Growth and characterization of pendeo-epitaxial GaN on 4H–SiC substrates

Growth on AlN/4H–SiC substrates of coalesced, non-polar GaN films having volumes of material with reduced densities of dislocations and stacking faults has been achieved from etched stripes via the statistical and experimental determination of the effect of temperature and V/III ratio on the lateral and vertical growth rates of the GaN{0 0 0 1} faces combined with pendeo-epitaxy. AFM of the uncoalesced GaN(0 0 0 1) and GaN vertical faces revealed growth steps with some steps terminating at dislocations on the former and a pitted surface without growth steps, indicative of decomposition, on the latter. Coalescence was achieved via (a) a two-step route and the parameters of (1) and V/III=1323 for 40 min and (2) 1020 °C and V/III=660 for 40 min and (b) a one-step route that employed and a V/III ratio=660 for 6 h. The densities of dislocations in the GaN grown vertically over and laterally from the stripes were 4×10¹⁰ cm⁻² and 2×10⁸ cm⁻², respectively; the densities of stacking fault in these volumes were 1×10⁶ cm⁻¹ and 2×10⁴ cm⁻¹, respectively. The defects in the wing material were observed primarily at the bottom of the film where lateral growth of the GaN occurred from the AlN and the SiC. Plan view AFM also revealed different microstructures and a reduction in the RMS roughness values from 1.2 to 0.95 nm in these respective regions.     

Growth and characterization of nonlinear optical single crystals of l-arginine diiodate

Growth of good optical quality single crystals of l-arginine diiodate (abbreviated as LADI), a semiorganic nonlinear optical (NLO) material is reported. Crystals of dimension up to were obtained from its aqueous solution by slow solvent evaporation technique. The crystals were characterized by single crystal XRD, FTIR, optical absorption spectrum, microhardness, dielectric and photoconductivity studies. The DTA and TGA traces of LADI confirm the decomposition of the sample at 145 °C.     

Effect of heat-treatment condition on crystallization behavior and thermal expansion coefficient of Li2O-ZnO-Al2O3-SiO2-P2O5 glass-ceramics

Utilizing P₂O₅ as nucleation agent, a Li₂O-ZnO-Al₂O₃-SiO₂ glass was prepared by conventional melt quenching technique and subsequently converted to glass-ceramics with different crystal phases. During the processing, two-step heat-treatments including nucleation and crystallization were adopted. The effects of heat-treatment on the crystal type, the microstructure and the thermal expansion behavior of the glass-ceramics were studied by means of differential scanning calorimetry, X-ray powder diffraction analysis, scanning electron microscopy and thermal expansion coefficient tests. It was shown that the crystallization of occurred after the glass was treated at 580 °C. As the temperature increased from 580 °C to 630 °C, cristobalite and were identified as main and second crystal phases, respectively, in the glass-ceramic. An increase in the temperature to 700 °C, the β-quartz solid solution in the glass-ceramic accompanied by a decrease in cristobalite content. The transformation from to γ₀-Li₂ZnSiO₄ took place from 700 °C to 750 °C. The resulting crystallization phases in the glass-ceramics obtained at the temperature higher than 750 °C were β-quartz solid solution and γ₀-Li₂ZnSiO₄. The glass-ceramics containing or β-quartz solid solution crystal phase possessed a microstructure formed by the development of dendritic crystals. The thermal expansion coefficient of the glass-ceramics varied from 36.7 to 123.8 × 10⁻⁷ °C⁻¹ in the temperature range of 20-400 °C, this precise value is dependent on the type and the proportion of the crystalline phases presented.     

Growth of single crystals of the new double perovskite Ba2HoRu1−xCuxO6 from high temperature solutions

Single crystals of Ba₂HoRu_1−xCu_xO₆ have been grown from high temperature solutions using PbO–PbF₂ as solvent in the temperature range 1150–1250 °C. Crystals with a six sided plate like morphology measuring up to 3 mm across and 0.5 mm thick and polyhedral habit measuring up to 2 and 1 mm in thick mass were obtained. Powder X-ray diffraction patterns obtained on the crystals were indexed to give a monoclinic space group P2₁/n with lattice parameters a=5.875(2), b=5.874(3), c=8.960(1) and β=89.995(2)°. The crystals with x=0 show a single anomaly at 6.5 K corresponding to an antiferromagnetic phase with . The crystals containing Cu show additional anomalies at 18 and 48 K. The SEM and EDS analysis reveals a 2116 phase.     

Densities of Li2O–B2O3 melts

The densities have been systematically measured in xLi₂O–(1−x)B₂O₃ melts of different compositions with Li₂O content varying from x=0 to 0.68 from their respective melting points up to about 1450 K with a modified Archimedean method. The density decreased with increasing temperature for all the melts measured in this work. When x<0.15, the plot of temperature versus density could be well fitted by a quadratic polynomial function, and when x0.15, density decreased linearly with increasing temperature. At a fixed temperature, the density of the melts increased rapidly with Li₂O content, went through a maximum at about x=0.333 (Li₂O–2B₂O₃), and then decreased slowly as Li₂O content was further increased. In addition, the volume expansion coefficient (β) was calculated based on the densities measured in this work, and it was found that a maximum value appeared in the dependence of β on the molar ratio of Li₂O at about x=0.333.     

Crystal growth, characterization and spectroscopic study of europium-doped NaY(PO3)4

Europium-doped NaY(PO₃)₄ single crystals have been synthesized by the flux method with sizes around 1 mm³. The unit cell parameters at room temperature refined by X-ray powder diffraction are a=7.1510(4) Å; b=13.0070(8) Å; c=9.6973(2) Å; β=90.606(3)°, Z=4 with the space group P2₁/n in monoclinic system. The present single crystals have a needle shape, they are elongated along the a crystallographic direction, and their size is in the 500 μm–1 mm range. The linear thermal expansion tensor parameters were determined, being the maximum value along the b direction, 16.1×10⁻⁶ K⁻¹ and the minimum along the a direction being 11.7×10⁻⁶ K⁻¹. The IR vibration modes attributed to the group P–O are consistent with the crystallographic data concerning the chain aspect of the phosphate anion. This material melts incongruently at 1141 K. Intense visible emissions attributed to Eu^{3+ 5}D₀→⁷F₁, ⁵D₀→⁷F₂ and ⁵D₀→⁷F₄, electronic transitions have been observed after pumping at 355 nm at room temperature.     

Glass transition and fragility of Na2O-TeO2 glasses

The heat capacity (C_p) change in the glass transition region for the xNa₂O ·(100−x)TeO₂, mol%, glass forming melts with x=7.5, 11.1, 15.0, 20.0 and 25.0 was measured as a function of heating rate (2, 4, 6, 10 and 15 °C/min) using differential scanning calorimetry. The glass transition properties that have been measured and reported in this paper include the glass transition temperature (T_g), glass transition width (ΔT_g), heat capacities in the glassy and liquid state (C_pg and C_pl) and the activation enthalpy for glass transition (). T_g for these sodium tellurite melts decreased and increased with increasing Na₂O. Values of the ratio C_pl/C_pg ranged between 1.28 and 2.47, and the fragility parameter ranged between 100 and 130, suggesting that these glass forming melts may be classified as intermediate between typical strong and fragile liquids. The viscosity, η, calculated at a few selected temperatures near the glass transition region decreased with increasing Na₂O at any given temperature, which is also expected.     

Structural investigation of sodium borate glasses and melts by Raman spectroscopy. II. Conversion between BO4 and BO2O units at high temperature

Raman scattering spectra were recorded for pure boron oxide and sodium borate glasses and their melts at the temperature ranging from room temperature to 1200 °C to investigate the structural changes occurring in the melts. The amounts of short-range order structures (SRO), BO₂O⁻ and BO₃, were estimated from the high frequency bands at 1100-1600 cm⁻¹. The ratio of 4-fold coordinated boron oxide BO₄, N₄, at high temperature could be derived for the glass melts as a function of Na₂O concentration. In Na₂O ?20 mol% region, N₄ showed a slight decrease while the remarkable decrease of N₄ was found in the region of Na₂O ?25 mol% with increasing temperature. The enthalpy of the equilibrium reaction,

     

Growth and optical properties of self-frequency-doubling laser crystal Yb:LuAl3(BO3)4

Single crystal of Yb:LuAl₃(BO₃)₄(Yb:LuAB) was grown by the flux method for the first time. The cell parameters of the grown crystal were estimated by X-ray diffraction analysis. The result indicates the symmetry of trigonal space group R32, with lattice parameters a=b=9.26372 Å, c=7.21405 Å, V=536.14 Å³, and Z=4. The absorption and emission spectra of Yb:LuAB crystal at room temperature has also been studied. The fluorescence lifetime for Yb:LuAB crystal is about 1.48 ms. The heat capacity was measured from 25 to 500 °C. Its second harmonic generation efficiency in LuAl₃(BO₃)₄ crystal is 3–4 times that of KDP crystal. These results show that Yb:LuAB crystal would be a potential self-frequency-doubling laser crystal.