共查询到20条相似文献,搜索用时 15 毫秒
1.
The viscoelastic properties of dendrimers of generation 1-4 are studied using nonequilibrium molecular dynamics. Flow properties of dendrimer melts under shear are compared to systems composed of linear chain polymers of the same molecular weight, and the influence of molecular architecture is discussed. Rheological material properties, such as the shear viscosity and normal stress coefficients, are calculated and compared for both systems. We also calculate and compare the microscopic properties of both linear chain and dendrimer molecules, such as their molecular alignment, order parameters and rotational velocities. We find that the highly symmetric shape of dendrimers and their highly constrained geometry allows for substantial differences in their material properties compared to traditional linear polymers of equivalent molecular weight. 相似文献
2.
I. A. Petlin R. V. Sozonov Yu. N. Khakimullin A. I. Kurkin 《Polymer Science Series D》2016,9(1):49-52
The properties of silane terminated polyurethane sealants produced using polyesters of different molecular weights have been studied. The relationship between the molecular weight of polyester with STP oligomer polarity, degree of swelling, and physicomechanical and adhesive properties of sealants has been established. It is shown that the polarity of oligomer and properties of sealants are reduced with increasing molecular weight of polyester. 相似文献
3.
Structure, spectroscopic constants and molecular properties of selected diatomic anions in their ground states have been studied in detail using HF/DF B3LYP method. The consistency of the calculated values of spectroscopic constants and molecular properties has been tested using four basis sets with improved quality. The spectroscopic constants and molecular properties of these diatomic ions agree well with the experimental and theoretical values wherever available. Most of the spectroscopic constants and molecular properties of these ions, in particular the spectroscopic constants of SiO−, CS− and the molecular properties of SiN−, CP−, SiO− are first reported. 相似文献
4.
共聚酯PEIT-PEG结晶性能的研究 总被引:3,自引:0,他引:3
通过偏光显微镜、广角X衍射与FTIR三种测试手段对共聚酯PEIT-PEG的结晶性能进行了系统的研究,重点分析了间苯二甲酸(IPA)、聚乙二醇(PEG)分子量和含量对共聚酯结晶性的影响。研究表明,PEIT与PEG之间发生了共聚反应,IPA的引入使PET结晶性能下降,晶粒尺寸减少,结晶度降低。引入PEG后,当PEG分子量和含量较低时,共聚酯结晶性能提高;当PEG含量较高时,在PEG分子量不变的情况下,随着PEG含量的增加,结晶性能下降;若PEG重量含量相同,PEG分子量越高,结晶性能越好。 相似文献
5.
One general class of polymer modeling applications involves materials which are large, in terms of molecular degrees of freedom, and poorly defined in terms of composition and morphology. Such materials are often multicomponent with respect to number of distinct polymers, fillers, additives, etc. Two obstacles limit the modeling of these materials. First, one normally does not have any idea about the key physicochemical molecular properties governing the system. Second, the functional dependence of the target properties of the material upon the key physicochemical molecular properties is usually totally unknown. Torsion angle unit (TAU) theory, a molecular decomposition technique, permits an arbitrarily large number of physicochemical properties to be computed in an open-ended fashion, and thus addresses the first problem. Genetic function approximation (GFA) analysis tackles the second problem by efficiently exploring any desired number of functional relationships between target properties and physicochemical molecular properties. Case studies of (TAU theory)-(GFA analysis) applications to estimate glass, Tg, and crystal-melt, Tm, transition temperatures will be described. 相似文献
6.
Nanofriction properties of molecular deposition films 总被引:15,自引:0,他引:15
The nanofriction properties of Au substrate and monolayer molecular deposition film and multilayer molecular deposition films on Au substrate and the molecular deposition films modified with alkyl-terminal molecule have been investigated by using an atomic force microscope. It is concluded that ( i ) the deposition of molecular deposition films on Au substrate and the modification of alkyl-terminal molecule to the molecular deposition films can reduce the frictional force; (ii) the molecular deposition films with the same terminal exhibit similar nanofriction properties, which has nothing to do with the molecular chain-length and the layer number; (iii) the unstable nanofriction properties of molecular deposition films are contributed to the active terminal of the molecular deposition film, which can be eliminated by decorating the active molecular deposition film with alkyl-terminal molecule, moreover, the decoration of alkyl-terminal molecule can lower the frictional force conspicuously; (iv) the relat 相似文献
7.
Renyuan Qian 《Macromolecular Symposia》1990,33(1):327-339
A review discussion of the facts and factors to be considered in the molecular design of conducting polymers is presented. Topics discussed are: molecular properties and solid state properties; towards high conductivity— conjugation length and chain orientation; counter ions and ion exchange; materials design—solubilization, processability and molecular composites. 相似文献
8.
9.
Poly(butylene succinate) (PBS) with different molecular weight was synthesized from 1, 4-butanediol and succinic acid by direct melt condensation. The synthesized PBS was identified by IH-NMR and FTIR spectrometry. The molecular weight was calculated from the intrinsic viscosity, and its value was between 20000 and 70000. The crystallization behavior and crystal morphology as function of molecular weight were investigated by DSC and PLM, respectively. The mechanical properties and hydrolytic degradation behaviors related with change of molecular weight were also studied in this work. The results demonstrated that the properties of PBS were determined by both molecular weight and crystallization properties (crystallinity as well as crystal morphology). Our work is important for the design and preparation of PBS with proper molecular weight for its practical application. 相似文献
10.
M. L. Wallach 《Journal of Polymer Science.Polymer Physics》1968,6(5):953-960
A series of well-characterized polyamic acids from pyromellitic dianhydride and 4,4′-diaminodiphenyl ether of systematically varied molecular weight and known molecular weight distribution were chemically converted to polyimide films under regulated conditions. The films were essentially noncrystalline, of moderate orientation, and soluble in concentrated sulfuric acid. The mechanical properties of the films varied sigmoidally with the solution properties of the precursor. Molecular weights were derived for the onset of mechanical strength and limiting property values are given. The relations between film properties and molecular structural parameters suggest that cyclization probably occurs here with little contribution from crosslinking, degradation, or other side reactions which would appreciably alter molecular weight and molecular weight distribution. 相似文献
11.
Silica-polypyrrole particles have been used as a composite stationary phase for liquid chromatography. Determination of capacity factors (k') of a wide number of polycyclic aromatic hydrocarbon (PAH) molecular probes allows the characterisation of the chromatographic properties of the silica-polypyrrole stationary phase. Capacity factors in the range of 0.10 up to 6.1 were determined, thus demonstrating the high affinity of the PAH probes towards the stationary phase. The selectivity of the composite stationary phase was also evaluated as a function of the planarity of the molecular probes injected. Capacity factors determined for PAHs (two-dimensional molecular probes) are higher than those measured for phenyl-substituted PAHs (phenyl-PAHs, three-dimensional molecular probes). Determination of capacity factors, dependence on the composition of the mobile phase demonstrates the reverse alpha-phase properties of the composite stationary phase. The acid-base properties of the composite silica-polypyrrole stationary phase were investigated using benzene derivative molecular probes (i.e., toluene, phenol, benzoic acid and aniline). Capacity factors in the range of 0.45 to 1.0 were determined. This study clearly demonstrates that this composite stationary phase exhibits selective interactions towards PAHs and phenyl-substituted PAHs and strong acid-base properties depending on the structure, the geometry and the acid-base properties of the molecular probes eluted. 相似文献
12.
Wulin Qiu 《European Polymer Journal》2006,42(5):1059-1068
Composite of highly crystalline fibrous cellulose (CE) and polypropylene (PP) of different molecular weights () was prepared via melting-mixing, maleic anhydride grafted polypropylene (MAPP) was used as a compatibilizer. And the effects of molecular weight of PP on the properties of the composites were investigated. Through the studying of mechanical properties, dynamic mechanical properties, melting and crystallization behaviors, thermo-oxidative properties, water absorption behaviors, and the morphology of the composites, it was found that PP with higher molecular weight revealed stronger interfacial interaction with cellulose in the composites. Compared with the lower molecular weight, the composites derived from higher molecular weight of PP exhibited stronger tensile strength at the same cellulose content. 相似文献
13.
The relationship between molecular structures and physical properties of linear low density polyethylenes (LLDPEs) produced with single-site catalyst (SSC) was investigated. SSC polymerized LLDPE have excellent physical properties corresponding to its homogeneous molecular structure that had never been achieved by conventional Ziegler-Natta catalysts. It was found that some SSCs have the capability to produce LLDPEs with narrow molecular weight distribution but excellent melt properties. This result suggests that there exist long chain branches in these LLDPEs. 相似文献
14.
The Kohonen self‐organizing map was introduced to map the protein molecular surface features. The protein or polypeptide properties, such as shape and molecular electrostatic potential, can be visualized by self‐organizing map, which was trained by the 3D surface coordinates. Such maps allow the visual comparison of molecular properties between proteins having common topological or chemical features. 相似文献
15.
共价双金属配合物因其结构的优越性,在分子器件特别是分子导线的研究方面有广阔的应用前景。分子内电子耦合作用的研究是揭示这类配合物构成的分子导线性能的关键之一。本文介绍了共价双金属配合物的分子内电子耦合作用及此类配合物的结构特点,总结了近年来共价双金属配合物在分子导线领域的研究进展,并对共价双金属配合物的发展前景进行了展望。 相似文献
16.
Oleg Borodin Dmitry Bedrov Grant D. Smith John Nairn Scott Bardenhagen 《Journal of polymer science. Part A, Polymer chemistry》2005,43(8):1005-1013
A methodology for simple multiscale modeling of mechanical properties of polymer nanocomposites has been developed. This methodology consists of three steps: (1) obtaining from molecular dynamics simulations the viscoelastic properties of the bulklike polymer and approximating the position-dependent shear modulus of the interfacial polymer on the basis of the polymer-bead mean-square displacements as a function of the distance from the nanoparticle surface, (2) using bulk- and interfacial-polymer properties obtained from molecular dynamics simulations and performing stress–relaxation simulations of the nanocomposites with material-point-method simulations to extract the nanocomposite viscoelastic properties, and (3) performing direct validation of the average composite viscoelastic properties obtained from material-point-method simulations with those obtained from the molecular dynamics simulations of the nanocomposites. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 1005-1013, 2005 相似文献
17.
AlPO4-5分子筛模板剂的量子化学计算 总被引:4,自引:0,他引:4
以23种有机分子作为模板剂用于AlPO4-5分子筛的合成,利用分子图形技术研究这些有机分子的形状和尺寸,采用量子化学PM3方法研究这些有机分子的电子性质,计算它们与AlPO4-5分子筛骨架模型簇之间的相互作用能。结果表明,量子化学计算数据可以作为寻找合成AlPO4-5分子筛新型模板剂时的重要参考依据。 相似文献
18.
19.
李宗良 《化学物理学报(中文版)》2011,24(2):194-198
Based on the first-principles computational method and the elastic scattering Green's func-tion theory, we have investigated the electronic transport properties of different oligothio-phene molecular junctions theoretically. The numerical results show that the difference of geometric symmetries of the oligothiophene molecules leads to the difference of the contact configurations between the molecule and the electrodes, which results in the difference of the coupling parameters between the molecules and electrodes as well as the delocalization properties of the molecular orbitals. Hence, the series of oligothiophene molecular junctions display unusual conductive properties on the length dependence. 相似文献
20.
讨论怎样理解子的配分函数的物理意义,以及它和系统的配分函数在计算热力学函数中的作用,指出它既不是系统的广延性质,也不是系统的强度性质,只是联系系统热力学函数与微观信息的纽带。 相似文献