Commensurate water monolayer at the RuO2(110)/water interface

We demonstrate the presence of two types of commensurate, registered water monolayers with different densities at the RuO2(110)/bulk-water (0.1 M NaOH solution) interface with off-specular, oxygen crystal truncation rods. At anodic potentials (close to oxygen evolution), the extraneous water layer and the surface hydroxide layer form a bilayer with O-H-O bond distances similar to that of ice X. At cathodic potentials, the water molecules converted from the bridging OH molecules form a low-density water layer.     

Sum-frequency generation at electrochemical interfaces: Cyanide vibrations on Pt(111) and Pt(110)

We use optical sum-frequency generation to investigate the stretching vibrations of cyanide (CN^–) molecules chemisorbed from aqueous electrolytes on single-crystalline Pt(111)- and Pt(110)-electrode surfaces. For clean and well-ordered Pt(111) electrodes, a single vibrational band between 2080 and 2150 cm^–1 with a nonlinear frequency dependence on the potential is observed and assigned to the CN stretching vibration of chemisorbed cyanide. A second band between 2145 and 2150 cm^–1 with very weak potential dependence appears on a surface which was subjected to oxidation-reduction cycles and is attributed to cyanide associated with a microscopically disordered surface. This assignment is supported by preliminary results for a Pt(110) single-crystal electrode. On a well-ordered (110) surface a single and potential-dependent cyanide vibration between 2070 and 2112 cm^–1 is observed. After oxidation of the cyanide and readsorption, this band is replaced by a higher frequency band at 2144 cm^–1 which is essentially not potential-dependent. Occasionally, additional vibrational bands at lower frequencies not reported in corresponding IR studies are observed on Pt(111).Paper presented at the 129th WE-Heraeus-Seminar on Surface Studies by Nonlinear Laser Spectroscopies, Kassel, Germany, May 30 to June 1, 1994     

Structure and dynamics at the Pt(100)-surface

Using first-principles total-energy calculations the lattice relaxation, surface energy, work function and surface phonons have been determined for the Pt(100)-surface. Calculation of forces allows for a very efficient determination of equilibrium geometries and interplanar force constants. Results will be presented and compared with available experimental information.     

Oxidation of Pt(110)

Using scanning tunneling microscopy and temperature programmed desorption we investigate the Pt(110) surface under strongly oxidizing conditions involving either high-pressure O2 or atomic oxygen exposure. At low temperatures, only disordered Pt oxide structures are observed. After annealing ordered surface oxide islands are observed to coexist with a highly stable reconstructed (12x2)-O chemisorption structure. From density functional theory calculations a model for the surface oxide phase is revealed. The phase is found to be metastable, and its presence is explained in terms of stabilizing defects in the chemisorption layer and reduced Pt mobility.     

Tunneling anisotropic magnetoresistance in multilayer-(Co/Pt)/AlO_(x)/Pt structures

We report observations of tunneling anisotropic magnetoresitance (TAMR) in vertical tunnel devices with a ferromagnetic multilayer-(Co/Pt) electrode and a nonmagnetic Pt counterelectrode separated by an AlOx barrier. In stacks with the ferromagnetic electrode terminated by a Co film the TAMR magnitude saturates at 0.15% beyond which it shows only weak dependence on the magnetic field strength, bias voltage, and temperature. For ferromagnetic electrodes terminated by two monolayers of Pt we observe order(s) of magnitude enhancement of the TAMR and a strong dependence on field, temperature and bias. The discussion of experiments is based on relativistic ab initio calculations of magnetization orientation dependent densities of states of Co and Co/Pt model systems.     

Surface self-diffusion on Pt(110): Directional dependence and influence of surface-energy anisotropy

The decay of periodic surface profiles by surface self-diffusion is simulated by numerically solving the phenomenological equations for this process. The crystalline nature of the surface is taken into account by introducing an anisotropic surface free energy,(). Depending on the degree of anisotropy of(), the decay kinetics and the shapes of the profiles are largely different. A comparison with measurements of profile decay on Pt(l10) single crystal surfaces shows that the anisotropy in() along the [1¯10] azimuth should be about 2–3%, while that along the [001] azimuth is expected near 8%. In the latter case large amplitude profiles exhibit (111) faceting and slow decay kinetics which are non-exponential. The rate of surface self-diffusion on Pt(110) is anisotropic with the [1¯10] direction being faster than the [001] direction.     

Structure and reactivity of surface oxides on Pt(110) during catalytic CO oxidation

We present the first structure determination by surface x-ray diffraction during the restructuring of a model catalyst under reaction conditions, i.e., at high pressure and high temperature, and correlate the restructuring with a change in catalytic activity. We have analyzed the Pt(110) surface during CO oxidation at pressures up to 0.5 bar and temperatures up to 625 K. Depending on the pressure ratio, we find three well-defined structures: namely, (i) the bulk-terminated Pt(110) surface, (ii) a thin, commensurate oxide, and (iii) a thin, incommensurate oxide. The commensurate oxide only appears under reaction conditions, i.e., when both and CO are present and at sufficiently high temperatures. Density functional theory calculations indicate that the commensurate oxide is stabilized by carbonate ions (CO3(2-)). Both oxides have a substantially higher catalytic activity than the bulk-terminated Pt surface.     

Formaldehyde decomposition and oxidation on Pt(110)

The decomposition reactions of formaldehyde on clean and oxygen dosed Pt(110) have been studied by LEED, XPS and TPRS. Formaldehyde is adsorbed in two states, a monolayer phase and a multilayer phase which were distinguishable by both TPRS and XPS. The saturated monolayer (corresponding to 8.06 × 10¹⁴ molecules cm⁻²) desorbed at 134 K and the multilayer phase (which could not be saturated) desorbed at 112 K. The only other reaction products observed at higher temperatures were CO and H₂ produced in desorption limited processes and these reached a maximum upon saturation of the formaldehyde monolayer. The desorption spectrum of hydrogen was found to be perturbed by the presence of CO as reported by Weinberg and coworkers. It is proposed that local lifting of the clean surface (1 × 2) reconstruction is responsible for this behaviour. Analysis of the TPRS and XPS peak areas demonstrated that on the clean surface approximately 50% of the adsorbed monolayer dissociated with the remainder desorbing intact. Reaction of formaldehyde with preadsorbed oxygen resulted in the formation of H₂O (hydroxyl recombination) and CO₂ (decomposition of formate) desorbing at 200 and 262 K, respectively. The CO and H₂ desorption peaks were both smaller relative to formaldehyde decomposition on the clean surface and in particular, H₂ desorbed in a reaction limited process associated with decomposition of the formate species. No evidence was found for methane or hydrocarbon evolution in the present study under any circumstances. The results of this investigation are discussed in the light of our earlier work on the decomposition of methanol on the same platinum surface.     

Low energy electron spectroscopy of Pt (100) and Pt (100)/CO

Fine structure in the n_vi, _VIIVV spectrum of clean Pt (100) has been observed, and interpreted as “band like” in origin rather than quasi-atomic. Differences in the dependence of the Auger yield on primary beam energy are observed between the N_VI, _VIIVV and O_IIIVV peaks, and are associated with anomalies in the dependence of the inner shell ionization crossection of the 4f level. Low energy electron loss spectra on the clean surface have been investigated at primary energies in the range 71–774 eV and at angles of incidence of the beam 0–60°. The results are related to high energy loss and optical data, and assignments are given for inter-band and plasmon losses. With approximately $\text{3}\text{4}$ of a monolayer of CO on the surface there is a prominent additional loss at around 13.5 eV, which is interpreted as a one electron transition from a σ state below the d band to available states several electron volts above the Fermi level.     

Ab-initio study of the coadsorption of Li and H on Pt(001), Pt(110) and Pt(111) surfaces

The coadsorption of Li and H atoms on Pt(001), Pt(110) and Pt(111) surfaces is studied using density functional theory with generalised gradient approximation. In all calculations Li, H and the two topmost layers of the metal were allowed to relax. At coverage of 0.25 mono-layer in a p(2×2) unit cell, lithium adsorption at the hollow site for the three surfaces is favoured over top and bridge sites. The most favoured adsorption sites for H atom on the Pt(001) and Pt(110) surfaces are the top and bridge sites, while on Pt(111) surface the fcc site appears to be slightly favoured over the hcp site. The coadsorption of Li and atomic hydrogen shows that the interaction between the two adsorbates is stabilising when they are far from each other. The analysis of Li, H and Pt local density of states shows that Li strongly interacts with the Pt surfaces.