Analysis of the effects of doping and barrier design on the small-signal modulation characteristics of long-wavelength multiple quantum well lasers

This theoretical work has modelled the small signal response of InGaAsP and InGaAlAs multiple quantum well (MQW) lasers based on an ambipolar carrier transport model. The MQW parameters such as barrier bandgap, barrier width and the number of quantum wells have been optimized for high-speed modulation. The effect of the p-type doping and the strain of the InGaAs well have also been investigated.For the InGaAsP-based system, the optimization for maximum 3 dB bandwitdth shows that the optimum width is about 5 nm for 1.1 m barriers and 7 nm for 1.2 m barriers. The optimum barrier bandgap wavelength is about 1.1 m for the barrier width of 6 nm, about 1.15 m for 8 nm and 10 nm barriers. The p-doped MQW exhibits a higher modulation bandwidth because of its high differential gain and improved carrier distribution among the MQWs. The compressively strained InGaAs quantum well system has the potential for a higher modulation bandwidth. For the InGaAlAs-based system, the optimization for maximum 3 dB bandwidth shows that the optimum width is about 4 nm for a barrier wavelength of 1.10 m, and 6 nm for 1.2 m. The optimum barrier bandgap wavelength is about 1.1 m for a barrier width of 4 nm, and about 1.2 m for 6, 8 and 10 nm.     

FIR gain measurements in cw laser pumped CH3OD

Direct measurements of small signal and saturated gain in cw laser pumped CH₃OD are reported for three lasing transitions of 57 m, 82 m and 103 m. The 57 m transition has a measured gain of 0.6/m, the strongest gain in methanol reported so far. Moreover small gain saturation of this line makes it to be one of the strongest known cw FIR laser lines.     

An Approach to Linear Scalable DH-PHEMT Model for Millimeterwave Application

This paper describes a scalable small-signal equivalent circuit for 0.25 m gatelength Double Heterojunction delta-doped PHEMTs. The scaling rules for all elements except the pad capacitances and bondwire inductances have been determined. Good agreement is obtained between simulation results and measured results for 2 times 20 m , 2 times 40 m, 2 times 60 m, 2 times 100 m gate width (number of gate fingers times unit gate width) DH PHEMT.     

Towards slow μ− production via muon catalyzed fusion

Slow ^– production via dd-CF using a two-layer arrangement is investigated. To determine its feasibility, experimental measurements are now in progress using the muonic X-ray detection method. The following experimental steps are being considered: (1) measurement of the number of ^– stopped inside a solid H₂/D₂ layer by detecting p K X-rays, (2) hot d emission detection by placing a secondary target at a distance of 10–30 mm from the layer and by detecting specific delayed X-rays, (3) measurement of the disappearance of d emission as the added D₂ layer is increased, (4) dd-CF measurement by detecting fusion protons, and (5) slow ^– emission detection. Results of the initial test experiment are presented.     

Poloidal Magnetic Field Measurements in a Reversed Field Pinch Plasma by a Far‐Infrared Polarimeter

A multichannel farinfrared (FIR) polarimeter has been installed in RFX, a Reversed Field Pinch (RFP) plasma experiment, to measure the poloidal magnetic field profile. The polarimeter uses a CH₃OH FIR laser operating at =118.8 m. Faraday rotation measurements on five of six parallel diagnostic chords are used in preliminary investigations of poloidal field profiles. The experimental results are generally found in good agreement with the &p model predictions. The choice of the profile of = ₀ j·B/B² is discussed. For the reconstruction of the magnetic field profiles a numerical filamentary current equilibrium code is described, where polarimetric data are included as constraints. An alternative method based on the bestfit of a threeparameter profile to the polarimetric data is also reported. Both methods provide reliable reconstructions of the plasma magnetic field and the results indicate the existence in RFX of hollow profiles.     

Continuity of type-I intermittency from a measure-theoretical point of view

We study a simple dynamical system which displays a so-called type-I intermittency bifurcation. We determine the Bowen-Ruelle measure and prove that the expectation (g) of any continuous functiong and the Kolmogoroff-Sinai entropyh() are continuous functions of the bifurcation parameter. Therefore the transition is continuous from a measure-theoretical point of view. Those results could be generalized to any similar dynamical system.     

The paramagnetic state (μ+e−) in silicon and tellurium at high temperature

The paramagnetic state (⁺e^–) in Si and Te was observed in a longitudinal magnetic field. The mean lifetimes of these states were obtained: _Si = 1.45(3) s, _Te = 12.5(8) s at 290 K, _Te = 12(2) s at 250 K.     

Feasibility of an experiment to determine the branching ratio for the emission of a heavy neutrino after muon capture in3He

The triton energy of the muon capture reaction ³He t+v, where ³ He is the ground state of muonic³He, has been measured in order to investigate a possible heavy v admixture into the flavour with high sensitivity. ³ He has been formed via the pd fusion reaction by stopping ^– in an ionization chamber (IC) filled with an H/D gas mixture of 3% D concentration at a pressure of 161 bar. In a first short experiment 650 triton events were observed yielding an upper limit for the -heavy v mixing strength of 2.3×10^–3 atE _0v=60 MeV.     

UV-holographic gratings in TS-diacetylene single crystals

Holographic gratings with grating periods between 0.37 m and 4.4 m, respectively, were recorded on the surface of TS-diacetylene single crystals by two interfering 257 nm laser beams. Diffraction efficiencies of up to 35 % were obtained for readout with red light of = 633 nm. The main modulation mechanism was phase modulation. The spatial resolution was better than 1600 lines/mm. The upper limit of the polymer chain length was 0.6 m. The holographic sensitivity was 4.5 cm²/J for immediate read-out at 633 nm without processing after exposure. — A weakly exposed latent hologram may be developed simply by gentle annealing the crystal which increases the sensitivity by one order of magnitude.     

Magnetic anisotropy in thin ferromagnetic films

The magnetic properties of thin ferromagnetic films are studied taking into account the magnetic anisotropy term in the Hamiltonian. In the second approximation equations are obtained for the magnetization of the monatomic layers parallel to the surface of the thin film. From these equations one obtains the Curie temperature, which depends on the thickness of the thin film and the ratio a between the anisotropy constant and the exchange energy between two neighbours. A value can be chosen for such that the thin film becomes ferromagnetic only for a thickness greater than a definite value and in this manner the theoretical results can be fitted to the experimental data. The situation in cobalt thin films is dealt with in particular.

---

. , . , . , , - , . , , .

---

---

The author extends his thanks to the research workers of CIFA 1 as well as to Dr. L. Valenta for information on the same subject.