Moisture absorption and absorption kinetics in polyelectrolyte films: influence of film thickness

Specular X-ray reflectivity (XR) and quartz crystal microbalance (QCM) measurements were used to determine the absorption of water into thin poly(4-ammonium styrenesulfonic acid) films from saturated vapor at 25 degrees C. The effect of film thickness on the absorption kinetics and overall absorption was investigated in the range of thickness from (3 to 200) nm. The equilibrium swelling of all the films irrespective of film thickness was (0.57+/-0.03) volume fraction. Although the equilibrium absorption is independent ofthickness, the absorption rate substantially decreases for film thickness < 100 nm. For the thinnest film (3 nm), there is a 5 orders of magnitude decrease in the diffusion coefficient for water.     

The influence of a self-assembled monolayer on the activity of rough gold for glucose oxidation

Gold surface has been roughened by amalgamation and tested for self-assembled monolayer (SAM) formation and glucose oxidation. The rough gold undergoes structural changes at elevated temperatures, which lead to loss of activity for glucose oxidation and lower affinity for the self-assembly. The transformation of “active” into “inactive” surface can be prevented by SAM formation. The SAM modified gold exhibits high activity for glucose oxidation. These results are important especially for those studies, which use rough gold modified by SAM for enzyme immobilisation and further glucose oxidation, since the gold activity itself was so far neglected.     

Characterization of monolayer formation on aluminum-doped zinc oxide thin films

The optical and electronic properties of aluminum-doped zinc oxide (AZO) thin films on a glass substrate are investigated experimentally and theoretically. Optical studies with coupling in the Kretschmann configuration reveal an angle-dependent plasma frequency in the mid-IR for p-polarized radiation, suggestive of the detection of a Drude plasma frequency. These studies are complemented by oxygen depletion density functional theory studies for the calculation of the charge carrier concentration and plasma frequency for bulk AZO. In addition, we report on the optical and physical properties of thin film adlayers of n-hexadecanethiol (HDT) and n-octadecanethiol (ODT) self-assembled monolayers (SAMs) on AZO surfaces using reflectance FTIR spectroscopy, X-ray photoelectron spectroscopy (XPS), contact angle, and near-edge X-ray absorption fine structure (NEXAFS) spectroscopy. Our characterization of the SAM deposition onto the AZO thin film reveals a range of possible applications for this conducting metal oxide.     

Photopolymerization kinetics of monolayer and bilayer Langmuir-Blodgett films of acetylenic acid salts

The photopolymerization of thin (monolayer and bilayer) Langmuir-Blodgett films of the lead salt of 2-docosynoic acid (CH₃(CH₂)₁₈C≡CCOOH, DCA), with a triple bond near the carboxylic group, and the lead salt of 23-tetracosynoic acid (HC≡C(CH₂)₂₁COOH, TCA), with a triple bond far from the carboxyl group, has been investigated by IR spectroscopy. The principal distinctions between the polymerization kinetics of the DCA salt and that of the TCA salt are observed for bilayers. It is hypothesized that the perfection of the molecular packing in the bilayers is governed by the interlayer interaction of carboxyl groups, which exerts a stronger effect on the mutual orientation of the triple bonds in the DCA salt films as compared to the TCA salt films. A model is suggested for describing the kinetics of the two-dimensional photopolymerization of monoacetylenic compounds. A comparison between simulated and experimental data for the monolayer films demonstrates that the observed saturation of conversion (α) as a function of the UV exposure time (t) at the α ≈ 0.5?0.6 level can be attributed to the fact that the intermolecular distance lengthens with local film densification during polymerization. The effects of the substrate and the orientation of molecules in the layer on α (t) is reported.     

The influence of the oxide film on the current in AlAl oxide—fatty acid monolayer—metal junctions

For Al-Al oxide-fatty acid monolayer-Pb (or Al) junctions, a broad peak is found in the d In (I/V)/dV versus V curves at | V | ≈ 80 mV. The observation can be shown to arise from the oxide film and is tentatively interpreted in terms of impurity-assisted tunnelling in the highly-contaminated Al oxide film.     

Tin underpotential deposition on platinum and its catalytic influence on the kinetics of molecular oxygen electroreduction

The formation and dissolution of tin ad-layers on polycrystalline platinum were analysed by cyclic voltammetry in aqueous 10^–4 M tin(II)/1 M sulfuric acid in the 0.05–0.70 V versus RHE range. At this concentration level it was possible to observe that platinum sites involving (110) planes are mainly related to tin underpotential deposition. In contrast to previous results, no irreversible adsorption was found in the course of the electrodeposition. Thermodynamic adsorption parameters were calculated from the potential dependence of tin surface coverage. Catalytic properties of this new surface were studied on the basis of oxygen electroreduction as a model. Kinetic runs were performed with rotating ring-disk electrodes on bare and tin-modified platinum surfaces. Molecular oxygen reduction on tin-modified platinum takes place through the production of both water and hydrogen peroxide. This interpretation was confirmed by calculating the reaction order with respect to oxygen. Electronic Publication     

The effect of platinum oxide films on reaction kinetics at platinum electrodes

It has been known for some time that the pre-treatment of platinum electrodes often effects subsequent electrochemical reactions. Part of the effect of pre-treatment is due to the fact that anodized or chemically oxidized platinum electrodes become coated to some degree with a film of platinum oxide. This work was concerned with quantitative measurement of kinetic parameters as a function of the extent of oxide film formation. Whenever possible, variations in reaction mechanisms are proposed.

Most of the experimental evidence has been taken from current-potential curves but the techniques of chronopotentiometry and microscopy were also used.

The reduction of vanadium^V chromium^VI, arsenic^V, iodate and oxygen were investigated as well as the oxidation of vanadium^IV, arsenic^III, oxalic acid, and formic acid. The presence of the platinum oxide film effected the reactions studied in a variety of ways but in every case some variation in the kinetic parameters of the reactions studied was recorded. For a number of cases, a modified oxygen bridge theory was found useful.     

Development of porous cathode powders for SOFC and influence of cathode structure on the oxygen electroreduction kinetics

Meso/macroporous La_1−xSr_xCoO_3−δ powder with the specific surface area higher than 140 m² g⁻¹ has been synthesized from the corresponding nitrates, using solution thermal decomposition method. These nanopowders have been used for preparation of SOFC cathodes, demonstrating lower oxygen electroreduction activation energy than that for less porous cathodes prepared from the powders synthesized using traditional solid state reaction method. To increase macroporosity of the cathodes the special pore forming agent has been added into the raw cathode paste. The very low total polarization resistance and activation energy values have been obtained for oxygen electroreduction, depending on the cathode porosity and potential applied.     

Photochemical patterning of a self-assembled monolayer of 7-diazomethylcarbonyl-2,4,9-trithiaadmantane on gold films via Wolff rearrangement

Photolithographic attachment of functional organic molecules via ester or amide linkages to self-assembled monolayers (SAMs) on gold thin films was achieved by employing a novel photoreactive surface anchor, 7-diazomethylcarbonyl-2,4,9-trithiaadmantane. The photoreactive SAM was prepared by the spontaneous physical adsorption of the photoreactive surface anchor onto gold surfaces. The alpha-diazo ketone moiety of the SAM was found to display the classical Wolff rearrangement reactivity to produce a ketene intermediate on the exposed area. Organic molecules such as alcohols and amines can thus be attached to the gold surfaces selectively by the facile in situ formation of ester or amide linkages. The structure and reactivity of the photoreactive surface anchor were characterized by real-time FT-IR, fluorescence, and polarization modulation infrared reflectance absorption spectroscopy (PM-IRRAS). The Wolff rearrangement reactivity of the SAM suggested that a "surface-isolated" carbonylcarbene may be generated when the SAM was exposed to 255-nm irradiation.     

Molecular orientation of evaporated pentacene films on gold: alignment effect of self-assembled monolayer

Pentacene films deposited on self-assembled monolayers (SAMs) bearing different terminal functional groups have been studied by reflection-absorption IR, grazing angle XRD, NEXAFS, AFM, and SEM analyses. A film with pentacene molecules nearly perpendicularly oriented was observed on Au surfaces covered with an SAM of alkanethiol derivative of X-(CH2)(n)-SH, with X = -CH(3), -COOH, -OH, -CN, -NH(2), C(60), or an aromatic thiol p-terphenylmethanethiol. On the other hand, a film with the pentacene molecular plane nearly parallel to the substrate surface was found on bare Au surface. A similar molecular orientation was found in thinner ( approximately 5 nm) and thicker (100 nm) deposited films. Films deposited on different surfaces exhibit distinct morphologies: with apparently smaller and rod-shaped grains on clean bare Au surface but larger and islandlike crystals on SAM-modified surfaces. X-ray photoemission electron microscopy (X-PEEM) was used to analyze the orientation of pentacene molecules deposited on a SAM-patterned Au surface. With the micro-NEXAFS spectra and PEEM image analysis, the microarea-selective orientation control on Au was characterized. The ability to control the packing orientation in organic molecular crystals is of great interest in fabricating organic field effect transistors because of the anisotropic nature of charge transport in organic semiconducting materials.     

Mechanism of oxygen electroreduction on gold surfaces in basic media

The mechanism of the electroreduction of oxygen on Au surfaces in basic media is examined using surface-enhanced Raman scattering (SERS) measurements and density functional theory (DFT) calculations. The spectroscopy reveals superoxide species as a reduction intermediate throughout the oxygen electroreduction, while no peroxide is detected. The spectroscopy also shows the presence of superoxide after the addition of hydrogen peroxide. The calculations show no effect of OH addition to the Au(100) surface with regard to O-O length. These results suggest that the four-electron reduction of O(2) on Au(100) in base arises from a disproportionation mechanism which is enhanced on Au(100) relative to the other two low Miller index faces of Au.     

The influence of reagent concentration on the kinetics of carbon dioxide-propylene oxide copolymerization in the presence of a cobalt complex

The effect of the concentrations of propylene oxide and the catalyst (salen)CoDNP/[PPN]Cl ((salen)CoDNP: [PPN]Cl = 1: 1, mol/mol) on the kinetics of the copolymerization of CO₂ and propylene oxide at 0.5 MPa and 20°C has been studied. The reaction proceeds at a constant rate after an induction period, and the value of this period varies with the reagent concentrations. The steady-state reaction rate increases linearly with the propylene oxide concentration in the range 5.0–14.3 mol/L. At high catalyst concentrations, such as (5.2–7.3) × 10^?3 mol/L, the reaction rate is first order in the catalyst; at concentrations below 5 × 10^?3 mol/L, the reaction rate is second order in the catalyst. Molecular mass increases in proportion to the propylene oxide conversion, that is consistent with a living polymerization process. A regioregular copolymer with 96% head-to-tail (HT) connectivity of propylene oxide has been obtained.     

Self-assembled arrays of zinc oxide nanoparticles from monolayer films of diblock copolymer micelles

A hexagonal array of optically active ZnO nanoparticles was synthesized in situ on the solid substrate by utilizing a single-layered film of diblock copolymer micelles as a nanostructured template.     

The kinetics of charging and discharging of iridium oxide films in aqueous and non-aqueous media

Cyclic voltammetry and chronocoulometry have been used to investigate the kinetics of oxidation and reduction of electrochenucally generated Ir oxide films in H₂SO₄(aq), basic aqueous LiClO₄ solutions and LiClO₄ + acetonitrile solutions. In acidic aqueous solutions, the scan rate at which the main anodic peak potential begins to shift positively in cyclic voltammetry experiments has been used as a parameter to assess the charging and discharging kinetics of Ir oxide films grown under various conditions. In acidic and basic aqueous solutions, chronocoulometric measurements indicate that electron transport through the oxide is rate limiting for the main redox wave, whereas ion transport probably limits the charging/discharging kinetics in LiClO₄ + CH₃CN solutions. In this non-aqueous medium, it appears that ca. 35% of the oxide sites charge and discharge approximately an order of magnitude more rapidly than the remaining sites.