Comparison of methods for the determination of total selenium in plasma by magnetic sector inductively coupled plasma mass spectrometry

Three sample preparation methods (dilution, microwave digestion and ethanol addition) were evaluated for the determination of Se in human plasma using magnetic sector inductively coupled plasma mass spectrometry (ICP-MS). A number of instrumental parameters were also considered, namely the choice of internal standard (Sc, Rh, In) and pre-defined spectral resolution (m/Δm ∼300 (low resolution, LR) and ∼7500 (high resolution, HR)). The isotopes and were selected for analysis avoiding the major and unresolvable Ar dimer interferences associated with other Se isotopes.Ethanol addition was found to be the most suitable and reliable sample preparation method. The optimum ethanol concentration for a 1+9 dilution of the plasma sample was 0.5% (v/v). Indium or Sc were selected over Rh as internal standards as Seronorm™ Level 1 target values were achieved at lower concentrations of ethanol modifier. Representative ICP-MS detection limits for this method using (HR) and (HR), were 0.1 and 0.2 μg l⁻¹.Accurate analysis of Se in Seronorm™ Level 1 (MI0181) was found using either or and HR (86±5 and 83±5 μg l⁻¹ respectively, n=5, In internal standard, target value=83±6 μg l⁻¹). Although offering improved precision (e.g. LR: 0-3% versus HR: 1-6%), accurate results were only obtained with LR for the Seronorm™ Level 1 sample when using (86±1 μg l⁻¹). The major interference precluded accurate Se analysis using and LR for all samples considered. Reliable Se concentrations were only found for a “real” pooled sample when using (HR), in part a result of non-negligible and unresolved interference when using LR. Consistently elevated Se concentrations were found under all conditions when Seronorm™ Level 2 (NO0371) was analysed. These results were confirmed by independent GF-AAS analysis.Magnetic sector ICP-MS with (HR), in combination with the ethanol addition sample preparation method, was used for the analysis of Se in human plasma samples as part of a small pilot study. Average measured selenium concentrations were 102±18 μg l⁻¹ (n=18).     

Determination of chromium, cadmium and lead in food-packaging materials by axial inductively coupled plasma time-of-flight mass spectrometry

Inductively coupled plasma mass spectrometry (ICP-MS) with a time-of-flight (TOF) analyser was used for the determination of chromium, cadmium and lead in six food-packaging materials (paper and paper board). The samples (0.20-0.25 g) were digested in concentrated nitric acid in a high pressure microwave oven at 180 °C within 15 min. Two different plasma conditions were applied: cool plasma conditions (0.76 kW; 0.85, 0.89 and 15.5 l min⁻¹ nebuliser, auxiliary and plasma gas flow rate, respectively) for the determination of chromium and normal plasma conditions (1.21 kW; 0.66, 0.68 and 13.6 l min⁻¹ nebuliser, auxiliary and plasma gas flow rate, respectively) for the determination of cadmium and lead. External calibration was used in combination with rhodium (40 ng g⁻¹) as an internal standard. The detection limits (DL = 3S.D./sensitivity) under the conditions used corresponded to 0.01 ng g⁻¹ (), 0.06 ng g⁻¹ (), 0.07 ng g⁻¹ (), 0.03 ng g⁻¹ () and 0.02 ng g⁻¹ ( and ). The precision (R.S.D.) for six replicate determinations (10 s integration time) of 1 and 10 ng g⁻¹ of each analyte varied from 0.72% () to 4.43% (). The contents of chromium, cadmium and lead in the examined materials were evaluated using the signals of , and . They were in the range: 0.25-0.50 μg g⁻¹ for Cr, not detected (nd) to 0.12 μg g⁻¹ for Cd and 0.28-0.35 μg g⁻¹ for Pb in paper and 0.50-0.64 μg g⁻¹ for Cr, nd to 0.09 μg g⁻¹ for Cd and 0.67-0.99 μg g⁻¹ for Pb in paper board.     

Determination of sulfur-containing amino acids by capillary electrophoresis dynamic reaction cell inductively coupled plasma mass spectrometry

Capillary electrophoresis dynamic reaction cell™ inductively coupled plasma mass spectrometry (CE-DRC-ICP-MS) for the determination of sulfur-containing amino acids is described. The sulfur-containing amino acids studied include l-cysteine, l-cystine, dl-homocystine and l-methionine. The species studied were well separated using a 70 cm length×75 μm i.d. fused silica capillary while the applied voltage was set at +22 kV and a 10 mmol l⁻¹ disodium tetraborate buffer (pH 9.8) containing 0.1 mmol l⁻¹ EDTA and 0.5 mmol l⁻¹ Triton X-100 was used as the electrophoretic buffer. The sulfur-selective electropherogram was determined at m/z 48 as by using its reaction with O₂ in the reaction cell. The method avoided the effect of polyatomic isobaric interferences at m/z 32 caused by and on by detecting as the oxide ion at m/z 48, which is less interfered. The detection limit of various species studied was in the range of 0.047-0.058 μg S ml⁻¹, which corresponded to the absolute detection limit of 1.3-1.6 pg S based on the injection volume of 27 nl. We determined the concentrations of selected sulfur-containing amino acids in urine and nutritive complement samples. The recovery was in the range of 92-128% for various species.     

Hetero dimer from tetrakisammonium cavitand and tetratopic crown ether cavitand

Hetero dimer between tetrakis(m-ammonium)cavitand and tetrakis(dibenzo-25-crown-8)cavitand 5 was formed in CDCl₃ at room temperature. The effects of solvent polarity and temperature on the stability of were studied and the thermodynamic parameters for the formation of are , ΔH⁰ = −67.4 kcal mol⁻¹ and ΔS⁰ = −201.6 cal mol⁻¹ K⁻¹.     

A new fluorescent metal sensor with two binding moieties

A new fluorescent chelator Oxa, having two metal-binding sites, was designed and synthesized in six steps. Oxa exhibited two distinctive dissociation constants for Zn²⁺ ( μM and  μM), with considerable fluorescence increase in aqueous buffer at pH 7.2. Affinities of Oxa for the other biologically important ions such as Ca²⁺ ( μM and  mM) and Mg²⁺ ( μM and could not be determined) in the same conditions were also obtained.