Performance studies of a pulsed HF laser with a sliding discharge plasma cathode

The plasma electrode design concept is applied for the first time to an HF laser. The discharge along the surface of a dielectric (sliding discharge) is used as a plasma cathode for the main laser discharge. The laser operates at atmospheric pressure with a gas mixture of He/SF₆/C₃H₈. Details are presented on the efficiency of energy transfer, the dependence of laser performance on circuit parameters, gas mixture, relative energy loading and time delay between the plasma electrode and main discharges. The F atom production rate is estimated from the linear dependence of the output energy on the electric charge passed through the discharge. Output energies of 600 mJ were obtained at 1.6% efficiency from a small active discharge of 108 cm₃ volume and 38 cm length, while the maximum specific input and output energies were 370 J/1 and 5.7 J/1, respectively. These values compare favourably with those reported in the literature for non-chain-reaction-type gas mixtures at 1 atm pressure and demonstrate that the plasma electrode design is a powerful scheme for developing gas-discharge lasers.     

High-efficiency,high-energy performance of a pulsed HF laser pumped by phototriggered discharge

A comparison of the performance of pulsed infrared HF lasers pumped by phototriggered discharges using either Ne/SF₆/H₂ or Ne/SF₆/C₂H₆ mixtures are presented. For an active volume of 50 cm³, a specific output energy as high as 11 J/ has been achieved with an efficiency higher than 3% when C₂H₆ is used as H atom fuel. The replacement of ethane by molecular hydrogen reduces the laser performance by 40%. The investigation of the temporal evolution of the laser intensity shows that this dramatic decrease results from a shortening of the laser pulse duration rather than from a decrease of the peak power. Indications are given that this behavior is correlated to a very different temporal evolution of the discharge parameters, especially at low reduced electric field E/N.     

Comparative study of spectral narrowing of a pulsed Ti:Sapphire laser using pulsed and CW injection seeding

We report a comparative study of a pulsed as well as continuous-wave (cw) injection seeding of a Ti:Sapphire laser pumped by aQ-switched frequency-doubled Nd³⁺:YAG laser for achieving narrow spectral bandwidth. The results have indicated that the Ti:Sapphire laser using either a pulsed or a cw injection seeding could achieve efficient energy extraction in a narrow spectral bandwidth. In the case of pulsed injection seeding, the injection energy required for the complete injection seeding critically depended upon the timing of the Ti:Sapphire laser with respect to the delayed onset of the slave laser. On the other hand, in the case of cw injection seeding, the spectral bandwidth of the Ti:Sapphire laser was efficiently narrowed down to approximately 0.01 cm^–1 with an injection power of less than 1 mW. In both types of injection seeding, characteristics observed experimentally were compared with those obtained by a numerical simulation code based on the one-dimensional rate-equation model.     

Optimum gain length for pulsed dye laser amplifiers

It is shown analytically that for a pulsed dye laser amplifier, transversely pumped by a short duration pulsed laser, there exists an optimum gain length of the amplifier at dye laser wavelengths at which ground state absorption does not vanish. Thus, if the available pump power is distributed over this gain length, the extraction efficiency and the saturated gain of the amplifier reaches a maximum. The dependence of the extraction efficiency and gain on the amplifier length is strongly affected by the nonlinear absorption of the dye laser arising from excited state absorption, subsequent to ground state absorption.     

Performance of a ten-liter electron avalanche-discharge XeCl laser device

This paper describes the laser performance of an X-ray preionized ten-liter volume, electron-avalanche discharge XeCl system, operated at dc charging voltages of up to 70 kV both with and without X-ray preionization. An output energy of more than 11J uniformly distributed over a (7×10) cm² spot size was achieved using a multichannel spark-gap as the main discharge switch. The discharge was also successfully operated in the switchless mode, yielding a 4.8 J output energy and a 0.9% efficiency. The time-resolved gain measurements provided information on the laser discharge evolution.ENEA GuestENEA Guest on leave from the Shanghai Institute of Optics and Fine Mechanics, the Chinese Academy of Sciences, Shanghai, China     

Two-wavelength self-seeded pulsed tunable laser

A compact self-seeded pulsed tunable laser is described. Its optical cavity comprises a diffraction grating, operating at a grazing angle of incidence as a spectral selector and narrow-band spectral gate. The grating couples two partially overlapping laser channels: a highly selective master laser and a nonselective slave laser. Due to the implemented efficient intracavity self-seeding the laser emits spectrally pure single-longitudinal-mode radiation at two independently tunable wavelengths, with an efficiency and output energy that are typical for nonselective lasers. Results of the experimental investigation of the laser’s output characteristics are presented. Received: 12 March 2001 / Revised version: 10 December 2001 / Published online: 7 February 2002     

Active mode locking of a high pressure CW waveguide CO2 laser

In this paper, we report on a new concept for active mode locking of lasers. It has been successfully applied to a cw waveguide CO₂ laser and pulse widths as short as 2 ns have been obtained.     

Kinetic study of a short-pulse electron-beam pumped Kr/F2 laser amplifier medium at very low pressure operation

A numerical investigation has been performed for very low pressure (200 Torr) buffer-free KrF laser-amplifier medium pumped by a short pulse (10 ns FWHM) electron beam with low excitation rate operation (200 kW/cm³). The small-signal-gain coefficient (g ₀) and absorption coefficient () have been estimated for this new operational mode. The formation and quenching processes are also discussed kinetically.     

Small signal gain measurements in a small scale HF overtone laser

The overtone gain medium of a small-scale HF overtone laser was probed using a sub-Doppler tunable diode laser. Two-dimensional spatially resolved small signal gain and temperature maps were generated for several ro-vibrational transitions in the HF (v=2→v=0) overtone band. Our results compare well with previous measurements of the overtone gain in a similar HF laser device. Received: 7 October 2002 / Accepted: 20 January 2003 / Published online: 28 May 2003 RID="*" ID="*"Corresponding author. Fax: +1-505/846-4807, E-mail: kevin.hewett@kirtland.af.mil     

A novel double grazing-incidence single-mode dye laser

Using only one grating and plane parallel glass plate in a novel double-grazing incidence configuration, twice higher dispersion is obtained, resulting in twofold narrowing of the single-pass linewidth, compared to the single grazing-incidence scheme. This laser cavity design features several-times improved signal-to-noise ratio and enhanced stability. Single-mode operation of 210±50 MHz is demonstrated.     

A novel picosecond distributed feedback dye laser arrangement for excimer laser pumping

A distributed feedback dye laser arrangement is described which can generate pulses at the subharmonic wavelengths of the main excimer laser lines (308 nm, 248 nm, 193 nm, etc.). The laser can be pumped with broadband lasers, such as the XeCl^* laserpumped dye laser with competing cavities. The laser is designed to be used as a part of a femtosecond, terawatt excimer laser system.     

CW and pulsed FIR-CO2 hybrid laser with improved efficiency and amplitude stability at short FIR wavelengths

For the first time stable cw output of a FIR-CO₂ hybrid laser has been achieved at wavelengths shorter than 300 m. Due to the saturable absorber characteristic of the FIR laser gas, cw or pulsed emission is observed on both, the CO₂ and the FIR laser output, depending on the operating conditions. Results are reported on different resonant lines in CH₃OH and the 67 m Raman line in NH₃. The good efficiency of this laser is also demonstrated by the excitation of two new emission lines in CH₃OH, namely 49 and 56 m, pumped by 9R(22) and 9R(24), respectively.On leave from the Institute of Physics, University of Beograd YU-11000, Beograd, Yugoslavia     

High pressure X-ray preionized TEMA-CO2 laser

The construction of a high-pressure (up to 20 atm) transversely excited CO₂ laser using transverse X-ray preionization is described. High pressure operation was found to be greatly improved in comparison to UV-preionized systems. Homogeneous discharges have been achieved in the pressure range 5–20 atm, yielding a specific laser output in the order of 35 J/l.     

A subpicosecond dye laser pumped by a xenon ion laser

A pulsed xenon ion laser has been used to pump a rhodamine 6G dye laser utilizing a ring resonator. The dye laser has been passively mode-locked; a pulsewidth of 0.5 ps and a 50 kW peak power have been obtained.Work partly supported by Italian C.N.R.     

An X-ray preionised self sustained discharge HF/DF laser

We report the design and characterisation of a flash X-ray preionised, transversely excited HF/DF laser with energy outputs at the joule level. The laser used a H₂/D₂: SF₆ mixture at a pressure of around 120 Torr. X-ray photon fluxes and ionisation rates in the laser gas are presented and the laser dependence on these examined. It is shown that X-ray preionisation can be effective and it is estimated that the laser should operate satisfactorily with as little as 5% of the total stored electrical energy in the preionisation circuit. The laser performance is comparable to that of a UV preionised device with similar operating parameters.     

Effective and simplified hybrid TEA laser design and operation

A compact hybrid TEA CO₂ laser has been developed which, when operated with the low pressure section well below oscillation threshold, demonstrates that little cw gain is necessary to ensure single longitudinal mode (SLM) output pulses with peak power, energy and pulse shape approaching those of normal multi-mode operation. This has allowed reliable SLM operation to be obtained with a very short, wide bore rf-excited low-pressure section, making feasible simple single-mode, large-aperture TEA lasers with high peak powers and energies.     

放电引发的非链式高功率重复频率HF/DF激光器

高功率重频HF/DF激光因其具有的波长和功率优势成为当前中红外激光技术发展的热点之一。介绍了利用紫外预电离横向放电结构和工作气体循环系统建立的放电引发高功率重频HF/DF激光装置。在对激光工作介质SF6/C2H6混合气体放电特性和激光输出特性研究的基础上,开展了强电负性气体的重频均匀体放电技术和气体快速循环置换技术研究,解决了泵浦源重频放电能量在气体介质中的有效沉积和提取问题,实现了激光器50Hz的重频稳定运行和能量稳定输出,HF激光的平均功率达到28W,脉宽100ns,峰值功率5.6 MW。     

放电引发的非链式高功率重复频率HF/DF激光器

高功率重频HF/DF激光因其具有的波长和功率优势成为当前中红外激光技术发展的热点之一。介绍了利用紫外预电离横向放电结构和工作气体循环系统建立的放电引发高功率重频HF/DF激光装置。在对激光工作介质SF6/C2H6混合气体放电特性和激光输出特性研究的基础上,开展了强电负性气体的重频均匀体放电技术和气体快速循环置换技术研究,解决了泵浦源重频放电能量在气体介质中的有效沉积和提取问题,实现了激光器50 Hz的重频稳定运行和能量稳定输出,HF激光的平均功率达到28 W,脉宽100 ns,峰值功率5.6 MW。     

Determination of the deuterium abundance in water using a cw chemical DF laser

This paper describes a new method for the determination of the deuterium content in water samples. The absorption of the radiation of a cw deuterium fluoride laser by HDO in water vapor is measured by means of a nonresonant spectrophone (optoacoustic detector). This method enables one to evaluate the isotope ratio of hydrogen in a rather simple and straightforward way. Advantage is taken of the fact that HDO absorbs some of the DF laser lines whereas H₂O shows no absorption. Due to the small concentration in natural water deuterium is practically entirely present as HDO. Therefore a selective determination of the deuterium content is possible. In the course of the investigation the absorption coefficients of HDO for the different laser lines were determined. It was thereby established that there exists a strong coincidence of an HDO absorption line with the 2P2 DF laser line. The detection sensitivity of the method was then examined for some selected laser lines. The concentration of HDO in natural water samples could be determined with an accuracy of better than 10%. The experiments, however, show that with appropriate improvements it should be possible to achieve an accuracy of better than 1%. This makes the method very interesting as an analytical tool in hydrology.     

A frequency-doubled pulsed chemical oxygen-iodine laser

The intracavity second-harmonic generation of pulsed chemical oxygen-iodine laser radiation was investigated. A pulsed chemical oxygen-iodine laser with a maximum output energy of 6.14 mJ was used. The second-harmonic output of 0.5 mJ was demonstrated using a lithium iodate crystal. The conversion efficiency of 8% was limited by intracavity losses. Numerical simulation predicts that a conversion efficiency of 75% can be obtained with 1% intracavity losses.