Mild hydrolytic cleavage of α-ferrocenylalkyl-O-methyl ethers

The conversion of α-ferrocenylalkyl-O-methyl ethers into the corresponding alcohols was successfully achieved by solvolysis in water/acetone mixtures. The content of water in the solvent markedly influenced the reaction rates. The reactivity of structurally different classes of ferrocenyl ethers was evaluated and in most cases high yields of ferrocenyl alcohols or diols were obtained in a few hours without any additive. Deprotection of less reactive substrates was accelerated in the presence of montmorillonite. The method is simple, environmentally benign and valuable in providing easy access to a variety of ferrocenyl derivatives through the use of the –O-methyl ether protective group.     

Synthesis of novel disulfide-bridged dilactam crown ethers

The novel macrocyclic dilactams with redox-switched disulfide linkage were synthesized.These compounds were obtained from 2,2'-dithiodibenzoyl chloride in the macrocyclization step by fast addition method in moderate yields.     

Preparation of dehydromorpholines from β-cyanoethyl ethers of acetylenic alcohols

Summary A method has been developed for the synthesis of dehydromorpholines from-cyanoethyl ethers of acetylenic alcohols.     

Asymmetric synthesis of γ-cyano silyl enol ethers

The selective oxidative cleavage of the SAMP-hydrazone moiety of 4-silyloxy-3-enal hydrazones 6, leading to the corresponding 4-silyloxy-3-alkenenitriles 7, is reported. A clean, good yielding transformation was observed when m-CPBA in CH₂Cl₂ was used as the oxidant, the presence of suspended solid NaHCO₃ being essential in preventing hydrolysis of the silyl enol ether moiety. Use of magnesium monoperoxyphthalate (MMPP) led to over-oxidated products, while hydrogen peroxide, in the presence of catalytic methyltrioxorhenium (MTO), was ineffective. Independent measurements of the enantiomeric excesses for compounds 7 demonstrated the absence of racemization during the process.     

Synthesis and structures of α-lithiated vinyl ethers

The structures of α-lithiated vinyl ethers were explored on the basis of a combined computational and NMR study. Calculations (M06/6-31 + G(d)) on free energies of aggregate formation for a series of α-lithiated vinyl ethers indicated that the tetramer is generated preferentially in both the gas phase and THF solution, except for cyclohexylidene derivatives. (1-(Methoxymethoxy)vinyl)lithium, (2,2-difluoro-1-(methoxymethoxy)vinyl)lithium, and (1-butoxyvinyl)lithium were prepared in NMR tubes by the deprotonation of alkyl/alkoxylalkyl vinyl ethers or by the transmetalation of tin compounds. The NMR spectra of these lithium species in THF solution showed that in each species one aggregate is primarily present at 173 K, which is consistent with the preference of the tetramer.     

Intramolecular ring closure of α,β-epoxy sulfoxides with hydroxyl group: A novel synthesis of 2-acyl cyclic ethers and 3-keto cyclic ethers

Exo-trigonal-type intramolecular ring closure of the α,β-epoxy sulfoxides with hydroxyl group gave 2-acyl cyclic ethers (5, 6, and 13 membered rings) in good yields. In contrast to this, endo-trigonal-type ring closure of the α,β-epoxy sulfoxides was rather difficult.     

A new approach to the synthesis of cyclic ethers via the intermolecular allylation of α-acetoxy ethers and ring-closing metathesis

A concise synthesis of the isolaurepinnacin skeleton 6 was achieved via the intermolecular allylation of the α-acetoxy ether 3 followed by ring-closing metathesis. This methodology was successfully applied to the convergent synthesis of the oxocene 15, an advanced synthetic intermediate for the total synthesis of laurencin.     

Addition of some α-halogeno ethers to α-thiooxides of alkenes

Summary Products of the addition of allyl chloromethyl ether, -chloroethyl methyl ether, -acetoxyethyl chloromethyl ether, cyclohexyl chloromethyl ether, and -chloroethyl ethyl ether to the thiooxides of ethylene and propylene have been prepared.     

γ-Rays-induced synthesis of hydrogels of vinyl ethers with stimuli-sensitive behavior

γ-Radiation method was applied to synthesize novel water-soluble and water-swelling polymers. Vinyl ether of ethylene glycol (VEEG), vinyl butyl (VBE) and vinyl isobutyl (VIBE) ethers were used as monomers. The synthesis of VEEG–VBE and VEEG–VIBE copolymers was carried out in a wide range of feed composition and absorbed dose. It was found that the hydrophobic–hydrophilic balance of the copolymers could be delicately varied by the copolymer composition as well as by the chemical structure of the alkyl substitute in the hydrophobic moiety. The copolymers exhibit thermo-sensitive behavior in water solutions. The value of transition temperature is considerably decreased at a higher concentration of the hydrophobic component in the copolymer composition.     

Molecular complexes of crown ethers. part 2: Complexes between crown ethers and π acceptors

The intermolecular charge transfer (CT) complexes of four crown ethers (CE), viz. B15C5, B18C6, DB18C6 and DB24C8 (as donors), and three acceptors, i.e. tetracyanoethylene (TCNE) 7,7,8,8-tetracyanoquinodimethane (TCNQ) and chloranil were studied in the UV-Visible region in 1,2-dichloroethane (DCE) at 298.2 K. Solid complexes were also prepared and the ratio of the donor to the acceptor was 1:1. Results indicate that the _max of the CT band decreases whileK _c (formation equilibrium constant) increases following the systematic change of the electron affinity of the acceptors. TheK _c values suggest that the phenyl group in CE plays a major role in the formation of a CT complex.     

PMA-SiO2 catalyzed synthesis of β-keto enol ethers

An efficient conversion of β-diketones into correspondingβ-keto enol ethers with catalytic amount of PMA-SiO_2 has been achieved.     

Addition of some α-halo ethers to unsaturated compounds

Summary The addition was carried out of 2-acetoxyethyl chloromethyl ether and of 2-chloroethyl chloromethyl ether to isobutene, to allyl chloride, to styrene, and to allyl acetate and also of 2-acetoxyethyl chloromethyl ether to butadiene and to ethyl cinnamate.     

Oxidative conversion of silyl enol ethers to α,β-unsaturated ketones employing oxoammonium salts

The oxidative conversion of silyl enol ethers to α,β-unsaturated ketones using a less-hindered class of oxoammonium salts (AZADO(+)BF(4)(-)) is described. The reaction proceeds via the ene-like addition of oxoammonium salts to silyl enol ethers.     

Zn-mediated rhodium-catalyzed α-trifluoromethylation of ketones via silyl enol ethers

The treatment of silyl enol ethers of ketones with CF₃-I and Et₂Zn in the presence of RhCl(PPh₃)₃ in DME gave α-trifluoromethyl ketones in good yields. The reaction can be widely applicable to silyl enol ethers derived from aliphatic or aromatic ketones. In the absence of the rhodium catalyst, the reaction was very slow and the yields were quite poor.