High Frequency and High Mode Purity Operations of Gyrotron FU IVA

The cavity of the newest gyrotron, Gyrotron FU IVA in the high frequency series of Fukui University gyrotrons (the Gyrotron FU series) is designed to minimize the mode conversion from the main cavity mode to the higher modes. In this paper, the experimental results are compared with simulations for the complete gyrotron oscillator. The gyrotron has an additional advantage to cover the wide frequency range in submillimeter wave region.     

High Power, Frequency Tunable, Submillimeter Wave ESR Device Using a Gyrotron as a Radiation Source

ESR device using a submillimeter wave gyrotron as a radiation source and a pulse magnet for high field up to 30 T has been constructed. Our gyrotrons (Gyrotron FU series) were developed as millimeter and submillimeter wave radiation sources and have attractive advantages for ESR spectroscopy, for example, high power and frequency tunability over broad range. The ESR device has been successfully applied to three cases of ESR measurements. In the first case, the temperature dependence of ESR was measured for a typical antiferromagnetic material MnO at the frequency of 301 GHz. In the second case, the dependence of the fine structure constant of the ruby on the magnetic field intensity was measured in the millimeter to submillimeter wave region. In these two cases, the gyrotron was operated by complete cw mode. In the final case, a pulse technique was applied to the ESR, the gyrotron was operated in pulse mode and the pulsed magnetic field was generated in the synchronized phase with the gyrotron operation.     

CW Operation of a Submillimeter Wave Gyrotron (Gyrotron Fu IV) for High Stability of the Output Frequency

The first cw operation of our submillimeter wave gyrotron (Gyrotron FU IV) using a 12 T superconducting magnet has been successfully carried out. Output power is more than 20 W at a frequency of 301 GHz in the TE₀₃₁ resonant cavity mode. Time-resolved frequency measurement s shows that the frequency fluctuation of the gyrotron output is smaller than 2 MHz. This frequency fluctuation is mainly due to the fluctuation in the output voltage of the power supply.     

Observation of Frequency Down-Shift in a Submillimeter Wave Gyrotron

Frequency down-shift in the initial stage of CW or long pulse operation of a submillimeter wave gyrotron, Gyrotron FU IV, is observed. The shift occurs in a few minutes after turning on the operation and the amount of the shift attains even 0.1 GHz. The observation results are analyzed on the basis of a simple model for heat conduction in the region of a resonant cavity. The frequency shift is explained consistently by expansion of the cavity.     

Higher Harmonic Operations of Submillimeter Wave Gyrotrons (Gyrotron FU Series)

Higher harmonic operation of gyrotrons is necessary to obtain high frequencies. Some gyrotrons included in the Gyrotron FU series developed at Fukui University have achieved operation at the third and even fourth harmonics of the electron cyclotron frequency. The output lies in the millimeter to submillimeter wavelength range and the output powers are several watts to several tens of watts. In this paper, the gyrotrons and the conditions under which they operate are described in detail.     

Application of the Gyrotron FU II Submillimeter Wave Radiation Source to Plasma Scattering Measurements

Gyrotron FU II has been successfully applied as a submillimeter wave radiation source to plasma scattering measurements on the Compact Helical System (CHS) in National Institute for Fusion Science (NIFS) in Japan. The gyrotron operates in a long pulse mode (the pulse width is about 600 ms) at a frequency of about 350 GHz (the corresponding wavelength is 0.85 mm). The output power is about 110 W. The output power is transmitted along a circular waveguide system and converted to a Gaussian-like beam by a quasi-optical antenna. After that, the beam is directed onto the CHS plasma and the scattered signal is detected by a homodyne detection system. The frequency and the wave number of the scattered signal are analyzed. The results suggest that a broad band low frequency (several tens to several hundreds kHz) density fluctuation is excited in the CHS plasma only during neutral beam injection (NBI) or ion cyclotron resonance (ICR) heating.     

Mode Cooperation in a Submillimeter Wave FU Series Gyrotron

At certain gyrotron operating conditions, mode cooperation instead of mode competition takes place between a fundamental and a second harmonic mode. This means the phase bunching of a gyrating electron beam under the second harmonic operation reduces the starting current for the fundamental operation and increases total output power as well as beam efficiency. Such mode cooperation is observed in experiments and confirmed by computer simulations for submillimeter wave Gyrotron FU II.     

Production of an Intense, Well-Collimated Submillimeter Wave Beam and Its Application to Plasma Scattering Measurements

Intense submillimeter wavelength radiation (f=354 GHz, P=110 W) from Gyrotron FU II is converted into a well-collimated, linearly-polarized beam by a quasi-optical transmission line consisting of a quasi-optical antenna and several mirrors. The observed focusing of the beam agrees with calculations based on the Huygens equation. We have used this intense beam to study low frequency density fluctuations by plasma scattering in Compact Helical System (CHS) plasmas at the National Institute for Fusion Science.     

Analysis of a Complete Gyrotron Oscillator Using the Scattering Matrix Description

Complete harmonic gyrotron oscillators in axial arrangement including cavity, uptapers, collector waveguide and output window have been numerically simulated using a scattering matrix resonator code. The output mode purity and the influence of window reflections on the performance of a step-tunable, very high frequency gyrotron, Gyrotron FU IV A, at Fukui University was analyzed.     

THE FIRST EXPERIMENT OF A THz GYROTRON WITH A PULSE MAGNET

A THz gyrotron with a pulse magnet has been designed, constructed and operated in FIR FU. It is developed as one of high frequency gyrotrons included in Gyrotron FU Series. The gyrotron has already achieved the first experimental result for high frequency operations whose radiation frequency exceeds 1 THz. In this paper, the design detail and the operation test results for sub-terahertz to terahertz range are described. The second harmonic operation is confirmed experimentally at the expected frequency of 1.005 THz due to TE_6,11 cavity mode at the magnetic field intensity of 19.0 T.     

Development of 394.6 GHz CW Gyrotron (Gyrotron FU CW II) for DNP/Proton-NMR at 600 MHz

Gyrotron FU CW II with an 8 T liquid He free superconducting magnet, the second gyrotron of the THz Gyrotron FU CW Series, has been constructed and the operation test was successfully carried out. It will be used for enhancing the sensitivity of 600 MHz proton-NMR by use of Dynamic Nuclear Polarization (DNP). The designed operation mode of the gyrotron is TE_2,6 at the second harmonic. The corresponding frequency is 394.6 GHz. The real operation frequency is 394.3 GHz at TE₀₆ mode, because of fabrication error of the diameter of the cavity. The operation is in complete CW at the output power of around 30 W or higher at the TE₀₆ cavity mode. There are many other operation modes at the fundamental and the second harmonic. Typical output power of the fundamental and the second harmonic are higher than 100 W and 20 W, respectively. The highest frequency observed up to the present is 443.5 GHz at the second harmonic operation of TE_6,5 mode. The measured results are compared with the theoretical consideration.     

Observation of Mode Patterns for High Purity Mode Operation in the Submillimeter Wave Gyrotron FU VA

Operation tests of a cavity designed for high purity mode operation of the submillimeter wave gyrotron FU VA has been carried out successfully. The observed emission patterns of several cavity modes appear very pure and are compared with calculated results. High purity mode operation has the advantage of making the conversion to Gaussian-like beams more efficient.     

Observation of Mode Patterns for High Purity Mode Operation in the Submillimeter Wave Gyrotron FU VA

Operation tests of a cavity designed for high purity mode operation of the submillimeter wave gyrotron FU VA has been carried out successfully. The observed emission patterns of several cavity modes appear very pure and are compared with calculated results. High purity mode operation has the advantage of making the conversion to Gaussian-like beams more efficient.     

Simulation and measurement of frequency modulation insubmillimeter-wave gyrotron

Frequency modulation of the gyrotron output has been numerically simulated employing the approximation of weakly relativistic, mono-velocity electron beam as well as a quasi-empirical approach. The simulation results are compared to a first experiment in the 300 GHz region performed with a submillimeter-wave gyrotron named “Gyrotron FU IV”. The modulation amplitude of 30 MHz has been achieved by a 120 V modulation of the accelerating voltage resulting in the variation of the relativistic electron mass and in the corresponding modulation of the electron cyclotron frequency. Calculated amplitudes of frequency modulation are in reasonable agreement with the experimental results     

Tuneable millimeter-wave gyrotrons

In the course of developing a low-power, tuneable millimeter-wave source, two gyrotrons have been constructed. Gyrotron I was a fixed-frequency device operating at 120 GHz while Gyrotron II produced more than 20 lines in the frequency range 130 to 260 GHz. The design of tuneable gyrotrons is discussed with reference to the Gyrotron II results.     

A quarter century of gyrotron research and development

The development of small-orbit gyrotrons operating at voltages ⩽100 kV is reviewed. Gyrotron oscillators have been developed to produce unprecedented 200-kW average power levels at frequencies spanning the range of 28-140 GHz with current work aimed at achieving 1-MW average power. They are widely used in plasma-heating studies and are the natural choice for material processing in the millimeter-wave region. Gyrotron amplifiers have exceeded the peak power limits of more conventional amplifiers at both 35 and 94 GHz, and have been used in a few radars. Gyro-amplifiers under development have been designed to surpass both the peak power and the average power limits of conventional amplifiers, and are anticipated to be widely accepted in millimeter-wave radar systems. Gyrotron amplifiers operating at voltages ~0.5 MV that are being evaluated for accelerator applications were reviewed in this journal in 1996 and are not included in this review paper,     

Phase Lock-In of MM/SUBMM Backward Wave Oscillators: Development, Evolution, and Applications

The development and evolution of a Phase-Lock Loop (PLL) system up to the highest frequencies of Backward Wave Oscillators (BWO) is considered starting from the first submillimeter BWO PLL in 1970. Improvements and increase of working range near to Terahertz are followed. Development of the series of commercial BWO-based millimeter wave frequency synthesizers, extension of the BWO PLL beyond Terahertz as well as recent progress in fast millimeter wave frequency synthesizers are described. Applications of BWO PLL systems for physical and technical measurements are discussed and some proposals for the next generation of BWO-based synthesizers are presented.     

过模矩形波导中硅芯片与基模亚毫米波的作用

模拟研究了过模矩形波导WR10中n型硅探测芯片对TE10模亚毫米波的响应。针对过模波导WR10中内置n型硅芯片的亚毫米波探测结构,推导了基模工作时的灵敏度表达式。采用三维电磁场时域有限差分方法,模拟计算了过模波导中300～400GHz频带的TE10模亚毫米波与硅芯片的相互作用,分析了探测结构中电压驻波比和芯片内平均电场随硅芯片参数变化的规律。结果表明,在相同的芯片参数下,过模探测结构并不影响电压驻波比和芯片内平均电场的大小,但两者随频率变化的波动程度增大。在300～400GHz工作频带内,优化得到了性能较优的过模探测结构,其电压驻波比不大于2.75(335～380GHz频带内不大于1.8),线性工作区的相对灵敏度约为0.127kW-1,频率响应的波动范围在±20.5%内,最大承受功率约为0.53kW,响应时间为100ps量级,满足亚毫米波大功率脉冲的直接探测需求。     

Evaluation of a simplified Doppler frequency shifter

Mechanical Doppler frequency shifting of a millimeter or submillimeter wave signal provides a means to implement a sensitive and highly coherent heterodyne receiver in a laboratory system. The rotary shifter, which we have previously described, is a precision-machined device suitable for use down to submillimeter wavelengths. We found at 140GHz, however, that the coherence of such a system is not affected by mechanical imprecision of the frequency shifter, and that the system dynamic range is only moderately affected by mechanical imprecision and by certain design simplifications. We have therefore built several versions of simpler and less precise Doppler frequency shifters and report here on their performance at 140GHz.     

Metal mesh couplers using evanescent waves at millimeter and submillimeter wavelengths

In this paper we introduce a metal mesh evanescent wave coupler that makes use of evanescent wave coupling between a metal mesh and a dielectric plate, as a quasi-optical component for millimeter and submillimeter wavelengths. The transmission properties of this type of couplers have been investigated experimentally and theoretically for both capacitive and inductive metal meshes in the frequency range from 40 GHz to 60 GHz. The transmittance of a capacitive metal mesh evanescent wave coupler can be adjusted more than 70% by changing the spacing between the capacitive mesh and the silicon plate less than 0.15 mm at around 57 GHz.