In-plane free vibration and stability of loaded and shear-deformable circular arches

The first known equations governing vibrations of preloaded, shear-deformable circular arches are derived according to a variational principle for dynamic problems concerning an elastic body under equilibrium initial stresses. The equations are three partial differential equations with variable coefficients. The governing equations are solved for arches statically preloaded with a uniformly distributed vertical loading, by obtaining a static, closed-form solution and an analytical dynamic solution from series solutions and dynamic stiffness matrices. Convergence to accurate results is obtained by increasing the number of elements or by increasing both the number of terms in the series solution and the number of terms in the Taylor expansion of the variable coefficients. Graphs of non-dimensional frequencies and buckling loads are presented for preloaded clamped arches. They clarify the effects of opening angle and thickness-to-radius ratio on vibration frequencies and buckling loads. The effects of static deformations on vibration frequencies are also investigated. This work also compares the results obtained from the proposed governing equations with those obtained from the classical theory neglecting shear deformation.     

钢管混凝土圆弧桁架拱平面内徐变稳定分析

核心混凝土的徐变会增加钢管混凝土拱肋的屈曲前变形,降低结构的稳定承载力,因此只有计入屈曲前变形的影响,才能准确得到钢管混凝土拱的徐变稳定承载力。基于圆弧形浅拱的非线性屈曲理论,采用虚功原理,建立了考虑徐变和剪切变形双重效应的管混凝土圆弧桁架拱的平面内非线性平衡方程,求得两铰和无铰桁架拱发生反对称分岔屈曲和对称跳跃屈曲的徐变稳定临界荷载。探讨了钢管混凝土桁架拱核心混凝土徐变随修正长细比、圆心角和加载龄期对该类结构弹性稳定承载力的影响,为钢管混凝土桁架拱长期设计提供理论依据。     

In-plane buckling of prismatic funicular arches with shear deformations

The in-plane buckling behavior of funicular arches is investigated numerically in this paper. A finite strain Timoshenko beam-type formulation that incorporates shear deformations is developed for generic funicular arches. The elastic constitutive relationships for the internal beam actions are based on a hyperelastic constitutive model, and the funicular arch equilibrium equations are derived. The problems of a submerged arch under hydrostatic pressure, a parabolic arch under gravity load and a catenary arch loaded by overburden are investigated. Buckling solutions are derived for the parabolic and catenary arch. Subsequent investigation addresses the effects of axial deformation prior to buckling and shear deformation during buckling. An approximate buckling solution is then obtained based on the maximum axial force in the arch. The obtained buckling solutions are compared with the numerical solutions of Dinnik (Stability of arches, 1946) [1] and the finite element package ANSYS. The effects of shear deformation are also evaluated.     

In-plane buckling of circular arches and rings with shear deformations

A finite strain formulation is developed for elastic circular arches and rings in which the effects of shear deformations are included. Timoshenko beam hypothesis is adopted for incorporating shear. Finite strains are defined in terms of the normal and shear component of the longitudinal stretch. The constitutive relations for stress and finite strain are based on a hyperelastic constitutive model. Virtual work and equilibrium equations are derived. Closed-form in-plane buckling solutions are developed for circular rings and high arches under hydrostatic pressure. The effects of axial deformation prior to buckling as well as shear deformations are included in the buckling analysis. The formulation developed is compared with solutions in the literature and to the predictions of the finite element package ANSYS. The importance of including the effects of shear deformations for deep arches is investigated.     

几何缺陷浅拱的动力稳定性分析

研究了几何缺陷对粘弹性铰支浅拱动力稳定性能的影响。从达朗贝尔原理和欧拉-贝努利假定出发推导了粘弹性铰支浅拱在正弦分布突加荷载作用下的动力学控制方程,并采用Galerkin截断法得到了可用龙格-库塔法求解的无量纲化非线性微分方程组。同时引入能有效追踪结构动力后屈曲路径的广义位移控制法,对含几何缺陷浅拱的响应曲线进行几何、材料双重非线性有限元分析。用这两种方法分析了前三阶谐波缺陷对浅拱动力稳定性能的影响,其中动力临界荷载由B-R准则判定。主要结论有:材料粘弹性使浅拱动力临界荷载增大且结构响应曲线与弹性情况差别很大;二阶谐波缺陷影响显著,它使动力临界荷载明显下降且使得浅拱粘弹性动力临界荷载可能低于弹性动力临界荷载。     

In-plane stability of uniform steel beam-columns on a Pasternak foundation with zero end-shortening

The linearized buckling response of uniform steel beam-columns resting on a Pasternak foundation type is dealt with in this work. The corresponding two-point boundary value problem depends on the two parameters associated with the foundation model, that is, shear layer constant and Winkler spring coefficient, as well as on the axial loading. The fourth-order differential equation of buckling and the consequent characteristic one yield exact values of the buckling loads, which may lead to shape functions, being either one sinusoidal waveform or the sum of two different waveforms. The former case is associated with a single-mode response, while the latter with mode coupling. The conditions for which each of these cases characterizes the beam-column behavior are fully assessed and the dependence on the combination of the aforementioned parameters on the response is discussed in detail. It is found that regardless of the order of coupling, the corresponding mode is not related to rational values of buckling loads and hence this unfavorable phenomenon is excluded in structural design.     

In-plane and out-of-plane free vibration and stability of a curved rod in flow

This paper investigates the free vibration and stability of a curved rod in flow. The equations of the three-dimensional motions of the rod are derived by the Newtonian approach. The differential quadrature method (DQM) is introduced to formulate the discrete forms of the governing equations of the inextensible rod with clamped–clamped supports. Based on numerical calculations, the effects of several system parameters, especially the flow velocity, on the natural frequencies and stability of the system are discussed. Buckling and flutter instability are detected as the flow velocity is varied in a certain range. Moreover, a derivation of the generalized slender-body theory for such a deformable curved rod is given in Appendix A.     

倒三角形截面板管连接式钢圆弧拱在平面内的稳定承载力研究

采用理论推导与数值模拟相结合的方法,对倒三角形截面板管连接式钢圆弧拱在平面内的弹性屈曲和弹塑性屈曲进行了深入研究.首先,理论推导了拱的截面剪切刚度,并提出了拱在全跨均布径向荷载作用下的弹性屈曲公式.此外,还提出了避免连接板和弦杆在拱发生整体弹性失稳之前发生局部失稳的限制条件.然后,分别研究了在全跨均布径向荷载和全跨均布...     

In-plane shear test of thin panels

Efficient application of thin-gage composite materials to helicopter fuselage structures necessitates that the materials be designed to operate at loads several times higher than initial buckling load. Methods are required to accurately measure and predict the response of thin-gage composites when subjected to these loads. This paper presents the results of an analytical and experimental study of the behavior of thin-gage composite panels subjected to in-plane shear loads. Finite-element stress analyses were used to aid in the design of an improved shear fixture that minimizes adverse corner stresses and tearing and crimping failure-modes characteristic of commonly used shear fixtures. Tests of thick buckle-resistant aluminum panels and thin aluminum and composite panels were conducted to verify the fixture design. Results of finite-element stress and buckling analyses and diagonal-tension-theory predictions are presented. Correlation of experimental data with analysis indicated that diagonal-tension theory can be used to predict the load-strain response of thin composite panels.     

In-plane perturbation of the tunnel-crack under shear loading I: bifurcation and stability of the straight configuration of the front

One considers a planar tunnel-crack embedded in an infinite isotropic brittle solid and loaded in mode 2+3 through some uniform shear remote loading. The crack front is slightly perturbed within the crack plane, from its rectilinear configuration. Part I of this work investigates the two following questions: Is there a wavy “bifurcated” configuration of the front for which the energy release rate is uniform along it? Will any given perturbation decay or grow during propagation? To address these problems, the distribution of the stress intensity factors (SIF) and the energy release rate along the perturbed front is derived using Bueckner–Rice's weight function theory. A “critical” sinusoidal bifurcated configuration of the front is found; both its wavelength and the “phase difference” between the fore and rear parts of the front depend upon the ratio of the initial (prior to perturbation of the front) mode 2 and 3 SIF. Also, it is shown that the straight configuration of the front is stable versus perturbations with wavelength smaller than the critical one but unstable versus perturbations with wavelength larger than it. This conclusion is similar to those derived by Gao and Rice and the authors for analogous problems.     

In-plane analysis of a cracked orthotropic half-plane

The stress fields in an orthotropic half-plane containing Volterra type climb and glide edge dislocations under plane stress condition are derived. The dislocation solutions are utilized to formulate integral equations for dislocation density functions on the surface of smooth cracks embedded in the half-plane under in-plane loads. The integral equations are of Cauchy singular type which are solved numerically. The dislocation density functions are employed to evaluate modes I and II stress intensity factors for multiple cracks with different configurations.     

In-plane shear testing of graphite-woven fabric composites

The losipescu shear test method was used to determine the in-plane shear response of AS4 and Celion carbon fiber/epoxy fabric composite materials. Several weave architectures were studied: AS4 uniweave, AS4 and Celion plain weaves, Celion 5-harness and 8-harness satin weaves. Specimens were tested using traditional strain gage techniques and full-field moiré interferometry. A full-node localized hybrid analysis is introduced to perform efficient reduction of moiré data, producing whole-field strain distributions in the specimen test section. It was found that the fabric yarn size greatly influenced the uniformity of the shear field in the specimen test section. However, consistent shear moduli still can be obtained using the modified losipescu specimen and Wyoming fixture except for fabrics with large fiber yarns.     

环形陀螺敏感结构的平面振动分析

在薄壁圆环振动特性基础上,研究了振动环式微机械陀螺的支撑梁对环的振动模态及自然频率的影响。对一种外支撑式环形微机械陀螺敏感结构进行了ANSYS模态仿真,得到工作振动模态的变形量。以薄壁环2节点变形模态函数为参考函数对仿真变形量用最小二乘法拟合,拟合误差在4.5%以内,各函数系数一致性误差小于1.5%。基于支撑梁对环结构的模态函数影响较小的条件,用能量法和速度积分法得到结构的应变能和动能函数,进一步得到具有支撑梁环结构自然频率的近似解。选取4组支撑梁尺寸,其近似解与仿真结果的相对误差在±3%以内。     

In-plane non-linear dynamics of the stay cables

Stay cables used in cable-stayed bridge and cable-stayed arch bridge are prone to vibration due to their inherent susceptibility to external deflection. The present work is devoted to the mitigation of a stay cable from the point of view of its nonlinear dynamics. The Galerkin integral, multiple scales perturbation method, and numerical techniques are applied to analyze the primary and subharmonic resonances of the stay cable. The nonlinear dynamic response of the stay cable subjected to parametrical and forced excitations is investigated numerically. The effects of some key parameters of the stay cable, such as initial tension force, damping and inclination angle, and the excitation frequency and amplitude are discussed. The carbon fiber reinforced polymers (CFRP) cable is also studied to understand the effect of the material properties of cable. The results show that these parameters have a considerable effect on the dynamic behavior of the cable. In particular, unreasonable tension force and inclination angle of stay cable may cause excessive vibration. It is suggested that CFRP cable replaces steel cable, which can mitigate the vibration of a stay cable.