共查询到20条相似文献,搜索用时 782 毫秒
1.
2.
3.
There are two different views on the definition of reaction molecularity in physical chemistry textbooks and related literatures so far. We give a deep discussion about this conception herein. Starting with the development of chemical kinetics and the definition of elementary reaction and state-state reaction, we clarify that elementary reaction and state-state reaction are the conceptions belonging to macro-and micro-systems, respectively, and reaction molecularity is also belonging to micro-conception. Based on this conclusion, we think that the more reasonable definition of reaction molecularity should be "the number of chemical particles that take part in a state-state reaction (or an elementary chemi-physical reaction) as a reactant". 相似文献
4.
用密度泛函理论(DFT)方法在B3LYP/6-31G*水平上研究了苯甲醛肟与炔丙醇加成反应的微观机制和热力学、动力学行为. 结果表明, 在苯甲醛肟与炔丙醇加成反应过程中, 8个可能反应通道的过渡态中均形成非平面五元环结构, 其中苯甲醛肟的Z、E构型特征得到了部分保留, 但主要部分的键长、键角均发生了变化, 电荷也进行了重新分布. 苯甲醛肟以羟基型参与反应的4个反应通道均为吸热反应和热力学非自发过程, 它们均具有较高的反应势垒、较慢的反应速率和较小的平衡常数; 而以离子型参与反应的四个反应通道均为放热反应和热力学自发过程, 它们的反应势垒较低, 反应速度较快, 平衡常数也较大, 故苯甲醛肟应主要以离子型参与反应. 炔丙醇的两种取向对应着加成反应的两种产物, 反应达到平衡后, 3-羟甲基二氢异噁唑为主要产物. 相似文献
5.
6.
固体聚合物电解质在肉桂醇电解氧化中的应用(II)——后续化学反应在电催化反应中的地位及其影响因素 总被引:4,自引:0,他引:4
对影响肉桂醇电极氧化的各种因素作了进一步的讨论. 实验结果表明固体聚合物电解质内水的含量、pH 以及浸入离子交换膜中的二价锰离子的浓度均对该电极反应的电位以及后续化学反应的速度有很大的影响, 在较高的温度下反应时, 有利手提高生成肉桂醛的电流效率. 相似文献
7.
以聚甲醛为羟甲基化试剂,研究了碱的种类、反应温度和反应时间等因素对芴与聚甲醛发生羟甲基化反应产物类型的影响。 结果表明,提高碱的强度有利于生成9,9-双羟甲基芴,升高温度和延长反应时间则有利于生成9,9′-亚甲基双芴。 通过控制反应条件,有可能优先生成9-芴甲醇或9,9-双羟甲基芴或联产这2个化合物。 相似文献
8.
The hydroboration reaction of methyl cyanide has been investigated by the MNDO method. It has been shown that the reaction requires an activation energy of 25.3 kcal/mol and involves a four-center-like transition state in the rate-determining step. This reaction has been compared with the corresponding reaction of hydrogen cyanide, and the effect of methyl substitution on the reaction has been discussed. The charge-transfer effects accompanying the reaction have also been studied. 相似文献
9.
The thermodynamics and mechanism of the reaction of elemental mercury with ozone has been studied computationally. The effect of water and water dimer molecules on the reaction has also been investigated. For dry reaction, we obtained two pathways and geometry optimization, atoms in molecules analysis and vibrational frequencies of all component of reaction have been used for confirming of reaction mechanism. Thermodynamic variable of reaction has been calculated. For the reaction in the presence of the water, our studies focus on ozone‐mercury complex reaction with water and water dimer and obtained the mechanism of reactions. Comparison of wet and dry reaction shows the energy profile of reaction decreases with water molecule correspond to experimental prediction. Calculated thermodynamic variable of all reaction shows the Gibbs free energy of reaction decreases with the number of water molecule. 相似文献
10.
11.
Direct dynamics within the framework of DFT was used to study the long-time puzzling mechanism of the reaction between F2 and ethylene. Three types of reactions are widely accepted : F atom elimination reaction, HF elimination reaction and the addition reaction. Several reaction mechanisms have been proposed, but only the radical mechanism can reasonably explain the initial reaction at low temperature. In this article, our calculations support the radical mechanism and the reaction mechanisms of the three reactions, and they are described in detail by trajectory simulation. The reactions in a cryogenic matrix with the reaction mechanism were also discussed. 相似文献
12.
以甘氨酸和金属钙盐为原料,采用水体系合成法制备甘氨酸钙螯合物,探讨不同反应温度、反应时问、反应体系pH等对产品产率的影响,从而确定反应的最佳条件,并对甘氨酸钙螯合物采用傅里叶红外光谱FT-IR进行表征。实验结果表明,合成甘氨酸钙螯合物的最适反应条件是,反应体系pH为5~6,反应时间为2~3h,反应温度为70~80℃。 相似文献
13.
M. Jabłoński 《Journal of Thermal Analysis and Calorimetry》2008,93(3):717-720
The reaction of sulphuric acid with titanium raw materials runs violently with simultaneous emission of gases. Such run of
reaction creates danger of explosion. This process is very complicated from the reason of complexity of reactions and variety
of compounds in reaction mixture. To determine safe conditions of reaction with high efficiency, it is necessary to investigate
phase composition products of reaction.
Products of reaction were investigated by using X-ray diffraction. However reaction products show high amorphy and this is
the reason of difficulties to determine all phases. For this reason also was used additional method — ‘drop’ calorimeter.
This method is used for determination of average specific heat of liquid or solid samples. In this case, this method was used
for verification of phase composition of products of reaction.
On the basis of investigation the phase composition of reaction product is following: titanyl sulfate, iron(III) sulfate,
monohydrated iron(II) sulfate, magnesium sulfate and unreacted remainders of ilmenite and magnesium silicate. 相似文献
14.
White JM Tunoori AR Dutta D Georg GI 《Combinatorial chemistry & high throughput screening》2000,3(2):103-106
Polymer-bound triphenylphosphine can replace triphenylphosphine in the Mitsunobu reaction to generate stereochemically inverted secondary alcohols. This method is comparable with the standard Mitsunobu reaction in terms of inversion of stereochemistry, yield, and reaction time, even for sterically very hindered secondary alcohols. The special merit of this reaction is that the excess polymer-bound triphenylphosphine and its by-products are easily removed by filtration from the reaction products. 相似文献
15.
A new reduction ring-opening reaction of 2-imidazoline with sodium borohydride is reported, and the effect of reaction condition on the yield, reaction mechanism and the use of the new reaction in synthesis of ethylenediamine derivatives are discussed. A new method for the preparation of unsymmetrical substituted ethylenediamine via the reduction ring-opening reaction of imidazoline is provided. 相似文献
16.
17.
本文提出了反应类等键反应方法,将通常用于热力学性质计算的等键反应方法推广用于类反应中反应势垒和反应焓变的计算. 对碳氢燃料低温燃烧反应机理中的一类重要反应类:?烷基自由基过氧化氢裂解生成烯烃和HO2自由基的反应势垒和反应焓变进行了计算. 通过对该类16个反应中的5个代表反应分别在不同计算水平HF、DFT、MP2、CCSD(T)的比较计算发现,采用等键反应方法可在较低从头算级别计算得到类反应较高精度的反应势垒,提高了计算的效率和精度. 本文采用反应类等键反应方法在B3LYP/6-311G(d,p)计算水平对该类16个反应进行了反应势垒和反应焓变的计算,并建立了反应势垒和反应能的线性自由能关系:delta V=71.02+0.41?delta E. 相似文献
18.
19.
20.
苯胺与氨基甲酸甲酯合成苯氨基甲酸甲酯反应研究 总被引:8,自引:0,他引:8
以无水氯化锌为催化剂,考察了温度、时间、催化剂含量及原料配比等条件对合成反应的影响,确定了最优化反应条件,并初步探讨了反应机理.最佳反应条件下MPC收率可达89.90%,选择性为99.76%. 相似文献