Structure of chlorinated poly(vinyl chloride). X. Conclusions on the chlorination mechanism

The chlorination of poly(vinyl chloride) (PVC) was investigated by using deuterated polymeric models of PVC, viz., α-deuterated PVC (α-d-PVC) and β,β-dideuterated PVC (β,β-d₂-PVC). The chlorinated samples of PVC, α-d-PVC, and β,β-d₂-PVC were examined by combining infrared (IR), ¹H-NMR, ¹³C-NMR, and mass spectroscopy. The results obtained were used in a study of the reaction mechanism of PVC chlorination. The selectivity of chlorination and the extent of the substitution and elimination-addition mechanism of chlorination are discussed with respect to the degree of chlorination and chlorination conditions.     

Structure of chlorinated poly(vinyl chloride). V. Molecular parameters of chlorinated poly(vinyl chloride)

The molecular parameters of samples of chlorinated poly(vinyl chloride) (CPVC) and chlorinated β,β-dideuterated poly(vinyl chloride) (β,β-d₂-CPVC) were determined by gel permeation chromatography (GPC), light scattering, osmometry, and viscometry. Comparison of GPC, light scattering, osmometric, and viscometric data resulted in a discussion of the possibility of degradation and the causes of changes in the solution properties in chlorination of PVC and ββ-dideuterated poly(vinyl chloride) (ββ-d₂-PVC). The results obtained are discussed in relation to the mechanism of chlorination of PVC.     

Thermal decomposition of poly(vinyl chloride) and chlorinated poly(vinyl chloride). II. Organic analysis

A concerted study of poly(vinyl chloride), chlorinated poly(vinyl chloride), and poly(vinylidene chloride) polymers by spectroscopy, thermal analysis, and pyrolysis-gas chromatography resulted in a proposed mechanism for their thermal degradation. Polymer structure with respect to total chlorine content and position was determined, and the influence of these polymer units on certain of the decomposition parameters is presented. Distinguishing differences were obtained for the kinetics of decomposition, reactive macroradical intermediates, and pyrolysis product distributions for these systems. It was determined that chlorinated poly(vinyl chloride) systems with long-chain ? CHCI? units were more thermally stable than the unchlorinated precursor, exhibited increasing activation energy for the dehydrochlorination, and produced chlorine-containing macroradical intermediates and chlorinated aromatic pyrolysis products. The poly(vinyl chloride) polymer was relatively less thermally stable, exhibited decreasing activation energy during dehydrochlorination, and produced polyenyl macro-radical intermediates and aromatic pyrolysis products.     

Structure of chlorinated poly(vinyl chloride). I. Determination of the mechanism of chlorination from infrared and NMR spectra

Infrared and NMR spectra of chlorinated poly(vinyl chloride) (CPVC) and of chlorinated α-deuterated poly(vinyl chloride) (α-d-CPVC) have been measured. It was found that the CDCl unit of α-d-PVC does not undergo chlorination. By assuming an analogous mechanism of chlorination in normal PVC, the populations of all the three possible types of two-carbon sequences (? CH₂? CHCl? , ? CHCl? CHCl, ? CHCl? CCl₂) in CPVC could be determined. The mechanism of chlorination of PVC is discussed from the viewpoint of the previous findings on the conformational structure of this polymer. Differences in structure between suspension- and solution-chlorinated PVC have been established.     

Thermal decomposition of poly(vinyl chloride) and chlorinated poly(vinyl chloride). I. ESR and TGA studies

Significant effort has been made in the past by many workers to investigate the mechanism of thermal decomposition of poly(vinyl chloride) (PVC). The presence and role of free radicals has been controversial in this regard. Our data on PVC and chlorinated PVC systems demonstrate the existence of macroradicals in the early stage of thermal decomposition under inert and oxidative atmospheres. Data from conventional thermogravimetric experiments are used in conjunction with the electron spin resonance findings.     

Structure of chlorinated poly(vinyl chloride). III. Preparation of poly(vinyl chloride)-β,β-d2 as a model for the study of the mechanism of chlorination and of the chlorinated poly(vinyl chloride) structure

A method for the preparation of poly(vinyl chloride)-β,β-d₂ (PVC-β,β-d ₂) as a model for the investigation of the mechanism of chlorination and of the CPVC structure has been suggested. The conditions of preparation of deuterated intermediates of a multistage synthesis of vinyl chloride-β,β-d₂ and of suspension-polymerized PVC-β,β-d₂ have been described including the mass balance. Malonic acid was used as the starting compound. Tacticity values of a sample of PVC-β,β-d₂ and its infrared and NMR spectra are presented and compared with data already published.     

Investigations on poly(vinyl chloride). II. Pyrolysis of chlorinated polybutadienes as model compounds for poly(vinyl chloride)

The pyrolysis of chlorinated polybutadienes (CPB) was investigated by using a pyrolysis gas chromatograph. CPB corresponds to poly(vinyl chloride) (PVC) constructed with head–head and tail–tail linkages of the vinyl chloride unit. Benzene, toluene, ethyl-benzene, o-xylene, styrene, vinyltoluene, chlorobenzenes, naphthalene, and methylnaphthalenes were detected in the pyrolysis products from CPB above 300°C, and no hydrocarbons could be detected at 200°C. The pyrolysis products from CPB were similar to those from PVC and new products could not be detected. Lower aliphatics, toluene, ethylbenzene, o-xylene, chlorobenzenes, and methylnaphthalenes were released more easily from pyrolysis of CPB than from PVC; amounts of benzene, styrene, and naphthalene formed were small. These results support the conclusion that recombination of chlorine atoms with the double bonds in the polyene chain takes place and that scission of the main chain may depend on the location of methylene groups isolated along the polyene chain during the thermal decomposition of PVC.     

Structure of chlorinated poly(vinyl chloride). II. Distribution of Cl atoms in the polymer chain

The distribution of chlorine atoms in the chain of solution-chlorinated PVC (CPVC) composed of ? CH₂? CHCl? (1), ? CHCl? CHCl? (2), and ? CCl₂? CHCl? (3) monomeric units is described by first-order Markoffian statistics based on the assumption that the chlorination mechanism is independent of tacticity. In this case, all the statistical parameters can be obtained from experimentally determined concentrations of CH₂, CHCl and CCl₂ units. Populations of the sequences (11) and (111) calculated from the statistical parameters agree with experimental values determined from infrared and 220 MHz NMR spectra. From infrared spectra, suspension-chlorinated CPVC contains blocks of intact PVC.     

Processability characteristics of chlorinated poly(vinyl chloride)

Chlorinated poly(vinyl chloride) (CPVC) is known to have a higher softening temperature than conventional poly(vinyl chloride) (PVC). Its processability characteristics are, however, different; it has been reported that CPVC is more difficult to process. However, only limited information on the processability characteristics is available. This paper describes some studies of the flow behavior of CPVC melts in a capillary rheometer. The true melt viscosity and activation energy were determined between 190° and 210°C for a number of samples, and they appear to be related to the cohesive energy density of the samples. It was observed that melt fracture, i.e., gross distortion of the extrudate, occurs even at low shear rates in samples having a high chlorine content. This has been attributed to the relatively high pressures that have to be used, the pronounced non-Newtonian nature of the melt, and melt elasticity. It is postulated that melt elasticity could result from crosslinking at the site of the double bond which is known to be formed by dehydrochlorination.     

The structure of chlorinated poly(vinyl chloride). VI. Comparison of the chlorination of poly(vinyl chloride) and β,β-d2-poly(vinyl chloride) with 1H-NMR and 13C-NMR spectroscopy

Samples of chlorinated poly(vinyl chloride) (CPVC) and chlorinated β,β-dideuterated poly(vinyl chloride) (β,β-d₂-CPVC) were prepared under identical reaction conditions. The microstructure of CPVC and β,β-d₂-(CPVC) was characterized by a combination of ¹H-NMR, ¹³C-NMR spectroscopy, and analytically determined chlorine content. A difference was observed in the reaction rates of chlorination of PVC and β,β-d₂-PVC, and, in their thermal chlorination in solution, also in the structure of the chlorinated products. It was proved that in the chlorination of β,β-d₂-PVC a new chlorine atom can also enter the original? CHCl? group. The results are discussed from the standpoint of the chlorination mechanism.     

Structure of chlorinated poly(vinyl chloride). IV. Chlorination of β,β-d2-poly(vinyl chloride) as model for determination of the mechanism of chlorination

Chlorinated β,β-dideuterated poly(vinyl chloride) (β,β-d₂-CPVC) was prepared by photochemical suspension chlorination in concentrated hydrochloric acid with chloroform as swelling agent, and thermally in tetrachloroethane solution. ¹H-NMR (nuclear magnetic resonance) spectra of β,β-d₂-CPVC were recorded. The content of deuterium was determined in combustion products of β,β-d₂-CPVC as the D₂O:(H₁D)₂O ratio by means of mass spectroscopy. Both in the photochemical suspension chlorination and in the thermal solution chlorination of β,β-d₂-PVC, a decrease of the concentration of ? CHCl? groups was observed. The differences in structure of the suspension chlorinated and solution chlorinated β,β-d₂-PVC were confirmed.     

NMR studies of chlorinated poly(vinyl chloride) and polybutadiene

Molecular structures of chlorinated poly(vinyl chloride) and polybutadiene have been studied by high resolution NMR. The spectra of the chlorinated polymers give broad signals. New peaks appear in the lower fields of the ? CH₂? and ? CHCl? groups with increasing chlorine content. The chlorination of poly(vinyl chloride) takes place predominantly on ? CH₂? rather than on ? CHCl? , e.g., a 70% chlorinated polymer has about 10 mole-% of ? CCl₂? groups. Polybutadiene reacts first with chlorine by addition to give a head-to-head poly(vinyl chloride), and then the substitution of the hydrogen atom takes place. Chlorinated polybutadiene with 70% Cl has about 18 mole-% of ? CCl₂? . The multiplets characteristic of spin-spin couplings in the spectrum of the original poly(vinyl chloride) are still observed in that of the highly chlorinated product. This fact shows that a considerable number of poly(vinyl chloride) sequences of certain lengths persist in the highly chlorinated polymer.     

Graft polymers from poly(vinyl chloride) and chlorinated rubber

Graft polymers from poly(vinyl chloride) (PVC) and chlorinated rubber (CIR) with side chains of poly(methyl methacrylate) (PMMA), poly(methyl acrylate) (PMA), or poly(ethyl methacrylate) (PEMA) were synthesized. For this purpose, a vinyl monomer was polymerized in the presence of small quantities of PVC or CIR with benzoyl peroxide as catalyst. The graft polymers were separated from both homopolymers by precipitation with methanol from methyl ethyl ketone solutions of the reaction products and the grafting efficiency was calculated. The graft polymers were characterized by infrared spectra, elemental analysis, NMR, and osmometric or light-scattering determinations. From the results it is concluded that the PVC or CIR molecules contain side chains of PMMA, PMA, or PEMA. The graft polymers showed higher molecular weights, and the values of second virial coefficient for these polymers were much different from those of the starting polymers.     

用DSC研究线形多嵌段聚氨酯与聚氯乙烯、氯化聚氯乙烯共混相容性

用示差扫描量热法（DSC）研究了线形多嵌段聚氨酯（PU）与聚氯乙烯（PVC）、氯化聚氯乙烯（CPVC）共混相容性，说明了PU／VC、PU／CPVC的相容是由于共混物中形成了新的氢键的缘故．聚酯型聚氨酯与PVC、CPVC的相容性要好子聚酸型聚氨酯，CPVC与PU的相容性又要好于PVC．聚氨酯中硬段的引入不利于PU／PVC、PU／CPVC的相容性．     

Photosensitized dehydrochlorination of poly(vinyl chloride). III. Reaction of thermally degraded poly(vinyl chloride) with hydrogen chloride

Films prepared from thermally degraded poly(vinyl chloride) were photolyzed in the presence of hydrogen chloride. When the light was filtered through a Pyrex disk, the absorbance in the region between 270 nm and about 415 nm decreased and reached a minimum value but the absorbance increased at wavelengths shorter than 270 nm and longer than 415 nm. Maximum bleaching occurred at a wavelength which depended on that of the irradiating light. When the Pyrex filter was omitted, an additional slower photodehydrochlorination reaction was superimposed on the photobleaching reaction. Photolysis of hexane or ethanol solutions of 1,8-diphenyloctatetra-1,3,5,7-ene and hydrogen chloride showed a similar reaction involving bleaching of the absorption of the polyene structure. The problems of using absorbance as an indication of the extent of the photodegradation of poly(vinyl chloride) are discussed.