硫代硫酸钠滴定法测定铜铟镓硒太阳能靶材中硒

建立了测定铜铟镓硒太阳能靶材中硒的硫代硫酸钠滴定法.用硝酸– 盐酸混合液(3:1)在低温加热条件下消解铜铟镓硒靶材样品,在盐酸介质中,用亚硫酸将亚硒酸还原为单质硒沉淀与其它杂质分离,用酸溶解沉淀,在硫酸介质中,加入碘化钾,以淀粉作指示剂,用硫代硫酸钠标准溶液滴定,计算硒的含量.该方法适合质量分数为30％～70％的硒的测...     

自动电位滴定法测定磺酸盐合成及产品中硫酸钠

石油系磺酸盐合成及产品 (如凝土外加剂 )中硫酸盐的测定 ,对控制磺酸盐质量具有重要意义。目前 ,磺酸盐产品中硫酸盐测定多采用“混凝土外加剂匀质性试验方法”中硫酸钡重量法或离子交换重量法[1 ] ,此法手续繁琐 ,尤其是费时 ,周期约 48ｈ ,难以满足生产特别是工艺开发阶段条件试验时调整工艺参数的要求。用铅离子作滴定剂 ,铅离子选择性电极为指示电极 ,电位滴定法测定硫酸盐是一种比较可靠的方法 ;用于磺酸盐中硫酸盐的分析 ,目前尚未见报道。作者运用计算机控制的自动电位滴定法[2 ] ,选择了适合在磺酸盐中进行测定的滴定介质、酸度、…     

Gran's plot titration and flow injection titration of sulfate in ground and drinking water with a barium ion-selective electrode

The application of a barium ion-selective electrode for the determination of sulfate is reported. Titrations in the batch mode using the Gran's plot method [1] have been carried out. In the presence of a lithium acetate buffer and after the addition of isopropanol it has been possible to determine sulfate with a relative standard deviation (RSD) of 1.5%. The concentration range of the samples was 5–400 mg sulfate/l. Interfering ions were separated by cation-exchange. This indirect titration constituted the basis of a flow injection titration (FIA titration) system for the continuous determination of sulfate. By plotting the peakwidth vs. the logarithm of the sulfate concentration of the injected samples, linear calibration graphs in the range of 50–200 mg sulfate/l were obtained. In this system, the sample stream was pumped through an ion-exchange column, mixed with a buffer stream of lithium acetate and injected in a reagent stream of a BaCl₂ solution. The resulting free Ba(II) concentration was monitored with a barium ion-selective electrode. The content of sulfate in ground and drinking water samples has been determined with a RSD between 1.2% and 1.3%.     

Determination of water in thiols by Karl Fischer titration

Water in thiol-containing samples may be determined by titration with Karl Fischer reagent after conversion of the thiol into a thioether. Both acrylonitrile and N-ethylmaleimide have been found to be suitable reagents.     

Determination of tetracyclines in surface water and milk by the magnesium hydroxide coprecipitation method

A simple coprecipitation method was developed for the determination of tetracyclines (TCs) in surface water and milk by high-performance liquid chromatography with diode-array detection (HPLC–DAD). Magnesium ion was added into the surface water or the acetonitrile (MeCN) extract of milk. After alkalinization, magnesium hydroxide precipitates which had been formed can be separated from the matrix solution easily by centrifuging and then a dissolution step was performed by adding a small amount of acid. The final solution could be introduced directly into HPLC system for the determination of the analytes. Under optimal conditions, recoveries for the analysis of spiked surface water samples ranged from 83.6% to 95.1% with relative standard deviation of 2.0–5.5%. For milk samples, relative recoveries were 95.9–104.6% with relative standard deviation of 3.4–6.7%. The enrichment factors ranged from 41.5 to 48.1 for 10 mL water samples, and from 3.6 to 4.4 for 1 mL MeCN extracts of milk. Limits of detection ranged from 0.13 to 0.51 ng/mL, and from 3.0 to 8.5 ng/g for four TCs in surface water and milk samples, respectively.     

Potentiometric titration of hydroxide,aluminate and carbonate in sodium aluminate solutions

An automated potentiometric titration of hydroxide, aluminate and carbonate in sodium aluminate solutions is described. The addition of barium chloride before titration with hydrochloric acid enables the three components to be determined in one run, involving neutralization of hydroxide, protonation of aluminate and dissolution of barium carbonate. The accuracy and precision of the method are satisfactory for a rapid method used for control of aluminum oxide production.     

Determination of solutions density by the dilatometric titration method

A new approach to the determination of solutions density based on dilatometric titration data was developed. The results of testing this method by the example of dilution of a sodium chloride solution are presented. The method allows density of solutions to be determined with a high accuracy (±1×10^?5 g cm^?3) in a wide concentration range in the course of a single experiment.     

Determination of aniline in environmental water samples by alternating-current oscillopolarographic titration

A new method for the determination of aniline in environmental water based on oscillopolarographic titration was presented in this paper. Several factors including the kind, concentration, and volume of acid, the dosage of potassium bromide, the temperature and concentration of concomitant substances were investigated in detail. The experimental results indicated that this method was simple, rapid, and sensitive. The linear range was 8.367×10-4 to 2.789×10-2 mol L-1, the relative standard deviation (R.S.D.) was lower than 0.96%, and the spiked recoveries of aniline in environmental water samples were in the range of 99.4-106.9% under the optimal conditions. The results indicated that the present method could be used as an alternative method for aniline determination in realworld water samples.     

Determination of glyphosate in water samples by alternating-current oscillopolarographic titration.

This paper describes a novel, simple and sensitive method for the determination of glyphosate in water samples by alternating-current oscillopolarographic titration. Under an acidic condition, glyphosate can be transferred into a nitrosocompound by reacting with NaNO2. The titration end-point was obtained by the formation of a sharp cut in the oscillopolarographic with infinitesimal NaNO2 on double platinum electrodes. The results showed that glyphosate had an excellent linear relationship over the range of 7.16 x 10(-6) - 4.14 x 10(-3) mol L(-1), the RSD of the proposed method was lower than 3%, and the spiked recoveries of three real water samples were in the range of 97.7 - 100.2%.     

Determination of phenytoin sodium injection and tablets by highly accurate nephelometric titration

A highly accurate nephelometric titration method was developed for the quantitative analysis of phenytoin sodium injection and tablets. The titration operating conditions and the validation of the method were studied. Five batches of phenytoin sodium injection and tablets were determined by the proposed method and the control experiment methods, respectively. The results of the titration are comparable to those of control experiments. The proposed method is accurate and reproducible, which is considered suitable for the quantitative analysis of a large number of samples.     

Microcomputer-aided high-speed potentiometric titration system by linear titration plots

Summary An apparatus for high-speed potentiometric titration was assembled and its advantage was demonstrated. Titrant additions were made stepwise in large volumes. The optimum increment volumes were automatically chosen by microcomputer, depending upon the sample concentration. Time intervals between the successive additions were controlled so as to add a new increment immediately after the electrode was equilibrated. On-line calculation of the equivalence volume was conducted based upon linear titration plots, using only four titration points before the equivalence point. The apparatus was capable of determining the concentration of strong and weak monoprotic acids in less than 22s with relative standard deviations of 0.1–0.2%.

---

Potentiometrisches Titrationssystem hoher Geschwindigkeit, das auf linearen Titrationskurven beruht und mit einem Mikrocomputer arbeitet

Zusammenfassung Der Aufbau des Geräts wird beschrieben und seine Vorzüge werden diskutiert. Die Zugabe des Titrationsmittels erfolgt stufenweise in großen Anteilen. Die optimalen Volumina werden automatisch je nach Konzentration von einem Mikrocomputer bestimmt. Die Zeitintervalle zwischen den Zugaben werden so gesteuert, daß jeweils nach Gleichgewichtseinstellung der Elektrode eine neue Zugabe erfolgt. Aufgrund linearer Eichkurven erfolgt die online Berechnung des Äquivalenzvolumens, wobei nur vier Titrationspunkte vor dem Äquivalenzpunkt verwendet werden. Mit Hilfe des Gerätes können starke und schwache monoprotische Säuren in weniger als 22 s mit einer relativen Standardabweichung von 0,1–0,2% bestimmt werden.

     

流动注射化学发光抑制法测定阿魏酸钠

提出了Fe2+-H2O2-亚甲基蓝化学发光新体系并用于阿魏酸钠的测定。实验发现,在酸性介质中,Fe2+-H2O2体系可与亚甲基蓝反应产生极强的化学发光,阿魏酸钠对此化学发光具有显著的抑制作用。据此,结合流动注射技术,建立了阿魏酸钠化学发光分析新方法。研究了影响化学发光强度的因素,化学发光信号的降低值(ΔI)与阿魏酸钠浓度在4.5×10-6～4.5×10-5mol/L范围内呈良好的线性关系,方法的检出限为7.0×10-7mol/L。对4.8×10-6mol/L的阿魏酸钠进行了11次平行测定,其RSD=0.8%,该法已用于片剂中阿魏酸钠含量的测定。     

全自动间断化学分析法测定锅炉水中磷酸根离子

建立全自动间断化学分析法测定锅炉水中磷酸根离子含量的方法.样品加入量为90μL,钼酸铵和酒石酸锑钾酸性混合溶液(R1)加入量为160μL,抗坏血酸溶液(R2)加入量为470μL,加入R1反应时间为50 s,加入R2反应时间为300 s,检测波长为880 nm,采用稀释模式检测.磷酸根离子的质量浓度在5～50 mg/L范...     

Determination of water in zeolites by a neutron reflection method

Water content in zeolites has been determined by an improved neutron reflection method using a Pu-Be neutron source of 10⁶ n·s^–1 intensity and a BF₃ counter. It was found that the water content of different types of zeolites collected in Hungary varies between 9 and 12 wt.%. The standard deviation of the determination does not exceed 0.5 wt.%. The matrix effect on the sensitivity and accuracy was also studied. An approximate relation is given between the count rate and the neutron physical parameters of the samples.     

EDTA滴定法测定分银渣中的铅含量

采用氟化铵-盐酸-硝酸-高氯酸溶解样品,加入氢溴酸除去样品中的砷、锑、锡等共存元素,加入硫酸将样品中的铅转化为硫酸铅沉淀,通过过滤与其它元素分离,滴定前加入巯基乙酸掩蔽铋,在乙酸-乙酸钠缓冲体系下,以二甲酚橙为指示剂,建立了采用EDTA络合滴定法测定分银渣中铅含量的方法。实验方法用于测定分银渣中的铅含量,测定结果的相对标准偏差(RSD,n=11)为0.32%～0.90%,加标回收率为100%～102%。能够满足日常测定需求。     

Determination of lead in paints by electro-oxidation in cationic surfactant—aqueous sodium hydroxide suspensions

It was shown that anodic voltammetry can be used to determine lead in paint samples by solubilizing the sample in an aqueous solution using a cationic surfactant (Hyamine 2389, prdominantly methyldodecylbenzyltrimethylammonium chloride). In addition to solubilizing the solid paint particles, the cationic surfactant increased the oxidation potential of water to the point where one could observe, in concentrated sodium hydroxide solutions, an anodic peak for the oxidation of lead monoxide to lead dioxide. If the surfactant was below the critical micelle concentration, the height of the peak was linearly proportional to the concentration of lead oxide in the paint. The technique was experimentally verified by comparing the concentration of lead in a commercial paint sample, as determined by x-ray fluorescence, with the concentration determined voltammetrically.