双传声器法测量斜入射吸声系数研究

本文从理论和实验两方面研究了双传声器法测量斜入射吸声系数时,双传声器间距,双传声器离材料表面距离,材料面积大小等因素对测量结果的影响。     

近场影响消除法测量声吸收系数

本文采用数值模拟方法理论研究了活塞式辐射器的辐射近场和采用“大”尺寸接收器接收对声场的平滑作用以及近场(及其过渡区域)对测量声吸收系数的影响.计算表明,在近场及其附近,用通常的方法测量声吸收系数将产生很大的误差.通过分析误差产生的原因,本文提出了近场影响消除法测量声吸收系数,并对a/λ=3、9,b=0、0.5a、a(a,b分别是辐射器和接收器半径)几种情况进行了数值模拟计算,结果表明,采用这种方法不仅能在近场区域进行测量,而且具有较高的测量精度。     

An impulse method of measuring normal impedance at oblique incidence

An experimental method of determining the oblique incidence behaviour of sound absorbing materials is given. The method involves the measurement of acoustic impulses at the surface of an absorbing material and comparing the complex frequency components with those of a reference signal recorded remote from the surface. Amplitude and phase characteristics of the reflected signal are thus obtained and hence the normal impedance of the material is found. Comparison between measurements made by the “surface” method and standing wave tube measurements shows good agreement for normal incidence. However, at very oblique angles of incidence the method is in obvious error, the accuracy being limited by a sphericity effect.     

The role of sample rotation and oblique ion incidence on quantum-dot formation by ion sputtering

Starting from a theory recently proposed by Kahng et al. that explains the formation of ordered dots by ion sputtering under normal ion incidence, it was demonstrated that extending this theory to ion sputtering under oblique ion incidence with simultaneous sample rotation offers the self-organized formation of dots by ion sputtering for a large variety of different ion/material combinations. While for sputtering under normal incidence the shape of the collision cascade must be anisotropic, where the lateral straggling exceeds the longitudinal straggling, this constraint is not necessary under oblique incidence. Received: 16 May 2001 / Accepted: 10 September 2001 / Published online: 17 October 2001     

Interference bleaching and absorption in magnetic films under oblique incidence of counterpropagating waves

The interference control of absorbance and transmittance of a thin magnetic layer using variations in (i) phase difference of counterpropagating coherent waves that are incident at a certain angle on opposite sides of the layer and (ii) external magnetic field is studied. It is demonstrated that the absorbance depends on the parameters of the layer. Almost total absorption and dissipation-free transmission of energy are possible for the absorbing layer.     

一种现场测量材料吸声特性的新方法

现有的材料吸声系数测量方法主要有混响室法和驻波管法,都属于实验室测量方法,不适合现场测量。使用普通扬声器的反射法可以对材料的吸声特性进行现场测量,但是对材料尺寸和测试环境有较高的要求。本文利用参量阵非线性自解调可听声的高指向性和在阵长距离内的平面波特性,结合传递函数法,测量材料的吸声系数,并与传统驻波管测量结果进行了对比。结果表明在普通房间条件下,不需要驻波管,混响室等实验环境,即可对小尺寸的材料进行吸声系数的现场快速测量,具有较大的实用性。     

I-scan thermal lens experiment in the pulse regime for measuring two-photon absorption coefficient

We present a new pump-probe mode-mismatched thermal lens method for pulse excitation aimed to the measurement of nonlinear absorption coefficient in optical materials. We develop a theoretical model based on the Fresnel diffraction approximation and their predictions are verified experimentally with samples of Rhodamine 6G and Rhodamine B in ethanol solution. The principal advantage of this technique is that it does not require any mechanical movement during measurement. Below we perform the new type of thermal lens experiment in the pulse regime for the measurement of nonlinear absorption coefficient in transparent samples and we demonstrate the validity of theoretical predictions using an alternative method to the classical thermal lens technique.     

A method of obtaining the oblique incident sound absorption coefficient through an on-the-spot measurement

A new method (tentatively called the ‘cancellation method’) of determining the sound absorption coefficient is presented. This method makes it possible to obtain the absorption coefficient of a wall material by means of an on-the-spot field measurement which has, until now, been considered very difficult. This paper shows that the reflection from a sample can be obtained by combining the outputs from two non-directional microphones through a phase inverter, and how, by comparing it with the direct sound, measured separately, the sound absorption coefficient can be estimated. Absorption coefficients of several kinds of samples obtained by this method are compared with those calculated theoretically for the locally reactive material.     

基于样片厚度精确估计的THz吸收系数谱算法

利用太赫兹时域光谱技术(THz-TDS)提取物质在太赫兹波段的吸收系数谱是太赫兹应用的一个重要方面。由于样品的吸收系数与其厚度存在着复杂的非线性关系,而厚度又不便于直接准确测量,往往造成吸收系数谱的失真。根据Duvillaret等用于LiNbO3的厚度估计方法,改进了谷氨酰胺(Gln)与组氨酸(His)在0.3～2.6THz(1THz=1012 Hz)波段的吸收系数谱的测定和计算。为了说明改进后的吸收系数谱的合理性,设计了一系列实验对比了同种氨基酸在不同浓度下吸收系数的线性符合程度。结果表明,改进后计算出的氨基酸吸收系数与浓度之间存在更好的线性关系,符合Lambert-Beer定律的描述,这为进一步的定量分析奠定了基础。     

基于声场重建的材料吸声系数测量方法

针对现有方法对材料吸声系数进行现场测量时存在低频测量误差大的问题,本文提出了一种利用扬声器线阵列对材料吸声系数进行现场测量的新方法。该方法使用基于能量比值约束的最小二乘法在待测材料表面进行平面波声场重建并结合双传声器传递函数法对材料的吸声系数进行测量。数值仿真表明在100～1600 Hz频率范围内,新方法在未加约束时能够对材料的吸声系数进行准确测量。在半消声室中利用新方法测量了三聚氰胺泡沫的吸声系数,分析了能量比值约束值对测量结果的影响,并和阻抗管以及其它两种现场测量方法的测量结果进行了对比。结果表明该方法能够对吸声材料在160～1600 Hz频段内的吸声系数进行准确测量,并且相较于现存的现场测量方法,新方法具有更低的测量频率下限。     

Effects of heat conduction and sample size on ultrasonic absorption measurements

The absorption coefficient of a material can be determined by measuring the heating which occurs as a result of ultrasonic irradiation. When narrow focused beams are used to heat a sample, or when the available volume of a material is restricted to small dimensions, then the effect of heat conduction to surrounding unheated regions becomes significant, complicating the relation between measured temperatures and acoustic parameters. In this paper new analytical expressions, which account for radial and axial heat flow in a medium, are derived for the case of Gaussian-shaped ultrasonic beam patterns in thin or semi-infinite absorbing materials. Solutions are given for temperature histories resulting from an ultrasonic impulse (pulse decay method) or a step input (rate of heating method). The use of these equations in absorption measurements is discussed, and experimental results are given. These expressions provide flexibility in choice of laboratory ultrasonic parameters, and the results are especially useful for many biomedical measurements where the volume of tissue available is restricted.     

The diffusion coefficient depends on absorption

The diffusion approximation is widely invoked to model the propagation of light in turbid media. When absorption is not weak in comparison with scattering, there is currently a controversy as to if, and how, the diffusion coefficient depends on absorption. Here it is shown that better agreement with random walk simulation is obtained if the photon-diffusion coefficient is taken as D=c/(3micro(s)(')+micro(a)) . One can reconcile this result with recent work advocating D=c/3micro(s)(') by noting that the diffusion equation must be correspondingly changed to a telegrapher's equation.     

有限液态介质样品声衰减的实验室测试新方法

本文介绍了一种在实验室条件下利用声脉冲测定有限容量液态介质样品声衰减系数的测试方法。该方法根据声纳方程原理导出了与测试系统参数和声场参数无关的计算式，从而避开了对测试系统参数和声场参数的测量，采用截取未被边界散射干扰的直达声脉冲的部分信号进行频谱分析，消除了在有限样品情况下必然存在的边界散射干扰，同时采用多次统计平均的做法抑制了噪声干扰。     

弯折波导杆的超声斜入射方法*

波导杆技术是一种有效的超声辅助检测方法,在提升高温关键承压设备安全运行方面具有重要作用。现有的波导换能器因直入式发射声波,常被用来在线监测壁厚的腐蚀进程,难以对指定方向的缺陷进行有效检测。为了解决这个难题,基于斯涅耳定理以及导波的频散特性提出了一种弯折结构的波导杆来实现超声斜入射。首先分析了弯折波导杆中水平剪切波的传播特性,探究了波导杆的厚度、弯折角度对杆中声波传播的影响规律;然后,进一步研究了弯折波导杆在半无限空间内的声束指向性;最后通过一对弯折波导杆在线检测结构内部缺陷的试验证明了波导超声斜入射的应用价值。研究结果为基于斜入射技术的波导超声在线监测提供了坚实的理论基础。     

太赫兹波斜入射到磁化等离子体的数值研究

针对“黑障”问题,借助于电磁波斜入射到磁化等离子体的传输模型,研究了太赫兹(THz)波在磁化、均匀等离子体中的传输特性,分析了太赫兹波在磁化等离子体中传播的反射、透射以及衰减。仿真结果表明,等离子体碰撞频率、电子密度、入射角度以及磁场强度,对衰减产生不同的影响。单纯的增加碰撞频率,衰减值呈现出先增大后减小的变化趋势;电子密度的增加,与衰减峰值的大小有关;外加磁场加入,衰减值降低。通过调节外加恒定磁场,可以有效地解决“黑障”问题。     

Experimental and theoretical determination of the continuum absorption coefficient for xenon

The continuous absorption coefficient of xenon has been measured in a shock-tube and new calculations have been performed which take into account the gap between 7p and 7s levels. This improves the agreement between experimental values and the ones predicted by the theory of Biberman and Norman.     

The parametric doppler effect upon oblique radiation incidence in quartz glass

Frequency and reflection angle of probe radiation from a refractive-index inhomogeneity induced by an intense pumping pulse in quartz glass and moving with a relativistic velocity are calculated. Conditions under which the normal component of the wave vector of the reflected wave is directed to the opposite or to the same direction as the same component for the incident wave are determined. Comparison with the case of radiation reflection from a relativistic mirror in vacuum is performed. Conditions of the appearance of the Vavilov-Cherenkov radiation from a relativistic refractive-index inhomogeneity induced in the medium by an intense laser pulse are discussed.