Effects of geometric distortions and substituents on rates of intersystem crossing; diazomethane and pyrazoline

We report a qualititive perturbation-theoretic analysis of the effects of substituents on the spin-orbit coupling and on the density of states in diazomethane and pyrazoline systems. The importance of the form of the distortion which accompanies approach to the singlet-triplet crossing zone is also discussed with the aim of determining when reactions involving a spin multiplicity change can compete in rate with spin-conserving reactions.     

Spectroscopy of large molecules in inert gas clusters

Aromatic hydrocarbons provide nucleation centers for the formation of clusters of inert gases in high-flow supersonic beams. Large clusters of Ar, each containing a single tetracene (T) molecule, were prepared by supersonic expansion of the seeded gas at pressures p = 3000–13000 Torr and interrogated by laser-induced fluorescence spectroscopy Evidence is reported for homogeneous line broadening of large TAr_n clusters prepared at p? 8000 Torr.     

Die rotationsisomerie des bicyclopropyls.: II. Die gauche/trans-isomerisierungsenthalpie und-entropie von bicyclopropyl aus ir-intensitäts-messungen. Ein experimenteller test

The determination of the enthalpy ΔH and entropy ΔS of the isomerization bicyclopropy l(trans)? bicyclopropyl(gauche) in the liquid phase by the IR intensity method is described. It is assumed that the ratio of the integral absorption coefficients of the two reference bands at 1351 cm^?1 (gauche) and 1291 cm^?1 (trans), which both belong to the same type of vibration, is temperature independent. The two values ΔH = ?160 ± 40 cal Mol^?1 and ΔS = ?0.4 ± 0.5 cal (Mol · Grad)^?1 respectively. ΔS_U = ?1.8 ± 0.5 cal (Mol · Grad)^?1 thus determined agree well with the corresponding results obtained from NMR and electron diffraction measurements. However, from the pair of reference bands at 695 cm^?1 (gauche) and 1291 cm^?1 (trans), which do not belong to the same type of vibration, strongly differing values for ΔH and ΔSresult under the same assumption as above, which apparently is not applicable in this case.It is shown through these data that the “Fateley-Test” does not provide a suitable tool to decide whether the absorption coefficients of the reference bands are temperature independent or not. The reason for this insignificance is the relatively poor accuracy and reproducibility of measured IR band intensities obtainable up to now.The relative density of bicyclopropyl between ?60°C and + 50°C was determined.     

Vibrational spectroscopic investigations of snse8-n molecules

The fundamental vibrations of 13 cyclic S_nSe_8-n (n = 7—2) molecules have been calculated using a modified Urey—Bradley force field with 9–14 independent force constants whose values have been adapted from those of Se₈ and S₈. Calculated wavenumbers are compared to those obtained by Raman spectroscopy for sulfur—selenium phases prepared by recrystallizing quenched molten mixtures of the elements as previously described. Agreement between the observed spectra and calculated wavenumbers is closest by assuming the existence of selenium—selenium bonds and the absence of isolated selenium atoms in S_nSe_8-n molecules. It is assumed that sulfur—selenium phases are mixed crystals with the following components in varying concentrations: 1,2-S₆Se₂, 1,2,3-S₅Se₃, 1,2,3,4-S₄Se₄, 1,2,5,6-S₄Se₄, 1,2,3-S₃Se₅ and 1,2-S₂Se₆. The presence of S₈ and Se₈ in some of the phases is indicated by the Raman spectra.     

Theoretical studies of some nonbenzenoid hydrocarbons—IV : Pleiadiene and related compounds

Pleiadiene and other similar compounds have been studied by the semi-empirical SCFMO method of Pariser, Parr and Pople using the core resonance integral value developed by Lo and Whitehead, Dewar et al. and Yamaguchi et al. It has been found that π^*←π transitions predicted by the methods of Lo and Whiteheadand Dewar et al. suitable for the prediction of ground state properties are also in good agreement with experimental results where available and comparable to those predicted by the method of Yamaguchi et al. developed for the prediction of spectral transitions. The resonance stabilization of the molecules 3,4.5,7,8 and 9 have also been studied. It is found that ethylinic linkage across the naphthalene moity in pleiadiene increases the resonance energy of the final compound, in contrast to our previous observation, i.e. ethylinic linkage across the naphthalene moiety reduces the resonance energy of the final compound.     

An ab initio MO calculation of the electronic structure and geometry of protonated methanol

Protonated methanol, CH₃ OH₂⁺, has been studied using the LCAO—MO—SCF method with a 7, 3 and 9, 5, 1 Gaussian orbital basis set on the heavy atoms and 4s on hydrogen. It is found that the ground state is non-planar around oxygen, in contrast with previous calculations, with an inversion barrier of 3 kcal mol^?1. The changes in electron distribution in the reacting systemCH₃⁺ + H₂O → CF₃OH₂⁺is also examined.     

Resonance Raman scattering near a threshold for dissociation

The threshold behavior of Raman amplitudes for photon energies near dissociation of the intermediate potential surface of a diatomic molecule is determined. Structure in the Raman amplitudes is calculated and found to be due to resonance of the intermediate potential surface.     

Homoisopavinanes—a highly probable class of phenethylisoquinoline alkaloids

Homoisopavinanes have been prepared by acid-catalysed cyclisation of the appropriately substituted aminoacetaldehyde dimethylacetal derivatives. The characteristic mass spectral fragmentation patterns of these homoisopavinanes is described.     

Polyurethane foam of the polyether type as a solid polymeric extractant for cobalt and iron from thiocyanate media

By combining instrumental and radiochemical neutron activation analysis, up to 47 elements including major, minor, and trace elements, have been determined in lake sediment samples. Instrumental neutron activation involving both short and long irradiations is used to determine 40 elements including most of the environmentally important ones. A radiochemical separation procedure allows the determination of 7 noble metals. The accuracy and precision of the method are 5–10%.     

Resonance energy transfer between lasing dyes in micellar media

The photophysical behaviour of rhodamine 6G and coumarin 1 has been studied in a range of aqueous micellar media. Resonance energy transfer is demonstrated in dilute (10^?5 M) solutions and the location of the dye molecules in the micelle deduced from fluorescence lifetimes. A highly efficient, energy transfer dye laser is reported for dyes in micellar matrices.     

Infrared band intensities: a comparative study of the transition moment matrix elements for fundamentals and overtones: Part I. General

A complete survey of the various expressions reported by different authors for transition moment matrix elements for infrared transitions of diatomic molecules has been made. The different expressions for fundamentals and overtones are presented in uniform coordinates. Although the expressions look different when compared in their original forms it is found that with the uniform coordinates, several of them are similar in the first few terms. Expressions obtained from the consideration of Morse potential as well as those obtained from inclusion of anharmonic potential are discussed. From the various expressions presented in uniform coordinates general remarks about the effects of inclusion of mechanical and electrical anharmonicity on the intensities of the fundamental and first two overtones are made. Since the effects of inclusion of mechanical and electrical anharmonicity are opposite in sign for the first overtone, it is further discussed that an increase in the intensity of the fundamental band on hydrogen bonding and a slight weakening of the intensity of the first overtone or no change in its intensity can be explained on the basis of an increase in the first and second derivatives of dipole moments on hydrogen bonding. Some general remarks are made regarding the dipole expansions and intensity expressions for polyatomic molecules.     

Phonon spectroscopy of photochemical reactions in organic solids: Photodimerization of 2,6-dimethyl-p-benzoquinone

The Raman phonon spectroscopic study shows that the photodimerization of 2,6-dimethyl-p-benzoquinone. In the solid state is initially a homogeneous reaction but later becomes heterogeneous as the product accumulates. The Ion-temperature electronic absorption spectrum reveals that the reaction is phonon assisted by a polaron formed due to a strong electron- phonon coupling in the cxcited ¹nπ^* state.     

CNDO/2 calculations of rotational barriers in N.N-dimethylamino-azines: Lineshape study of the barrier in 3-dimethylamino-1,2,4-triazine

3-Dimethylamino-1,2,4-triazine has been prepared and the hindered rotation around the exocyclic C-N bond has been studied by a complete lineshape method. CNDO/2 calculations on dimethylamino derivatives of pyridine, pyrimidine, 1,2,4-triazine and 1,3,5-triazine have been performed, and it is found that the calculations satisfactorily reproduce the experimental data. The barrier heights are also discussed in terms of total and π-charge densities obtained from CNDO/2 calculations.     

Intermolecular coupling of the CO stretching vibrations in liquid acetone: an isotopic dilution study

The separation Δv between the isotropic and anisotropic component of the CO stretching Raman band was studied in mixtures of acetone-¹⁶O and acetone-¹⁸O. An explanation is proposed for the observed invariance of the aniso tropic frequency. The isotropic bandwidth and the concentration threshold for the appearance of Δv are discussed.     

Production of atomic oxygen following flash photolysis of ClONO2

The photodissociation of ClONO₂ using a broad-band ultraviolet photolysis source has been investigated using time-resolved atomic absorption spectroscopy in the vacuum ultraviolet. The predominant atomic photolysis product is O(³PJ), the quantum yield for Cl(²PJ) production being less than 4%.     

Effect of quadratic interactions on the resonance raman scattering of T × t2 jahn-teller systems

Raman excitation profiles and depolarization dispersion curves are calculated for T × t₂ Jahn-Teller systems that are subject to quadratic vibronic (Renner-Teller) coupling as well as frequency changes of the active vibrational mode.     

Medium effects on fluorescence quantum yields and lifetimes for coumarin laser dyes

Fluorescence quantum yields and lifetimes of coumarin dyes are sharply reduced in polar solvents if amine substituent groups are free to rotate. The polar solvent effect is interpreted in terms of relaxation of excited dye from an initial planar conformation to a twisted zwitterionic state.     

NMR determination of absolute site-specific natural isotope ratios of hydrogen in organic molecules. Analytical and mechanistic applications

It has been shown that the “internal” isotope distribution within a given molecular species at the natural abundance level is accessible by a new method, SNIF-NMR, which is based on deuterium NMR. Relative internal factors, R_i/j,have been defined which enable the isotope content of a given site, i, to be compared to that of another molecular site, j, taken as the reference. Several referencing methods intended to provide direct access to relative $\text{externals}$, T_i , and $\text{absolute}$, (D/H)_i , site-specific parameters, are now discussed from both the theoretical and the experimental points of view. In the $\text{intramolecular referencing method}$, which involves a time-consuming chemical transformation of the sample, the risk exists of more or leas systematic errors resulting from discriminating fractionation effects. However this technique offers, conversely, an interesting way of investigating kinetic isotope effects without the need for specific labelling. In spite of its lower spectral precision the $\text{external referencing method}$ has the advantage of being fast and less sensitive to systematic errois and may be used for direct rough routine determinations of the site-specific isotope contents. More precise results can be obtained, at the price of contaminating the sample, when an $\text{intermolecular reference}$ is added and signal heights are used, remembering however that the intensity parameters then have no strict physical meaning in terms of absolute isotope contents. The site-specific parameters, T_i and (D/H)_i thus accessible, provide new information on the mechanisms of the fractionation effects occurring in natural conditions and examples are considered.     

A new approach to the measurement of the momentum densities in solids using an electron microscope

A new approach to the direct determination of electron momentum distributions in solids, using a combination of electron microscopy and electron spectroscopy, is described. The technique is several orders of magnitude more sensitive than currently available ones. The results of measurements on amorphous carbon are presented and used to demonstrate the potential of this new technique.