色散对高能激光光纤前端FM-AM效应的影响

<正>弦相位调制脉冲可以满足高能激光驱动器对宽带和束匀滑的要求,在光纤系统中传输后,由于光纤中群速度色散的作用,将会产生强度调制,从而加剧光纤功率放大器中的非线性效应和光谱整形的难度.通过对2GHz,14·25GHz正弦相位调制脉冲经过不同光纤长度传输实验为例,结合光纤系统中色散对FM-AM效应影响的理论分析,发现2GHz相位调制脉冲的实验结果与模拟结果符合较好.     

具有高阶耦合色散系数三芯光纤耦合器非线性光开关特性的研究

利用两种方法研究了高速光脉冲在具有交叉相位调制的等边三角形排列结构的非线性三芯光纤耦合器中传输和开关特性.首先利用变分原理得到三纤芯中传输转移系数随距离变化的方程,然后利用分裂步长傅里叶方法求得了光脉冲的数值解.变分法和数值模拟的结果表明：当一阶模间色散系数较小时,光脉冲仍能在三芯之间周期性耦合传输,并且表现出良好的开关特性,但是随着一阶模间色散系数的增大,脉冲耦合传输的周期性和陡峭的开关特性都遭到破坏,光脉冲在传输中发生分裂;二阶耦合色散系数和初始啁啾都能使光脉冲传输时的耦合长度变短、光脉冲在三纤芯之间 关键词： 三芯光纤耦合器 模间色散系数 耦合长度 开关阈值功率     

Measurement of fiber chromatic dispersion using spectral interferometry with modulation of dispersed laser pulses

We propose and experimentally demonstrate a method for fiber dispersion measurement based on the modulation of laser pulses stretched by the fiber under test. The measured spectrum of the modulated pulses is the result of the interference between the stretched pulse spectra shifted by the modulation harmonics. The interference pattern is processed as in Fourier transform spectral interferometry. Unlike to conventional spectral interferometry, environmental conditions do not affect the interferogram due to the lack of any interferometer; additionally, large dispersions can be characterized by the method proposed. Its high accuracy is demonstrated in experimental comparison with the widely used phase shift technique.     

Third- and fourth-order active dispersion compensation with a phase modulator in a terabit-per-second optical time-division multiplexed transmission

Broadening of the pulse waveforms by the higher-order dispersion of a transmission line is a critical limiting factor in achieving terabit-per-second optical time-division multiplexed (OTDM) transmission with femtosecond pulses. We show that the third- and fourth-order dispersion of a transmission line can be simultaneously compensated for by use of a phase modulator. In this method, sinusoidal phase modulation applied to the linearly chirped pulse before transmission compensates for the phase shift caused by the third- and fourth-order dispersion of the transmission line. The pulse broadening of a 380-fs pulse after a 70-km transmission in a 1.28-Tbit/s OTDM experiment was as small as 20 fs.     

Generation of bound solitons in actively phase modulation mode-locked fiber ring resonators

Bound solitons generated in actively mode-locked lasers enable new forms of pulse pairs and multiple pairs or groups of solitons in optical transmission or logics. In this paper, we present the generation of stable bound states of multiple solitons in an active mode-locked fiber laser using continuous phase modulation for wideband phase matching. Not only that dual-soliton bound states but also the triple- and quadruple-soliton pulses can be established. Simulation of the generated solitons are demonstrated. We have also prove by simulation that experimental relative phase difference and chirping caused by phase modulation of LiNbO₃ modulator in the fiber loop significantly influences the interaction between the solitons and hence their stability as they circulate in the anomalous path-averaged dispersion fiber loop.     

Higher-order dispersion compensation using phase modulators

The use of electro-optic phase modulation of dispersed optical pulses is investigated for compensating higher-order chromatic dispersion effects. The capability and limitations of the technique are described for compensating third- and fourth-order dispersion terms.     

Long-distance 40-Gbit/s soliton transmission over standard fiber by use of dispersion management

We demonstrate, through numerical simulations, the possibility of transmitting solitonlike pulses over 2000 km of standard fiber at a single-channel data rate of 40 Gbits/s. The system used here employs a novel dispersion map to overcome the large fiber dispersion. The longest transmission distance was achieved with pulses that did not exhibit the enhanced energy normally associated with dispersion management and indeed had lower energy than an equivalent average soliton.     

High-Q microwave photonic filter with self-phase modulation spectrum broadening and third-order dispersion compensation

We propose and experimentally demonstrate a scheme of high-Q microwave photonic filter （MPF） using the techniques of self-phase modulation （SPM） spectrum broadening and third-order dispersion （TOD） compensation. The optical pulses from a mode-locking laser are spectrally broadened by the SPM in the highly nonlinear fiber. A wideband optical frequency comb with 365 spectral lines within 10-dB power variation from the highest spectral power is obtained. By applying a cubic phase modulation via a waveshaper, the effect of TOD which broadens the MPF passband is eliminated. The final implemented MPF has a Q-value as high as 296 and a tuning range of 700 MHz.     

Chromatic dispersion compensation techniques and characterization of fiber Bragg grating for dispersion compensation

Pulse spreading due to the dispersion causes the overlapping of the transmitted pulses at the receiver end known as inter symbol interference (ISI). The ISI thus limits transmission of high speed data. We are living in the age of bandwidth hungry and high speed applications, for which optical networks form the most important part because of its high bandwidth. In optical networks chromatic dispersion (CD) is one of the main obstacle in high speed transmission. Hence this CD is compensated by various approaches throughout the transmission system. A review of all the main approaches is presented in this paper. Characterization of fiber Bragg grating for dispersion compensation is done using the reflection spectrum and group delay response analysis.     

基于频域相位共轭技术的交叉相位调制所致失真的复原

理论分析和讨论了基于频域相位共轭技术的交叉相位调制所致信号失真的复原和补偿机理，数值模拟了在交叉相位调制作用下，高斯脉冲在中距相位共轭光纤系统中的传输演化过程.结果表明，频域相位共轭技术能够抑制交叉相位调制对光纤系统中传输信号的损害，复原其所导致的信号失真，并能够同步补偿群速度色散和自相位调制非线性效应所导致的信号失真.合适的初始脉冲时延和初始脉冲啁啾有利于频域相位共轭技术对交叉相位调制所致信号失真的抑制. 关键词： 频域相位共轭 交叉相位调制 色散 自相位调制     

Group velocity dispersion and polarization mode dispersion compensation by high-birefringence linearly chirped fiber Bragg grating

A high-birefringence linearly chirped fiber Bragg grating (FBG) is written into a polarization-maintaining photosensitive fiber by ultraviolet (UV) beam through a linearly chirped phase mask. Its performance as group velocity dispersion (GVD) and polarization mode dispersion (PMD) compensator is demonstrated in short pulse fiber optical transmission systems.     

Photosensitivity-enabled dispersion controllability for quasi-phase-matching in photonic crystal fibers

A novel photonic crystal fiber featured by concentric cores is proposed to induce dispersion controllability by photosensitivity. Chromatic dispersion can be changed from -1827 to 72 ps/nm/km with refractive index modulation of 4 x 10(-4) produced in Ge-doped regions in the fiber. Effective mode area of inner mode is as small as 6.4 mum(2). The proposed fiber enables to achieve quasi-phase-matched nonlinear parametric interaction in a single piece of photonic crystal fiber, by periodically alternating dispersion and compensating for phase mismatching caused by the dispersion.     

Pulse compression of nanojoule pulses in the visible using microstructure optical fiber and dispersion compensation

Experimental results on the pulse compression of 1-nJ, 150-fs pulses from a tunable, 76-MHz Ti:sapphire laser oscillator operating at around 750 nm are reported. The length of the pulses can be compressed to nearly one tenth by applying a high-delta, single-mode microstructured optical fiber exhibiting zero group-delay dispersion at 767 nm, and by a prism-pair/chirped-mirror compressor. The experimental results are verified by theoretical investigations modeling the pulse propagation taking into account non-linear self-phase modulation and fiber dispersion. Received: 10 June 2002 / Revised version: 15 November 2002 / Published online: 12 February 2003 RID="*" ID="*"Corresponding author. Fax: +36-1/375-4553, E-mail: szipoecs@sunserv.kfki.hu     

Acoustic dispersion and attenuation measurement using both transmitted and reflected pulses

Traditional broadband transmission method for measuring acoustic dispersion and attenuation requires the measurement of the thickness of the specimen, the transmission coefficient at the water–specimen interface, and the Fourier spectra of two transmitted pulses. A new method has recently been developed that can determine both the thickness and dispersion of the specimen by utilizing the phase spectra of two additional pulses reflected back from the front and back surfaces of the specimen. In this paper, the method is further extended to the measurement of attenuation. If the density of the specimen is known, the frequency-dependent transmission coefficient can be determined based on the measured phase velocity, and only the amplitude spectra of the two transmitted pulses are used to determine the attenuation. If the density of the specimen is unknown, the attenuation can be determined from the amplitude spectra of all the four pulses. In both cases, the thickness estimated from the phase spectra of the four pulses is utilized. Experimental results from two specimens are presented to demonstrate the application of the new method.     

Measurement of acoustic dispersion using both transmitted and reflected pulses

Traditional broadband transmission method for measuring acoustic dispersion requires the measurements of the sound speed in water, the thickness of the specimen, and the phase spectra of two transmitted ultrasound pulses. When the sound speed in the specimen is significantly different from that in water, the overall uncertainty of the dispersion measurement is generally dominated by the uncertainty of the thickness measurement. In this paper, a new water immersion method for measuring dispersion is proposed which eliminates the need for thickness measurement and the associated uncertainty. In addition to recording the two transmitted pulses, the new method requires recording two reflected pulses, one from the front surface and one from the back surface of the specimen. The phase velocity as well as the thickness of the specimen can be determined from the phase spectra of the four pulses. Theoretical analysis and experimental results from three specimens demonstrate the advantages of this new method.     

用Kramers-Kronig关系求出反射镜的相位色散

光学元件相位色散在超短光脉冲的产生和传播中起着重要的作用,本文提出运用Kramers-Kronig关系,从反射谱直接求出反射镜的相位色散.文中对此法作了分析并以多层介质膜和铝膜反射镜为例子进行了讨论.     

Cross-phase modulation induced phase fluctuations in optical RZ pulse propagating in dispersion compensated WDM transmission systems

The basic mechanism of cross-phase modulation induced phase fluctuations in optical RZ pulse propagating in a periodically dispersion compensated transmission line has been investigated. Ordinary differential equations have been derived using variational analysis to estimate the phase fluctuation and the analytical result is verified by numerical simulations based on split-step Fourier method. We therefore explore the impact of different dispersion compensation maps on phase fluctuation for 10 Gb/s and 40 Gb/s WDM transmission systems. The effects of initial pulse spacing between channels, channel spacing and residual dispersion on phase shift have been studied. We find that cross-phase modulation induced phase fluctuation can be mitigated by proper adjustment of channel spacing and/or residual dispersion.     

Influence of group-delay ripple on timing jitter induced by SPM and IXPM in systems with dispersion compensated by CFBG

An analytical expression was proposed to analyze the influence of group-delay ripple (GDR) on timing jitter induced by self-phase modulation (SPM) and intra-channel cross-phase modulation (IXPM) in pseudolinear transmission systems when dispersion was compensated by chirped fiber Bragg grating (CFBG).Effects of ripple amplitude, period, and phase on timing jitter were discussed by theoretical and numerical analysis in detail. The results show that the influence of GDR on timing jitter changes linearly with the amplitude of GDR and whether it decreases or increases the timing jitter relies on the ripple period and ripple phase. Timing jitter induced by SPM and IXPM could be suppressed totally by adjusting the relative phase between the center frequency of the pulse and the ripples.     

Measurement of pulse amplitude and phase using cross-phase modulation in microstructure fiber

Cross-phase modulation in a highly nonlinear microstructure optical fiber with low dispersion and high birefringence is used for the measurement of the pulse amplitude and phase of picosecond pulses by frequency-resolved optical gating. An alignment-free configuration including an optical amplifier is proposed and experimentally tested. The simulated annealing method is used for retrieving the amplitude and phase from cross-phase modulation spectrograms. It takes into account the birefringence of the measurement fiber and the resolution of the optical spectrum analyzer.     

Microjoule level femtosecond optical pulses with double-cladding fiber-based nonlinear chirped-pulse amplification

An all-fiber high-energy nonlinear chirped-pulse amplification system with two-stage double-cladding fiber amplifiers is presented in this paper. It generates pulses with the energy up to 10 μJ at 20 kHz repetition rate and total accumulated nonlinear phase shift as large as 12.8π. The pulses can be compressed to 137 fs with the compensation of mismatched third-order dispersion by self-phase modulation in the fiber amplifiers.