光参量啁啾脉冲放大增益特性研究

 通过对非线性三波耦合方程组进行数值求解,研究了光参量放大的增益特性及饱和放大特性。给出了泵浦光、信号光参数对参量增益的影响及其与晶体饱和长度的关系。且OPA具有传统CPA系统所不具有的优点,将有可能取代传统的CPA系统而作为超短超强激光系统的新型前端。     

Spectral narrowing of negatively chirped femtosecond pulse by cross-phase modulation in a single-mode optical fiber

We demonstrate theoretically that the negatively chirped femtosecond laser pulse can be spectrally narrowed by cross-phase modulation. The new view is well supported by numerical simulation. The negative chirp method in fibers might be useful in all optical wavelength switching applications.     

啁啾脉冲堆积及其放大特性

 根据啁啾脉冲堆积的原理以及模型介绍了两路脉冲堆积时脉冲的时间与频谱特性,分析了堆积脉冲产生时间与频谱调制,以及交叠区产生非线性频率啁啾的原因。通过非线性薛定谔方程,分析了堆积脉冲的放大特性,介绍了啁啾参量对放大结果的影响以及放大后堆积脉冲的频率啁啾的变化。研究表明,在堆积脉冲的放大过程中自相位调制效应非常明显,严重影响了脉冲的频谱与频率啁啾。     

Stacking chirped pulse optical parametric amplification

Stacking chirped pulse optical parametric amplification based on a home-built Yb³⁺-doped mode-locked fiber laser and an all-fiber pulse stacker has been demonstrated. Energic 11 mJ shaped pulses with pulse duration of 2.3 ns and a net total gain of higher than 1.1 × 10⁷ at fluctuation less than 2% rms are achieved by optical parametric amplification pumped by a Q-switched Nd:YAG frequency-doubled laser, which provides a simple and efficient amplification scheme for temporally shaped pulses by stacking chirped pulse.     

Numerical studies of optical parametric chirped pulse amplification

Based on the coupled wave equations, optical chirped-pulse parametric amplification (OPCPA) is simulated and its characteristics are investigated under the conditions of small-signal and pump depletion. The influence of the group-velocity mismatch and the phase mismatch among the three waves on the process of the amplification are discussed, respectively. Compared with the conventional chirped-pulse amplification system, synchronization between pump and signal-pulses is a crucial issue in OPCPA. The requirement on Δτ_p–s as well as the stability of the system is investigated.     

自由电子激光放大啁啾脉冲的数值模拟

 利用1维非定态程序对单程自由电子激光(FEL)放大器放大线性啁啾脉冲的过程进行了数值模拟,得到了不同啁啾参数的脉冲通过FEL放大器的增益曲线,计算了不同啁啾参数的脉冲被单程FEL放大器放大后的腔外压缩情况。通过对数值模拟结果的定性分析得出：影响输出脉冲宽度和峰值功率的主要因素是FEL放大器的增益线宽和啁啾参数,并以此说明,通过先使用FEL放大器放大啁啾脉冲、然后再将其在腔外压缩的方法产生超短脉冲FEL是可行的。     

啁啾脉冲放大系统展宽压缩器各阶色散分析

 通过在光程差中增加相位校正项,重新推导了更为完善的压缩器各阶色散解析式。并对压缩器的各阶色散作了光线追迹的模拟计算,得到与解析式完全一致的计算结果,从而验证了解析式的正确性。基于解析式和光线追迹的方法,更加系统完善地对比较常用的Offner展宽器的各阶色散进行了研究,分析了入射角、光栅与凹面镜距离对其各阶色散及剩余各阶色散的影响。同时,还对非匹配的展宽压缩系统的剩余色散的影响因素进行了讨论。     

光参量啁啾脉冲放大过程中脉冲特性理论研究

 通过数值求解非线性三波耦合方程组,并利用色散致啁啾引起的瞬时频率与时间的关系,模拟了啁啾脉冲在光参量放大过程中的脉冲波形和频谱形状的变化关系,以及通过压缩器的脉冲形状。模拟结果表明：啁啾脉冲在光参量放大过程中的时域宽度和频谱有很小程度的加宽,但基本上不影响放大后脉冲的压缩及信噪比。     

Diode-pumped chirped pulse amplification to the joule level

The POLARIS project aims at the development of an all-diode-pumped, high-peak-power femtosecond laser system reaching the petawatt level. The laser amplifiers are based on pumping Yb³⁺-doped fluoride phosphate glass at 940 nm. Recently, stable operation of the first three amplifiers was achieved. Pulses with a bandwidth of 12 nm, which supports 135 fs pulses with energies up to 1.25 J, were generated in the third amplifier with a 12-pass configuration. The amplifier was pumped by 150 collimated high-power laser diodes. Successive polarization maintenance is used for a compact, stable, and convenient adjustable setup. Thermally induced abberations of lowest order were compensated by adaptive mirrors. PACS 42.55.Xi; 42.60.By; 42.70.Hj     

Optimization of optical parametric chirped pulse amplification with different pump wavelengths

Optical parametric chirped pulse amplification with different pump wavelengths was investigated using LBO crystal, at signal central wavelength of 800 nm. According to our theoretical simulation, when pump wavelength is 492.5 nm, there is a maximal gain bandwidth of 190 nm centered at 805 nm in optimal noncollinear angle using LBO. Presently, pump wavelength of 492.5 nm can be obtained from second harmonic generation of a Yb:Sr₅(PO₄)₃F laser. The broad gain bandwidth can completely support ∼6 fs with a spectral centre of seed pulse at 800 nm. The deviation from optimal noncollinear angle can be compensated by accurately tuning crystal angle for phase matching. The gain spectrum with pump wavelength of 492.5 nm is much better than those with pump wavelengths of 400, 526.5 and 532 nm, at signal centre of 800 nm.     

Compact high gain double-pass optical parametric chirped pulse amplifier

A novel double-pass noncollinear optical parametric chirped pulse amplifier based on an Yb³⁺-doped passively mode-locked fiber laser has been demonstrated in this paper. The signal was double-pass amplified in a single nonlinear crystal by a long pump pulse, and the signal and pump pulses of each pass were completely phase matched in the plane of the maximum effective nonlinearity. Net saturated gain of 2×10⁶ was achieved and the superfluorescence was suppressed by increasing the overlap time between the signal and pump pulses.     

Ultrafast noncollinear optical parametric chirped pulse amplification in KTiOAsO4

Amplification of femtosecond pulses at 1.56 microm based on noncollinear parametric chirped pulse amplification in a potassium titanyl arsenate (KTA) crystal with pumping at 1.05 microm is reported. The 100 fs pulses of an erbium fiber laser are parametrically amplified while synchronously pumped by an amplified mode-locked Nd:YLF laser. This amplifier has a saturated gain of 65 dB with 30% conversion efficiency and has produced 160 fs pulses with peak powers of up to 0.75 GW. The system produced 380 mW before compression and can be readily scaled to the multiwatt range with bandwidths to support sub-100 fs pulses.     

A theoretical study about the chirped pulse amplification laser

Starting from the Maxwell‘s equation,and using the resonant-dipole equation together with the multilevel rate equations which take the effects of energy relaxation into consideration,we have derived a more realistic numerical model of the chirped pulse amplification for an ultra-broad band width laser amplifier.Numerical simulations of this model show that both the intensity profile and the energy fluence of the amplified chirped pulse are closely connected with the two relaxation effects:the relaxation of the thermalization among the components of the laser multiplets and the depletion of the lower laser level.The results are valuable for the design of ultra-broad bandwidth chirped pulse amplification lasers.     

Mutual compensation of higher-order dispersion in chirped pulse amplification system with regenerative amplifier

In this paper, based on ray tracing, the approach of mutual compensation that introduced properly the negative third-order dispersion to balance the higher-order dispersion in the chirped pulse amplification (CPA) system with regenerative amplifier is presented. A shorter pulse with near-transform-limitation can be generated by this method than by the conventional approach that zeros the second- and the third-order dispersion successively in the CPA system.     

α-parameter dependence of chirped pulse from injection-moudated semiconductor lasers

It is found from a series of numerical simulations that a simple relation, ΔtΔf_c=0.4α, holds between an amount of down-chirp (Δf_c) and a pulsewidth (Δt) for pulses from an injection-modulated semiconductor laser having a known α-Parametef value. This relation is useful for estimating the amount of chirp existing in pulses. The validity of the relation is examined by a direct observation of chirped pulses using a combination of a streak camera and a spectrometer.     

Dynamic gain induced pulse shortening in Q-switched lasers

We describe a novel mechanism of pulse shortening in a Q-switched laser induced by the gain compression effect under strong pumping conditions. The pulse shortening requires a large variation of the gain excursion during the saturation process and benefits from the large volume of the gain medium. The effect has been experimentally demonstrated using a passive Q-switched Tm/Ho-doped fiber laser that shows gain-induced pulse compression from 800 ns down to 160 ns when the pump threshold is exceeded by 15 times.     

Superradiant linear Raman amplification in plasma using a chirped pump pulse

A theoretical and numerical investigation of small-signal Raman backscattering from a chirped pump pulse in plasma shows that an ultrashort probe pulse will grow superradiantly, i.e., with an amplitude that scales with the propagation length while contracting self-similarly. These features are commonly associated with the nonlinear stages of Raman amplification in the pump depletion and Compton regimes. We show that the superradiant scaling results in very broad-bandwidth amplification due to gain distributed in frequency as well as spatially. Since different frequencies excite the plasma at different positions, wave breaking is avoided, and prepulses and pedestals are substantially suppressed. Linear chirped pulse amplification in plasma could provide a very broad-bandwidth alternative to solid state laser amplifiers, potentially usable for optical pulses a few cycles in duration.     

Multiterawatt laser system based on optical parametric chirped pulse amplification

A compact multiterawatt laser system based on optical parametric chirped pulse amplification is demonstrated. Chirped pulses are amplified from 20 pJ to 900 mJ by two lithium triborate optical parametric preamplifiers and a final KDP optical parametric power amplifier with a pump energy of 5 J at 532 nm from Nd:YAG-Nd:glass hybrid amplifiers. After compression, we obtained a final output of 570-mJ-155-fs pulses with a peak power of 3.67 TW, which is the highest output power from an optical parametric chirped pulse amplification laser, to the best of our knowledge.     

35 J broadband femtosecond optical parametric chirped pulse amplification system

We report on what is believed to be the first large-aperture and high-energy optical parametric chirped pulse amplification system. The system, based on a three-stage amplifier, shows 25% pump-to-signal conversion efficiency and amplification of the full 70 nm width of the seed spectrum. Pulse compression to 84 fs achieved after amplification indicates a potential of 300 TW pulse power for 35 J amplified pulse energy.