基于布儒斯特定律的分光仪测量玻璃折射率实验

光学材料折射率测量的常见方法有阿贝折射仪全反射法,分光仪最小偏向角法等.本文描述了运用布儒斯特定律在分光仪上测量折射率的新实验方法,并得到相关测量数据.     

结合计算层析与光学相干层析测量折射率分布

通过将计算层析技术与光学相干层析技术相结合,测量散射介质非均匀折射率分布。该方法测量散射样品折射率分布时,通过光学相干层析技术测量散射样品折射率分布在多个方向上的投影,采用计算层析技术实现对样品折射率分布的层析重建,克服了传统折射率光学测量方法如单纯的基于光学相干层析原理的焦点追迹法和光程匹配法,不能测量散射介质非均匀折射率分布的缺点。采用该方法在实验中对梯度折射率棒的径向相对折射率分布进行层析重建,取得了较好的实验结果。     

基于机器视觉的快速玻璃折射率测量方法

为实现玻璃折射率快速、高精度测量需求,提出一种基于机器视觉的玻璃折射率测量方法.推导了玻璃折射率测量数学模型,采用自准直平行光管实现传统V棱镜平行光管的功能,同时对V槽的装卡倾角进行正交性校准;双CCD结合棱镜分光实现大视场拼接,运用图像处理技术直接测量折射光线的偏折角.搭建试验样机,并与传统V棱镜折射仪和数字化V棱镜折射仪进行对比.结果表明测量精度优于±2×10-6,测量速度少于10s.测量精度和测量时间都优于前两者,对实现快速、高精度光学玻璃折射率测量具有实际意义.     

测量液体折射率的一种新方法——液芯柱透镜散焦宽度法

本文提出了一种基于消球差复合液芯柱透镜快速、准确测量液体折射率的新方法——液芯柱透镜散焦宽度法.该方法利用消球差复合液芯柱透镜在较宽折射率范围内系统球差小、成像准确的特点,基于不同折射率在成像系统上呈现一一对应的散焦图像,仅需采集一幅散焦图像即可得到待测液体的折射率.用该方法测量了室温(20℃)下21组不同液体的折射率,测量结果与用阿贝折射仪测量结果一致,用ZEMAX和光线追迹逐面成像法仿真的散焦宽度图像与实验图像一致.用该方法测量液体折射率具有系统简单、稳定性好、操作简便、测量速度快等特点.     

沿膜厚方向的簿膜非均匀折射率及其色散测量

以传统的光学监控法与石英晶体振荡法为基础,在薄膜沉积过程中,同时测量膜片的透过率及膜层的厚度,以及与它们对应的控制波长,并根据三者与折射率之间的关系,由计算机反解出不同膜厚处的折射率——非均匀折射率及不同厚度、不同波长处的薄膜折射率——非均匀色散。同时给出了硫化锌薄膜在水晶石薄膜的测量实例,并进行了分析与讨论。     

测量晶体最大双折射率温度系数的偏光干涉法

介绍了测量晶体的最大双折射率温度系数的偏光干涉法. 利用分光光度计测量出不同温度下晶体波片的偏光干涉谱. 通过对不同温度下谱线极值点所对应波长的精确判断,准确计算出相应的最大双折射率,并由曲线拟合得到最大双折射率温度系数的表达式. 测量的双折射率精度可达到10-5.     

容器壁厚度对光栅衍射法测量液体折射率的影响

利用光栅衍射法测量了NaCl溶液的折射率,并分析了容器壁厚度引起的附加光程对折射率的影响.采用折射率修正公式运用一级衍射得到的溶液的折射率更可靠.     

高折射率玻璃微珠折射率的测量

用激光作为测量光源,利用激光经玻璃微珠一次或多次内部反射后出射,形成最小偏转角的原理,对高折射率玻璃微珠折射率的测量进行了理论分析和实验测试.比较了不同内反射次数对测量精度的影响.该测量方法尤其适用于已在微珠列阵逆向反光膜上大量使用的、折射率位于1.8～2.4之间的高折射率玻璃微珠折射率的测量,较传统方法具有简便、快捷和安全的特点.经分析和对不同类型微珠样品的实测比较,获得了测量精度优于1%的结果.     

泄漏辐射模显微镜测量薄膜的局域双折射率

介质双折射率的传统测量方法有偏振光椭圆率测量仪和光学相干断层扫描等.提出一种新型的介质双折射率测量方法--切向偏振光照明的泄漏辐射模显微镜激励波导模共振,通过对物镜后焦面的傅里叶光谱信息进行成像,测量介质的双折射率.分析了利用切向偏振光照明的泄漏辐射模显微镜测量介质双折射率的原理并测量了双折射率差为△n≈0.005的偶...     

泄漏波导法精确测量薄膜参数的理论和实验研究

对泄漏波导法测量薄膜折射率和厚度的实验方法做了介绍,基于四层介质结构的理论模型,通过严格的电磁场理论推导出了测量方法依据的本征色散方程,并使用了Newton-Raphson方法求解复传播常数,保证了测量的精确与快捷.以等离子增强化学气相沉积法生长的SiO2薄膜为例,对其折射率和厚度进行了测定.实验证明,本文方法与传统方法相比,不仅具有更高的测量精度,而且数据处理更加快捷,完成一片样品测试,仅花费机时60 ms.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.