共查询到20条相似文献,搜索用时 0 毫秒
1.
2.
研究了在多脉冲强激光辐照下靶材的热传导与热冲击特性。基于非傅里叶导热定律和热弹性理论,推导出多脉冲激光辐照下靶材温度场和热应力场的解析式;结合适当的边界条件,以不锈钢靶材为例,利用有限差分法和Matlab计算得到了多脉冲强激光辐照下靶材内部过余温度随时间和深度演化情况以及内部热应力的演化规律。计算结果表明:多脉冲激光辐照下靶材热响应在离边界不同截面处温度波形变化出现延迟性,其滞后性能与弛豫时间有关;非傅里叶解中应力波的波前十分陡峭,具有明显的热冲击性。 相似文献
3.
研究了在多脉冲强激光辐照下靶材的热传导与热冲击特性。基于非傅里叶导热定律和热弹性理论,推导出多脉冲激光辐照下靶材温度场和热应力场的解析式;结合适当的边界条件,以不锈钢靶材为例,利用有限差分法和Matlab计算得到了多脉冲强激光辐照下靶材内部过余温度随时间和深度演化情况以及内部热应力的演化规律。计算结果表明:多脉冲激光辐照下靶材热响应在离边界不同截面处温度波形变化出现延迟性,其滞后性能与弛豫时间有关;非傅里叶解中应力波的波前十分陡峭,具有明显的热冲击性。 相似文献
4.
5.
Experimental study has been performed on nanosecond (ns) laser ablation of silicon at 1064 nm, through which a so-called “multi-pulse enhancement effect” has been revealed, which has been rarely reported in literature. The major features of this effect are: (1) for multi-pulse laser ablation at the same spatial location, the ablation efficiency increases as the pulse number increases and the pulse-to-pulse temporal distance decreases; (2) for multi-pulse ablation performed sequentially at a group of locations, the ablation quality and efficiency starting from the second location can be significantly enhanced if the distance between adjacent locations is sufficiently small. Further study is needed to confirm and understand the underlying physical mechanism for the multi-pulse enhancement effect, which can be utilized to significantly improve the quality and efficiency of laser silicon micromachining using the low-cost and low-energy-consumption infrared ns lasers. This may decrease the cost and energy consumption of many relevant areas, such as the solar cell industry. 相似文献
6.
The circular-like sidewall and trench around the periphery of the crater are obtained on Zinc metal surface subjected to fewer than 200 cumulative pulses laser ablation.These patterns can be attributed to the higher secondary heating by regular plasma spherical pressure.The 600 pulses laser ablation,however,results in the formation of undesirable bulk wrinkles of super-heated liquid at the side of the trench.These features may be applied in micro-manufacturing of high localizability and selectivity using laser zone texturing. 相似文献
7.
8.
9.
为研究激光烧蚀靶产生冲量过程和机理, 建立了一个复杂的一维热传导和流体动力学模型. 以空间碎片常见材料Al为例, 用建立的模型数值计算了纳秒脉宽激光烧蚀靶产生的冲量及冲量耦合系数随时间变化情况. 数值结果和已有的实验数据符合的较好. 数值计算表明: 激光脉冲时间内, 靶获得的冲量随时间迅速增加, 在脉冲时间结束后, 冲量变化随时间趋于稳定; 在冲量耦合过程中, 烧蚀等离子体向真空膨胀, 羽流尺度逐渐增大, 同时吸收入射激光能量, 导致激光与靶耦合的能量降低.
关键词:
激光烧蚀
冲量耦合
等离子体 相似文献
10.
Dynamics of cavitation bubbles generated by multi-pulse laser irradiation of a solid target in water
Ayaka Tamura Tetsuo Sakka Kazuhiro Fukami Yukio H. Ogata 《Applied Physics A: Materials Science & Processing》2013,112(1):209-213
The effect of the second and later pulses on the expansion dynamics of the cavitation bubble produced by multi-pulse microchip laser irradiation of a Cu target in water has been investigated. We clarified the bubble dynamics by taking shadowgraph images and measuring the bubble radius as a function of time. Shock waves were also measured to investigate the explosive expansion of the bubble. As a result, the second and later pulses did not cause an explosive expansion, and the ablation of the target by these pulses was rather mild, although they had a certain contribution to the expansion of the bubble. The energies given to the bubble expansion from the first pulse and also from the second pulse were estimated by comparing the experimental results with the calculation based on the Rayleigh model. 相似文献
11.
采用二维雷诺平均N-S方程,数值模拟研究了大气条件下短脉冲激光与固体靶相互作用所产生等离子体的动力学过程。采用k-ε两方程模型用于湍流的数值模拟,分别利用ROE格式和二阶中心格式对对流通量和粘性通量进行离散处理;用高斯-赛德尔隐式格式对方程进行时间推进求解。数值模拟给出了激光引发靶蒸气等离子体侧向膨胀、稀疏等二维流体动力学过程的物理图像,讨论了靶与光斑尺寸对脉冲激光冲量的影响。结果表明,不同宽度固体靶受到的激光冲量有很大差异,固体靶宽度越大,受到的激光冲量也越大。 相似文献
12.
利用激光清除空间碎片被认为是一种可行手段,冲量耦合系数是数值计算空间碎片清除效果的重要参数。建立了激光烧蚀冲量耦合系数解析计算模型,引入电离度参数,将气化机制与等离子体机制两种机制下的冲量耦合系数解析计算模型联系起来,建立统一的耦合系数解析模型。以空间碎片常见材料Al为例,计算得到冲量耦合系数、电离度、激光功率密度三者之间的变化关系。随着激光功率密度的增加,气化机制逐渐向等离子体机制过渡,电离度增加,直至完全电离,冲量耦合系数先增加后减少,并且在等离子机制占主导情况下达到最优冲量耦合。 相似文献
13.
利用激光清除空间碎片被认为是一种可行手段,冲量耦合系数是数值计算空间碎片清除效果的重要参数。建立了激光烧蚀冲量耦合系数解析计算模型,引入电离度参数,将气化机制与等离子体机制两种机制下的冲量耦合系数解析计算模型联系起来,建立统一的耦合系数解析模型。以空间碎片常见材料Al为例,计算得到冲量耦合系数、电离度、激光功率密度三者之间的变化关系。随着激光功率密度的增加,气化机制逐渐向等离子体机制过渡,电离度增加,直至完全电离,冲量耦合系数先增加后减少,并且在等离子机制占主导情况下达到最优冲量耦合。 相似文献
14.
15.
16.
17.
18.
19.
H. Blancher R. Occelli P. Torchio P. Baulaigue 《International Journal of Infrared and Millimeter Waves》1997,18(2):359-367
In this article, we study the spatial and temporal IR distribution of the temperature in an absorbant material, while periodically
exposing it to IR luminescent radiation.
We compare our results with those obtained experimentally from semiconductor materials.
An understanding of the form of the signal permits us to determine the ratio of the penetration depth of the IR radiation
to the thermal diffusion length into the material.
In the case of weak concentration of absorbant impurities in a homogeneous material, the thermal properties are slightly modified
and absorption is proportional to concentration.
With this method, we satisfactorily found it possible to determine the rate of the impurities distributed in the material. 相似文献
20.