窄带高反射光纤布拉格反射滤波器

利用改进的非对称六层波导模型，分析了光纤布拉格反射滤波器的特性。讨论了波导结构参数－主要是高折射率层的厚度对器件特性的影响，指出了在制作过程中控制器件反射率的途径。     

Integrated optical Bragg filter with fast electrically controllable transfer function

We demonstrate an integrated optical Bragg filter based on lithium niobate, with a fast electrically controllable transfer function. The technique is based on phase-shift keying of the reflection Bragg grating in a waveguide. The transfer function can be tuned or favourably reconfigured by applying different combinations of electrical voltage to the electrode pairs on both sides of the waveguide. The demonstrated time of reconfiguration is less than 1 μs.     

Multiband processing of multimode light: combining 3D photonic lanterns with waveguide Bragg gratings

The first demonstration of narrowband spectral filtering of multimode light on a 3D integrated photonic chip using photonic lanterns and waveguide Bragg gratings is reported. The photonic lanterns with multi‐notch waveguide Bragg gratings were fabricated using the femtosecond direct‐write technique in boro‐aluminosilicate glass (Corning, Eagle 2000). Transmission dips of up to 5 dB were measured in both photonic lanterns and reference single‐mode waveguides with 10.4‐mm‐long gratings. The result demonstrates efficient and symmetrical performance of each of the gratings in the photonic lantern. Such devices will be beneficial to space‐division multiplexed communication systems as well as for units for astronomical instrumentation for suppression of the atmospheric telluric emission from OH lines.     

The theory of planar Bragg resonators

The reflecting properties of one-dimensional planar Bragg gratings are studied. A coupled resonator model for studying the diffraction of electromagnetic waves in an arbitrarily corrugated waveguide is suggested. It is based on exact relationships that follow from the two-dimensional boundary-value problem stated in terms of the Helmholtz equation. The specific relationships for the rectangular corrugation of the grating-forming plates are presented. The reflection coefficients of the Bragg gratings vs. corrugation length and incident radiation frequency are calculated. An analytical solution for the “narrow” corrugation is obtained.     

高折射率芯Bragg光纤的色散特性研究

应用超格子模型分析了高折射率芯Bragg光纤的色散特性，讨论了Bragg光纤的色散的比例性质以及光纤的芯径、包层周期、填充率与波导色散的关系，并利用这些关系举例实现了Bragg光纤在1.55μm附近的宽带色散平坦. 关键词： Bragg光纤 模式 色散 波导色散     

All-Fiber Spectroscope with Second-Order Fiber Bragg Grating for Rotational Raman Lidar

Owing to the second-order fiber Bragg grating possessing narrower reflectivity bandwidth than first-order, an all-fiber spectroscopic filter with several second-order fiber Bragg gratings and optical fiber couplers in the visible region is designed to extract interest rotational Raman spectra. Considering the inference fringe visibility of inscribing fiber Bragg grating and the fiber core index dispersion effect, numerical simulations are made by the improved mathematical model based on an exponential photorefractive dynamic, and its simulative results show better agreement with the experimental data. We propose an all-fiber spectroscopic configuration, which could balance lidar sensitivity against signal-to-noise ratio for optimizing remote sensing performance by fiber Bragg gratings serially. Simulative results show that the thumb principle for fabricating second-order fiber Bragg grating is the increasing gratings length, and that this all-fiber spectroscope can achieve >70 dB suppression to elastic scattering and efficiently extract the rotational Raman signal for profiling atmospheric temperature.     

Simulation of micro/nanometer-scale self-organized lightwave network (SOLNET) using the finite difference time domain method

A simulator for self-organized lightwave network (SOLNET) is developed. The simulator is based on the finite difference time domain method. SOLNET enables us to construct self-aligned coupling waveguides between misaligned micro/nanometer-scale optical devices by self-focusing, which arises from an increase in refractive index induced by write beams in photo-refractive materials. The SOLNET simulator reveals that an L-shaped nanometer-scale optical waveguide of SOLNET is grown from a 0.5-μm-wide optical waveguide when write beams are introduced from the optical waveguide into photo-refractive materials, where a wavelength filter is embedded. The SOLNET simulator also reproduces coupling path construction between a 2-μm-wide optical waveguide and a 0.5-μm-wide optical waveguide having a wavelength filter on the core edge. The optical waveguides are placed with misalignment of 0.5-μm offset. By introducing write beams from the 2-μm-wide optical waveguide, the incident write beams and reflected write beams from the wavelength filter merge into one optical waveguide in the photo-refractive materials, constructing a self-aligned coupling waveguide.     

Design and analysis of nano-deep corrugated waveguide grating-based dual-resonant filters in visible and infra-red regions

A theoretical analysis of nano-deep corrugated long-period waveguide gratings on a SU-8 polymer-based channel waveguide with NOA61 optical epoxy coated upper- and lower cladding is presented. The transmission spectra of the gratings show strong rejection bands both at visible (at wavelength region of 450?460 nm) and infra-red (at wavelength region of 1530?1540 nm) regions when a grating period of ?68 μm with optimized grating tooth height is considered. Phase-matching graphs are studied to find the relationship between resonance wavelength and grating period. These results show that the grating parameters significantly affect the characteristics of transmission spectra as well as the resonance wavelength of the grating. Long-period waveguide grating-based band pass filter made by use of same polymer materials are also designed and analyzed. These types of waveguide grating-based filters can widely be used for visible and infra-red wavelength sensing applications.     

Highly efficient tunable fiber Bragg grating filters using multilayer piezoelectric transducers

We realized a wavelength tunable optical filter based on a fiber Bragg grating using multilayer piezoelectric transducers (MLP). The Bragg wavelength of the filter can be easily tuned in proportion to an applied low DC voltage. The tuning range efficiency was as high as 0.2 nm/V. We realized a 10 nm Bragg wavelength shift by applying as low as 50 V to the MLP. The MLP was also used in a higher order dispersion equalizer which consists of a pair of nonlinearly chirped gratings. A zero dispersion wavelength shift of 7 nm was successfully realized for the equalizer.     

Fabricating a Dichroic Plasmonic Mirror in Fused Silica by Dual-Ion Implantation

We show that the metal nanoparticle chains supporting localized surface plasmon resonance can behave as transmission Bragg gratings on a dielectric waveguide. An analytical model is developed to interpret the experimental results.     

Integrated optical Bragg-grating-based chemical sensor on a curved input edge waveguide structure

A novel integrated optical chemical sensor based on a surface-relief Bragg grating in a waveguide with a curved input edge, and coated with a chemically sensitive polysiloxane cladding, is described. The curved edge provides a mechanism within the device fabrication that allows for alignment of the input beam to the grating to achieve Bragg scattering. As proof of principle, a low-parts-in-10(6) toluene-vapor sensor with a fast response time is demonstrated.     

Polarization-independent guided-mode resonance filter with cross-integrated waveguide resonators

A cavity-resonator-integrated guided-mode resonance filter (CRIGF) has been proposed and investigated in order to realize high-efficiency narrowband reflection with a small aperture. The CRIGF consists of a grating coupler integrated in a cavity resonator constructed by a pair of distributed Bragg reflectors on a thin-film waveguide. This time, orthogonally crossed integration of two CRIGFs was demonstrated in order to obtain polarization-independent reflection spectrum. An SiO₂-based device with 10?μm aperture was designed and fabricated for around 850?nm wavelength operation, and narrowband polarization-independent reflection was confirmed experimentally.     

Ge0.05Si0.95/Si异质结单模共面布拉格反射波导光栅的设计与分析

GeSi/Si异质结布拉格反射光栅是硅基光电集成领域一种重要的集成光学器件,分析GeSi/Si异质结的传光特性和布拉格条件,通过求解布拉格光栅方程,得出耦合系数和耦合效率。利用上述原理设计出入射角为66°,波导层的厚度为2μm,光栅长度为4252μm,槽深为0.05μm,光栅周期为0.456μm,滤波带宽为0.214nm,耦合效率为84.1%的1.3μm Ge_0.05Si_0.95/Si异质结单模共面布拉格反射光栅,并用数值模拟了入射光波电场和反射光波电场的分布。     

High channel-count comb filter based on multi-concatenated sampled chirped fiber Bragg gratings

A high channel-count comb filter based on multi-concatenated sampled chirped fiber Bragg gratings(MC-SCFBGs) is proposed and optimally designed by using several chirped gratings with different fundamental grating periods,instead of non-grating sections of SCFBGs.The numerical simulations of the reflection spectra show that the channel spacing and the channel bandwidth in MC-SCFBGs are smaller than those in multi-concatenated chirped fiber Bragg gratings(MC-CFBGs) and that the spectral bandwidth of MC-SCFBGs can be greatly broadened by increasing the cascade number of the grating sections in each sampling period.     

Control of light transmission in laser-written phase-shifted Bragg grating couplers

We demonstrate the fabrication by direct laser writing and the operation of a directional coupler containing Bragg gratings in each waveguide. We achieve high-precision control over the longitudinal shift between the gratings, which feature first-order Bragg resonance at telecommunication wavelengths. We observe fundamental differences between light transmission characteristics in couplers with unshifted and shifted gratings in agreement with theoretical predictions.     

Production of optical notch filters with fine parameter control using regenerated fiber Bragg gratings

A new method to create a controlled notch filter for attenuation of signals based on regenerated fiber Bragg gratings is experimentally demonstrated. A fine adjustment of the notch depth is achieved by controlling the time of regeneration phenomenon in strongly saturated Bragg gratings written in standard ITU G.652 single-mode fiber. This method can used to produce tailored notch filters for several photonic applications, such as optical RF filtering, subcarrier processing or radio over fiber systems.     

Subwavelength grating waveguide devices in siliconon-insulators for integrated microwave photonics

We provide an overview of our recent work on developing subwavelength grating(SWG) waveguide devices as an enabling technology for integrated microwave photonics. First, we describe wavelength-selective SWG waveguide filters, including ring resonators, Bragg gratings, and contradirectional couplers. Second, we discuss the development of an index variable optical true time delay line that exploits spatial diversity in an equal-length waveguide array. These SWG waveguide components are fundamental building blocks for realizing more complex structures for advanced microwave photonic signal processing.     

Femtosecond laser direct writing of multiwavelength Bragg grating waveguides in glass

Novel Bragg grating waveguide structures have been fabricated in bulk borosilicate glass through a type II photosensitivity mechanism driven by single femtosecond laser pulses. Low-loss single-mode waveguides and narrow-linewidth Bragg gratings were generated simultaneously by forming an array of refractive index voxels in a single laser scan. Laser pulse duration is shown to significantly affect the grating strength and waveguide loss. Bragg wavelengths, defined by the periodicity of laser-modified volumes, were fully controlled by the sample scan speed to provide resonances anywhere in the 1200-1620 nm telecommunication bands. Four linear Bragg filters with distinct resonant wavelengths are presented that define the first demonstration of laser writing of multiple-wavelength and cascaded Bragg grating waveguides in a single process step.     

Compact surface plasmon amplifier in nonlinear hybrid waveguide

Surface plasmon polariton(SPP), a sub-wavelength surface wave promising for photonic integration, always suffers from the large metallic loss that seriously restricts its practical application. Here, we propose a compact SPP amplifier based on a nonlinear hybrid waveguide(a combination of silver, LiNbO_3, and SiO_2), where a couple of Bragg gratings are introduced in the waveguide to construct a cavity. This special waveguide is demonstrated to support a highly localized SPP-like hybrid mode and a low loss waveguide-like hybrid mode. To provide a large nonlinear gain, a pumping wave input from the LiNbO_3 waveguide is designed to resonate inside the cavity and satisfy the cavity phase matching to fulfill the optical parametric amplification(OPA) of the SPP signal. Proper periods of gratings and the cavity length are chosen to satisfy the impedance matching condition to ensure the high input efficiency of the pump wave from the outside into the cavity. In theoretical calculations, this device demonstrates a high performance in a very compact scheme(~3.32 μm) and a much lower pumping power for OPA compared with single-pass pumping. To obtain a comprehensive insight into this cavity OPA, the influences of the pumping power, cavity length, and the initial phase are discussed in detail.     

Two-dimensional non-spatial filtering based on holographic Bragg gratings

The filter made up of two gratings performs as a two-dimensional non-spatial filtering. This paper reports that the volume Bragg gratings are fabricated by interfering two collimated coherent laser beams in photopolymer. Diffraction efficiency of a single grating is up to 78% in Bragg's condition, then a two-dimensional non-spatial filter, which consists of two volume Bragg gratings and a half-wave plate, enables the laser beam filtered in two dimensions with the diffraction efficiency of 54%. The Bragg's condition and effect of polarisation on performances of the two-dimension filter are also discussed.