一种新型自激发布里渊掺铒光纤激光器

利用级联的受激布里渊效应,自激发布里渊掺铒光纤激光器可以实现常温下的多波长激光输出。通过在自激发掺铒光纤激光器中引入一个高双折射萨尼亚克(Sagnac)环形滤波器,调节萨尼亚克环形滤波器的偏振控制器(PC),实现了可调谐多波长输出,同时在实验中观测到双布里渊多波长带的现象。研究了这种光纤激光器中萨尼亚克环形滤波器的带宽和980 nm抽运光功率对输出波长数的影响,在萨尼亚克环形滤波器的带宽为83.3 nm以及980 nm抽运光功率为260 mW时,得到了52个间隔为0.088 nm的多波长激光输出。     

单纵模布里渊掺铒光纤激光器的实验研究

提出了一种具有多环形腔(MRC)和光纤布拉格光栅可调谐滤波器(FBG-TF)相结合的单纵模布里渊掺铒光纤激光器(BEDFL).实验中通过观察激光器输出光的拍频信号分析其光谱精细结构,分别讨论了布里渊增益、FBG-TF、MRC对BEDFL单模输出的贡献,给出了激光器的功率特性曲线和波长稳定性测试图.实验得到了在1550 nm处功率为4 dBm,信噪比(SNR)>60 dB,线宽小于1.5 kHz的稳定单纵模输出光.     

四波混频增强多波长布里渊掺铒光纤激光器的实验研究

提出一种利用四波混频增强多波长布里渊掺铒光纤激光器的方法,在激光器中使用色散位移光纤作为布里渊增益介质,通过布里渊多波长之间四波混频效应提供的参变增益展宽激光器的有效增益谱,产生高阶斯托克斯光和反斯托克斯光,增加多波长的数目并改善输出功率.分析了激光器中掺铒光纤放大器功率和布里渊抽运功率对四波混频增强效果的影响,在98...     

掺铒石英光纤中的受激布里渊散射

本文报导用染料调Ｑ红宝石激光（波长λ＝６９４．３ｎｍ）泵浦掺Ｅｒ３＋石英光纤进行的受激布里渊散射（ＳＢＳ）实验研究。测量了受激布里渊散射频移，计算出掺铒石英光纤的体压缩系数。探讨了掺铒光纤中的受激布里渊散射的应用前景。     

布里渊-掺铒光纤随机光纤激光器输出特性分析

设计了一种基于受激布里渊散射和掺铒光纤混合增益的随机光纤激光器,该激光器选用两段长为20km的单模光纤组成全开放腔结构,利用单模光纤的瑞利散射提供随机光反馈.研究表明,固定布里渊泵浦波长和泵浦功率分别为1 550.00nm和2.19mW时,增加掺铒光纤泵浦功率,可以实现两个波长的随机激光输出,一阶和二阶受激布里渊散射光与布里渊泵浦光波长间隔分别约为0.088nm和0.174nm,产生一阶和二阶受激布里渊散射对应的掺铒光纤泵浦功率分别为190mW和370mW;当掺铒光纤泵浦功率为433mW时,激光器两端的最大输出功率为1.60mW和1.68mW.当掺铒光纤泵浦功率明显高于阈值功率时,获得的一阶和二阶随机激光输出稳定,3dB线宽约为0.022nm,峰值强度和位置基本不随时间而变化.     

间隔0.173nm的可调谐多波长布里渊掺铒光纤激光器

使用四端口环行器和可调谐滤波器,设计了一种间隔为双倍布里渊频移的多波长布里渊掺铒光纤激光器.该光纤激光器中使用的四端口环形器可以限制奇次阶斯托克斯光在腔内循环并耦合输出初始泵浦光和偶次阶斯托克斯光,而可调滤波器抑制环形腔所形成的自激振荡模,增加了激发多波长激光的功率,从而增加多波长输出个数及其调谐范围.在布里渊泵浦功率为8dBm、980nm泵浦功率为279mW时,实验获得波长间隔为0.173nm的6个波长的激光输出,输出激光的可调谐范围为28nm.     

基于受激布里渊散射的波长间隔可变多波长光纤激光器

提出了一个基于自激发受激布里渊散射的波长间隔可变多波长光纤激光器.利用单模光纤中自激发产生的非线性布里渊增益和掺铒光纤的线性增益组成混合增益光纤激光器,从而使光纤激光器在室温下产生稳定的多波长输出.改变双折射光纤环镜滤波器中保偏光纤的长度,可以实现波长间隔可变多波长激光产生,提高了多波长光纤激光器操作的灵活性和实用性.实验实现了波长间隔从0.8 nm至0.076 nm可变的多波长激光产生,波长数随波长间隔减小而增加,间隔为0.08 nm的激光波长数达86.     

基于受激布里渊散射的波长间隔可变多波长光纤激光器

提出了一个基于自激发受激布里渊散射的波长间隔可变多波长光纤激光器.利用单模光纤中自激发产生的非线性布里渊增益和掺铒光纤的线性增益组成混合增益光纤激光器,从而使光纤激光器在室温下产生稳定的多波长输出.改变双折射光纤环镜滤波器中保偏光纤的长度,可以实现波长间隔可变多波长激光产生,提高了多波长光纤激光器操作的灵活性和实用性.实验实现了波长间隔从0.8nm至0.076nm可变的多波长激光产生,波长数随波长间隔减小而增加,间隔为0.08nm的激光波长数达86.     

掺饵石英光纤中的受激布里渊散射

本文报导用染料调Ｑ红宝石激光（波长λ＝６９４．３ｎｍ）泵浦掺Ｅｒ＾３＋石英光纤进行的受激布里渊散射（ＳＢＳ）实验研究，测量了受激布里渊散射频，计算出掺饵石英光纤的体压缩系数，探讨了掺饵光纤中的受激布里渊散射的应用前景。     

全光纤色散腔掺铒光纤激光器

报道用９７１ｎｍ半导体激光器泵浦的掺铒光纤激光器的一些实验研究结果。演示了由光纤环反射器和光纤光栅构成的全光纤色散掺铒光纤激光器，在１．５５μｍ波段获得了线宽小于０．０５ｎｍ的激光输出。     

An Efficient Photonic Crystal Fiber-Based Brillouin Erbium Fiber Laser Using a Fiber Bragg Grating for Multi-Wavelength Generation

Abstract

An efficient multi-wavelength Brillouin erbium fiber laser is demonstrated using an improved configuration with a broadband fiber Bragg grating and a piece of photonic crystal fiber. The laser generates more than 55 lines of optical comb with a line spacing of approximately 0.09 nm in a 1,565-5 nm region using pump powers of 3 dBm and 150 mW for the Brillouin and 980-nm pumps, respectively. The Brillouin erbium fiber laser with a fiber Bragg grating's reflectivity of 50% obtained a higher number of comb lines compared to that of 99% reflectivity.     

Modeling of Multi-Wavelength Brillouin Fiber Laser Based on Analytical Solutions in a Linear Cavity

Abstract

In this article, an accurate model of multi-wavelength Brillouin fiber laser is developed by analytically solving cascade-stimulated Brillouin scattering equations in a linear cavity. The dependence of Stokes signal power on the incident pump power and the successive reflected transmitted powers is calculated. Furthermore, an analytical approach that can be used to predict the generated Stokes signals power is derived. Finally, this derived model is checked with experimental results that show significant agreement with the analytical solution of the model.     

Two-Frequency Brillouin Fiber Laser Controlled by Temperature Difference in Fiber Ring Resonator

A Brillouin fiber laser (BFL) consisting of a fiber ring resonator with different fiber temperatures emits two-frequency light output. The two-frequency BFL yields an optical beat output which can be utilized as an optical frequency shifter. The output beat frequency is controllable by the temperature difference in the fiber ring resonator and changes with a step of a resonant frequency interval of BFL. The temperature dependence of the BFL output frequency was 2.4 MHz/°C. The stability of the output beat frequency to the temperature fluctuation was estimated as 1.04°C/2.5 MHz.     

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

A novel and simple two-frequency Brillouin fiber laser is presented. It is based on a fiber Fabry-Perot cavity with fiber Bragg gratings as reflectors. The model of stimulated Brillouin scattering in fiber grating-based Fabry-Perot resonator is investigated. The laser allows conversion efficiency of close to 100% and suppresses the higher-order Stokes waves. The theoretical prediction is presented and the experimental demonstration is realized.     

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

Abstract

A novel and simple two-frequency Brillouin fiber laser is presented. It is based on a fiber Fabry-Perot cavity with fiber Bragg gratings as reflectors. The model of stimulated Brillouin scattering in fiber grating–based Fabry-Perot resonator is investigated. The laser allows conversion efficiency of close to 100% and suppresses the higher-order Stokes waves. The theoretical prediction is presented and the experimental demonstration is realized.     

光纤光栅梳状滤波器及其在新型可选波长激光器中的应用

对现有在同～段光纤上多次写入光栅制成光栅梳状滤波器的方法进行了改进,利用增加光栅长度,精确控制不同光栅的曝光时间,并结合调整光栅实际写入长度的方法,制成了不均衡度小于5％、最低峰值反射率高于95％的光纤光栅梳状滤波器;同时提出了一种新颖的可选波长光纤激光器结构。采用由上述方法制作出的反射率均衡的光纤光栅梳状滤波器和可调光滤波器结合在一起进行波长选择,实现了波长的快速准确选择,同时各个波长激光的输出特性稳定,功率均衡性好,边模抑制比大于50dB。     

Dynamics of Stimulated Brillouin Scattering in a Short and High-Finesse Fiber Fabry-Perot Resonator

We theoretically investigate the dynamics of stimulated Brillouin scattering (SBS) in a short fiber Fabry-Perot resonator with reflection mirrors. The analysis is based on the coherent six-wave model including an optical Kerr effect and the linear cavity detunings for the pump and created Stokes waves are taken into account in the formulation. The instabilities including periodic, quasi-periodic and chaotic oscillations can occur owing to the Kerr effect even if the fiber resonator is so short as to ensure a single longitudinal-mode operation. The threshold power for SBS and the boundary power between the stable and unstable regions are numerically calculated as a function of the amplitude reflectance of mirrors for different cavity detunings. The dynamics of SBS and these two critical powers depend on the amplitude reflectance and the cavity detuning. Although an increase in the mirror reflectance decreases the threshold power for SBS, it may limit the utility of SBS since the stable region is narrow and the output power levels of the pump and Stokes waves are low.