Determination of gatifloxacin in bulk and tablet preparations by high-performance liquid chromatography

A sensitive, precise, and specific high-performance liquid chromatographic (HPLC) method was developed for the assay of gatifloxacin (GATX) in raw material and tablets. The method validation parameters yielded good results and included the range, linearity, precision, accuracy, specificity, and recovery. It was also found that the excipients in the commercial tablet preparation did not interfere with the assay. The HPLC separation was carried out by reversed-phase chromatography on a C18 absorbosphere column (250 x 4.6 mm id, 5 microm particle size) with a mobile phase composed of acetic acid 5%-acetonitrile-methanol (70 + 15 + 15, v/v/v) pumped isocratically at a flow rate of 1.0 mL/min. The effluent was monitored at 287 nm. The calibration graph for GATX was linear from 4.0 to 14.0 microg/mL. The interday and intraday precisions (relative standard deviation) were less than 1.05%.     

Determination of disulfiram by micellar liquid chromatography in illicit preparations

Presently, disulfiram is used in aversion therapy for recovering alcoholics. It acts by inhibiting aldehyde dehydrogenase, leading to high blood levels of acetaldehyde. A simple direct injection micellar liquid chromatographic procedure was developed to determine disulfiram in illicit preparations (ayurvedic, herbal, divine ash, and traditional medicine), as well as in pharmaceuticals and biological samples (urine). After application of a predictive optimization strategy, the proposed method was developed using a 0.1 M sodium dodecyl sulfate-butanol 4% (v/v) buffered to pH 7 as the mobile phase at a flow rate of 1 mL/min, an octyl silyl (C8) 150 mm column, and diode array detection at 248 nm. Under the above conditions, the analysis time was below 8 min. Validation studies were based on U.S. Food and Drug Administration guidelines. The LOD (3 x SD criterion) was 15 ng/mL and LOQ (10 x SD criterion) was 70 ng/mL for disulfiram. The intraday and interday precisions were below 3.5%, recoveries were in the range of 97-102%, and robustness was below 3%. The optimized and validated micellar liquid chromatographic method was successfully applied to the determination of disulfiram in ayurvedic, herbal, divine ash, and other samples. The procedure developed could also be used in the fields of QC, routine analysis, and pharmacokinetic studies.     

Determination of omeprazole in bulk and injectable preparations by liquid chromatography

An accurate, simple, reproducible, and sensitive liquid chromatographic method was developed and validated for the determination of omeprazole in powder for injection and in pellets. The analyses were performed at room temperature on a reversed-phase C18 column of 250 x 4.6 mm id, 5 microm particle size. The mobile phase, composed of methanol-water (90 + 10, v/v), was pumped at a constant flow rate of 1.5 mL/min. Detection was performed on a UV detector at 301 nm. The method was validated in terms of linearity, precision, accuracy, and ruggedness. The response was linear in the range 32-48 microg/mL (r2 = 0.9976). The relative standard deviation values for intra- and interday precision studies were 1.22 and 1.56% for injectable and 2.13 and 2.45% for pellets, respectively. Recoveries ranged between 95.81 and 100.48%.     

Determination of active ingredients in cough-cold preparations by micellar liquid chromatography

The chromatographic behaviour of some active ingredients in cough-cold pharmaceutical preparations, the antihistamine chlorpheniramine (or the dextro enantiomer dexchlorpheniramine), and the phenethylamines phenylephrine, phenylpropanolamine and pseudoephedrine, has been studied using a C(18) column, micellar mobile phases of sodium dodecyl sulphate (SDS) and pentanol, and with UV detection. All possible combinations of chlorpheniramine/phenethylamine were resolved and determined using a mobile phase of 0.15 M SDS-6% (v/v) pentanol at pH 7, with analysis time below 7 min. Repeatabilities and within laboratory precisions were evaluated at four different drug concentrations in the range 0.5-25 mug ml(-1) (n=5), resulting RSDs below 1.6%. The drug amounts found in the analysis of 14 commercialised preparations agreed with those declared by the manufacturers within the tolerance limits, and with those obtained using an aqueous 60% (v/v) methanol reference mobile phase. No interference was observed from other accompanying drugs such as acetylsalicylic acid, ascorbic acid, betamethasone, caffeine, codeine phosphate, diphenhydramine, lactose, paracetamol, and prednisolone. The studied combinations required a rather high amount of methanol in conventional RPLC to be eluted from the column. In contrast, the proposed procedure used a much lower amount of organic solvent (pentanol), which is highly retained in the SDS solution, being also less toxic than methanol.     

Determination of fleroxacin in pure and tablet forms by liquid chromatography and derivative UV-spectrophotometry

Derivative UV-spectrophotometric and liquid chromatographic (LC) methods for fleroxacin determination were validated. In the spectrophotometric assay, first-, second-, third-, and fourth-order measurements were applied with the use of peak-zero and peak-peak techniques. The linear correlation between amplitude of the peak and concentration of the examined drug ranged from 2.0 to 12.0 micro/mL. An isocratic LC analysis was performed on a Purospher ODS column with an acidic mobile phase containing tetrabutylammonium hydroxide. Measurements were made at a wavelength of 285 nm with 4-aminobenzoic acid (PABA) as internal standard. The calibration curve was linear (r = 0.9999) in the studied range of concentration (1.0-10.0 microg/mL). The accuracy (mean recovery, about 100%), precision (relative standard deviation < 1%), selectivity, and sensitivity of the elaborated methods were satisfactory.     

Determination of the analgesic components of Spasmomigraine tablet by liquid chromatography with ultraviolet detection

A procedure was developed for the determination of the analgesic components of Spasmomigraine tablets, which are ergotamine (I), propyphenazone (II), caffeine (III), camylofin (IV), and mecloxamine (V). They were subjected to high-performance liquid chromatography on a column (300 x 3.9 mm, 10 rlm particle size) packed with micro-Bondapak C18. Separations were achieved with the mobile phase methanol-water-triethylamine (60 + 40 + 0.1, v/v/v) flowing at a rate of 1.5 mL/min, and quantitative determination was performed at 254 nm at ambient temperature for I-III; acetonitrile-25 mM KH2PO4-acetic acid (45 + 55 + 0.2, v/v/v), flowing at a rate of 1.5 mL/min and detection at 234 nm at ambient temperature, was used for IV and V. Methyl paraben was used as an internal standard. The detection limits were 0.35 (I), 5.0 (11), 1.5 (111), 3.0 (IV), and 2.0 microg/mL (V). The method was accurate (mean recovery 98+/-2%, n = 4) and precise (coefficient of variation <5%, n = 5). The proposed method is rapid and sensitive and, therefore, suitable for the routine control of these ingredients in multicomponent dosage forms.     

Determination of undecenoic acid in dermatological preparations by liquid chromatography with direct UV detection

Separation on a ODS reversed-phase column with acetonitrile—0.1% phosphoric acid (65 + 35) as mobile phase provides a simple and rapid method for the determination of undecenoic acid in dermatological preparations. Common preservatives, bactericides and antiseptics do not interfere. Tolnaftate was employed as the internal standard throughout the assay. A linear relationship was established between the peak-area ratio of undecenoic acid to the internal standard and concentration of undecenoic acid over the range 0.01–0.1 ng ml^?1.     

Determination of vitamin A in pharmaceutical preparations by high-performance liquid chromatography with diode-array detection

Summary A very simple high-performance liquid chromatographic method for determination of Vitamin A in pharmaceutical preparations without the need for saponification was developed. A reversed-phase (Nova-Pack C₁₈, 4 m) column was used with a mobile phase of acetonitrile-tetrahydrofuran-water (55378) and a flowrate of 1.5 ml/min. Sample treatment only consisted of the extraction of retinol acetate content from capsules or tablets with methanol. Total extraction was achieved by shaking vigorously with the aid of magnetic stirring for three hours at room temperature. No change of solvent is necessary to introduce the sample in the chromatographic system. This method is suitable for routine quantification of Vitamin A.     

Determination of ofloxacin and lomefloxacin in chicken muscle using molecularly imprinted solid-phase extraction coupled with liquid chromatography

A new molecularly imprinted solid-phase extraction (MISPE) procedure combined with liquid chromatography was developed for the simultaneous selective extraction and determination of ofloxacin (OFL) and lomefloxacin (LOM) in chicken muscle samples. The water-compatible molecularly imprinted microspheres (MIMs) were synthesized by aqueous suspension polymerization using 2-hydroxy-3-naphthoic acid and 1-methylpiperazine as mimic templates. The MIMs applied as selective sorbents in SPE method showed high selectivity and affinity to OFL and LOM in complex biological matrices. Good linearity was obtained in a range of 0.025-2.0 μg/g, and the average recoveries of OFL and LOM at three spiked levels ranged from 94.4 to 96.9%, respectively, with the relative standard deviation ≤4.7%. The developed MISPE-HPLC method was successfully applied to the isolation of OFL and LOM in chicken muscles, which demonstrated the potential ability of the novel MIMs for selective extraction of fluoroquinolones in biological samples.     

Determination of streptomycin in pharmaceutical preparations by gas chromatography

The antibiotic streptomycin can be reliably quantitated in injectable pharmaceuticals by GC. The manipulations are not difficult, and total analysis time for duplicate samples is less than twenty minutes. Reaction of the drug with aqueous sodium hydroxide solution generates maltol, which is extracted into chloroform prior to silylation. The silyl ether of maltol is then assayed, using naphthalene as internal standard. Duplicate analyses of twenty pharmaceutical samples showed a relative standard deviation of ±1.3%.     

Determination of cinnamic acid and paeoniflorin in traditional Chinese medicinal preparations by high-performance liquid chromatography.

A high-performance liquid chromatographic method for the determination of cinnamic acid in Cinnamomi ramulus and paeoniflorin in Paeoniae radix was established. The samples were separated by a LiChrospher RP-18 column with water-acetonitrile-methanolacetic acid (61:34:5:0.1 or 80:15:5:0.1, v/v) as the mobile phase at a flow-rate of 1.0 ml/min. Cinnamic acid and paeoniflorin were determined by UV detection at 280 and 250 nm, respectively. The method was applied to determine the optimum conditions for the extraction of the traditional Chinese medicinal preparation Huang Chi Chien Chung Tong, which contains Cinnamomi ramulus and Paeoniae radix. The results indicate that the best extraction conditions involved the use of an ultrasonic bath at 60 degrees C for 30 min. In this experiment, butyl paraben and methyl paraben were used as the internal standards for cinnamic acid and paeoniflorin, respectively. A good and reproducible separation of cinnamic acid and paeoniflorin was obtained within 15 min. The method was also applicable to other preparations that contain Cinnamomi ramulus and Paeoniae radix such as Guey Chi Chia Long Ku Muu Li Tong, Kuei Chi Chien Chung Tong and Tang Kuei Chien Chung Tong.