Broadband spectral shaping in a Ti:sapphire regenerative amplifier

A birefringent crystal quartz plate of known thickness has been used as a spectral filter for spectral shaping in a Ti:sapphire regenerative amplifier. The spectral profile of the amplified pulse ejected from the regenerative amplifier was observed while adjusting the birefringent crystal plate in the cavity. By altering the gain spectrum, the bandwidth of the regeneratively amplified pulse was increased from 18 to 35 nm by using a 0.34-mm thick birefringent plate. The output pulse spectrum from the regenerative amplifier neared the bandwidth of the seed pulse. As a comparison, we used a coated filter outside the regenerative amplifier cavity, and the bandwidth of the regeneratively amplified pulse was stretched to 28 nm. When the bandwidth was stretched to 35 nm, the pulse was compressed to 35 fs.     

高能量环形长腔再生放大啁啾脉冲激光的研究

介绍了一种新型的高能量环形长腔再生放大器, 通过对谐振腔的模式分布进行计算, 建立了腔长为12 m的环形腔再生放大器, 在150 mJ的抽运能量下, 得到了单脉冲能量为20 mJ的放大激光输出, 对应的转化效率为13.3%, 其输出激光的能量远远超过了常规的再生放大器输出激光的单脉冲量. 放大激光的输出光谱为30 nm, 可以支持<40 fs的傅里叶转换极限脉宽. 关键词： 环形腔 再生放大 高能量     

全固态kHz啁啾脉冲飞秒激光放大器

要建造大功率超强激光系统,必须将nJ量级的种子进行放大,以得到mJ量级以及更高能量的激光输出.为达到这个目的,必须使种子能量指数增加,再生腔放大器是实现这一目的的良好途径;同时,为了得到更稳定的激光输出,须采用高重复频率的泵浦源.为此,设计了一种kHz重复频率激光泵浦的再生放大器,使用15 mJ的527 nm的绿光泵浦,得到了约2.3 mJ的800 nm放大激光输出,同时,对其输出激光的光谱特性进行了测量,将带宽为40 nm的种子注入后,得到了光谱带宽约为30 nm激光输出.     

输出能量4mJ的1kHz飞秒掺钛蓝宝石激光再生放大研究

针对高能量千赫兹重复频率飞秒激光的应用需求,设计了一套采用线性再生腔结构的高效率飞秒钛宝石激光啁啾脉冲放大系统.通过优化腔型设计,在重复频率为1 kHz、单脉冲能量为20 mJ的527 nm激光抽运下,将展宽后的800 nm啁啾脉冲激光的能量放大到5.8 mJ,对应斜效率达到30.7%.进一步通过色散补偿压缩脉冲宽度,获得了单脉冲能量为4 mJ、脉冲宽度为45.7 fs的输出,稳定性测量表明激光的能量抖动仅为0.18%(均方根值).     

无展宽器的高重复率钛宝石啁啾飞秒脉冲再生放大器的研究

通过优化放大腔结构参数和采用高光束质量的泵浦激光,依靠放大器腔内各个元件的色散展宽种子脉冲, 用钛宝石作为增益介质, 在低泵浦能量下, 实现了高光束质量,高稳定的中等能量的高重复率飞秒脉冲再生放大. 将钛宝石晶体离焦放置,有效的避免了光学损伤. 在1.1 mJ的绿光泵浦下, 获得了2 ps, 120 μJ, 重复频率为1 KHz, 光谱带宽7.8 nm的放大脉冲, 用石英棱镜对压缩可得到130 fs的激光脉冲.     

High-energy, diode-pumped, picosecond Yb:YAG chirped-pulse regenerative amplifier for pumping optical parametric chirped-pulse amplification

A diode-pumped, cryogenic-cooled Yb:YAG regenerative amplifier utilizing gain-narrowing has been developed. A 1.2-ns chirped-seed pulse was simultaneously amplified and compressed in the regenerative amplifier, which generated a 35-ps pulse with ~8-mJ of energy without a pulse compressor. Second-harmonics of the amplified pulse was used to pump picosecond two-color optical parametric amplification.     

Six 38.7 W pulses in a burst of pulse-burst picosecond 1064 nm laser system at 1 kHz

A burst of six pulses with an average power of 38.7 W are obtained for a pulse-burst picosecond 1064 nm laser system at 1 k Hz. The six pulses have equal amplitudes and pulse spacings of 800 ps, the beam quality of the M2 factor is less than 2, and the pulse width is 67 ps. Seed pulses are broadened from 22 to 136 ps by single-pass volume Bragg gratings. A laser-diode end-pump Nd:YVO_4 beam-splitting amplifier is used to divide and amplify a single pulse into six pulses. An Nd:YAG regenerative amplifier and a single-pass high-gain amplifier are applied.     

基于大基模体积的10mJ飞秒钛宝石激光再生放大器

文章报导了基于大基模体积的高能量飞秒钛宝石激光再生放大器的设计与实验研究,在重复频率10 Hz、抽运能量60 mJ的激励下,得到了单脉冲能量17.4 mJ的种子脉冲放大结果,压缩后的脉冲宽度为40.6 fs,能量为13.9 mJ.借助于此大基模体积再生腔,仅增加一级多通放大,实现了峰值功率达1.9 TW飞秒激光脉冲输出.结果表明,大模体积再生放大不仅降低了后续放大对抽运能量的要求,也可以单独压缩实现再生腔直接输出10 mJ量级的飞秒激光脉冲,是大能量高峰值功率飞秒激光系统的优质前端.     

Broad-band regenerative laser amplification in ytterbium-doped calcium fluoride (Yb:CaF<Subscript>2</Subscript>)

An output pulse energy of 17.3 mJ has been achieved with a diode-pumped Yb:CaF₂ regenerative laser amplifier. The bandwidth of the output pulse spectrum was 7.3 nm, being seeded with femtosecond pulses stretched to 2.2 ns. In cw operation a tuning range of 80 nm has been observed. A maximum pulse energy of 44 mJ at a repetition rate of 1 Hz has been obtained in Q-switched mode. The laser damage threshold of a Yb:CaF₂ crystal has been determined at a wavelength of 1064 nm and a pulse duration of 10 ns. PACS 42.55.Ah; 42.55.Xi; 42.70.Hj     

High-power picosecond regenerative amplifier based on CW diode side-pumped Nd:YAG with high beam quality

A compact high-power picosecond regenerative amplifier based on continuous wave(CW) diode sidepumped Nd:YAG is demonstrated.Average power of 8.8 W is achieved at a repetition rate of 5 kHz at a wavelength of 1 064 nm with a pulse duration of 28 ps,corresponding to a pulse energy of 1.76 mJ and a peak power of 62.9 MW.The beam quality is close to the di?raction limit with Mx2 = 1.24,My2 = 1.03.To the best of our knowledge,this is the highest pulse energy obtained from a CW diode pumped Nd:YAG picosecond regenerative amplifier.     

Octave-spanning carrier-envelope phase stabilized visible pulse with sub-3-fs pulse duration

The visible second harmonic of the idler output from a noncollinear optical parametric amplifier was compressed using adaptive dispersion control with a deformable mirror. The amplifier was pumped by and seeded in the signal path by a common 400 nm second-harmonic pulse from a Ti:sapphire regenerative amplifier. Thus, both the idler output and the second harmonic of the idler were passively carrier-envelope phase stabilized. The shortest pulse duration achieved was below 3 fs.     

Diode-pumped, chirped-pulse Yb:S-FAP regenerative amplifier for laser-Compton X-ray generation

We present a diode-pumped, chirped-pulse Yb:S-FAP regenerative amplifier. This regenerative amplifier was developed as a first amplifier in an all-solid-state Yb:S-FAP laser system for laser-Compton X-ray generation. The amplifier delivers pulse energies above 24 mJ at a repetition rate of 50 Hz. Pulse compression reduces pulse widths to approximately 2.0 ps.     

Sub-picosecond pulses at 100 W average power from a Yb:YLF chirped-pulse amplification system

We present a high-repetition-frequency, diode-pumped, and chirped-pulse amplification system operating at 106 W average output power with excellent beam quality (M(2)=1.3), based on cryogenically cooled Yb:YLF. 1 nJ seed pulses, derived from a mode-locked Ti:sapphire laser, are first amplified to 1 mJ pulse energy at 10 kHz repetition frequency in a regenerative amplifier. The second-stage, multipass amplifier increases the pulse energy to 10.6 mJ, resulting in a spectral width of 2.2 nm. The pulses are compressed to 865 fs in duration, which is 1.26 times the transform limit.     

30-mJ, diode-pumped, chirped-pulse Yb:YLF regenerative amplifier

A diode-pumped chirped-pulse regenerative amplifier with a cooled Yb:YLF crystal has been developed. The output pulse energy is 30 mJ at 20-Hz repetition rate. A high effective extraction efficiency of 68% is obtained, which is attributed to reduced saturation fluence at low temperature and to a high effective pulse energy fluence during regenerative amplification. After pulse compression by use of a parallel grating pair, 18-mJ pulse energy and 795-fs pulse duration are obtained.     

An Ultra-Broadband Spatially Dispersed Regenerative Amplifier Free from Spatial Chirp

An ultra-broadband Ti：sapphire regenerative amplifier based on spatially dispersed amplification is demonstrated experimentally. Departing from previous reports, a new design of the cavity gets the amplified pulse free from spatial chirp. Utilizing this new regenerative amplifier, chirped pulses with bandwidth （FWHM） of about 80 nm are obtained, and the bandwidth is limited only by that of the incident seed pulses.     

Synchronized Nd3+ laser pulses using a regenerative amplifier

A single 30 ps pulse from a passively mode-locked Nd:YAG oscillator was synchronized with a longer pulse of 3–5 ns from a Nd:YAG regenerative amplifier. Jitter between the two pulses was found to be negligible over a wide range of energies injected into the regenerative amplifier.     

钛宝石再生放大器1056nm波长稳定输出

讨论钛宝石再生放大器工作在１０５６ｎｍ波长时，获得稳定输出的条件，并在实验上成功地演示了稳定的放大脉冲输出，输出能量均方根起伏小于５％。     

High energy and long pulse generation with high-birefringence photonic crystal fibre and laser-diode pumped regenerative amplifier

We report on the generation of a high energy and long pulse for pumping optical parametric chirped-pulse amplification (OPCPA) by a high-birefringence photonic crystal fibre (HB-PCF) and a laser-diode-pumped regenerative chirped pulse amplifier. Using the femtosecond pump pulse centred at 815~nm, a 1064~nm soliton pulse is produced in the HB-PCF. After injecting it into an Nd:YAG regenerative amplifier with the glass etalons, a narrow-band amplified pulse with an energy of $\sim $4~mJ and a duration of 235 ps is achieved at a repetition rate of 10~Hz, which is suitable for being used as a pump source in the 800~nm OPCPA system.     

采用环形再生腔结构的飞秒激光啁啾脉冲放大研究

采用环形再生腔结构的啁啾脉冲放大技术方案, 在重复频率100 Hz,单脉冲能量33.1 mJ的532 nm激光抽运下, 从钛宝石激光中获得了单脉冲能量9.84 mJ的放大输出, 对应的斜效率达33.1%.在重复频率10 Hz的情况下, 同样获得了单脉冲能量为9.64 mJ, 对应斜效率达36.8%的高效率放大结果. 通过色散补偿压缩该啁啾激光脉冲后的单脉冲能量为6.36 mJ, 脉冲宽度为59.7 fs. 测量结果表明典型的能量不稳定度为1.85%. 关键词： 啁啾脉冲放大 再生放大 飞秒激光 环形腔     

Multi-pulse high energy regenerative amplifier with stable long cavity

The amplification of multiple seed pulses in a regenerative amplifier was experimentally studied. Output of a 140 MHz pulse sequence with a pulse width of 21.2 ps was achieved from a kilohertz regenerative amplifier. The output pulse sequence has a pulse energy of 1.6 mJ and an average power of 8 W.