Analysis of n-alkanes at sub microgram per liter level after direct solid phase microextraction from aqueous samples.

This work describes the application of the previously presented solid phase microextraction (SPME) fiber in direct mode for sampling of C10-C20 n-alkanes from aqueous solution. The fiber has simple composition and is constructed from activated charcoal:PVC suspension in tetrahydrofuran. When the composition of the fiber was optimized that the optimum composition was 90:10 (activated charcoal:PVC) for direct mode, whereas it was 75:25 for sampling from the headspace of aqueous samples. This fiber is completely stable in contact with water. The extraction efficiency is improved in the presence of 0.1 M NaCl. The value is between 17.8-38.5% for the first extraction, which better than the efficiency of similar commercial fibers. After seven extractions, all analytes are removed from the aqueous samples nearly 100%. Single fiber repeatability and fiber-to-fiber reproducibility are good and both are less than 13% for all studied alkanes. Finally, direct mode SPME was used in the determination of n-alkanes in the range of sub microg L(-1) without any additional preconcentration procedure. Gas chromatography along with flame ionization detection were used for separation and detection of the studied analytes.     

Carbon and nitrogen isotope analysis of atrazine and desethylatrazine at sub-microgram per liter concentrations in groundwater

Environmental degradation of organic micropollutants is difficult to monitor due to their diffuse and ubiquitous input. Current approaches—concentration measurements over time, or daughter-to-parent compound ratios—may fall short, because they do not consider dilution, compound-specific sorption characteristics or alternative degradation pathways. Compound-specific isotope analysis (CSIA) offers an alternative approach based on evidence from isotope values. Until now, however, the relatively high limits for precise isotope analysis by gas chromatography—isotope ratio mass spectrometry (GC-IRMS) have impeded CSIA of sub-microgram-per-liter scale micropollutant concentrations in field samples. This study presents the first measurements of C and N isotope ratios of the herbicide atrazine and its metabolite desethylatrazine at concentrations of 100 to 1,000 ng/L in natural groundwater samples. Solid-phase extraction and preparative HPLC were tested and validated for preconcentration and cleanup of groundwater samples of up to 10 L without bias by isotope effects. Matrix interferences after solid-phase extraction could be greatly reduced by a preparative HPLC cleanup step prior to GC-IRMS analysis. Sensitivity was increased by a factor of 6 to 8 by changing the injection method from large-volume to cold-on-column injection on the GC-IRMS system. Carbon and nitrogen isotope values of field samples showed no obvious correlation with concentrations or desethylatrazine-to-atrazine ratios. Contrary to expectations, however, δ ¹³ C values of desethylatrazine were consistently less negative than those of atrazine from the same sites. Potentially, this line of evidence may contain information about further desethylatrazine degradation. In such a case, the common practice of using desethylatrazine-to-atrazine ratios would underestimate natural atrazine degradation.     

Analysis of nitriles at low parts per million levels by capillary gas chromatography

Two methods have been developed for the determination of trace levels of acetonitrile and propionitrile in light naphthas. One involves clean-up and preconcentration by medium pressure liquid chromatography (MPLC) in which nitriles are concentrated ten-fold while the complex hydrocarbon matris is removed. The concentrated solution is then analyzed by high resolution GC with flame ionization detection. The second method involves direct injection of samples into a capillary GC equipped with chemiluminescence nitrogen detection. The results and repeatability obtained from both methods are comparable. Preconcentration enables identification by GC-MS and simultaneous analysis of other polar species, with no need for selective detectors. Direct analysis is, on the other hand, much less time-consuming and requires less sample.     

Selective method for the analysis of perchlorate in drinking waters at nanogram per liter levels, using two-dimensional ion chromatography with suppressed conductivity detection

The United States Environmental Protection Agency (EPA) collected drinking water occurrence data for perchlorate in the Unregulated Contaminant Monitoring Regulation (UCMR 1; 2001-2005) using EPA Method 314.0. To address the interest in increasing sensitivity and selectivity for the analysis of perchlorate, three new methods, EPA Methods 314.1, 331.0 and 332.0, were subsequently published by EPA for the analysis of perchlorate in drinking water. In 2006, an automated two-dimensional ion chromatography (2D-IC) method for measuring perchlorate with suppressed conductivity detection was developed. Two-dimensional IC is essentially an automated "heart-cutting", column concentration and matrix elimination technique. In the first dimension, a large sample volume is injected onto a first separation column and the separated matrix ions are diverted to waste while the analyte(s) of interest are selectively cut, trapped and concentrated in a concentrator column. In the second dimension, the contents from the concentrator column are eluted onto a second analytical column for separation and quantitation of the analyte(s) of interest. Incorporation of two columns with different affinities for the analyte(s) in a single analysis can provide comparable selectivity and superior sensitivity to a method using second column confirmation in a second separate analysis step. Use of this approach led to the development of a new, highly sensitive and selective 2D-IC, suppressed conductivity method with a Lowest Concentration Minimum Reporting Level (LCMRL) of 55 ng/L for perchlorate in drinking water samples. This new method has comparable sensitivity and selectivity and is simpler and more economical than IC-mass spectrometric (MS) or IC-MS-MS techniques. The method is now being prepared for publication as EPA Method 314.2.     

Determination of chlorate at low microgram/l levels by ion-chromatography with postcolumn reaction.

A new method for the determination of low concentrations of chlorate in natural waters is described. Chlorate is analyzed by ion-chromatography followed by an osmate-catalyzed postcolumn reaction of chlorate with iodide and UV-detection of triiodide. The new osmate catalysis allows to carry out the oxidation of iodide by chlorate at pH 3 instead of 6 M HCl for the uncatalyzed reaction. A detection limit of 5 nM (0.4 microgram/l) chlorate is achieved. The method also allows the simultaneous determination of chlorite, bromate, and nitrite at the low microgram/l level.     

On‐line solid phase extraction CZE for the simultaneous determination of lanthanum and gadolinium at picogram per liter levels

A non‐specific on‐line method is presented for the extraction and preconcentration of two rare earth elements using a microcartridge containing C₁₈‐derivatized silica particles prior to their analysis by CZE. The microcartridge, named analyte concentrator, was coupled on‐line to the inlet of the separation capillary (fused‐silica (FS) capillary, 75 μm id ×12 cm from the inlet to the microcartidge and 37 cm from the microcartridge to the detector). The reversed‐phase sorbent quantitatively retained gadolinium (Gd) and lanthanum (La) as 2‐(5‐bromo‐2‐pyridylazo)‐5‐diethylaminophenol complexes in the presence of non‐ionic micelles of polyethylene glycol tert‐octylphenyl ether, enabling sample clean‐up and concentration enhancement with minimum sample handling. The rare earth elements chelates were released from the sorbent with methanol and then analyzed by CZE with diode array detection. A background electrolyte of 20 mM sodium tetraborate containing 8% ACN, pH 9.0, was found to be optimal for the separation of metal chelates. The concentration limits of detection were lowered to picogram per liter levels (20 pg/L for La and 80 pg/L for Gd). A 1000‐fold improvement in concentration sensitivity for La‐ and Gd‐2‐(5‐bromo‐2‐pyridylazo)‐5‐diethylaminophenol complexes with respect to CZE without preconcentration was reached.     

Determination of methyl- and ethylmercury in natural waters at sub-nanogram per liter using SCF-adsorbent preconcentration procedure

An analytical procedure for determining methyl- and ethylmercury (MeHg/EtHg) in natural waters is described. MeHg/EtHg was preconcentrated from water on a sulfhydryl cotton fiber (SCF) adsorbent and eluted with a small volume of a mixture of 1 M hydrochloric acid and 2 M sodium chloride. The eluate was extracted with benzene. The measurements of MeHg/EtHg in benzene extract were determined by gas chromatography with electron capture detector. The detection limit for MeHg/EtHg was about 0.04 ng L-1 using a 20 L water sample. The precision was about 20%. The application of the proposed method to one snow and four freshwater samples varying in humus content is described. The MeHg concentrations found in different freshwater samples were ranged from 0.09 to 0.22 ng L-1 and the recoveries of spiked MeHg were ranged from 42 to 68% which were strongly correlated to the content of humic substances. The MeHg concentration found in snow was 0.28 ng L-1 and the recovery was 79%. The analytical results of MeHg concentration in freshwater samples are discussed in relation to the pH used in the preconcentration, the humus content, the fraction of methylmercury in organic bound mercury and mercury in fish.     

Sampling and analytical methods for the determination of copper,cadmium, zinc,and nickel at the nanogram per liter level in sea water

Sea-water samples collected by a variety of clean sampling techniques yielded consistent results for copper, cadmium, zinc, and nickel, which implies that representative, uncontaminated samples were obtained. A dithiocarbamate extraction method coupled with atomic absorption spectrometry and electrothermal atomization is described which is essentially 100% quantitative for each of the four metals studied, has lower blanks and detection limits, and yields better precision than previously published techniques. A more precise and accurate determination of these metals in sea water at their natural ng l^-1 concentration levels is therefore possible. Samples analyzed by this procedure and by concentration on Chelex-100 showed similar results for cadmium and zinc. Both copper and nickel appeared to be inefficiently removed from sea water by Chelex-100. Comparison of the organic extraction results with other pertinent investigations showed excellent agreement.     

Favoured conformations of methyl isopropyl,ethyl isopropyl,methyl tert‐butyl,and ethyl tert‐butyl 2‐(triphenylphosphoranylidene)malonate

The conformations of organic compounds determined in the solid state are important because they can be compared with those in solution and/or from theoretical calculations. In this work, the crystal and molecular structures of four closely related diesters, namely methyl isopropyl 2‐(triphenylphosphoranylidene)malonate, C₂₅H₂₅O₄P, ethyl isopropyl 2‐(triphenylphosphoranylidene)malonate, C₂₆H₂₇O₄P, methyl tert‐butyl 2‐(triphenylphosphoranylidene)malonate, C₂₆H₂₇O₄P, and ethyl tert‐butyl 2‐(triphenylphosphoranylidene)malonate, C₂₇H₂₉O₄P, have been analysed as a preliminary step for such comparative studies. As a result of extensive electronic delocalization, as well as intra‐ and intermolecular interactions, a remarkably similar pattern of preferred conformations in the crystal structures results, viz. a syn–anti conformation of the acyl groups with respect to the P atom, with the bulkier alkoxy groups oriented towards the P atom. The crystal structures are controlled by nonconventional hydrogen‐bonding and intramolecular interactions between cationoid P and acyl and alkoxy O atoms in syn positions.     

Preparation of 9, 9-dimethylfluorene in methylphosphonic acid tetramethyldiamide and other cation-solvating solvents

Conclusions 9, 9-Dimethylfluorene was obtained in high yield (95%) upon metallation of fluorene with potassium tert-butoxide with subsequent treatment of the reaction mixture with methyl iodide in cation-solvating solvents: methylphosphonic acid tetramethyldiamide, hexamethapol, dimethyl sulfoxide, diglyme.Translated from Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, No. 1, pp. 182–183, January, 1969.     

Multiresidue analysis of 95 pesticides at low nanogram/liter levels in surface waters using online preconcentration and high performance liquid chromatography/tandem mass spectrometry

A new multiresidue method for the analysis of 95 pesticides and breakdown products with a wide range of physiochemical properties in surface and ground water using online solid-phase extraction coupled with HPLC/MS/MS is presented. Using an injection volume of only 500 microL filtered water, an LOD in the 1-10 ng/L range was achieved for all but one substance, and recoveries were, with a few exceptions, in the 70-120% range. Large differences were found in the adsorption of pesticides on nine filter materials tested for filtration of the water samples. Filters of regenerated cellulose were chosen due to good recoveries and easy handling. Results from the proposed method were compared with results from previously used methods for 31 pesticides in 99 surface water samples, collected in 2008, with good agreement.     

Determination of trace metals in natural waters at nanogram per liter levesls by electrothermal atomic absorption spectrometry after extraction with sodium diethyldithiocarbamate

The determination of trace metals (Cd, Co, Cu, Fe, Ni and Pb) at concentrations found in fresh and sea waters is described. The metals are extracted as diethyldithiocarbamates from 500-ml samples into carbon tetrachloride, the extracts are evaporated to dryness and the residues are mineralized with 0.1 ml of concentrated nitric acid. This solution is used for graphite-furnace atomic absorption spectrometry after appropriate dilution. The detection limits are 10 pg Cd, 150 pg Co, 125 pg Cu, 100 pg Fe, 250 pg Ni and 100 pg Pb. The extraction/mineralization method is almost free from interferences, e.g., from trace elements at 500-fold and Na, K, Ca and Mg at million-fold amounts. The procedure is successfully applied to the determination of the above metals in deionized water, and river and sea waters.     

Relative reactivities of isopropyl,ethyl and methyl groups in the gas-phase side-chain deprotonation of alkylaromatic radical cations

The relative reactivity of isopropyl, ethyl and methyl groups in the gas-phase side-chain deprotonation of alkylaromatic radical cations by some pyridines has been determined by using Fourier transform mass spectrometry.     

Rate constants for the bimolecular self-reactions of ethyl,isopropyl, and tert-butyl radicals in solution. A direct comparison

A competitive method involving the direct measurement of radical concentrations by EPR spectroscopy has been used to show that in solution at 25°C the rate constants for the bimolecular self-reactions of ethyl, isopropyl, tert-butyl, cyclopentyl, and trichloromethyl are all approximately equal, as had been indicated previously by direct measurement of the rate constants for decay of these radicals.