Heterogeneous reactions of singlet molecular oxygen with solid polymers

The effect of gas-phase singlet molecular oxygen (¹ΔO₂) upon several solid polymers was investigated by using electron paramagnetic resonance, infrared spectroscopy, and chemical detection techniques. The study was performed by use of ¹ΔO₂ produced by microwave discharge. The application of this method to polymer studies was closely examined. The saturated-chain polymers polystyrene, polyurethane, and polyethylene were found to be inert within the experimental conditions to reaction with ¹ΔO₂, while the unsaturated polymers cis-polybutadiene, trans-polybutadiene, and trans-polyisoprene were found to react quite readily in an apparently surface or near-surface limited reaction to produce hydroperoxide and/or peroxide groups. The introduction by homogeneous mixing of some known metal-chelate ¹ΔO₂ quenchers into the polymer trans-polyisoprene appeared to significantly decrease the rate of oxidation observed.     

Oxidation of fully substituted alkoxyoxazolcs with singlet molecular oxygen

Diacylcurbamatcs IV can be prepared from alkoxyoxazoles 1 by ¹O₂ oxidation. When the reaction is opportunely earried out a new heterocyclic system, namely the 3H-1, 2, 4-dioxazole III, is formed. A mechanistic interpretation of the results is suggested.     

Soluble polymers with pendant thionine groups: Synthesis and evaluation as singlet oxygen photosensitizers

Thionine ( 1 ) has been covalently bound to linear copoly(styrene-p-vinylbenzyl chloride) and to linear copoly(acrylic acid-2-ethylhexyl acrylate). The resulting polymeric dyes, purified by ultrafiltration, present quantum yields of singlet oxygen generation in dimethylformamide solution lower than their corresponding low-molecular-weight models thionine hydrochloride ( 1.HCl ) and N(3)-acetylthionine ( Ac-1 ), the decrease being more pronounced in the case of the polystyrene-dye photosensitizer. High chromophore concentrations within the volume encompassed by each macromolecule in the solution can explain this fall in efficiency. The free dyes thionine hydrochloride and its hydrolysis products thionoline ( 2 ) and thionol ( 3 ) behave as good singlet oxygen generators, with quantum yields of 0.71, 0.62, and 0.63, respectively. © 1993 John Wiley & Sons, Inc.     

Reversible light and air-driven lithography by singlet oxygen

Monolayers and thin films of diphenylanthracene react in the presence of a singlet oxygen sensitizer by irradiation on air to the corresponding endoperoxides and reconvert to the starting compounds upon heating. This reaction has been applied to create 2D fluorescent pattern structures. Motifs which are written by this technique can be erased and replaced by new images.     

Oxidation of human catalase by singlet oxygen in myeloid leukemia cells

Catalases are oxidized by singlet oxygen giving rise to more acidic conformers detected in zymograms after electrophoresis in polyacrylamide gels. This shift in catalase mobility can be indicative of singlet oxygen production in vivo. Catalase from human cells, as from many organisms, is susceptible to in vitro modification by singlet oxygen. Human myeloid leukemia (U937) cells were treated under different stress conditions and catalase activity and its electrophoretic mobility was monitored. The U937 cells were found to have high levels of catalase activity, as compared to cultured fibroblasts, and to be very resistant to oxidative stress. Hydrogen peroxide did not modify the electrophoretic mobility of catalase, even at doses that produced cell damage. Conditions that primarily generate superoxide, such as treatment with paraquat or heat shock, also failed to modify the enzyme. In contrast, photosensitization reactions using rose Bengal gave rise to a more acidic conformer of catalase. Singlet oxygen quenchers prevented catalase modification by rose Bengal and light. The growth medium had a photosensitizing activity. Catalase was not modified in cells illuminated in phosphate buffer but was modified in cells illuminated in phosphate buffer containing riboflavin. Intense light per se also generated a slight shift in the electrophoretic mobility of catalase. Ultraviolet light (350 or 366 nm) did cause a change in catalase, but to a less acidic catalase conformer, indicating other modifications of the enzyme. The main effect of photosensitization with methylene blue was crosslinking of the enzyme, although some shift to acidic conformers was observed at a low concentration of the photoactive compound. Results indicate that catalase can be modified by singlet oxygen generated intracellularly, even though the enzyme is predominantly inside peroxisomes. Under some photosensitization conditions, catalase modification can be used as a marker to detect intracellular singlet oxygen.     

Impact of photosensitized oxidation and singlet oxygen on degradation of stabilized polymers

Photooxidation, an important component of polymer weathering, involves excited polymer-inherent chromophores and photoactive additives and impurities. Quenching of excited species by ground state molecular oxygen, the common component of air, results in the formation of singlet state molecular oxygen ¹O₂. This active form of oxygen is a strong oxygenation agent attacking stabilized polymers. Resulting transformations of the polymer matrix and additives have a negative effect on the service life of the material. The formation of ¹O₂, its properties, and reactions and products arising from stabilizers are outlined.     

Studies on CSA-induced processability of conducting poly(o-toluidine) and its polyblend with ABS

Poly(o-toluidine) emeraldine base (EB) has been protonated with d,l -camphor sulfonic acid (HCSA). The CSA-doped poly(o-toluidine) (POT-CSA) is completely soluble in m-cresol, and the electrical conductivity is ∼ 28 S/cm. The incorporation of CSA has been proved by means of UV-Vis and IR spectroscopy. Thermogravimetric (TG)/mass (MS) analysis shows that POT-CSA is stable up to 180°C indicating the processability with other insulating polymers upto this temperature. TG curve of POT-CSA yields a four step decomposition pattern, and the degradation of the polymer backbone starts at 430°C. The thermal elimination of CSA occurs in the temperature range of 180 to 430°C. The viscometric and spectroscopic results suggest the change in molecular conformation from the compact coil to the expanded coil type which is enhanced by increasing the protonation level of EB by the addition of HCSA. The conductivity data were well equivalent to the viscometric data. Furthermore, POT-CSA-ABS (acrylonitrile/butadiene/styrene) blends were successfully fabricated with an extremely low percolation threshold of 2.66%. The scanning tunneling microscopic (STM) results reveal that the low percolation threshold reflects the formation of interconnecting path of conducting particles in ABS matrix. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 2657–2665, 1999     

Reactions of singlet oxygen with biomolecules

Rate constants of singlet oxygen quenching by glycyrrhetic acid, glycyrrhizic acid, isoliquiritigenin, licurazide,d-glucose, andl-arabinose were determined. An increase in the quenching rate constants by more than an order of magnitude is observed on going from aglycone to the corresponding glycoside.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 57–59, January, 1996.     

Chemistry of singlet oxygen with arylphosphines

The chemistry of singlet oxygen with a variety of arylphosphines has been studied. Rates of singlet oxygen removal by para-substituted arylphosphines show good correlation with the Hammett σ parameter (ρ=−1.53 in CDCl₃), and with the Tolman electronic parameter. The only products for the reactions of these phosphines with singlet oxygen are the corresponding phosphine oxides. Conversely, for ortho-substituted phosphines with electron-donating substituents, there are two products, namely a phosphinate formed by intramolecular insertion and phosphine oxide. Kinetic analyses demonstrate that both products are formed from the same intermediate, and this allows determination of the rate ratios for the competing pathways. Increasing the steric bulk of the phosphine leads to an increase in the amount of insertion product. VT NMR experiments show that peroxidic intermediates can only be detected for very hindered and very electron-rich arylphosphines.     

Comparative studies of reactions of commercial polymers with molecular oxygen,singlet oxygen,atomic oxygen and ozone—II. Reactions with 1,2-polybutadiene

The oxidations of 1,2-polybutadiene by molecular oxygen, singlet oxygen, atomic oxygen and ozone have been studied using u.v. and i.r. spectroscopic methods. Some possible implications of the results of oxidation in the presence of singlet oxygen (parallel free radical oxidation) and atomic oxygen (formation of NO₂ and its reaction with polymer) are discussed. Crosslinking was observed during all types of oxidation. A new mechanism involving formation of free radicals has been considered in detail. During ozonization of 1,2-polybutadiene, formation of formaldehyde and formic acid were detected. An ozonization mechanism has been proposed.     

Studies on the photooxidation mechanism of polymers. V. Oxidation of polybutadienes by singlet oxygen from microwave discharge and in dye-photosensitized reactions

The singlet oxygen oxidation of cis- and trans- 1,4-polybutadienes was studied by using singlet oxygen generated in a microwave generator and in dye-photosensitized reactions of these polymers in the solid state and in solution. It was shown that the reactions of singlet oxygen result in formation of hydroperoxide groups, whereas ultraviolet oxidation by molecular oxygen in addition leads to formation of carbonyl groups. During dye-photosensitized oxidation of polydienes in benzene solution, a very rapid decrease in the molecular weight was observed.     

Importance of single electron-transfer in singlet oxygen reaction in aqueous solution : Oxidation of electron-rich thioanisoles

Oxidation of substituted thioanisoles by chemically generated singlet oxygen was investigated in polar aqueous media. The formation of the superoxide ion was observed during sulphoxidation of 4-hydroxythioanisole (4) in phosphate buffer at pH 7.5. Control experiments indicated that the superoxide ion was formed by a direct reaction between singlet oxygen and 4. The kinetics of the trapping reaction by diphenylsulphoxide indicated the involvement of a single intermediate. The overall rate constants of the reaction of thioanisoles with singlet oxygen in methanol-water (1:1) are one order of magnitude larger than those in benzene. On the basis of these results, a mechanism involving a charge-transfer complex has been proposed for the reaction of electron-rich thioanisoles with singlet oxygen, whereby the charge-transfer complex would produce persulphoxide directly or dissociate to the cation radical and superoxide ion in polar aqueous media.     

Comparative studies of reactions of commercial polymers with molecular oxygen,singlet oxygen,atomic oxygen and ozone—I. Reactions with cis-1,4-polybutadiene

The oxidation of cis-1,4-polybutadiene by molecular oxygen, singlet oxygen, atomic oxygen and ozone has been studied using u.v. and i.r. spectroscopic methods. Some possible implications of the results of oxidation in the presence of singlet oxygen (parallel free radical oxidation) and atomic oxygen (formation of NO₂ and its reaction with polymer) are discussed. Chain scission was observed during all types of oxidation. A new mechanism involving opening of double bonds and formation of biradicals has been considered in detail.     

Reactions of singlet oxygen with polyisoprene and model compounds

Results from the study of singlet oxygen reaction with cis-1,4-polyisoprene and with various models are compared. The nature of the products and their reactivity are discussed for two kinds of models, namely oligodienes and trisubstituted mono-olefins with various substituent length. The reactivity of the double bond decreases with lengthening of the alkyl substituents but the reactivity of 4-methyl-4-octene is close to that of the polymer. The hydroperoxidation of a unit in an oligodiene does not deactivate significantly the adjacent units towards singlet oxygen addition. The reactivity of the allylic hydrogen a, b, and c in the olefin

depends on both the position and the length of the substituents and follows the sequences K _c > k _b > k _a. The principle of syn-ene addition can be extrapolated to polyisoprene. The rate constant determined for the cis-1,4-polyisoprene ¹O₂ reaction allows the conclusion that the probability of reaction of ¹O₂ with the solid polymer may be high. Similarity in the behaviour of polymer and models in this reaction allows for the estimation of the reactivity of other unsaturated or reactive polymers towards ¹O₂.     

Photo-oxidation of water by molecular oxygen: isotope exchange and isotope effects

Photolysis of (17,18)O-labeled water in the presence of molecular oxygen is accompanied by transfer of (17)O and (18)O isotopes from water to oxygen, demonstrating that photoinduced oxidation of water does occur. The reaction exhibits the following isotope effect: oxidation of H(2)(17)O is faster by 2.6% (in the Earth's magnetic field) and by 6.0% (in the field 0.5 T) than that of H(2)(18)O. The effect is supposed to arise in the two spin-selective, isotope-sorting reactions-recombination and disproportionation-in the pairs of encountering HO(2) radicals. The former is spin allowed from the singlet state; the latter occurs only in the triplet one. Nuclear spin sorting produced by these reactions proceeds in opposite directions with the dominating contribution of recombination, which provides observable (17)O/(18)O isotope fractionation in favor of magnetic isotope (17)O. Neither isotope exchange nor the reaction itself occurs in the dark.     

Two-photon photosensitized production of singlet oxygen: sensitizers with phenylene-ethynylene-based chromophores

[reaction: see text] Singlet molecular oxygen (a(1)Delta(g)) has been produced and optically monitored in time-resolved experiments upon nonlinear two-photon excitation of photosensitizers that contain triple bonds as an integral part of the chromophore. Both experiments and ab initio computations indicate that the photophysical properties of alkyne-containing sensitizers are similar to those in the alkene-containing analogues. Most importantly, however, in comparison to the analogue that contains double bonds, the sensitizer containing alkyne moieties is more stable against singlet-oxygen-mediated photooxygenation reactions. This increased stability can be advantageous, particularly with respect to two-photon singlet oxygen imaging experiments in which data are collected over comparatively long time periods.     

Anionic synthesis of polystyrene and polybutadiene heteroarm star polymers

The use of living linking reactions of poly(styryl)lithium with 1,3-bis(1-phenylvinyl)benzene followed by crossover reactions with styrene or butadiene monomers has been used to prepare four-armed heteroarm, star-branched polymers. Bimodal molecular weight distributions have been observed for crossover reactions with both styrene and butadiene. Addition of THF ([THF]/[Li]=14–32) for crossover to styrene and lithium sec-butoxide for crossover to butadiene produces monomodal molecular weight distributions. Symmetrical, four-armed star polystyrenes have been synthesized; properties have been compared with a corresponding polymer prepared via a silicon tetrachloride linking reaction. Heteroarm, star-branched polymers with two polystyrene arms and two polybutadiene arms with high 1,4-microstructure have been prepared.