Short Total Synthesis of Ajoene, (E,Z)-4,5,9-Trithiadodeca-1,6,11-triene 9-oxide,in Batch and (E,Z)-4,5,9-Trithiadodeca-1,7,11-triene in Continuous Flow

A short total synthesis of ajoene, (E,Z)-4,5,9-trithiadodeca-1,6,11-triene 9-oxide, has been achieved over six steps. In addition, a continuous flow synthesis under mild reaction conditions to (E,Z)-4,5,9-trithiadodeca-1,7,11-triene is described starting from simple and easily accessible starting materials. Over four steps including propargylation, radical addition of thioacetate, deprotection, and disulfide formation/ allylation, the target product can be obtained at a rate of 0.26 g h⁻¹ in an overall yield of 12 %.     

Conformational Properties of (Z,Z)-, (E,Z)-, and (E,E)-Cycloocta-1,4-dienes

Summary.  Ab initio calculations at the HF/6-31G^* level of theory for geometry optimization and the MP2/6-31G^*//HF/6-31G^* level for a single point total energy calculation are reported for (Z,Z)-, (E,Z)-, and (E,E)-cycloocta-1,4-dienes. The C ₂-symmetric twist-boat conformation of (Z,Z)-cycloocta-1,4-diene was calculated to be by 3.6 kJ·mol⁻¹ more stable than the C _S-symmetric boat-chair form; the calculated energy barrier for ring inversion of the twist-boat conformation via the C _S-symmetric boat-boat geometry is 19.1 kJ·mol⁻¹. Interconversion between twist-boat and boat-chair conformations takes place via a half-chair (C ₁) transition state which is 43.5 kJ·mol⁻¹ above the twist-boat form. The unsymmetrical twist-boat-chair conformation of (E,Z)-cycloocta-1,4-diene was calculated to be by 18.7 kJ·mol⁻¹ more stable than the unsymmetrical boat-chair form. The calculated energy barrier for the interconversion of twist-boat-chair and boat-chair is 69.5 kJ·mol⁻¹, whereas the barrier for swiveling of the trans-double bond through the bridge is 172.6 kJ·mol⁻¹. The C _S symmetric crown conformation of the parallel family of (E,E)-cycloocta-1,4-diene was calculated to be by 16.5 kJ·mol⁻¹ more stable than the C _S-symmetric boat-chair form. Interconversion of crown and boat-chair takes place via a chair (C _S) transition state which is 37.2 kJ·mol⁻¹ above the crown conformation. The axial- symmetrical twist geometry of the crossed family of (E,E)-cycloocta-1,4-diene is 5.9 kJ·mol⁻¹ less stable than the crown conformation. Corresponding author. E-mail: isayavar@yahoo.com Received March 25, 2002; accepted April 3, 2002     

Singlet oxygenation of cycloocta-1,3,5-triene: Formation of (4.2.2)- and (2.2.2)- cycloadducts.

Photosensitized singlet oxygenation of 1,3,5-cyclooctatriene affords the (4.2.2)- and (2.2.2)-type endoperoxides, which were reduced with diimide, thermally isomerized, and deoxygenated with triphenylphosphine.     

Domino 6pi-electrocyclization/Diels-Alder reactions on 1,6-disubstituted (E,Z,E)-1,3,5-hexatrienes: versatile access to highly substituted tri- and tetracyclic systems

The (E,Z,E)-1,3,5-hexatrienes 1a, 2a,b and 3b undergo 6pi-electrocyclization within 15-30 min upon heating to 200-215 degrees C. While the cyclohexene-annelated products 8a,b were stable, the analogous cyclopentene- and cycloheptene-annelated derivatives 7a and 9b easily underwent dehydrogenation to the corresponding aromatic compounds 10a and 12b during the work-up. The cyclohexadiene derivatives 8a,b were employed in thermal Diels-Alder reactions with 4-phenyl-3H-1,2,4-triazoline-3,5-dione (PTAD) and tetracyanoethylene (TCNE) to give the expected [4+2] cycloadducts 13a and 14a in good yields (60 and 78%). The initially formed cycloadduct of 8a and dimethyl acetylenedicarboxylate (DMAD) underwent a subsequent retro-Diels-Alder reaction to give the tetrahydronaphthalene 11b (47%). Under high pressure (10 kbar), the cycloadduct 15a was formed at room temperature and could be isolated in 44% yield. TCNE and N-phenylmaleimide with 8a under high pressure also led to the [4+2] cycloadducts 14a and 16a in good yields (60 and 77%). The 6pi-electrocyclization and subsequent Diels-Alder reaction, when performed as a one-pot domino process, provided direct access to Diels-Alder products of intermediately formed 6pi-electrocyclization products, for example from the 1,3,5-hexatrienes 1a,b, 2a,b, 3b and TCNE to the corresponding tricyclic products 17a,b, 14a,b, 18b in moderate to good yields (27-80%) depending on the nature of the alkoxycarbonyl group. Such sequential reactions with N-phenylmaleimide, maleic anhydride, dimethyl maleate and fumarodinitrile, the latter two under high pressure (10 kbar), worked as well to yield 16b (70%), 19a,b (19, 32%) and 20b (39%) and 21b (76%), respectively. With PTAD, however, the hexatrienes 2a,b reacted at ambient temperature without 6pi-electrocyclization to give the formal [4+2] cycloadducts 27a,b (48 and 46%), most probably via zwitterionic intermediates 23a,b and 25a,b.     

Stereospecific preparation of (Z)- and (E)-2,3-difluoro-3-stannylacrylic ester synthons and a new, efficient stereospecific route to (Z)- and (E)-2,3-difluoroacrylic esters

[reaction: see text] The (Z)-2,3-difluoro-3-stannylacrylic ester is readily prepared from (Z)-1,2-difluorovinyltriethylsilane via stereospecific stannyl/silyl exchange with KF/(Bu3Sn)2O or Bu3SnCl in DMF at 70 degrees C. The corresponding (E)-2,3-difluoro-3-stannylacrylate is prepared by stereospecific carbonylation of (E)-1,2-difluorovinyl iodide followed by low temperature/in situ stannylation of the resultant (Z)-2,3-difluoroacrylic ester. With Cu(I) iodide and Pd(PPh3)4 catalysis, the (Z)- and (E)-stannylacrylate esters readily couple with aryl iodides and vinyl bromides, as well as 2-iodothiophene, at room temperature to stereospecifically produce the respective (E)- and (Z)-2,3-difluoro-3-aryl substituted acrylic esters or conjugated dienes in high yields.     

Synthesis and structure of 5,5′-[(E,E)-2,5-diiodohexa-1,5-diene-1,6-diyl]bis(2,3-dichloro-4,4-dimethoxycyclopent-2-en-1-one)

Treatment of 2,3,5-trichloro-5-[(E)-2,3-diiodoprop-1-en-1-yl]-4,4-dimethoxycyclopent-2-en-1-one with SmI₂ in THF gives 5,5′-[(1E,5E)-2,5-diiodohexa-1,5-diene-1,6-diyl]bis(2,3-dichloro-4,4-dimethoxycyclopent-2-en-1-one) and its meso form at a ratio of 3:1.     

Highly stereoselective synthesis of (E)- and (Z)-alpha-fluoro-alpha,beta-unsaturated esters and (E)- and (Z)-alpha-fluoro-alpha,beta-unsaturated amides from 1-bromo-1-fluoroalkenes via palladium-catalyzed carbonylation reactions

The highly stereoselective synthesis of (E)- and (Z)-alpha-fluoro-alpha,beta-unsaturated esters and (E)- and (Z)-alpha-fluoro-alpha,beta-unsaturated amides is described. 1-Bromo-1-fluoroalkenes (E/Z approximately 1:1), which are readily available starting materials, have been found to isomerize to high E/Z ratios after storage at -20 degrees C for 1 week or by photolysis at 254 nm. Since the (E)-isomers have been found to react faster than the corresponding (Z)-isomers at room temperature in Pd(0)-catalyzed reactions, the palladium-catalyzed carboalkoxylation of high E/Z 1-bromo-1-fluoroalkenes lead to a high Z/E (Z/E >/= 98:2) ratio of the alpha-fluoro-alpha,beta-unsaturated esters. When 1-bromo-1-fluoroalkenes (E/Z approximately 1:1) were reacted with HCOOH/NBu(3)/Pd(II)/DMF, the (E)-isomer was selectively reduced, and the remaining (Z)-1-bromo-1-fluoroalkenes were recovered in essentially pure isomeric form. The resulting mixture of (Z)-1-bromo-1-fluoroalkenes and the reduced products underwent similar palladium-catalyzed carboalkoxylation reactions at 70 degrees C, and the (E)-alpha-fluoro-alpha,beta-unsaturated esters were stereospecifically obtained. This methodology was also successfully applied for the stereospecific synthesis of (Z)- and (E)-alpha-fluoro-alpha,beta-unsaturated amides: the palladium-catalyzed carboamidation reaction of high E/Z and (Z)-1-bromo-1-fluoroalkenes lead to pure (Z)- and (E)-alpha-fluoro-alpha,beta-unsaturated amides, respectively.     

Isomerism in metal complexes of 1,3,5-diazaphosphorinanes. Synthesis,crystal and molecular structure of conformers ofcis-bis(1,3,5-triphenyl-1,3,5-triazaphosphorinane)dichloroplatinum(II)

The crystal and molecular structures were determined for two individual conformers ofcis-bis(1,3,5-triphenyl-1,3,5-diazaphosphorinane)dichloroplatinum(II) differing in the rotation of the heterocyclic ligand planes around the P-Pt bond and in the orientation of the substituents at the phosphorus atoms in the ligands.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1650–1655, September, 1993.