共查询到17条相似文献,搜索用时 218 毫秒
1.
2.
3.
4.
5.
6.
7.
8.
《物理学报》2017,(5)
通过水洞实验对有水流速度影响的水下超声速气体射流进行实验研究,通过高速摄像系统记录射流形态演变过程,采用动态测力系统测量射流演变过程中射流周围环境压力的脉动特征.对剪切层涡旋结构进行分析,得到水流冲击射流的剪切涡流动形态演化和压力脉动特征.实验结果表明,射流主体形态的非定常运动依赖于水流速度,无水流速度时,射流主体受到重浮力影响向上弯曲较大,并且可以捕捉到射流的振荡诱导喷管口平面处主频为200 Hz的压力脉动,当存在水流速度时,射流主体向下游发展过程中的偏斜程度较小,射流与水流相互作用形成剪切涡,在水流作用下射流主体向下游发展过程中卷入射流剪切层,与射流主体掺混形成较大尺度的涡结构,喷管口平面处主频消失. 相似文献
9.
利用溢流恒压装置产生具有稳定出流速度的圆管潜射流, 结合染色液流态显示方法, 在多种射流无量纲潜深d/H、雷诺数Re以及限制数C的组合下, 实验研究了该潜射流动量在有限深密度均匀流体中的演化特性, 其中d为射流潜深, H为水深. 研究表明, 当C<1时潜射流表现为深水特征, 而当1≤ C<2时潜射流表现为过渡特征, 在这两种情况下均不产生任何形式的大尺度相干结构; 当2≤ C<10时潜射流表现为浅水特征, 而C≥10时潜射流表现为极浅水特征, 在这两种情况下均产生大尺度的偶极子涡结构. 对极浅水特征潜射流, 在各种无量纲潜深下, 偶极子涡结构的无量纲形成时间tf*与无量纲射流时间Tinj*均满足相同的正比例关系; 对浅水特征潜射流, 当d/H=0.5时, tf*与Tinj*满足某种线性关系, 但对其他无量纲潜深, tf*与Tinj*之间无明显规律.
关键词:
圆管潜射流
限制数
偶极子涡结构
形成时间 相似文献
10.
11.
A vortex ring impacting a three-dimensional bump is studied
using large eddy simulation for a Reynolds number Re=$4$x$10^4$ based on the initial diameter and
translational speed of the vortex ring. The effects of bump
height and vortex core thickness for thin and thick vortex
rings on the vortical flow phenomena and the underlying
physical mechanisms are investigated. Based on the analysis of
the evolution of vortical structures, two typical kinds of
vortical structures, i.e., the wrapping vortices and the
hair-pin vortices, are identified and play an important role in
the flow state evolution. The boundary vorticity flux is
analyzed to reveal the mechanism of the vorticity generation on
the bump surface. The circulation of the primary vortex ring
reasonably elucidates some typical phases of flow evolution.
Further, the analysis of turbulent kinetic energy reveals the
transition from laminar to turbulent state. The results
obtained in this study provide physical insight into the
understanding of the mechanisms relevant to the flow evolution
and the flow transition to turbulent state. 相似文献
12.
Vedanth Nair Matthew Sirignano Benjamin Emerson Ben Halls Naibo Jiang Josef Felver Sukesh Roy Jim Gord Tim Lieuwen 《Proceedings of the Combustion Institute》2019,37(2):1489-1496
This paper analyzes the time averaged flow structure of a reacting jet in cross flow (RJICF), emphasizing the structure of the counter-rotating vortex pair (CVP) by using simultaneous tomographic particle image velocimetry (TPIV) and hydroxyl radical planar laser induced fluorescence (OH-PLIF). It was performed to determine the extent to which heat release, and the associated effects of gas expansion and baroclinic vorticity production, impact the structure of the CVP. These results show the clear presence of a CVP in the time averaged flow field, whose trajectory lies below the jet centerline on either side of the centerplane. Consistent with other measurements of high momentum flux ratio JICF in nonreacting flows, there is significant asymmetry in strength of the two vortex cores. The strength and structure of the CVP was quantified with vorticity and swirling strength (λci), showing that some regions of the flow with high shear are not necessarily accompanied by large scale bulk flow rotation and vice-versa. The OH PLIF measurement allows for correlation of the flame position with the dominant vortical structures, showing that the leeward flame branch lies slightly above, as well as, in the region between the CVP cores. 相似文献
13.
In this paper, large eddy simulation (LES) of a three-dimensional turbulent lid-driven cavity (LDC) flow at Re = 10,000 has been performed using the multiple relaxation time lattice Boltzmann method. A Smagorinsky eddy viscosity model was used to represent the sub-grid scale stresses with appropriate wall damping. The prediction for the flow field was first validated by comparing the velocity profiles with previous experimental and LES studies, and then subsequently used to investigate the large-scale three-dimensional vortical structures in the LDC flow. The instantaneous three-dimensional coherent structures inside the cavity were visualised using the second invariant (Q), Δ criterion, λ2 criterion, swirling strength (λci) and streamwise vorticity. The vortex structures obtained using the different criteria in general agree well with each other. However, a cleaner visualisation of the large vortex structures was achieved with the λci criterion and also when the visualisation is based on the vortex identification criteria expressed in terms of the swirling strength parameters. A major objective of the study was to perform a three-dimensional proper orthogonal decomposition (POD) on the fluctuating velocity fields. The higher energy POD modes efficiently extracted the large-scale vortical structures within the flow which were then visualised with the swirling strength criterion. Reconstruction of the instantaneous fluctuating velocity field using a finite number of POD modes indicated that the large-scale vortex structures did effectively approximate the large-scale motion. However, such a reduced order reconstruction of the flow based on the large-scale vortical structures was clearly not as effective in predicting the small-scale details of the fluctuating velocity field which relate to the turbulent transport. 相似文献
14.
15.
螺旋状尾迹涡是直升机悬停旋翼流场的主导特征之一,其时空演化特性对旋翼气动性能具有重要影响.为了揭示悬停状态下旋翼尾迹涡的演化特征,对两桨叶刚性旋翼在高雷诺数悬停状态下的双螺旋状尾迹涡开展数值研究,采用基于流场特征的网格自适应技术,结合低耗散迎风/中心混合格式以及延迟脱体涡模拟方法对Caradonna-Tung旋翼在桨尖马赫数为0.439、桨尖雷诺数为1.92×10~6的悬停流场进行了高分辨率计算.基于欧拉和拉格朗日两种描述方法对计算结果进行了分析,揭示了双螺旋尾涡系统的演化特性:后缘尾涡面在桨尖附近的反向卷起及其与下游桨尖涡的相互作用是影响涡系稳定性以及涡-涡相互作用的重要因素;涡龄小于720°时,在固连于桨叶上的旋转坐标系中观察,涡系具有时空稳定性,涡管中心处轴向涡量随涡龄按照幂函数规律衰减.在固连于漩涡中心的局部极坐标系中,周向速度分布以及涡核半径随涡龄的变化与理论涡模型相符合,环量随涡龄的变化显示了漩涡的生长、平衡及耗散等演化阶段;模态分析结果表明,除点涡模态外,来流与点涡的复合模态在漩涡演化过程中对流动特征的转变有重要影响;涡系轴截面速度场的拉格朗日拟序结构直观地显示了漩涡场的时空演化过程,揭示了漩涡配对和共旋穿越等流动特征,同时也展示了后缘尾涡面卷起现象在漩涡演化过程中的作用. 相似文献
16.
The turbulent wake behind a curved circular cylinder is investigated based on data obtained from a direct numerical simulation. Here, emphasis is placed in the assessment of two approaches for simplified modelling: reduced-order modelling (ROM) and Reynolds-averaged Navier–Stokes equations. To this end, the instantaneous vortical structures, the proper orthogonal decomposition (POD) of the flow, and relevant Reynolds stress components have been analysed. The results show that despite the complexity of the instantaneous vortical structures, the wake dynamics are governed by the quasi-periodic shedding of primary vortices. Between 24% and 50% of the kinetic energy in the POD is captured by the two most energetic modes, and about 200 modes are needed to capture 90% of the kinetic energy. These findings suggest that, as long as the large-scale structures of the von Kármán vortex shedding are concerned, the present case can be approached by ROM; but a detailed representation of the flow dynamics without an eddy viscosity model that accounts for the unresolved turbulent fluctuations would require a large amount of degrees of freedom. Concerning the Reynolds stresses, their magnitude varies considerably depending on the depth at which they have been sampled. This dependence is related to the strength of the vortex shedding, and the intensity of the secondary flows induced by the curvature of the cylinder. As a consequence of the combination of these two effects, the correlation between streamwise and vertical velocity fluctuations is highest in the wake behind the midspan of the curved cylinder, and the correlation between cross-flow and vertical velocity fluctuations reaches large values in the lower wake. 相似文献
17.
Particle image velocimetry technique has been used to investigate the evolution of synthesised vortical structures in the turbulent boundary layer. Synthetic jet actuator is implemented on the flat plate surface to synthesise various vortical structures by operating the actuator at varying operating parameters. The vortices are issued into the boundary layer and their evolution and subsequent interaction with the relatively less energetic near wall fluid is studied. The investigation is based on the quantitative measurements that are made both on the central and parallel lateral planes. Finally, the enhancement of the wall shear stress resulted in by the passing vortices is measured to evaluate the effectiveness of the actuator towards flow separation control. 相似文献