IR spectra of methane adsorbed on MgO

Methane adsorbed on MgO is activated to form CH₃ fragments stabilized on cations and OH groups.

---

, MgO CH₃-, OH-.

     

Influence of substrate dynamics on CO-MgO(001) bonding--using molecular dynamics snapshots in quantum-chemical calculations

Combined molecular dynamics (MD) and quantum mechanics (QM) calculations have been performed for CO adsorbed on MgO(001) at 50 K. The changes in the adsorption energy caused by the surface dynamics have been analyzed, and a clear correlation was found between the dynamic variation of the adsorption energy and the electrostatic field above the adsorption site. By separating the electrostatic contributions arising from the local structure at the adsorption site from those originating from the rest of the slab, a linear expression of these contributions could be fitted which closely reproduces the dynamic changes in the adsorption energy. Using this simple linear expression, the distribution of adsorption energies for CO above the Mg(2+) sites on the MgO(001) surface at 50, 80, and 150 K have been predicted.     

Accurate adsorption energies for small molecules on oxide surfaces: CH4/MgO(001) and C2H6/MgO(001)

A hybrid method is applied that combines second order Møller–Plesset perturbation theory (MP2) for cluster models with density functional theory for periodic (slab) models to obtain structures and energies for methane and ethane molecules adsorbed on the MgO(001) surface. Single point calculations are performed to estimate the effect of increasing the cluster size on the MP2 energies and to evaluate the difference between coupled cluster (CCSD(T)) and MP2 energies. The final estimates of the adsorption energies are 12.9 ± 1.3 and 18.9 ± 1.8 kJ/mol for CH₄ and C₂H₆, respectively. © 2016 Wiley Periodicals, Inc.     

Vibrational frequencies and normal modes of Co adsorbed on Ni(001)

The vibrational modes of CO adsorbed on a Ni(001) metal surface have been obtained using two different cluster models to represent the on-top and bridge-bonding situations. New modes, not previously available in the literature, are obtained for the bridge cluster.     

Effects of adsorbed bismuth on Si(001) surface electronic states

It is shown that depositing Bi on an Si(001) surface fills the free broken-bond surface states, whose concentration decreases linearly as the bismuth coating 8 increases up to _st, = 0.6 monolayer. The bismuth desorption activation energy is constant < _st, (E_d = 2.77 ± 0.1 eV) and decreases for > _st.Taras Shevachenko Kiev National University, ul. Vladimirskaya 64, 252601 Kiev-17, Ukraine. Translated from Teoreticheskaya i Éksperimental'naya Khimiya, Vol. 32, No. 3, pp. 168–171, May–June, 1996. Original article submitted September 19, 1995.     

O2在具有氧和镁缺陷MgO(001)表面的吸附

在密度泛函理论的框架下，采用嵌入点电荷簇模型研究了O2在具有氧缺陷和镁缺陷MgO(001)表面上的吸附.用电荷自洽的方法确定了点电荷的值.计算结果表明，O2倾向吸附在具有氧缺陷的MgO(001)表面上.通过和我们近期研究过的O2在低配位的边、角上吸附结果相比较，发现具有氧缺陷的MgO(001)表面更加有利于O2的吸附和解离. Mülliken电荷分析表明，电荷由底物向吸附的O2反键轨道上转移是导致O2键强削弱的主要原因.势能曲线表明，O2在具有氧缺陷的MgO(001)表面上发生解离所需要克服的能垒比在角阳离子端发生解离所需克服的能垒有大幅度降低.     

Ab initio calculations for adsorbed state of OH group on Ni(110)

Ab initio quantum-chemical calculations of OH radical adsorption on Ni(110) have been carried out in cluster approximations. It is shown that unlike energy calculations of adsorbed complexes, their vibrational frequencies must be calculated with taking into account 3d orbitals of Ni.

---

OH Ni(110) . , , 3d-.

     

Variation of lattice dimensions in epitaxial SnS films on MgO(001)

Epitaxial and polycrystalline SnS films were prepared on MgO(001) and glass substrates using molecular beam epitaxy. The films were characterized by X-ray diffraction method. The orientations of epitaxial films were (010)[100]SnS||(001)[100]MgO or (010)[001]SnS||(001)[100]MgO. Lattice parameters of the polycrystalline film closely resembled those of bulk SnS at room temperature. However, the lattice parameters of epitaxial films varied widely and were very different from those of bulk SnS at room temperature. Considering the lattice dimensions and a/c ratio, the films roughly correspond to bulk SnS at elevated temperatures from 371 to 666 K. SEM images of the films showed needle- or circular-like SnS crystallites segregated from the epitaxial films. Respective energies of indirect band gaps of the films and refractive index of the polycrystalline film were estimated using results of optical transmission experiments.     

NO在MgO(001)缺陷表面吸附解离的量子化学研究

在密度泛函理论框架下,采用嵌入点电荷簇模型研究了NO在MgO(001)完整和缺陷表面上的吸附。研究结果表明:具有氧缺陷结构表面的催化活性较高,有利于NO键的削弱;当另一个NO分子进攻已吸附的NO分子时,NO键将进一步削弱,直致断裂,并伴有N2O产生,这与UPS和MIES实验观察到的现象一致。Mulliken布居分析指出,底物电子向NO转移,并填充到NO的*反键轨道上,从而导致NO键的削弱,并形成NO-。这也是可能导致形成NO-的原因。研究还表明,具有镁缺陷的MgO(001)表面对NO的解离没有催化活性。     

Evidence for the conformation of H2O adsorbed on Ru(001)

The electron stimulated desorption ion angular distributions (ESDIAD) method has been used to study the adsorption of H₂O by Ru(001). The results indicate that chemisorbed, undissociated H₂O is bonded to Ru via the oxygen atom, and that interactions between neighboring molecules occur as coverage increases. The utility of ESDIAD for structure determination in the absence of long range order is demonstrated.     

Dissociative chemisorption and energy transfer for methane on Ir(111)

A 3-parameter local hot spot model of gas-surface reactivity is employed to analyze and predict dissociative sticking coefficients for CH(4) incident on Ir(111) under varied nonequilibrium and equilibrium conditions. One Ir surface oscillator and the molecular vibrations, rotations, and translational energy directed along the surface normal are treated as active degrees of freedom in the 14 dimensional microcanonical kinetics. The threshold energy for CH(4) dissociative chemisorption on Ir(111) derived from modeling molecular beam experiments is E(0) = 39 kJ/mol. Over more than 4 orders of magnitude of variation in sticking, the average relative discrepancy between the beam and theoretically derived sticking coefficients is 88%. The experimentally observed enhancement in dissociative sticking as beam translational energies decrease below approximately 10 kJ/mol is consistent with a parallel dynamical trapping/energy transfer channel that likely fails to completely thermalize the molecules to the surface temperature. This trapping-mediated sticking, indicative of specific energy transfer pathways from the surface under nonequilibrium conditions, should be a minor contributor to the overall dissociative sticking at thermal equilibrium. Surprisingly, the CH(4) dissociative sticking coefficient predicted for Ir(111) surfaces at thermal equilibrium, based on the molecular beam experiments, is roughly 4 orders of magnitude higher than recent measurements on supported nanoscale Ir catalysts at 1 bar pressure, which suggests that substantial improvements in catalyst turnover rates may be possible.     

Thermodynamic and structural properties of water adsorbed film on MgO (100) ionic surface

We have investigated by adsorption isotherms and neutron diffraction measurements, respectively the thermodynamic and structural properties of water physisorbed film on MgO (100) powder. Thanks to a high temperature thermal treatment, under vacuum, our MgO powder samples are characterized by a highly homogeneous (100) MgO surface. We have determined the structure of the (2D) water film physisorbed on such an ionic surface. This one is a commensurate P(2×3) structure which is very similar to the (110) planes of ice-VII. Recall that ice VII, which is stable at very high pressure, is characterized by a quite large density (d = 1.6).     

DFT Study of Alkali Metal Atom Adsorption on Defect-Free MgO(001) Surface

The adsorption of isolated alkali metal atoms (Li, Na, K, Rb, and Cs) on defect-free sur-face of MgO(001) has been systemically investigated with density functional theory using a pseudopotential plane-wave approach. The adsorption energy calculated is about -0.72 eV for the lithium on top of the surface O site and about one third of this value for the other alkali metals. The relatively strong interaction of Li with the surface O can be explained by a more covalent bonding involved, evidenced by results of both the projected density of states and the charge density difference. The bonding mechanism is discussed in detail for all alkali metals.     

Theoretical study of Sn adsorbed on the MgO(100) surface with defects

In this study, the adsorption of Sn atom at various sites on the MgO(100) surface was characterized using a theoretical approach based on density functional theory calculations. Both regular adsorption centers (O^2? and Mg²⁺) and defects (such as neutral and charged O and Mg vacancies) were considered. Several key parameters for these sites with the adsorbed Sn atom were determined to provide its geometric, energetic, and electronic characterization. The interaction between Sn and the Mg vacancy sites is very strong and is associated with a relatively small distance of the adsorbed Sn atom from the surface and with a large electronic charge transfer from Sn to the surface. A much smaller strength of Sn atom adsorption is observed for the O vacancies and regular sites. Among them, the ${{\text{F}}_{\text{s}}}^{\text{0}}$ center binds the Sn atom strongest and, in consequence, this atom acquires a significant amount of electronic charge.     

Theoretical study of MgO(001) surfaces: Pure,doped with Fe,Ca, and Al,and with and without adsorbed water

Ab initio calculations of large cluster models have been performed in order to study water adsorption at the five‐fold coordinated adsorption site on pure Mg(001) and MgO(001) surfaces doped with Fe, Ca, and Al. The geometric parameters of the adsorbed water molecule have been optimized preparatory to analysis of binding energies, charge transfer, preferential sites of interaction, and bonding distances. We have used Mulliken population analysis methods in order to analyze charge distributions and the direction of charge transfer. We have also investigated energy gaps, HOMO energies, and SCF orbital energies as well as the acid‐base properties of our cluster model. Numerical results are compared, where possible, with experiment and interpreted in the framework of various analytical models. © 2001 John Wiley & Sons, Inc. Int J Quant Chem, 2001     

Phenanthrenequinone adsorbed on Si(001): geometries, electronic properties, and optical response

As a prototypical case of a pi-conjugated organic overlayer on a semiconductor surface the adsorption of phenanthrenequinone (C14O2H8) on the Si(001) surface is studied by means of first principles calculations, using gradient-corrected density functional theory together with ultrasoft pseudopotentials and the projector augmented wave method. A thermodynamic phase diagram gives adsorption geometries depending on experimental conditions, the microscopically most favorable bonding configuration representing a "[4+2]-cycloaddition product". The surface electronic structure depends strongly on the respective adsorption configuration. Calculations of the surface optical signature show its sensitivity to molecular adsorption and are in agreement with experimental results. A detailed analysis illustrates that the bonding to the surface has to be taken into account accurately to unveil the molecule's contribution to the surface optical response.     

MgO缺陷和不规则表面吸附Cl2的电子结构研究

采用从头算程序对MgO表面 3种不同配位位置吸附Cl2 的构型进行优化 ,并用扩展休克尔紧束缚 (EHT)晶体轨道方法对MgO的缺陷和不规则表面吸附Cl2的可能构型进行能带计算 ,讨论了吸附前后能带组成和成键性质的变化。研究表明 :MgO表面吸附Cl2 将更趋向于吸附在O原子上而非Mg原子上 ,而且在 3种配位中MgO表面三配位氧最有利于吸附Cl2 ;吸附时 ,电子从O原子转移到Cl2 分子的反键轨道 ,但是各种吸附构型的MgO表面对Cl2 的吸附作用均比较微弱 ,是典型的物理吸附。