Effect of low-temperature high-pressure sintering on BiFeO3 density,electrical magnetic and structural properties

Single-phase multiferroic BiFeO₃ (BFO) powders were prepared by hydrothermal microwave synthesis and dense BiFeO₃ ceramics were fabricated for the first time by the low-temperature high-pressure (LTHP) sintering technique. Effect of sintering temperature ranging from 400 to 800 °C (3 min and 10 min) and pressure of 3–8 GPa on structural, microstructural, electric and magnetic properties were investigated through X-ray diffraction, scanning electron microscope (SEM), electrochemical impedance spectroscopy (EIS), density and magnetic measurements. The results highlighted that LTHP sintering method, thanks to the high pressure involved, requires lower temperature and shorter time than other techniques, avoiding BiFeO₃ phase degradation. SEM images show that for short experimental time (t = 3 min) the average grain size of the sintered samples was approximately the same size of raw powder. Extending the sintering time up to 10 min the grain growth phenomena occurred. Moreover the results indicate that the best obtained density value was around 98% of theoretical density. The dielectric behavior of BiFeO₃ ceramics was not significantly influenced by the LTHP sintering conditions. Magnetic measurements showed that ceramic BiFeO₃ is weakly ferromagnetic at room temperature.     

Experimental study of electrical properties at the Nd-doped Si-SiO2 interface

This paper presents the results of an experimental study designed to explore the electrical properties at the Nd-doped Si-SiO₂ interface. The Nd-doped silicon wafers and control silicon wafers (undoped) were annealed under different conditions of temperature, time and atmosphere. The electrical properties were measured using MOS test structures. The Nd-doped silicon wafers were analysed by electron spectroscopy (AES and ESCA). These results were compared with the Pd-, Rh-, La- and Gd-doped interfaces and briefly discussed in terms of the relevant action mechanisms of the negative electric effects.     

Preparation of Nd-doped BiFeO3 films and their electrical properties

The Nd-doped BiFeO₃ thin films were prepared on SnO₂(FTO) substrates spin-coated by the sol–gel method using Nd(NO₃)₃·6H₂O, Fe(NO₃)₃·9H₂O and Bi(NO₃)₃·5H₂O as raw materials. The microstructure and electric properties of the BiFeO₃ thin films were characterized and tested. The results indicate that the diffraction peak of the Nd-doped BiFeO₃ films is shifted towards right as the doping amounts are increased. The structure is transformed from the rhombohedral to pseudotetragonal phase. The crystal grain is changed from an elliptical to irregular polyhedron. Structure transition occurring in the Bi_0.85Nd_0.15FeO₃ films gives rise to the largest Pr of 64 μC/cm². The leakage conductance of the Nd doped thin films is reduced. The dielectric constant and dielectric loss of Bi_0.85Nd_0.15FeO₃ thin film at 10 kHz are 190 and 0.017 respectively.     

Nanostructural,magnetic and electrical properties of Ag doped Mn-ferrite nanoparticles

Nano-crystalline MnFe_2−xAg_xO₄ (x = 0, 0.1, 0.2, 0.3 and 0.6) samples with average grain size of 4–7 nm were synthesized by a simple method based on decomposition of metal nitrates in presence of citric acid. The samples were characterized by different structural, magnetic and electrical measurements. Rietveld refinement of X-ray diffraction data confirmed cubic spinel structure of the samples. Results show that Ag doping decreases the crystallite size, magnetization and coercivity of nanoparticles. By increasing the Ag content in the samples the saturation magnetization shows interesting temperature dependent behavior. It was realized that magnetization of smaller particles show higher sensitivity to temperature variations than larger particles. DC electrical resistivity measurements in the temperature range of 300–650 K show that the resistivity first increases and then decreases by increasing the Ag content in the samples. Curie temperature (T_c) and polaron activation energy in ferromagnetic and paramagnetic regions were estimated by using resistivity curves.     

Thickness dependent magnetic and ferroelectric properties of LaNiO3 buffered BiFeO3 thin films

BiFeO₃ (BFO) thin films with thickness increasing from 40 to 480 nm were successfully grown on LaNiO₃ (LNO) buffered Pt/Ti/SiO₂/Si(100) substrate and the effects of thickness evolution on magnetic and ferroelectric properties are investigated. The LNO buffer layer promotes the growth and crystallization of BFO thin films. Highly (100) orientation is induced for all BFO films regardless of the film thickness together with the dense microstructure. All BFO films exhibited weak ferromagnetic response at room temperature and saturation magnetization is found to decrease with increase in film thickness. Well saturated ferroelectric hysteresis loops were obtained for thicker films; however, the leakage current dominated the ferroelectric properties in thinner films. The leakage current density decreased by three orders of magnitude for 335 nm film compared to 40 nm film, giving rise to enhanced ferroelectric properties for thicker films. The mechanisms for the evolution of ferromagnetic and ferroelectric characteristics are discussed.     

Preparation and properties of semiconductor CuO nanoparticles via a simple precipitation method at different reaction temperatures

Preparation and properties of CuO nanoparticles as an important p-type semiconductor via a simple precipitation method at different reaction temperatures varying from 10 to 115°C using copper acetate as a starting material have been reported. In addition, we investigated the influence of the ultrasonic irradiation through synthesizing the nanosized CuO at 60°C. Samples were characterized by XRD, FT-IR, SEM, TEM and UV-Vis techniques. XRD patterns of samples were identical to the single-phase pure CuO with a monoclinic structure. FT-IR spectra exhibited sharp peaks at around 519 and 598?cm^?1 which can be assigned to vibrations of the Cu-O bond. Results indicated that properties of samples had great dependence on the temperature and ultrasonic irradiation. The crystallite size and crystallization increased with increasing the temperature from 10 to 115°C. The band gap of samples was estimated to be in the range of 1.9–2.9?eV that is larger than the reported value for the bulk CuO (1.85?eV). This study provides a simple method for the preparation of nanosized CuO with a better surface uniformity and a narrow size distribution. Synthesized CuO samples with adjustable and controllable optical properties make the applicability of copper oxide even more versatile.     

Effect of Ca substitution on structural,magnetic and dielectric properties of BiFeO3

Bi_1-xCa_xFeO₃ (x = 0.40, 0.50) compounds are synthesized by conventional solid-state reaction method. The effect of Ca²⁺ substitution is investigated on structural, dielectric and magnetic properties. Rietveld refinement confirms that crystal structures of both the samples are tetragonal with P4mm symmetry. The highest values of remnant magnetization (M_r ) and coercive field (H_c ) are 0.002 emu/g and 0.23 kOe, respectively, for x = 0.50. The electric modulus formalism is used to distinguish and separate out the relaxation process which is dominated by the transport phenomenon. The relaxation process has activation energy ～0.32 eV which is found to be related to both the hopping mechanisms, i.e. electronic and oxide ions.     

Effects of(La,Sr) co-doping on electrical conduction and magnetic properties of BiFeO_3 nanoparticles

Multiferroic material as a photovoltaic material has gained considerable attention in recent years.Nanoparticles(NPs)La_(0.1)Bi_(0.9-x)Sr_xFeO_y(LBSF,x = 0,0.2,0.4) with dopant Sr~(2+)ions were synthesized by the sol–gel method.A systematic change in the crystal structure from rhombohedral to tetragonal upon increasing Sr doping was observed.There is an obvious change in the particle size from 180 nm to 50 nm with increasing Sr substitution into LBFO.It was found that Sr doping effectively narrows the band gap from～2.08 e V to～1.94 e V,while it leads to an apparent enhancement in the electrical conductivity of LBSF NPs,making a transition from insulator to semiconductor.This suggests an effective way to modulate the conductivity of BiFeO_(3-)based multiferroic materials with pure phase by co-doping with La and Sr at the A sites of BiFeO_3.     

Finite-temperature properties of multiferroic BiFeO3

An effective Hamiltonian scheme is developed to study finite-temperature properties of multiferroic BiFeO3. This approach reproduces very well (i) the symmetry of the ground state, (ii) the Néel and Curie temperatures, and (iii) the intrinsic magnetoelectric coefficients (that are very weak). This scheme also predicts (a) an overlooked phase above Tc approximately 1100 K that is associated with antiferrodistortive motions, as consistent with our additional x-ray diffractions, (b) improperlike dielectric features above Tc, and (c) that the ferroelectric transition is of first order with no group-subgroup relation between the paraelectric and polar phases.     

Hg_(1-x)Cd_xTe材料变温特性的实验研究

对碲镉汞(Hg1-xCdxTe)材料的电学特性进行了变温实验研究.通过变温(80~300 K)霍尔效应测量,研究了Hg1-xCdxTe材料的霍尔系数RH、电导率σ和霍尔迁移率μH的温度依赖关系.结果表明,Hg1-xCdxTe晶体在低温下为p型导电,而在室温下为n型导电.     

Structure,magnetic and microwave properties of FeNi invar nanoparticles obtained by electrical explosion of wire in different preparation conditions

Magnetic nanoparticles (MNPs) of close to invar (Fe_0.635Ni_0.365) composition were prepared by the electrical explosion of wire using different conditions to insure different values of overheating rates. X-ray diffraction, transmission electron microscopy, low temperature nitrogen adsorption, magnetic and microwave measurements were used for the characterization of MNPs. Increase of the energy injected into the wire led to increase of the specific surface (S_sp) of the produced MNPs from 4.6 to 13.5 m²/g. The fabricated MNPs were spherical and weakly aggregated with the average weighted diameter in the range of 54–160 nm depending on the S_sp. The phase composition of FeNi MNPs consists of two solid solutions of Ni in α-phase and γ-phase lattices. The increase of the energy injected into the wire leads to increase of the α-phase from 5 to 10 wt% as the injected energy raised from 0.8 to 2.5 times the sublimation energies of the wire material. Comparative analysis of structure magnetic and microwave properties showed that the obtained MNPs are important magnetic materials with high saturation magnetization and significant zero field microwave absorption which can be expected to lead to important technological applications.     

Thermal diffusion and heat conductivity of BiFeO3 and Bi0.95La0.05FeO3 multiferroics at high temperatures

The thermal diffusion and heat conductivity of BiFeO₃ and Bi_0.95La_0.05FeO₃ multiferroics at high temperatures (300–1200 K) have been examined. The dominant mechanisms of phonon heat transfer in the region of ferroelectric and antiferromagnetic phase transitions have been revealed. The temperature dependence of the mean free path of phonons has been determined.     

Effect of nitriding time on secondary recrystallization behaviors and magnetic properties of grain-oriented electrical steel

The effect on secondary recrystallization behaviors and magnetic properties of grain-oriented electrical steel of nitriding time from 0 to 240 s in the acquired-inhibitor method has been studied. It was found that the volume fraction of nitride precipitates increased with increasing nitriding time. However, the average diameter of the nitride precipitates decreased with increasing nitriding time. Two kinds of nitride precipitates were found to have formed after primary recrystallization annealing. A fine rod-shaped precipitate was found to be Si₃N₄ and and a coarse, lozenge-shaped precipitate was MnSiN₂. Moreover, primary grain size decreased with increasing nitriding time due to retarding of the grain growth by precipitates. After secondary recrystallization annealing, the specimen that was nitrided for 30 s obtained the largest volume fraction of abnormal growth grains and largest area percentage of Goss grains. Conversely, specimens that were nitrided more or less than 30 s demonstrated poor secondary recrystallization and obtained low area percentage of Goss grains. Furthermore, the optimum nitriding time to obtain the best magnetic properties was 30 s. In addition, the optimum nitrogen content was 150 ppm.     

Unusual electrical properties of hydrothermally grown ZnO

Bulk ZnO of high structural and optical quality can be grown by the hydrothermal method. An X-ray rocking-curve linewidth of 18 arcsec has been measured for the (002) reflection, and a photoluminescence linewidth of 0.3 meV has been found for one of the donor–bound exciton lines. However, the electrical properties are unusual in that shallow donors are not dominant, as is the case for vapor-phase-grown and melt-grown bulk crystals. This situation can be greatly modified by annealing in forming gas (5% H₂ in N₂) at , with bulk shallow donors then becoming completely dominant for , and near-surface donors at lower temperatures. As T_A is varied from 100–650 C, both the mobility and carrier concentration vary in nonmonotonic fashion, due to changes in the relative strengths of the bulk and surface components of conduction.     

Multiferroic properties of Tb-doped BiFeO3 nanowires

The aim of this study was to investigate the protective role of quercetin and/or l-arginine against the cardiotoxic potency of zinc oxide nanoparticle (ZnO-NP)-induced cardiac infarction. ZnO-NPs (50 nm) were administered orally at either 600 mg or 1 g/kg body weight for 5 consecutive days. The results revealed that co-administration of quercetin and/or l-arginine (each 200 mg/kg body weight) daily for 3 weeks to rats intoxicated by either of the two doses markedly ameliorated increases in serum markers of cardiac infarction, including troponin T, creatine kinase-MB, and myoglobin, as well as increases in proinflammatory biomarkers, including tumor necrosis factor-α, interleukin-6, and C-reactive protein, compared with intoxicated, untreated rats. Each agent alone or in combination also successfully modulated the alterations in serum vascular endothelial growth factor, cardiac calcium concentration, and oxidative DNA damage as well as the increase in the apoptosis marker caspase 3 of cardiac tissue in response to ZnO-NP toxicity. In conclusion, early treatment with quercetin and l-arginine may protect cardiac tissue from infarction induced by the toxic effects of ZnO-NPs.