二氧化硫脲对有机化合物的还原作用研究

报道了在碱性醇水溶液中，二氧化硫脲对含有硝基、羰基及烯键的有机化合物的还原作用，研究了这些反应的反应条件、反应产物和反应机理。     

原油中有机硫化物成因的硫酸盐热化学还原反应模拟研究

原油中部分有机硫化物来源于硫酸盐热化学还原反应。利用高压釜在高温高压含水条件下对正戊烷 硫酸镁反应体系进行了热模拟实验研究。通过气相色谱仪、微库仑仪、毛细管气相色谱/脉冲火焰光度检测器、红外光谱仪及X射线衍射仪,对气、油、固三相产物进行了分析。结果表明,硫酸盐热化学还原反应在425℃~525℃可以进行,主要生成氧化镁、炭、硫化氢、二氧化碳以及硫醇、硫醚和噻吩类等有机硫化物。根据动力学模型计算出该反应活化能为58.0kJ/mol。     

Reactions of organic halides with organometallic compounds and terminal acetylenes catalyzed by palladium complexes

The results of the investigation of the cross-coupling of organometallic compounds and terminal acetylenes with organic halides catalyzed by transition metal complexes are generalized and analyzed. The influence of different factors on the rate and selectivity of catalytic cross-coupling is discussed. A detailed mechanism of the cross-coupling of Grignard reagents with organic halides is suggested. The cross-coupling reaction involving organotin compounds proceeds under very mild conditions in the presence of a ligand-free Pd catalyst. Examples of using catalytic cross-coupling of organic halides with organomagnesium, organozinc, and organotin compounds are presented.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 2148–2167, September, 1996.     

Tubular bimetal oxysulfide CuMgOS catalyst for rapid reduction of heavy metals and organic dyes

Tubular bimetal oxysulfide CuMgOS catalyst was prepared using a feasible method at a low process temperature of 95°C. X‐ray diffractometry, X‐ray photoelectron spectrometry, field emission‐scanning electron microscopy, transmission electron microscopy, UV–Vis diffuse reflectance spectroscopy, photoluminescence emission spectrum, and nitrogen adsorption–desorption isotherms were used for CuMgOS characterizations. The CuMgOS reduction activities were investigated through the reduction of heavy metals of Cr (VI), Pb (II) and Hg (II) solutions, and the organic dyes of rhodamine‐B (RhB), methyl orange (MO) and methylene blue (MB) solutions under dark. The results showed that the CuMgOS prepared with an appropriate N₂H₄ amount for a suitable Cu (I)/Cu (II) ratio exhibited fast reduction activity without adding any reagents, with which the 100 mL Cr (VI), Pb (II) and Hg (II) solutions of 50 ppm were 100% reduced by 20 mg CuMgOS within 4 min, 6 min and 4 min, respectively. The 100 mL RhB, MO and MB solutions of 50 ppm were 100% reduced by 10 mg CuMgOS within 4 min, 5 min and 1 min, respectively, under the existence of NaBH₄. CuMgOS displayed excellent chemical stability for the re‐use tests on heavy metal ions and organic dyes. The excellent performance is attributed to CuMgOS bimetal oxysulfide catalyst with active surface reaction centers to interact with reactants, and the carrier hopping between Cu (I) and Cu (II).     

Evaluation of a new graphitized carbon black employed in sampling volatile organic compounds

A new adsorbent, high-surface-area graphitized carbon black (HSGCB), with a surface area of 560 m²/g, superior to that of commonly traded graphitized carbons, was studied. The evaluation was performed in terms of breakthrough volumes and thermal desorption recoveries of substances representative of the main classes of organic compounds. HSGCB was found to be an interesting alternative to activated charcoal for volatile compounds in that it can be used in thermal desorption.     

The reduction of aromatic nitro compounds by oxiranes

Aromatic nitro compounds are reduced to the corresponding amines by epoxides at elevated temperatures (>170 °C).Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1491–1494, August, 1994.The authors are grateful to Prof. Yu. N. Belokon' for his participation in the discussion of the results of the work.This work was financially supported by the Russian Foundation for Basic Research (code No. 93-03-18044).     

Regioselective Arene C−H Alkylation Enabled by Organic Photoredox Catalysis

Expanding the toolbox of C?H functionalization reactions applicable to the late‐stage modification of complex molecules is of interest in medicinal chemistry, wherein the preparation of structural variants of known pharmacophores is a key strategy for drug development. One manifold for the functionalization of aromatic molecules utilizes diazo compounds and a transition‐metal catalyst to generate a metallocarbene species, which is capable of direct insertion into an aromatic C?H bond. However, these high‐energy intermediates can often require directing groups or a large excess of substrate to achieve efficient and selective reactivity. Herein, we report that arene cation radicals generated by organic photoredox catalysis engage in formal C?H functionalization reactions with diazoacetate derivatives, furnishing sp²–sp³ coupled products with moderate‐to‐good regioselectivity. In contrast to previous methods utilizing metallocarbene intermediates, this transformation does not proceed via a carbene intermediate, nor does it require the presence of a transition‐metal catalyst.     

Recent advances in transition-metal-catalyzed asymmetric reactions of diazo compounds with electron-rich (hetero-) arenes

The transition-metal-catalyzed reaction of diazo compounds with arenes or heteroarenes is an efficient and straightforward approach to functionalize aromatic compounds. This digest summarizes recent progresses on transition-metal-catalyzed asymmetric reactions of diazo compounds with electron-rich (hetero-) arenes, including C–H functionalization, cascade reaction, cyclopropanation, cycloaddition, Buchner reaction and intramolecular dearomatization.     

Isolation and preconcentration of volatile organic compounds from water

Methods for the isolation and/or concentration of volatile organic compounds from water samples for trace organic analysis by gas chromatography are reviewed. The following basic groups of methods are discussed: liquid-liquid extraction, adsorption on solid sorbents, extraction with gas (gas stripping and static and dynamic headspace techniques) and membrane processes. The theoretical bases of these methods are discussed. Experimental arrangements for the isolation and/or concentration of volatile compounds from water are presented and discussed with respect to their efficiency. The applicability of the described methods to the isolation and/or concentration of various organic compounds from waters of various origins is discussed.     

有机同系物性质的递变规律研究

以有机同系物结构重复单元数值连续变化为模型,得到同系物行质递变的两个基本规律：P=a+bn和P=c+kln(n+a/n+b),a,b,c,k均为常数,n为结构重复单元数值,P为同系物的物性。一般地,加和型性能遵守直线变化规律,而结构型和凝聚型性能遵守同系对数线性规律。     

Redox‐Active Ligands in Catalysis

Nature’s use of redox‐active moieties combined with 3d transition‐metal ions is a powerful strategy to promote multi‐electron catalytic reactions. The ability of these moieties to store redox equivalents aids metalloenzymes in promoting multi‐electron reactions, avoiding high‐energy intermediates. In a biomimetic spirit, chemists have recently developed approaches relying on redox‐active moieties in the vicinity of metal centers to catalyze challenging transformations. This approach enables chemists to impart noble‐metal character to less toxic, and cost effective 3d transitional metals, such as Fe or Cu, in multi‐electron catalytic reactions.     

Adsorption and mobility of molecules of water and organic compounds in carbon adsorbents

The mobility of molecules of water and fluorine-containing organic compounds adsorbed in a mixture on active carbons has been studied by the NMR pulsed field gradient technique (¹H and¹⁹F resonances). Samples with various H₂O/C₆F₆ and H₂O/C₂Cl₃F₃ ratios have been examined. The mobility of components at total fill factors > 0.8 has been shown to decrease in comparison with the adsorption of pure substances while the diffusion activation energy increases. The results are interpreted on the basis of adsorption mechanisms of water and organic compounds on active carbons.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 56–61, January, 1993.In conclusion the authors would like to express their thanks to the German Research Society for the financial support of this work.     

Adsorption of volatile organic compounds in porous metal–organic frameworks functionalized by polyoxometalates

The functionalization of porous metal–organic frameworks (Cu₃(BTC)₂) was achieved by incorporating Keggin-type polyoxometalates (POMs), and further optimized via alkali metal ion-exchange. In addition to thermal gravimetric analysis, IR, single-crystal X-ray diffraction, and powder X-ray diffraction, the adsorption properties were characterized by N₂ and volatile organic compounds (VOCs) adsorption measurements, including short-chain alcohols (C<4), cyclohexane, benzene, and toluene. The adsorption enthalpies estimated by the modified Clausius–Clapeyron equation provided insight into the impact of POMs and alkali metal cations on the adsorption of VOCs. The introduction of POMs not only improved the stability, but also brought the increase of adsorption capacity by strengthening the interaction with gas molecules. Furthermore, the exchanged alkali metal cations acted as active sites to interact with adsorbates and enhanced the adsorption of VOCs.     

Catalytic reduction of NOx by CO on hydrotalcites-derived mixed oxides CoAlM and MgAlM (M=Cr,Mn, Fe,Co, Ni,Cu)

Two series of mixed oxides, GIAlM and MgAlM (M= G, Mn, Fe, Co, Ni, Cu), were prepared by calcining their corresponding hydrotalcite-like compounds (HTLc). The ratio of Mg: Al: M (or Co: Al: M) was 3:1:1. The catalytic activity of all samples for the reaction of NO + CO was investigated. The results showed that the activity of CoAlM was much higher than that of MgAlM. The structure and the property of redox were characterized by XRD and H₂-TPR. The results indicated that only MgO phase was observed after calcining MgAlM hydrotalcites, and the transition metals became more stable. The spinel-like phase appeared in all of CoAlM samples after the calcination, and the transition metals were changed to be more active, and easily reduced. The activities of three series of mixed oxides CoAlCu obtained from different preparation methods, Different ratio of Co: Al: Cu and at different calcination temperatures. were studied in detail for proposing the mechanism of reaction. The ability of adsorption of NO and CO were investigated respectively for supporting the mechanism.     

Indirect polarographic microdetermination of chlorine or bromine in organic compounds

A polarographic method for the microdetermination of chlorine or bromine in organic compounds is based on oxygen-flask combustion followed by an exchange reaction of chloride or bromide with excess of solid silver chromate, and polarographic determination of the chromate liberated. The method has been applied satisfactorily to a wide range of chlorine or bromine organic compounds with a coefficient of variation not exceeding 1%.     

Catalytic reduction of NO_x by CO on hydro-talcites-derived mixed oxides Co AIM and MgAlM (M = Cr, Mn, Fe, Co, Ni, Cu)

Two series of mixed oxides, CoAlM and MgAlM (M= Cr, Mn, Fe, Co, Ni, Cu) , were prepared by calcining their corresponding hydrotalcite-like compounds (HTLc) . The ratio of Mg: Al: M (or Co: Al: M) was 3:1:1. The catalytic activity of all samples for the reaction of NO CO was investigated. The results showed that the activity of CoAlM was much higher than that of MgAlM. The structure and the property of redox were characterized by XRD and H2-TPR. The results indicated that only MgO phase was observed after calcining MgAlM hydrotalcites, and the transition metals became more stable. The spinel-like phase appeared in all of CoAlM samples after the calcination, and the transition metals were changed to be more active, and easily reduced . The activities of three series of mixed oxides CoAlCu obtained from different preparation methods, different ratio of Co:Al:Cu and at different calcination temperatures, were studied in detail for proposing the mechanism of reaction. The ability of adsorption of NO and CO     

Homogeneously catalysed isomerisation of allylic alcohols to carbonyl compounds

Isomerisation of allylic alcohols forms an elegant shortcut to carbonyl compounds in a completely atom-economical process that offers several useful applications in natural-product synthesis and in bulk chemical processes. This review focuses on the heart of isomerisation catalysis: the catalyst. Combinations of transition metals (from Group 4 to 10), ligands and reaction conditions are compared with respect to yield, turnovers, rate and selectivity. A selected number of clever solutions to synthetic problems are highlighted, such as the synthesis of enols and enolates, chiral carbonyl compounds and silyl substituted ketones. Furthermore, a general overview of the mechanisms proposed for the isomerisation of allylic alcohols is given while some catalyst systems are singled out to discuss mechanistic research.     

Determination of very volatile organic compounds in environmental water by injection of a large amount of headspace gas into a gas chromatograph

An injection method for a large amount of headspace gas which enables determination of trace amounts of very volatile organic compounds (VVOCs), dichlorodifluoromethane, chloromethane, vinyl chloride, bromomethane, chloroethane and trichlorofluoromethane in all kinds of environmental water was developed. A gas phase equilibrated with the water phase in a vial was purged with helium for a short time. The VVOCs were then introduced into a trapping tube packed with Tenax TA, which had been cooled using carbon dioxide. After trapping, the VVOCs were thermally desorbed and put into a GC–MS system for subsequent analysis. This method is applicable to various types of samples.     

Co?Cu?Al mixed oxides derived from hydrotalcite-like compound for NO reduction by CO

Various hydrotalcite based catalysts were prepared for catalytic removal of NO (NO reduction by CO). The general formula of hydrotalcite compounds (HTLc) was Co−Cu−Al-HTLc. Precalcination of these materials at 450°C for NO reduction by CO, was necessary for catalytic activity. All catalysts except Co−Al and Cu−Al have very good activity at lower temperature for NO reduction by CO. All samples were characterized by XRD and BET. The tentative reaction mechanism was also proposed.