六角蜂窝结构光子晶体异质结带隙特性研究

利用蜂窝结构光子晶体具有两个范围较大绝对带隙的特性，设计新型六角蜂窝结构光子晶体异质结，采用平面波展开和超晶胞相结合的方法来研究异质结的能带结构特性.给出异质结的结构和相应的能带图，分析异质结界面传导模，研究两侧结构作横向拉开和侧向滑移时对传导模的影响，讨论这些结构的实际可行性.计算结果表明，没有任何晶格移动，此种结构异质结在绝对带隙中就有导模存在，两边晶格横向拉开对导模影响较大，而侧向滑移的影响则较小. 关键词： 光子晶体 异质结 光子带隙 超晶胞     

修正的频域有限差分法在二维金属光子晶体分析中的应用

与介质光子晶体相比,金属光子晶体的带隙特性在毫米波和亚毫米波波段有着重要的应用价值.基于Yee网格的频域有限差分法推导得出的本征模方程,求解后能方便而又可靠地得出介质光子晶体的带隙图和场分布.但由于金属与介质的本质差异,该方法不能直接应用于金属光子晶体.文中引入了金属表面边界条件,推导了二维金属周期结构的光子带隙本征模方程.通过数值计算,得出了不同晶格结构（正方/三角格子）下两种模式（TE/TM）的全禁带特性,并与介质周期结构的禁带特性进行对比,分析了金属周期结构在模式选择和器件集成方面的优点.     

修正的频域有限差分法在二维金属光子晶体分析中的应用

与介质光子晶体相比,金属光子晶体的带隙特性在毫米波和亚毫米波波段有着重要的应用价值.基于Yee网格的频域有限差分法推导得出的本征模方程,求解后能方便而又可靠地得出介质光子晶体的带隙图和场分布.但由于金属与介质的本质差异,该方法不能直接应用于金属光子晶体.文中引入了金属表面边界条件,推导了二维金属周期结构的光子带隙本征模方程.通过数值计算,得出了不同晶格结构（正方/三角格子）下两种模式（TE/TM）的全禁带特性,并与介质周期结构的禁带特性进行对比,分析了金属周期结构在模式选择和器件集成方面的优点. 关键词： 金属光子晶体 频域有限差分法 全禁带     

二维非正交坐标斜方格金属光子带隙结构

金属光子带隙结构在高能加速器、微波真空电子器件和太赫兹波源等方面具有重要的应用前景.基于实空间传输矩阵理论，详细研究了非正交坐标系下二维斜方格金属光子带隙结构，给出了计算横电模、横磁模完全带隙结构的一般公式，并分析了填充系数、任意斜角及金属柱横截面对带隙结构的影响.计算结果在退化为正方格情况下时，与其他方法的计算结果取得很好的一致. 关键词： 光子晶体 金属光子带隙 传输矩阵法 微波真空电子器件     

Extension of photonic band gaps in one-dimensional photonic crystals

A method is proposed for extending photonic band gaps by constructing periodic structures from two or more consecutively located photonic crystals with different lattice constants or filling factors. The photonic band gaps with a maximum extension are predicted by superposing the photonic band gap maps on one another. It is demonstrated that both the lowest and higher order band gaps can be merged in photonic crystals with a high refractive index contrast.     

Polarization multiplexed fluorescence enhancer using a pixelated one-dimensional photonic band gap structure

Fluorescence enhancement using photonic crystals can produce a significant improvement in the signal-to-noise ratio for single molecule and low molecule-concentration fluorescence imaging in biological and biochemical studies. In this Letter, a pixelated one-dimensional photonic band gap structure was designed to enhance both transverse electric and transverse magnetic polarizations through a spatially multiplexed photonic crystal resonance. The average enhancement of 15.6 and 17.9 fold were experimentally verified for the transverse and longitudinal fields on the same substrate. This device may be used as an optical platform for molecular orientation determination.     

Tetragonal photonic woodpile structures

The photonic properties of dielectric woodpile structures with face-centered-tetragonal (fct) and body-centered-tetragonal (bct) lattice symmetries are theoretically studied. Computational calculation of the photonic band structure reveals a photonic band gap between the second and third photonic band in both symmetries. A complete photonic band gap is not found in the bct structure due to a band gap shift with variable direction of lightflow. When the degree of layer disorder in fct woodpiles is increased, the stop bands slightly narrow and the attenuation of the optical transmission is reduced. Even so, layer-to-layer misalignment in dielectric woodpile structures may be tolerable up to 20–30% in most applications. The complete photonic band gap in fct woodpiles remains open with planar layer-to-layer disorder up to 60–70%.     

Geometric properties of optimal photonic crystals

Photonic crystals can be designed to control and confine light. Since the introduction of the concept by Yablonovitch and John two decades ago, there has been a quest for the optimal structure, i.e., the periodic arrangement of dielectric and air that maximizes the photonic band gap. Based on numerical optimization studies, we have discovered some surprisingly simple geometric properties of optimal planar band gap structures. We conjecture that optimal structures for gaps between bands n and n+1 correspond to n elliptic rods with centers defined by the generators of an optimal centroidal Voronoi tessellation (transverse magnetic polarization) and to the walls of this tessellation (transverse electric polarization).     

Maximizing band gaps in two-dimensional photonic crystals by using level set methods

The optimal design of photonic band gaps for two-dimensional square lattices is considered. We use the level set method to represent the interface between two materials with two different dielectric constants. The interface is moved by a generalized gradient ascent method. The biggest gap of GaAs in air that we found is 0.4418 for TM (transverse magnetic field) and 0.2104 for TE (transverse electric field).     

一维函数光子晶体的研究

本文提出一种新型函数光子晶体, 其折射率是空间位置函数. 由费马原理, 我们给出光在一维、 二维和三维函数光子晶体中的运动方程, 以及一维函数光子晶体的色散关系、 带隙结构和透射率, 再利用传输矩阵理论研究函数光子晶体周期数、 入射角和介质层的厚度等对透射率和禁带结构的影响, 计算发现通过选择不同的折射率空间分布函数, 可以得到比传统光子晶体更宽或更窄的禁带结构. 这样为我们设计不同带隙结构的光子晶体提供理论依据.     

Photonic band gap failure in photonic crystal devices

The photonic crystal is an artificial material with periodic dielectric constant and the key factor to preserve their band features is its periodicity. When the number of periods of photonic crystal is decreased the photonic band gap cannot prevent the light of the corresponding frequencies from propagating in photonic crystal, in another word, photonic band gap will be failure. The minimum periods of photonic crystal device which can keep photonic band gap effective in miniaturization process is analyzed, the transmittance spectrum is calculated by the Finite-difference time-domain algorithm (FDTD) [1], the minimum periods is got in the simulation and the reason which affects the minimum periods is analyzed in this paper.     

含特异材料一维超导光子晶体的带隙特性研究

利用传输矩阵法研究了含特异材料的一维超导光子晶体的带隙特性. 研究表明, 这类超导光子晶体同样具有由传统的电介质材料构成的超导光子晶体一样的低频带隙, 且在一定的参数下该低频带隙可以相当宽. 但在一定的结构参数下, 这类超导光子晶体同完全由传统的电介质构成的光子晶体一样不存在低频带隙. 还就超导光子晶体的偏振特性、光子晶体结构参数及环境温度的变化对光子带隙结构的影响进行了研究. 关键词： 超导光子晶体 传输矩阵法 特异材料 光子带隙     

Modelling and design of complete photonic band gaps in two-dimensional photonic crystals

In this paper, we investigate the existence and variation of complete photonic band gap size with the introduction of asymmetry in the constituent dielectric rods with honeycomb lattices in two-dimensional photonic crystals (PhC) using the plane-wave expansion (PWE) method. Two examples, one consisting of elliptical rods and the other comprising of rectangular rods in honeycomb lattices are considered with a view to estimate the design parameters for maximizing the complete photonic band gap. Further, it has been shown that complete photonic band gap size changes with the variation in the orientation angle of the constituent dielectric rods.      

Polaritonic and photonic gap interactions in a two-dimensional photonic crystal

If an ionic material is used in a photonic crystal, the lattice resonance creates a polaritonic gap in the infrared range. The interaction between a polaritonic gap and the structure gap in a 2D square photonic crystal is studied by transfer matrix photonic band structure calculations. The polaritonic gap appears for a surprisingly low volume density of the ionic material. The TM gaps are larger than the TE gaps, as in the dielectric case. By varying the lattice constant, the structure gaps can be shifted across the polaritonic gap, and the effects of merging the two gaps can be studied.     

Inhibited spontaneous emission of quantum dots observed in a 3D photonic band gap

We present time-resolved emission experiments of semiconductor quantum dots in silicon 3D inverse-woodpile photonic band gap crystals. A systematic study is made of crystals with a range of pore radii to tune the band gap relative to the emission frequency. The decay rates averaged over all dipole orientations are inhibited by a factor of 10 in the photonic band gap and enhanced up to 2× outside the gap, in agreement with theory. We discuss the effects of spatial inhomogeneity, nonradiative decay, and transition dipole orientations on the observed inhibition in the band gap.     

Analysis of photonic band gaps in a two-dimensional photonic crystal with centrifugal core-shell rods

The absolute photonic band gap (PBG) in two-dimensional (2D) photonic crystal with excentric core-shell rods is studied in this paper. The core rod shifts away from the core-shell rod center, and its position is decided by two new introduced parameters — the shift angle θ and the offset ρ. We use the FDTD algorithm to calculate the photonic bands of the photonic crystal, and analyze how the offset and shift angle affect the photonic bang gap of excentric core-shell photonic crystal for different core rod size. It has been shown that the variation of the photonic band gap is quite peculiar.     

Photonic band gap engineering in 2D photonic crystals

The polarization-dependent photonic band gaps (TM and TE polarizations) in two-dimensional photonic crystals with square lattices composed of air holes in dielectric and vice versa i.e., dielectric rods in air, using the plane-wave expansion method are investigated. We then study, how the photonic band gap size is affected by the changing ellipticity of the constituent air holes/dielectric rods. It is observed that the size of the photonic band gap changes with changing ellipticity of the constituent air holes/dielectric rods. Further, it is reported, how the photonic band gap size is affected by the change in the orientation of the constituent elliptical air holes/dielectric rods in 2D photonic crystals.     

Geometrically distributed aperiodic circular photonic crystals with broad and isotropic photonic band gaps

In this paper, a new type of circular photonic crystal (CPC) with a geometrical distribution of concentric layers is presented. A broad and isotropic photonic band gap is achieved using this geometrically distributed CPC (GCPC). Also, the influence of the number of concentric layers to the overall band gap of GCPC is studied. It is demonstrated that the band gap broadens with a red shift when the number of concentric layers is increased. The reason for the red shift of the band gap is further investigated.     

介质柱型二维Triangular格子光子晶体的禁带特性

采用平面波展开法数值计算了空气背景中由圆形、正六边形和正方形介质柱构造的二维三角晶格光子晶体禁带结构,并研究了介质方柱旋转角度、介质折射率和填充比对完全光子禁带宽度的影响.结果表明,在低频区,介质方柱旋转17°时,出现最大完全光子禁带,且最大禁带宽度随介质折射率的变化较为稳定.在高频区,介质方柱旋转30°时,完全光子禁带宽度最大;且介质材料折射率n=2.2时即出现完全光子禁带,n=2.6时,完全光子禁带达到最大.