development and validation of a gas chromatographic method for analysis of fosfomycin in chicken muscle samples

Summary A gas chromatographic method for the determination of residues of Fosfomycin in chicken muscle samples has been developed. Muscle samples were homogenised with TRIS buffer, containing phenylphosphonic acid (as internal standard) and Fosfomycin using a tissue homogenizer. Afterwards, the samples were ultrafiltered and the ultrafiltrate was evaporated to dryness. A silylation reagent for derivatization was used in order to reconstitute the residue. The linear concentration range of application was 10–150 μgg⁻¹, with a detection and quantitation limit of 3.11 and 10 μgg⁻¹, respectively. The method was efficient with a mean recovery of 87.83% from spiked muscle. The results obtained show that gas chromatography is a useful method for the determination of Fosfomycin residues in chicken muscle samples.     

Quick gas chromatographic method for determining common pesticides in musts and wines

Summary A rapid method based on gas chromatography which determines parathion-methyl, fenitrothion, chlorpyrifos, dichlofluanid, vinclozolin, chlozolinate, procymidone and iprodione is described. It involves quantitative extraction with n-hexane and determination by capillary gas chromatography using an electron capture detector. Pesticides were satisfactorily separated in 15 min with a phenylmethylsilicone fused-silica capillary column under isothermal conditions. Quantitation was carried out using dieldrin as internal standard. The method seems appropriate for oenological laboratory work because of its simplicity and rapidity. It was successfully used to identify and quantify pesticides studied in musts and wines.     

Development of a carbohydrate silylation method in ionic liquids for their gas chromatographic analysis

This paper reports on the feasibility of silylation of low molecular weight carbohydrates dissolved in different ionic liquids (ILs) for their further analysis by gas chromatography (GC). Derivatization reagents (nature and amounts), temperature and time of reaction and stirring conditions were evaluated for different carbohydrates (i.e., glucose, mannose, fructose and lactose) dissolved in 1-ethyl-3-methylimidazolium dicyanamide [EMIM][DCA]. Evaluation of conformational isomerism of glucose dissolved in [EMIM][DCA] revealed the effect of the time of dissolution in the equilibration of α- and β-furanoses (up to 3% and 6%, respectively, after 70 h of incubation) and that 21 h sufficed to obtain results similar to those provided by the reference method involving pyridine. Once optimized, the proposed derivatization procedure provided satisfactory yields (i.e., close to 100%) using 100 μL of trimethylsilylimidazole (TMSI) at mild conditions (25 °C) for a relatively short time (1 h) for most of the investigated carbohydrates. Under these experimental conditions, linear responses (i.e., R² better than 0.974) were obtained in the tested range of 0.25–1 mg of the derivatized target compounds. Other reagents, such as N,O-bis(trimethylsilyl)trifluoroacetamide (BSTFA) + 1% trimethylchlorosilane (TMCS), were successfully used under ultrasonic conditions for aldose monosaccharides and disaccharides derivatization, while BSTFA was useful for ketose monosaccharides. The possibility of using the proposed method for the derivatization of selected carbohydrates dissolved in different ILs and the efficiency of the method applied to the analysis of carbohydrates present in real samples (fruit juices) have also been investigated.     

Miniaturized molecularly imprinted polymer extraction method for the gas chromatographic analysis of flavonoids

In this study, the use of monolithic molecularly imprinted polymers in a micropipette tip format allowing the simple and fast extraction of flavonoids from standard solutions and a black tea sample is demonstrated. The imprinted polymer employed quercetin, methacrylic acid or 4‐vinylpyridine, and ethylene glycol dimethacrylate as template, functional monomer, and cross‐linker, respectively. Surface morphologies of the quercetin‐imprinted polymers and the corresponding nonimprinted polymers were characterized by SEM. Extraction of flavonoid standards was performed to evaluate the selectivity and recovery with these imprinted and nonimprinted polymers. Flavonoid compositions in aliquots eluted from the tips were identified using fast GC with flame ionization detection. Maximum specific capacities of 0.2, 5.7, and 16.0 mg/g for catechin, morin, and quercetin, respectively, were obtained with the imprinted polymer prepared with methacrylic acid, with the corresponding recoveries of 99.8, 98.8, and 95.4%, respectively. Efficient extraction by the quercetin‐imprinted polymer of epicatechin, catechin, and quercetin from an apple‐flavored black tea sample was achieved, with GC–MS employed for compound identification for both the tea and extracted samples.     

Sampling device for a simple,fast calibration technique in gas chromatographic trace analysis of gas phases and vapor phases

In order to accommodate continually changing tasks in the [μl/l]–[nl/m³] ranges of gas chromatographic trace analysis of gas phases and vapor phases, a simple and time-saving calibration technique is presented which renders unnecessary conventional test mixtures of the abovementioned concentration ranges. This new method is based on the simulation of such mixtures at the inlet of the GC unit with the aid of commercially available multiway sampling valves of various volumes by means of partial pressure sampling.     

Derivatization of amines with chloroformate esters for gas chromatographic analysis

Summary The gas chromatographic analysis of amines after conversion to electron capture sensitive carbamates in two-phase systems has been studied. Hydrophilic compounds, for instance methylamine, are reacted with 2,2,2-trichloro-tert. butyl chloroformate. Quantitation below 10^–7 M can be made by thermionic or electron capture detection. A hydrophobic amine, namely N,N-dimethyl-n-octylamine, was derivatized with 2,4,6-tribromophenyl chloroformate with addition of iodide ion to the aqueous phase. The favorable effect of iodide ion as well as the choice of pH and chloroformate ester is discussed.Presented at the 14th International Symposium on Chromatography London, September, 1982     

Determination of the gas chromatographic gas hold-up time

Summary New versions are suggested for the gas hold-up time calculation in gas chromatography. The results are compared with those obtained by using other methods. The advantages of the suggested ways of calculation are pointed out.     

A novel technique for the sampling and gas chromatographic analysis of vapours

Summary A conventional pyrolysis gas chromatography system has been adapted to the analysis of vapours. A Curie point pyrolysis wire is used as a holder for granular active carbon on which the sample can be adsorbed. Desorption is achieved in the pyrolysis unit, but no pyrolysis occurs. The present study reports on the completeness of adsorption by the sampler and on the degree of release of adsorbate from it.     

Gas chromatography active ingredient control of aerosol insecticide from Algerian market

Household insecticide products are common and a popular mode of personal protection against household insect pests in all parts of the world. A chromatographic method for the control of aerosol insecticide active ingredient content was developed to be simple and rapid for the inspection of the numerous products for professional and private uses proposed in the Algerian market. Throughout, the most sold aerosol insecticides only two over eight were fair to the label declaration. However, the product labels need the addition of some details, like the active ingredients concentrations.     

Evaluation of 3,5-stigmastadiene content of edible oils: Comparison between the traditional capillary gas chromatographic method and the on-line high performance liquid chromatography-capillary gas chromatographic analysis

Summary The quantitation of 3,5-stigmastadiene and other steroidal hydrocarbons, commonly known as steradienes, is a valid tool for the recognition of refining (in particular bleaching) of edible oils; the evidence of this process is nowadays of a great interest due to growing market for virgin, cold-pressed, natural oils. Due to the long time required (about 4 hours) and the amount of solvents employed (about 650 mL) to perform the official analysis, other methods have been recently proposed, the most important of which involves high performance liquid chromatography coupled with capillary gas chromatography (HPLC-GC). In this study the results of ten oil samples, analysed by both the official method and HPLC-GC, are reported and the two methods compared and discussed, for routine use, in terms of sample preparation, time of analysis and setting up, difficulty and reproducibility.