The radiation impedance of a baffled piston source

The problem of a vibrating disk set in a finite, rigid, concentric baffle is reduced to the solution of a Fredholm integral equation of the second kind. The acoustic radiation impedance is computed from the numerical solution of this equation and results tabulated for values of (wavenumber × disk radius) between 0·2 and 2·0.     

Quantum chaos for the radially vibrating spherical billiard

The spherical quantum billiard with a time-varying radius, a(t), is considered. It is proved that only superposition states with components of common rotational symmetry give rise to chaos. Examples of both nonchaotic and chaotic states are described. In both cases, a Hamiltonian is derived in which a and P are canonical coordinate and momentum, respectively. For the chaotic case, working in Bloch variables (x,y,z), equations describing the motion are derived. A potential function is introduced which gives bounded motion of a(t). Poincare maps of (a,P) at x=0 and the Bloch sphere projected onto the (x,y) plane at P=0 both reveal chaotic characteristics. (c) 2000 American Institute of Physics.     

Active vibration control on a quarter-car for cancellation of road noise disturbance

In this paper, a methodology is presented for the cancellation of road noise, from the analysis of vibration transmission paths for an automotive suspension to the design of an active control system using inertial actuators on a suspension to reduce the vibrations transmitted to the chassis. First, experiments were conducted on a Chevrolet Epica LS automobile on a concrete test track to measure accelerations induced on the suspension by the road. These measurements were combined with experimental Frequency Response Functions (FRFs) measured on a quarter-car test bench to reconstruct an equivalent three dimensional force applied on the wheel hub. Second, FRFs measured on the test bench between the three-dimensional driving force and forces at each suspension/chassis linkage were used to characterize the different transmission paths of vibration energy to the chassis. Third, an experimental model of the suspension was constructed to simulate the configuration of the active control system, using the primary (disturbance) FRFs and secondary (control) FRFs also measured on the test bench. This model was used to optimize the configuration of the control actuators and to evaluate the required forces. Finally, a prototype of an active suspension was implemented and measurements were performed in order to assess the performance of the control approach. A 4.6 dB attenuation on transmitted forces was obtained in the 50–250 Hz range.     

Target enhancement and noise cancellation in the identification of a rudimentary sound source in noise

Perturbation analysis was used to determine the relative contribution of target enhancement and noise cancellation in the identification of rudimentary sound source in noise. In a two-interval, forced-choice procedure, listeners identified the impact sound produced by the larger of two stretched membranes as target. The noise on each presentation was the impact sound of a variable-sized plate. For four of five listeners, the relative weights on the noise were positive indicating enhancement, and for the remaining listeners, they were negative indicating cancellation. The results underscore the difficulty with evaluating models of masking solely in terms of measures of performance accuracy.     

Spatial impulse responses from a flexible baffled circular piston

The theory of orthogonal polynomial (Zernike) expansions of functions on a disk, as used in the diffraction theory of optical aberrations, is applied to obtain (semi-) analytical expressions for the spatial impulse responses arising from a non-uniformly moving, baffled, circular piston. These expressions are in terms of the expansion coefficients of the non-uniformity and the responses of the orthogonal expansion functions. The latter impulse responses have a closed form as finite series involving the Legendre functions and the sinc function. The method is compared with a similar method, proposed by P. R. Stepanishen [J. Acoust. Soc. Am. 70, 1176-1181 (1981)] where zeroth order orthogonal Bessel functions, rather than Zernike polynomials, are used as expansion functions.     

基于经验模式分解的拖曳式声纳拖船噪声抵消研究

拖曳式线列阵声纳的拖船噪声具有多途角扩展等特点，并且是一个非平稳过程，使得对该噪声的消除或抑制是一大难点。经验模式分解是一种用于分析非线性非平稳信号的新方法，该方法自适应地将嵌于数据内部的多个固有模式函数逐一分解开来。本文尝试利用经验模式分解方法分离出水听器接收信号中的拖船干扰噪声，从而达到消除干扰的目的。海上试验数据的处理结果充分验证了这种方法的可行性。     

有源噪声控制的一种变换域算法

有源噪声控制广泛应用于中低频噪声控制中。传统的有源控制都是在时域内使用LMS算法进行控制，由于LMS算法的收敛速度跟输入信号的自相关矩阵特征值分布有关，当特征值分布较大时，LMS算法的收敛速度会变的很慢。本文使用离散余弦变换(DCT)技术，在变换域内进行有源噪声控制的研究，同时考虑了变换域约束。仿真表明算法的有效性。     

Active noise control with linear control source and sensor arrays for a noise barrier

A study is conducted on minimizing the sum of the squared acoustic pressures with a linear array of control sources and a perpendicular linear array of error sensors, placed above the top of a noise barrier. Particular angular orientations, with respect to the center of the barrier top, and spacings of the linear arrays of control sources and error sensors result in moderate to significant additional reduction of the acoustic pressure in the shadow zone. Visual inspection of the sound pressure field, with and without active noise control, found that uniform and significant additional insertion loss can be generated near the barrier. Numerical simulations were conducted to test the proposed method. For separations between control sources and error sensors much less than a quarter wavelength of the primary noise disturbance, results show that the angular orientation, of the combined linear control source and sensor arrays, is a weak factor for acoustic pressure reduction in the shadow zone. Weak angle dependence serves as an advantage to the proposed method, which yields uniform performance for any angular orientation. An angular orientation involving the alignment of the furthest error sensor with the first diffracting edge of the barrier and the primary source was observed to perform well for a variety of frequencies, since the spacing between error sensors and between control sources is of the order of a quarter-wavelength. Improved noise control in the shadow zone of a barrier is achieved by the use of two control sources and angular orientation as mentioned above. Further spatial extension of the area of reduced acoustic pressure is possible by utilizing an increased number of control sources.     

Background noise cancellation of manatee vocalizations using an adaptive line enhancer

The West Indian manatee (Trichechus manatus latirostris) has become an endangered species partly because of an increase in the number of collisions with boats. A device to alert boaters of the presence of manatees is desired. Previous research has shown that background noise limits the manatee vocalization detection range (which is critical for practical implementation). By improving the signal-to-noise ratio of the measured manatee vocalization signal, it is possible to extend the detection range. The finite impulse response (FIR) structure of the adaptive line enhancer (ALE) can detect and track narrow-band signals buried in broadband noise. In this paper, a constrained infinite impulse response (IIR) ALE, called a feedback ALE (FALE), is implemented to reduce the background noise. In addition, a bandpass filter is used as a baseline for comparison. A library consisting of 100 manatee calls spanning ten different signal categories is used to evaluate the performance of the bandpass filter, FIR-ALE, and FALE. The results show that the FALE is capable of reducing background noise by about 6.0 and 21.4 dB better than that of the FIR-ALE and bandpass filter, respectively, when the signal-to-noise ratio (SNR) of the original manatee call is -5 dB.     

AC shot noise through a vibrating quantum dot

In this paper we investigate the joint effects of the electron-phonon interaction and an external alternating (ac) gate voltage on the spectral density of shot noise through a vibrating quantum dot system, by applying the Lang-Firsov canonical transformation and the Keldysh nonequilibrium Green's function (NGF) technique. We find that the effects of the electron-phonon and electron-photon interaction on the differential shot noise are different. The main resonant peak of the differential shot noise is decreased only when a time-dependent gate voltage is imposed on quantum dot. With the ac field amplitude increasing, the main resonant peak of the differential shot noise decreases. The Fano factor of the system, which exhibits the deviation of shot noise from the Schottky formula, is also studied. Super-Poissonian shot noise appears due to the photon absorption (emission) processes in the low bias voltage region.     

Image noise cancellation using linear matrix inequality and cellular neural network

In this paper, the technique of image noise cancellation is presented by employing cellular neural networks (CNN) and linear matrix inequality (LMI). The main objective is to obtain the templates of CNN by using a corrupted image and a corresponding desired image. A criterion for the uniqueness and global asymptotic stability of the equilibrium point of CNN is presented based on the Lyapunov stability theorem (i.e., the feedback template “A” of CNN is solved at this step), and the input template “B” of CNN is designed to achieve desirable output by using the property of saturation nonlinearity of CNN. It is shown that the problem of image noise cancellation can be characterized in terms of LMIs. The simulation results indicate that the proposed method is useful for practical application.     

球谐域自适应混响抵消与声源定位算法

提出了一种基于球谐域的自适应混响抵消与声源定位算法,该方法通过去混响处理改善语音质量,并提高球谐域定位算法在混响环境下的定位性能。推导了基于多通道线性预测的自适应混响抵消算法在球谐域的表达式,针对刚球模型提出分阶处理的去混响方法,并对去混响后的信号进行波达方向估计。采用32元球阵的仿真结果表明,相比于球谐域不分阶去混响方法,该方法最大可减少约2/3的运算量,同时语音PESQ得分及SRMR均显著提高。利用实验数据对算法性能进行测试,实验结果验证了该方法在实际声学环境中去混响和声源定位的有效性。     

Numerical and experimental study of Near-Field Acoustic Radiation Modes of a baffled spherical cap

In this paper, the Acoustic Radiation Modes (ARMs) of spherical structures are studied using the Pressure-Velocity (PV) method. This method yields the active and reactive modes, which refer to the radiated and non-radiated sound power components respectively, without restrictions on the observation distance. The accuracy of the method is verified through the analysis of Near Field ARMs (NFARMs) of a sphere in spherical coordinates compared to the analytical solution. Differences are analyzed between the NFARMs and the Far Field ARMs (FFARMs) of a baffled spherical cap, as well as between the active and reactive parts of the sound power radiated when varying the frequency and the observation distance to the source. It was found that the radiation efficiency of the active ARMs is independent of the observation distance, while that of reactive ARMs decreases sharply when retreating from the source. Experiments were performed using the acoustic reciprocity principle to measure the NFARMs and FFARMs of a 3D-printed spherical cap radiating in a hemi-anechoic room. Experimental results provided a reliable validation of the numerical results.     

Toward a spherical spot distribution with 4pi focusing of radially polarized light

The properties of the focal spot for 4pi focusing with radially polarized light are presented for various apodization factors. With a focusing system satisfying the Herschel condition, sharp focal spots with almost-perfect spherical symmetry (leading to equal axial and transverse resolution) and extremely low sidelobes are achieved.     

Reduction of radiated exterior noise from the flexible vibrating plate of a rectangular enclosure using multi-channel active control

This study attempted to control the radiated exterior noise from a rectangular enclosure in which an internal plate vibrates by acoustic excitation and noise is thus radiated from that plate. Multi-channel active control was applied to reduce the vibration and external radiation of this enclosed plate. A piezoelectric ceramic was used as a distributed actuator for multiple mode control of the vibration and radiated noise in the acoustically excited plate. To maximize the effective control, an approach was proposed for attachment the piezoelectric actuator in the optimal location. The plate and internal acoustic space in the enclosure are coupled with each other. This will change dominant frequency characteristics of the plate and, thus, those of the externally radiated noise. Active noise control was accomplished using an accelerometer attached to the plate and a microphone placed adjacent to that plate as an error sensor under acoustic excitation of sine wave and white noise. It was found that the control of radiated external radiation noise requires a microphone as an error sensor, a sound pressure sensor due to vibration of the plate, differences in the dominant frequency of externally radiated noise, and complex vibration modes of the plate.     

Sound field of a baffled sound source covered by an anisotropic rigid-porous material

A theoretical approach for the sound field of a piston sound source covered by a finite thickness layer of anisotropic rigid-porous material is presented. The formulation is an extension of the method worked out by Amedin et al. [Sound field of a baffled piston source covered by a porous medium layer. J Acoust Soc Am 1995;98(3):1757]. First, in the present study the sound field of a point source is described by cylindrical waves. Then, with the proper boundary conditions, the sound pressure radiated from a piston source covered by a layer of anisotropic porous material can be calculated. The effects of frequency and bulk density of material on the sound propagation in an anisotropic porous material are studied. Finally, the effect of anisotropy is discussed.     

Active control of radiation from a piston set in a rigid sphere

Active control of the sound radiated from a piston set in a rigid sphere with a set of control point sources around is considered in this paper, where the scattering sound field of the control sound from the rigid sphere has been taken into account to minimize the total radiated sound power. Analytic results of the sound power are obtained and numerical simulations show that it is possible to reduce the radiation from a small piston set in a rigid sphere similar to the size of a human head up to a certain frequency. It is found that the introduction of the scattering object makes significant differences from the active control without scattering objects. This being the case, the scattering object makes the active noise control easier. To increase the global reduction of sound-power output, the optimal number and locations of the control sources and the optimal number and locations of error sensors are discussed. Finally, experiments with one control source and one error sensor around a head simulator have been carried out to verify the simulation results.