S在Cu(111)表面吸附的第一性原理研究*

基于广义梯度近似的投影缀加平面波(Projector augmented wave) 赝势和具有三维周期性边界条件的超晶胞模型,采用第一原理方法计算并分析了由于S吸附所形成的S/Cu(111)界面体系的吸附结构、吸附能和局域电子结构,考虑了不同覆盖度（1,0.25ML）下S在不同吸附位置的吸附特性. 结果表明：S原子倾向于吸附在高对称的fcc位与hcp位;由于S的负电性而使S/Cu吸附能随覆盖度的减小而增加, 与之相应,S-Cu键长随覆盖度的减小而缩短. DOS图、Bader电荷分析表明杂化主要发生在S的3p态和表面Cu原子的3d态之间,表层近邻的Cu原子向S转移的电子数随覆盖度增加而减小,这表明S与Cu(111)面有强的相互作用.     

S在Cu(111)表面吸附的第一性原理研究

基于广义梯度近似的投影缀加平面波(Projector augmented wave)赝势和具有三维周期性边界条件的超晶胞模型,采用第一原理方法计算并分析了由S吸附所形成的S/Cu(111)界面体系的吸附结构、吸附能和局域电子结构,考虑了不同覆盖度(1,0.25 ML)下S在不同吸附位置的吸附特性.结果表明:S原子倾向于...     

The Tamm surface state on Cu(111) and Ag(111)

It is shown, that the well-known d-electron Tamm surface-state emission observed in photoelectron spectra from Cu(111) at the M̄ point in the surface Brillouin zone, is indeed due to such a surface state and not a bulk band transition as recently suggested L. Wallden, Solid State Commun. 59, 205 (1986). A similar surface state on Ag(111) is reported.     

First-principles study on the (111) surface of half-metallic rocksalt VPo

In this work, we have probed the structural, electronic, and magnetic properties of the (111) surface of rocksalt (RS) VPo. The first-principles full-potential linearized augmented plane-wave method is used. Bulk VPo is found to be a half-metallic ferromagnet at equilibrium lattice constant (0.59 nm) with a total spin magnetic moment of 3.0 μ_B per formula unit. At the same equilibrium lattice constant, the V-terminated (111) surface preserves the half-metallic characteristics of the bulk VPo, however, the surface states destroy the gap in the minority spin band of the Po-terminated (111) surface. We also discuss the surface stability.     

Scanning tunneling microscopy study of a Ag monolayer on Cu(111)

The structure of submonolayer Ag deposited on Cu(111) has been examined with scanning tunneling microscopy. The long diffusion length of Ag leads to the formation of large (111)-like islands nucleating from the “downhill” side of Cu step edges. The growth fronts of the Ag islands are mostly straight and lie along the 〈1̄10〉 directions. The Ag overlayer is apparently slightly compressed relative to bulk Ag, and forms a mixture of superstructures rotated slightly relative to the substrate.     

Electronic structure of the Cu(111) surface

Self-consistent electronic structure calculations are reported on bulk Cu, and 3- and 5-layer Cu films. These yield a size insensitive work function, φ = 5.0±.1 eV, and a surface energy of 0.75 eV, in agreement with experiment. Good size convergence of the film potential permits the construction of a self-consistent potential for an 11-layer Cu(111) film, whose spectral properties we studied. A prominent p-like surface band was found within 0.1 eV of experiment, serving as a check on the surface potential.     

Theoretical investigation of the structure and properties of the VN(111) monolayer on the MgO(111) surface

The VN(111) monolayer on the MgO(111) surface has been simulated and optimized in terms of the density functional theory (DFT) calculations. The most favorable arrangement of vanadium nitride on the surface of the magnesium oxide plate has been found. The band structure and densities of states for the VN(111) monolayer have been calculated. It has been concluded based on the densities of states for the VN monolayer on the MgO surface that this structure exhibits properties of a diluted magnetic semiconductor.     

Adsorption-desorption properties and surface structural chemistry of chlorine on Cu(111) and Ag(111)

The adsorption, desorption, and structural properties of chlorine adlayers on Cu(111) and Ag(111) have been studied by LEED, Auger, Δ?, and thermal desorption measurements. Ancillary experiments were also carried out on cuprous chloride for purposes of comparison with the Cu(111)-Cl data. Chlorine adsorption is rapid on both metals and follows precursor kinetics, the absolute initial sticking probabilities being ~1.0 (Cu) and ~0.5 (Ag). Δ? results suggest that significant depolarisation of the chemisorption bond occurs at high coverages, the maximum values being + 1.2 eV (Cu) and + 1.8 eV (Ag). On Cu(111), adsorption leads to the formation of a sequence of well-ordered phases; in order of increasing coverage, these are as follows: (√3 × √3)R30°, (12√3 × 12√3)R30°, (4√7 × 4√7)R19.2°, and (6√3 × 6√3)R30°. On Ag(111) (√3 × √3)R30°, and (10 × 10) structures are observed. All six structures are susceptible to a straightforward interpretation in terms of coincidence lattices resulting from the progressive uniform compression of a hexagonal layer of Cl atoms. This interpretation is consistent with all the experimental results, and gives values for the nearest-neighbour ClCl spacing on both Cu(111) and Ag(111) which are in good agreement with other work on other surfaces. Chlorine desorbs exclusively as atoms from both metals with first-order desorption kinetics, and apparent desorption energies of 236 (Cu) and 209 (Ag) kJ mol^?1. These values, which depend on an assumed pre-exponential factor of 10¹³ s^?1, are shown to be inconsistent with the thermochemical constraints on the system necessitated by the complete absence of Cl₂ desorption. Lower limits for the pre-exponential factors are then deduced, and the values are found to be consistent with the differences between the CuCl and AgCl systems.     

Structural properties of a monolayer graphite film on the (111)Ir surface

The structural properties of a monolayer graphite film prepared on the (111)Ir surface through thermal decomposition of benzene molecules were studied. The study was carried out in ultrahigh vacuum using scanning tunneling microscopy, which allowed observation of the atomic structure of the film. It is shown that, on extended smooth regions of the Ir surface, a continuous graphite film with a regular arrangement of carbon atoms in a planar hexagonal lattice is formed. The orientation of zigzag carbon atom chains coincides with the 〈110〉 direction on the Ir surface. Structural defects of the (5, 7) configuration were revealed in the film. A comparison of the topographies of the film and the (111)Ir surface shows that the graphite layer smoothly (without discontinuities) flows over subnanometer topographical features existing on the Ir surface and that the distance between the graphite film and the metal surface in this case can reach 1 nm.     

LEED and Auger investigations of Cu (111) surface

After ultrahigh vacuum bake-out, electropolished Cu (111) surfaces were shown by Auger analysis to be contaminated by C, N, O, S and Cl. Other than C and S, which were contained in the bulk, the impurities were introduced by surface preparation; but all were easily removed by light Ar ion bombardment. Heating to ≈ 750°C caused diffusion of C and S from the bulk to the extent that a clear diffraction pattern corresponding to a √7 × √7 structure was produced by S on the surface. At ≈ b 900°C evaporation of Cu occurred to an observable degree, and S and C could no longer be detected on the surface. Auger analysis of clean Cu surfaces showed many details of the LMM and MMM types of transitions. Kinetic energies of all observed Auger electrons were in excellent agreement with calculated values. Also, the ≈ 62 eV MMM peak was resolved into two components related to the small differences in the M₂ and M₃ energy levels. The LMM transitions were classified according to their intensities, which could be rationalized on the basis of Coster-Kronig transitions and transition probabilities, as L₃MM > L₂MM > L₁MM.     

Adsorption behavior of Fe atoms on a naphthalocyanine monolayer on Ag(111) surface

Adsorption behavior of Fe atoms on a metal-free naphthalocyanine(H2Nc) monolayer on Ag(111) surface at room temperature has been investigated using scanning tunneling microscopy combined with density functional theory(DFT)based calculations. We found that the Fe atoms were adsorbed on the centers of H2 Nc molecules and formed Fe–H2Nc complexes at low coverage. DFT calculations show that Fe sited in the center of the molecule is the most stable configuration, in good agreement with the experimental observations. After an Fe–H2Nc complex monolayer was formed, the extra Fe atoms self-assembled to Fe clusters of uniform size and adsorbed dispersively at the interstitial positions of Fe–H2Nc complex monolayer. Therefore, the H2 Nc monolayer grown on Ag(111) could be a good template to grow dispersed magnetic metal atoms and clusters at room temperature for further investigation of their magnetism-related properties.     

Size-dependent surface states of strained cobalt nanoislands on Cu(111)

Low-temperature scanning tunneling spectroscopy over Co nanoislands on Cu(111) showed that the surface states of the islands vary with their size. Occupied states exhibit a sizable downward energy shift as the island size decreases. The position of the occupied states also significantly changes across the islands. Atomic-scale simulations and ab initio calculations demonstrate that the driving force for the observed shift is related to size-dependent mesoscopic relaxations in the nanoislands.     

Self-consistent pseudopotential calculation for the (111) surface of aluminum

The electronic structure of the (111) surface of aluminum is calculated using self-consistent pseudopotentials. Surface states are identified and the (111) work function calculated. The behavior of the total charge density and potential near the surface is displayed and discussed. Self-consistency is found to be of crucial importance.     

Electronic states of a C70 monolayer on the surface of Ag(111)

We have investigated the electronic states of a C(70) monolayer on the surface of Ag(111) (1 ML C(70)/Ag(111)) using synchrotron radiation photoelectron spectroscopy and soft x-ray absorption spectroscopy techniques. The experimental data exhibit metallic properties and at least 2.6 e(-) charge transfer per C(70) molecule. The screening effect of Ag(111) on the electronic structure of C(70) is remarkable; it greatly reduces or even eliminates the on-site Hubbard energy. The work functions of the C(70) multilayer and monolayer are determined as 4.53 eV and 4.52 eV respectively. The energy levels of C(70) align with the Fermi level of the Ag(111) substrate, and the shift of the vacuum level caused by C(70) adsorption is negligible. Potassium doping indicates that 1 ML C(70)/Ag(111) can still accommodate about nine electrons and that the sample remains metallic at any doping level.