空间有源消声的微机控制

本文讨论了通用微机控制空间有源消声，以修正的ＰＩＤ算法加上逻辑判断构成的控制软件，使得系统收敛迅速，跟踪速度快，消声效果令人满意，而且系统工作稳定可靠。     

微机在有源消声中的应用

本文讨论将微机技术引入单源有源消声器。微机控制其可变参数,使消声系统能对噪声源进行自动跟踪。其参数在一定范围内随着消声情况的变化而变化,始终保持最佳的消声效果。对线状谱噪声可将其剩余噪声控制在本底噪声或比本底噪声稍高一点的范围内(～3dB)。跟踪速度较快,最佳消声状态的稳定性也较好。     

局部空间自适应宽带有源消声

本文提出一个局部空间自适应宽带有源消声系统,该系统能实现有源消声所要求的任意带宽噪声在局部空间衰减,能自动补偿背景噪声及消声装置中不可控参数及噪声源变化对消声效果的影响.自适应滤波由TMS 32010数字信号处理器采用NLMS算法多路并行处理完成.实验结果表明:对普通房间中的单次级源布置方式,在主次级源前方1m,±30°扇面区域内,该系统对20—600Hz内的宽带噪声抵消,取得的最大降噪量在25dB(A)以上.     

有源消声耳罩控制器的实现

本文用传递函数描述了复合式有源消声耳罩的系统模型,确定了模拟式消声控制器的合理阶次,对于前馈控制器和反馈控制器,均比出了电路实现方案,最后,实际设计了复合式有源消声耳罩,并实测了控制器特性和消声效果,验证了本文提出了的控制器实现方法的有效性。     

次级声源优化布放的局部空间有源降噪

针对区域有源降噪问题,为获得更优降噪效果,根据实际次级通路传递函数,提出次级声源优化布放的有源控制系统并详细比较了两种次级声源优化布放算法与次级声源均匀布放的实际降噪效果。应用的第一种次级声源优化算法是l₂范数约束的约束匹配追踪算法,第二种次级声源优化算法是l₁范数约束的稀疏正则化方法。在全消声室中利用扬声器线阵进行多通道有源降噪实验研究,实验结果表明,在200～1000 Hz,次级声源优化布放的控制系统的平均降噪量比次级声源均匀布放的控制系统的平均降噪量多5 dB左右;在1100～1900 Hz,次级声源优化布放的控制系统的平均降噪量比次级声源均匀布放的控制系统的平均降噪量多11～13 dB左右,次级声源优化布放的控制系统的降噪量分布更加均匀且次级声源输出能量更小。此外,两种优化算法中,稀疏正则化方法的降噪效果更佳。     

军用运输机机舱有源消声实验系统的设计与实现

为验证有源消声技术在军用运输机机舱低频噪声消除方面的有效性,设计和实现了一套机舱有源消声实验系统。采用“激振器+舱壁板”方式实现了飞机螺旋桨对机舱诱导噪声的声源模拟,设计了基于前馈控制结构的自适应有源噪声控制系统,构建了基于FX-LMS算法的自适应消声控制器,采用监测麦克风组对舱内空间的消声效果进行监测。实验结果验证了自适应有源噪声控制技术在军用飞机舱室消声降噪领域的有效性,并表明初、次级声源间距对自适应有源消声系统的消声效果具有重要的影响。     

有源消声耳罩中的通信信号补偿

在有源消声罩的很多应用场所,耳罩中引入了通信信号,在提高有源消声量的同时,还要保证通信信号的清晰。本文针对有源消声耳罩的不同消声结构,分析了其中通信信号所受到的影响,对于通信信号受影响较大的消声结构,提出了相应的补偿方案,推导了补偿器的理论补偿公式,并且实际设计了消声耳罩和相应的通信信号补偿器,实测了通信信号的补偿效果,就实验结果分析了通信信号补偿方案的有效性。     

空间有源消声实验研究

本文分别在半声室和普通房间进行有源消声实验，证明了作者以前提出的算法是收敛的，稳定的，以此算法构成的多通道有源消声系统对直达声和混响声都能进行了有效的控制。     

A compound secondary source for active noise radiation control

Based on the analysis of active noise control system with multi-channel monopole secondary sources, a kind of compound secondary source is proposed in this paper. The proposed compound secondary source consists of two closely located monopole sources with their distance much smaller than a wavelength. The characteristics of the compound source are analyzed, and the performances of the active noise control system with the compound secondary sources on the monopole primary sound field and sound radiated by a plate are investigated both numerically and experimentally. It has been found that the proposed compound secondary sources control system can provide higher noise reduction for free field noise radiation control with the same number of control channels. It is shown that the better performance in noise reduction of the compound secondary sources control system is mainly due to the directivity of the secondary sources where the energy radiation pattern of the compound sources is similar to that of the primary sources.     

应用于有源声辐射控制的一种组合次级声源

在分析多通道单极子次级源控制系统的基础上,提出一种幅度调节型组合次级声源,这种组合源由两个单极子声源构成,单极子声源的间距远小于声波的波长。文中就组合次级源在自由场中对不同初级声源辐射噪声的控制进行理论分析和实验验证,并与同等条件下的单极子次级源控制系统的降噪性能进行了比较分析。数值计算和实验结果均表明,对于不同的初级声场,在次级通道数相同的情况下,组合次级源控制系统可以得到比单极子次级源控制系统高的降噪量。     

噪声主动控制研究的发展与动向

本回顾了噪声主动控制的典型设计方法和常见的算法,结合当前较新的鲁棒控制方法,指出今后噪声主动控制的一些发展动向,为这一技术的实用性提供借鉴。     

Hybrid active and passive control of fan noise

This paper deals with the global reduction of axial flow fan noise in ducts in a building using a hybrid passive-active noise control method. The effectiveness of using an infra-red device as a reference signal source is also investigated. It is shown that using such a hybrid noise control system over an axial-flow fan reduces the overall sound pressure level by 5 dB(A) in the surrounding environment and global control of the blade passing frequency can also be achieved. This paper also shows that using an infra-red device as a reference signal source produces marginally better control as compared with using a microphone reference sensor. Moreover, long term stability is guaranteed and the possibility of acoustic feedback is eliminated.     

Causality study on a feedforward active noise control headset with different noise coming directions in free field

A systematic analysis is proposed to predict the performance of a typical feedforward single channel ANC headset in terms of the delay, especially the non-causal delay caused by different noise coming directions. First, the performance of a non-causal feedforward system for a band-limited noise is analyzed by using a simplified pure delay model, where it is found that the noise reduction bandwidth is narrowed and the maximum noise reduction is decreased with the increase of the non-causal delay. Second, a systematic method is developed, which can be used to predict the system performance with measured primary and secondary path transfer functions in most practical sound fields and to study the effects of the control filter length and the path delay on the performance. Then, the causality of a typical feedforward active noise control headset with the primary source at 0° and 90° positions in an anechoic chamber is analyzed, and the performance for the two locations predicted by the systematic analysis is shown in good agreements with the experiment results. Finally, an experiment of a typical feedforward active noise control headset in a reverberation chamber is carried out, which shows the validity of the proposed systematic analysis for other more practical sound fields.     

Improving performance of FxRLS algorithm for active noise control of impulsive noise

Active noise control (ANC) systems employing adaptive filters suffer from stability issues in the presence of impulsive noise. New impulsive noise control algorithms based on filtered-x recursive least square (FxRLS) algorithm are presented. The FxRLS algorithm gives better convergence than the filtered-x least mean square (FxLMS) algorithm and its variants but lacks robustness in the presence of high impulsive noise. In order to improve the robustness of FxRLS algorithm for ANC of impulsive noise, two modifications are suggested. First proposed modification clips the reference and error signals while, the second modification incorporates energy of the error signal in the gain of FxRLS (MGFxRLS) algorithm. The results demonstrate improved stability and robustness of proposed modifications in the FxRLS algorithm. However, another limitation associated with the FxRLS algorithm is its computationally complex nature. In order to reduce the computational load, a hybrid algorithm based on proposed MGFxRLS and normalized step size FxLMS (NSS-FXLMS) is also developed in this paper. The proposed hybrid algorithm combines the stability of NSS-FxLMS algorithm with the fast convergence speed of the proposed MGFxRLS algorithm. The results of the proposed hybrid algorithm prove that its convergence speed is faster than that of NSS-FxLMS algorithm with computational complexity lesser than that of FxRLS algorithm.     

机车驾驶室中自适应有源降噪系统的研究

根据机车驾驶室中噪声特征的分析结果，提出了采用FIR滤波器的自适应有源降噪(ANNC)系统。为消除机车驾驶室中严重的背景噪声干扰影响，应用伪随机相关法对驾驶室中的噪声脉冲响应进行测量。通过数字仿真研究，对基于IMS算法的ANNC系统的关键参数进行了寻优。最后，在实际声场中建立了实时双通道ANNC系统并进行了相关的实验验证。仿真与实验的结果证明了本文提出的AANC系统的可行性和有效性。     

A simplified adaptive feedback active noise control system

In the adaptive feedback active noise control system based on the internal model control (IMC) structure, the reference signal is regenerated by synthesizing the error signal and the secondary signal filtered with the estimation of the secondary path, hence more computation load and extra programming are required. Motivated by the engineering truth that the primary noise cannot be completely cancelled in most practical active noise control applications and the error signal still contains some portions of the primary noise, a simplified adaptive feedback active noise control system is proposed in this paper, which adopts the error signal directly as the reference signal in an adaptive feedforward control system and utilizes the leaky filtered-x LMS algorithm to update the controller. The convergence properties of the proposed system are investigated and its advantages are discussed by comparing with other feedback control systems as well as the weakness. Finally, simulations and experiments are carried out to demonstrate the effectiveness of the proposed system.