Superactive and stereospecific catalysts. I. Structures and productivity

Two series of catalysts were made, one from MgCl₂–A solution containing MgCl₂, EH (2-ethylhexanol), and EB (ethyl benzoate) dissolved in decane and another from MgCl₂–B solution containing MgCl₂, EH, and phthalic anhydride which reacted to form the corresponding phthalic ester. Reactions of these solutions with TiCl₄ with or without another ester produced a family of eight catalysts. They form two groups, one having monoesters as modifiers, and the other containing diesters as modifiers. The surface area, pore volume, x-diffractions, polymerization activity, and catalytic stereospecificity of these catalysts have been compared. The diester catalysts differ from the monoester catalysts in every respect. By comparison the corresponding member of the diester catalysts have half as much Ti per Mg, more than 10 times the pore volume, more than a 100-fold the surface area, about 50% more productivity, and greatly increased steroespecificity.     

Superactive and stereospecific catalysts. II. Kinetics of propylene polymerizations

The kinetics of propylene polymerization by superactive CH-catalyst prepared from toluene solution of MgCl₂ · EH/PA/TiCl₄–TEA/PES was investigated. The results are compared with CW-catalyst prepared from crystalline MgCl₂/EB/PC/TEA/TiCl₄–TEA/MPT (abbreviations given in the text). The former is four times more active than the latter and produces more isotactic polypropylene. The CH-catalyst has 25% of the Ti as isospecific sites as compared to 6.7% for the CW-catalysts. These sites have the same rate constant of propagation so that the higher polymerization activity of the CH-catalyst is attributable simply to a greater number of active sites. Differences in the kinetics of deactivation and of chain transfer for the two catalysts are described.     

Superactive and stereospecific catalysts. IV. Influence of structure of esters on MgCl2 supported olefin polymerization catalysts

CH-type catalysts were prepared by reacting MgCl₂ · ROH, where ROH is 2-ethyl hexanol (EH), (R)-2-octanol (R-20), and (S)-2-octanol (S-20), with TiCl₄ in the presence of di-i-butyl phthalate (BP), di-i-butyl terephthalate (BT), (-)-dimenthyl phthalate (MP), or (-)-dimenthyl terephthalate (MT). The MT catalysts were found to incorporate 8.9 to 13% Ti whereas the BP catalysts contain only 1.9 to 2.6% Ti. Comparison of the CH(EH, BP) and CH(EH, MT) catalysts showed that they have about equal number of isospecific active sites per gram of catalyst and the same rate constants of propagation for their nonspecific sites, however, the isospecific sites in the latter are less active by comparison. Consequently, the CH(EH, BP) catalysts is five times more active than the CH(EH, MT) catalysts and produces polypropylene which is 97% isotactic (reflux n-heptane insoluble) as compared to 84.7% for the latter. The catalysts derived from 2-octanols are much less active than the corresponding catalysts prepared with 2-ethyl hexanol due to lack of reactivity with phthalic anhydride which permits excessive incorporation of TiCl₄ to form nonstereospecific catalytic sites as well as inactive Ti species.     

Magnesium-chloride-supported high-mileage catalysts for olefin polymerization. III. Electron paramagnetic resonance studies

Electron paramagnetic resonance (EPR) was used to study a MgCl₂-supported, high-mileage olefin polymerization catalyst. Anhydrous Toho MgCl₂ was the starting material. Treatment with HCl at an elevated temperature, ethyl benzoate by ball-milling, p-cresol, AlEt₃, and TiCl₄produced a catalyst that contained a single EPR observable Ti⁺³ species A, which was strongly attached to the catalyst surface, had a D_3h symmetry, and no other Ti⁺³ ion in an immediately adjacent site. Species A constitutes only 20% of all the trivalent titaniums; the remainder is EPR-silent and may be attributed to those Ti⁺³ ions that have adjacent sites occupied by one or more Ti⁺³ ions. Activation with preformed AlEt₃/methyl-p-toluate complexes produced a single Ti⁺³ species (C) with rhombic symmetry and displaying ²⁷Al superhyperfin splitting which has attributes for a stereospecific active site. This species is unstable under polymerization conditions and is transformed to another species with axial symmetry and solubilization. Both processes could lead to catalyst deactivation and loss of stereospecificity. Catalysts activated by AlEt₃ and methyl-p-toluate separately in various sequential orders produced a multitude of EPR-observable Ti⁺³ species with varying degrees of motional freedom deemed detrimental to stereospecific polymerization of α-olefins.     

Comparative identification of irradiated herbs by the methods of electron paramagnetic resonance and thermoluminescence

Non irradiated and γ-irradiated dry herbs savoury (Savoury), wild thyme (Thymus serpollorium) and marjoram (Origanum) with absorbed dose of 8 kGy have been investigated by the methods of elecrtron paramagnetic resonance (EPR) and thermoluminescence (TL). Non-irradiated herbs exhibit only one weak siglet EPR signal whereas in irradiated samples its intensity increase and in addition two satelite lines are recorded. This triplet EPR spectrum is attributed to cellulose free radical generated by irradiation. It has been found that upon keeping the samples under the normal stock conditions the life-time of the cellulose free radical in the examined samples is ∼60–80 days. Thus the conclusion has been made that the presence of the EPR signal of cellulose free radical is unambiguous indication that the sample under study has been irradiated but its absence can not be considered as the opposite evidence. In the case when EPR signal was absent the method of TL has been used to give the final decision about the previous radiation treatment of the sample.     

Electron paramagnetic resonance for everybody--MICROspec-X--a new class of electron paramagnetic resonance spectrometer

The electron paramagnetic resonance spectroscopy is the only method for detecting free radicals. Free radicals have an increased importance in our daily life. A small transportable EPR spectrometer is presented for the popularisation of the EPR method. The technical construction and some applications are illustrated which show the usability of the spectrometer.     

The determination of tungsten by electron paramagnetic resonance spectrometry

Electron paramagnetic resonance is used to determine tungsten in the range 5–400 μg ml^-1. Tungstate is reduced to tungsten(V) in the presence of thiocyanate in acidic medium and detected as the tungsten(V)—thiocyanate complex in amyl acetate after extraction. Molybdenum does not interfere; vanadium (5 mg) interferes. The relative standard deviation for mid-range concentrations is about 3%.     

Investigation of antioxidant radicals by the electron paramagnetic resonance method

Journal of Structural Chemistry -     

High-frequency and -field electron paramagnetic resonance of high-spin manganese(III) in tetrapyrrole complexes

High-field and -frequency electron paramagnetic resonance (HFEPR) spectroscopy has been used to study three complexes of high spin Manganese(III), 3d4, S = 2. The complexes studied were tetraphenylporphyrinatomanganese(III) chloride (MnTPPCI), phthalocyanatomanganese(III) chloride (MnPcCl), and (8,12-diethyl-2,3,7,13,17,18-hexamethylcorrolato)manganese(III) (MnCor). We demonstrate the ability to obtain both field-oriented (single-crystal like) spectra and true powder pattern HFEPR spectra of solid samples. The latter are obtained by immobilizing the powder, either in an n-eicosane mull or KBr pellet. We can also obtain frozen solution HFEPR spectra with good signal-to-noise, and yielding the expected true powder pattern. Frozen solution spectra are described for MnTPPCl in 2:3 (v/v) toluene/CH2Cl2 solution and for MnCor in neat pyridine (py) solution. All of the HFEPR spectra have been fully analyzed using spectral simulation software and a complete set of spin Hamiltonian parameters has been determined for each complex in each medium. Both porphyrinic complexes (MnTPPCl and MnPcCl) are rigorously axial systems, with similar axial zero-field splitting (zfs): D approximately -2.3 cm(-1), and g values quite close to 2.00. In contrast, the corrole complex, MnCor, exhibits slightly larger magnitude, rhombic zfs: D approximtely -2.6 cm(-1), absolute value(E) approximately 0.015 cm(-1), also with g values quite close to 2.00. These results are discussed in terms of the molecular structures of these complexes and their electronic structure. We propose that there is a significant mixing of the triplet (S = 1) excited state with the quintet (S= 2) ground state in Mn(III) complexes with porphyrinic ligands, which is even more pronounced for corroles.     

Distance measurements on spin-labelled biomacromolecules by pulsed electron paramagnetic resonance

The biological function of protein, DNA, and RNA molecules often depends on relative movements of domains with dimensions of a few nanometers. This length scale can be accessed by distance measurements between spin labels if pulsed electron paramagnetic resonance (EPR) techniques such as electron-electron double resonance (ELDOR) and double-quantum EPR are used. The approach does not require crystalline samples and is well suited to biomacromolecules with an intrinsic flexibility as distributions of distances can be measured. Furthermore, oligomerization or complexation of biomacromolecules can also be studied, even if it is incomplete. The sensitivity of the technique and the reliability of the measured distance distribution depend on careful optimization of the experimental conditions and procedures for data analysis. Interpretation of spin-to-spin distance distributions in terms of the structure of the biomacromolecules furthermore requires a model for the conformational distribution of the spin labels.     

New molybdenum compound suitable for determination by electron paramagnetic resonance

Molybdenum reacted with diethyldithiocarbamate showed a single line at g=1.980 in electron paramagnetic resonance spectrometry at room temperature after reduction by oxalic acid. Molybdenum in 10 μl of urine could be quantitated within 5 min with the detection limit of 50 pg.     

A study of Roman glass by reflectance and electron paramagnetic resonance spectroscopies

Reflectance and electron paramagnetic resonance (EPR) spectroscopies were used to study 25 fragments of Roman glass. Colour coordinates were used for an unbiased classification of the glasses in colour groups, which accounted for the presence of blue, blue-green, green, yellow-green, yellow and purple samples. Reflectance spectra were recorded in the 250–2500 nm wavelength range and showed absorption bands characteristic of Fe^II, Fe^III and Mn^III ions; furthermore, Co^II and Cu^II bands were observed in the spectra of the blue glasses. A decrease of the absorbance ratio of Fe^II to Fe^III ions was observed moving from blue-green to green and yellow-green glasses; however, yellow fragments still proved to be reduced glasses. EPR spectra displayed the characteristic patterns of Fe^III and Mn^II ions, with g-values in the 2–5 interval and spectral features depending on the relative content of the two elements. The characteristic pattern of the V^IV ion (g ≈ 2) and signals due to the formation of iron-sulphur complexes (g ≈ 6) appeared in the spectrum of a dark yellow glass, recorded at 77 K.     

Exchange narrowing in electron paramagnetic resonance of ruby

Previous theories of exchange narrowing of electron paramagnetic resonance spectra are re-examined. In the case of strong exchange interactions the diagonal matrix elements of the dipolar and fine structure interactions are time independent and symmetrization and narrowing of the electron resonance spectra result from a reordering of the magnetic energy levels by the strong exchange interaction. Lineshape calculations are given for concentrated ruby (10 mole % Cr₂O₃) and reasonable agreement with experiment is obtained.     

Uses of electron paramagnetic resonance in studying fracture

The uses of electron paramagnetic resonance (EPR) in studying aspects of polymer fracture are discussed. The sensitivity of EPR is such that all phases of fracture are not amenable to investigation by these means. This paper attempts to define those areas where the authors' experience would indicate that success might or might not be expected. A discussion of the difference between the tensile fracture of drawn polymer fibers, in which strong signals are obtained, and cast and molded materials is given.     

Structural transition in nickel-doped zinc fluotitanate observed by electron paramagnetic resonance

The EPR spectrum of Ni²⁺ in single crystals of zinc fluotitanate ZnTiF₆·6H₂O has been studied between 4.2 K and room temperature in the frequency range 14.0–16.5 GHz. A structural transition was observed at (180±2) K between a high-temperature trigonal structure and a low temperature orthorhombic structure. Spin hamiltonian parameters are reported above and below the transition.     

Gamma-irradiated ExtraVit M nutritive supplement studied by electron paramagnetic resonance spectroscopy

An unirradiated and γ-irradiated nutritive supplement named ExtraVit M was studied by electron paramagnetic resonance (EPR) spectroscopy in order to detect stable paramagnetic species following improvement of hygienic quality by γ-radiation. Free radicals were induced by γ-radiation in the studied samples from low absorbed doses, showing a certain sensibility of these samples to the radiation treatment. The EPR spectrum of irradiated ExtraVit M is typical for drugs or nutritive supplements containing high levels of sugars, vitamin C and cellulose.     

Radiation-induced electron paramagnetic resonance signal and soybean isoflavones content

Electron Paramagnetic Resonance (EPR) is a well-known spectroscopic technique that detects paramagnetic centers and can detect free radicals with high sensitivity. In food, free radicals can be generated by several commonly used industrial processes, such as radiosterilization or heat treatment. EPR spectroscopy is used to detect radioinduced free radicals in food. In this work the relation between EPR signal induced by gamma irradiation treatment and soybean isoflavones content was investigated. Present results did not show correlation between total isoflavones content and the EPR signal. Nevertheless, some isoflavone contents had a negative correlation with the radiation-induced EPR signal.