Improved Solvent‐Free Dakin Oxidation Protocol

A solvent‐free Dakin reaction with mCPBA was accomplished with various aromatic aldehydes, resulting in an easy and improved methodology for the preparation of corresponding phenols. 3,4‐Methylenedioxyphenol, 3,4‐dimethoxyphenol, 4‐methoxyphenol, 4‐chlorophenol, and other functionalized phenols were obtained in high yields from the corresponding aromatic aldehydes in a few minutes. This new methodology represents an efficient alternative for this important synthetic conversion.     

Compensation Between the Entropic and Enthalpic Changes Arising from Changes in Solvent–Solvent Interactions in Mixed Solvents

A theorem presented by Professor Ben-Naim (J Phys Chem 82:874–885, 1978) states that the standard state enthalpy and entropy changes arising from changes in the solvent structure that are induced by solvation of a solute cancel exactly in the standard state Gibbs energy. In this paper this is explored by consideration of the thermodynamics of transfer of electrolytes in mixed solvents, using previously developed models of the solvation process. Two cases are considered. One is random solvation, where curvatures in plots of the transfer enthalpies and entropies, which arise from changes in solvent–solvent interactions, exactly compensate in the transfer Gibbs (free) energies, which are sensibly linear with solvent composition. The second type of system are those with strong preferential solvation where it is found that the transfer Gibbs energies can be accounted for quantitatively in terms of changes in the solute–solvent interactions, with no contribution from changes in solvent–solvent interactions. The results are entirely consistent with the Ben-Naim theorem.     

Solvent “Goodness” in Polymer Separation by Flow

The graft copolymerization of methyl methacrylate onto silk fibers was investigated in aqueous solution using the V⁵⁺?thiourea redox system. The rate of grafting was determined by varying monomer, thiourea, acidity of the medium, temperature, initiator concentration, and reaction medium. The percentage of graft yield increases significantly by increasing the initiator concentration up to 0.01 M and thereafter decreases with a further increase of initiator concentration. The graft yield increases with an increase of thiourea concentration up to 10.0 × 10^?4 and then decreases with a further increase of thiourea concentration. The effect of increasing the monomer concentration brings about a significant enhancement in the graft yield. A suitable kinetic scheme has been proposed and the rate equation has been evaluated.     

Solvent‐Free Thermal Dehydration of Pentitols on Zeolites

Abstract

Dehydration of D‐arabinitol, ribitol, and xylitol at high temperature in the presence of molecular sieves without solvent in an argon atmosphere is described. Products arising after the dehydration–cyclization (cyclodehydration) reaction with retention or inversion of the configuration of asymmetric carbon atoms, were observed. Complete analytical separations of exhaustively O‐acetylated reaction products were achieved by means of GC. The chemical structures of the compounds obtained were assigned using co‐injection with standards.     

Image Contrast Inversion of a Solvent Cast SEBS Film

The image contrast inversion was investigated in detail when soft polymeric materials were imaged with tapping mode atomic force microscopy （TM-AFM）. Solvent cast film of polystyrene-block-poly（ethylene/butylene）block-polystyrene （SEBS） triblock copolymers was used as a model system in this study, which showed phase separation domains with a size of several tens of nanometers. AFM contrast reversal process, through positive image, to an intermediary and till negative image, could be clearly seen in height images of the soft block copolymer using different tapping force. The higher tapping force would lead to not only contrast inversion, but also the different size of the microdomains and different roughness of the images. Moreover, contrast inversion was explained on the basis of attractive and repulsive contributions to the tip-sample interaction and indentation of the soft domains.     

Solvent extraction of uranium from aqueous solutions by α-benzoinoxime

Solvent extraction of uranium with α-benzoinoxime from aqueous solutions has been systematically investigated. The extraction equilibration was very fast and achieved at 60 s for uranium. The extraction of uranium was pH-dependent using α-benzoinoxime as extractant. The effect concentration of uranium and α-benzoinoxime was studied. The uranium loaded in the organic phase can be stripped efficiently with 93 % yield using 0.1 M HCl as the stripping agent in a single stripping step. A good selectivity for uranium was observed through α-benzoinoxime as extractant from aqueous solution with other interfering cation ions. Present study suggested that α-benzoinoxime can be used as a potential extractant for separation of uranium from aqueous solution using centrifugal extractor in industrial application.     

Does Solvent Influence the Ground-state Tautomeric Population of Hypericin?¶

Nuclear magnetic resonance measurements indicate that hypericin exists in the same "normal" tautomeric form irrespective of whether the solvent is dimethyl sulfoxide or tetrahydrofuran. This result is discussed in the context of previous experimental and theoretical work. It is concluded that solvent perturbations cannot induce tautomerization in hypericin.     

The Rapid Synthesis of Schiff-Base without Solvent under Microwave Irradiation

The chemistry of the carbon-nitrogen double bond plays a vital role in the progresses of chemistry science1. Schiff-base compounds have been used as fine chemicals and medical substrates. Recently multi-dentate complexes of iron and nickel showed high activities of ethylene oligomerization and polymerization2. In our efforts for ligands of polymerization catalysts, synthesis of Schiff-base through classical condensation of aldehydes (or ketones) and amines were pursued, however, the yield o…     

Clean SEA-TROSY Experiments to Map Solvent Exposed Amides in Large Proteins

It is well known that the SEA-TROSY experiment could alleviate some of the problems of resonance overlap in ^15N/^2H labeled proteins as it was designed to selectively map solvent exposed amide protons. However, SEATROSY spectra may be contaminated with exchange-relayed NOE contributions from fast exchanged hydroxyl or amine protons and contributions from longitudinal relaxation. Also, perdeuteration of the protein sample is a prerequisite for this experiment. In this communication, a modified version, clean SEA-TROSY, was proposed to eliminate these artifacts and to allow the experiment to be applied to protonated or partially deuterated proteins and protein complexes.     

An Unexpected Chromophore–Solvent Reaction Leads to Bicomponent Aggregation-Induced Phosphorescence

Organic luminogens with persistent room-temperature phosphorescence (RTP) have found a wide range of applications. However, many RTP luminogens are prone to severe quenching in the crystalline state. Herein, we report a strategy to construct a donor-sp³-acceptor type luminogen that exhibits aggregation-induced emission (AIE) while the donor-sp²-acceptor counterpart structure exhibits a non-emissive solid state. Unexpectedly, it was discovered that a trace amount (0.01 %) of the structurally similar derivative, produced by a side reaction with the DMF solvent, could induce strong RTP with an absolute RTP yield up to 25.4 % and a lifetime of 48 ms, although the substance does not show RTP by itself. Single-crystal XRD-based calculations suggest that n–σ* orbital interactions as a result of structural similarity may be responsible for the strong RTP in the bicomponent system. This study provides a new insight into the design of multi-component, solid-state RTP materials from organic molecular systems.     

Solvent effect on SiH stretching bands of substituted silanes

Infrared frequencies of SiH stretching vibration bands of dimethyl naphthoxy silane and dimethyl quinoxy silane have been measured in a number of solvents. The results have been used to examine the importance of the bulk dielectric effect and specific solute—solvent interactions. The deviation from the Kirkwood—Bauer—Magat relationship produced by polar, as well as by non-polar, solvents is analysed in terms of the formation of molecular complexes.     

Facile Synthesis of Ferrocenylenones in Free Solvent at Room Temperature

The rate of formation of aldol condensation products by being ground acetylferrocene and various aromatic aldehydes without solvent was dramatically enhanced comparing to ,the conventional methods. The yield is high (84 % - 96 %) at room temperature.     

Solvent effects in competition between guest molecules forβ-cyclodextrin

The effect was investigated of increasing concentrations of co-solvents ethanol, isopropanol, tetrahydrofuran (THF), dimethylformamide (DMF), formamide and ethylene glycol on the selectivity of inclusion for binary mixtures of the following guest molecules: pinene, eugenol, cineole, limonene and camphor, and of isopropanol for the ternary mixtures eugenol/cineole/pinene; and limonene/cineole/pinene. In contrast to the strong solvent dependent effects on-cyclodextrin solubility, the changes in selectivity are similar for each system, show little variation from solvent to solvent and are guest dependent. Similar guest induced effects are observed for ternary mixtures. They appear to be additive.     

Characterization of Microwave-Induced Electric Discharge Phenomena in Metal–Solvent Mixtures

Electric discharge phenomena in metal–solvent mixtures are investigated utilizing a high field density, sealed-vessel, single-mode 2.45 GHz microwave reactor with a built-in camera. Particular emphasis is placed on studying the discharges exhibited by different metals (Mg, Zn, Cu, Fe, Ni) of varying particle sizes and morphologies in organic solvents (e.g., benzene) at different electric field strengths. Discharge phenomena for diamagnetic and paramagnetic metals (Mg, Zn, Cu) depend strongly on the size of the used particles. With small particles, short-lived corona discharges are observed that do not lead to a complete breakdown. Under high microwave power conditions or with large particles, however, bright sparks and arcs are experienced, often accompanied by solvent decomposition and formation of considerable amounts of graphitized material. Small ferromagnetic Fe and Ni powders (<40 μm) are heated very rapidly in benzene suspensions and start to glow in the microwave field, whereas larger particles exhibit extremely strong discharges. Electric discharges were also observed when Cu metal or other conductive materials such as silicon carbide were exposed to the microwave field in the absence of a solvent in an argon or nitrogen atmosphere.     

Mapping Catalyst–Solvent Interplay in Competing Carboamination/Cyclopropanation Reactions

Group 9 metals, in particular Rh^III complexes with cyclopentadienyl ligands, are competent C−H activation catalysts. Recently, a Cp*Rh^III-catalyzed reaction of alkenes with N-enoxyphthalimides showed divergent outcome based on the solvent, with carboamination favored in methanol and cyclopropanation in 2,2,2-trifluoroethanol (TFE). Here, we create selectivity and activity maps capable of unravelling the catalyst-solvent interplay on the outcome of these competing reactions by analyzing 42 cyclopentadienyl metal catalysts, Cp^XM^III (M=Co, Rh, Ir). These maps not only can be used to rationalize previously reported experimental results, but also capably predict the behavior of untested catalyst/solvent combinations as well as aid in identifying experimental protocols that simultaneously optimize both catalytic activity and selectivity (solutions in the Pareto front). In this regard, we demonstrate how and why the experimentally employed Cp*Rh^III catalyst represents an ideal choice to invoke a solvent-induced change in reactivity. Additionally, the maps reveal the degree to which even perceived minor changes in the solvent (e. g., replacing methanol with ethanol) influence the ratio of carboamination and cyclopropanation products. Overall, the selectivity and activity maps presented here provide a generalizable tool to create global pictures of anticipated reaction outcome that can be used to develop new experimental protocols spanning metal, ligand, and solvent space.     

Solvent‐Free Synthesis of Benzothiazolines in the Presence of Alumina

o‐Aminothiophenol reacted with ketones and β‐keto esters in the presence of alumina under mild and solvent‐free conditions to afford the corresponding benzothiazolines in high yields. Alumina can be reused for subsequent reactions without any loss of the activity.     

Microwave‐Assisted Synthesis of Amide under Solvent‐free Conditions

An efficient and environmentally friendly synthetic method for the synthesis of primary amides under microwave irradiation was described, in which the primary amine was directly reacted with acid without any catalytic agents. The reaction took place in 8–12 min, which was much shorter than the traditional synthetic methods, with almost quantitative yields. The influential factor of the reaction was discussed. The tautomerization between the carboxylic acid group and the H atom in α‐carbon of L‐amino acid was observed, presumably a dehydrated intermediate forming from this tautomerized isomer.     

Can Dispersion Forces Govern Aromatic Stacking in an Organic Solvent?

Experimental support for the dominance of van der Waals dispersion forces in aromatic stacking interactions occurring in organic solution is surprisingly limited. The size‐dependence of aromatic stacking in an organic solvent was examined. The interaction energy was found to vary by about 7.5 kJ mol^?1 on going from a phenyl–phenyl to an anthracene–pyrene stack. Strikingly, the experimental data were highly correlated with dispersion energies determined using symmetry‐adapted perturbation theory (SAPT), while the induction, exchange, electrostatic, and solvation energy components correlated poorly. Both the experimental data and the SAPT‐dispersion energies gave high‐quality correlations with the change in solvent accessible area upon complexation. Thus, the size‐dependence of aromatic stacking interactions is consistent with the dominance of van der Waals dispersion forces even in the presence of a competing polarizable solvent.