Column performance of uranyl ion exchange on tin(IV) antimonite hydrous oxide

Column chromatographic technique has been utilized to study the column performance of uranyl ion separation on tin(IV) antimonite hydrous oxide matrix. Different flow rates were applied, at 0.6 ionic strength and pH 3, to evaluate the effect of different flow rate on column breakthrough behaviour. Van Demeeter equation was used to emphasize the optimum column conditions. High equivalent to theoretical plate, breakthrough capacity (Q _0.5) were also calculated.     

Separation of lithium and magnesium isotopes by hydrous manganese(IV) oxide

Lithium and magnesium isotopes were separated by chemical ion exchange using hydrous manganese(IV) oxide and elution chromatography. The capacity of manganese(IV) oxide was 0.5 meq/g. The glass ion exchange column used was 35 cm long with an inner diameter of 0.2 cm, and 2.0M CH₃COONH₄ solution served as eluent. The single stage separation factor was determined from the elution curves and isotopic assays according to the method of Glueckauf. The separation factor of ⁶Li⁺-⁷Li⁺ was 1.022±0.002, those of ²⁴Mg²⁺-²⁵Mg²⁺, ²⁴Mg²⁺-²⁶Mg²⁺, and ²⁵Mg²⁺-²⁶Mg²⁺ were 1.012±0.001, 1.021±0.002, and 1.011±0.001, respectively.     

Radiochemical separation of thorium by isotope ion exchange

The aim of the present work is to obtain the separation of²³³Th from the radioisotopes formed in the irradiation of Mn, U, Ba, Cs, Co and the lanthanide elements with thermal neutrons, because they may interfere in the neutron activation analysis of Th, when the activity of²³³Th is used. The experiments were performed with the resin Bio-Rad AG 50W X-4 and X-8 (100–200 mesh) in the thorium form. The separation of²³³Th from the interfering radioisotopes is based on the retention of²³³Th by the resin (isotope exchange) and the elution of the interfering radioisotopes with a dilute solution of Th in 0.5M HCl. Batch experiments were made in order to determine the equilibrium time for the isotopic ion exchange of thorium and also the distribution coefficients of the interfering elements between the solution and the resin. Column experiments were carried out with the purpose of establishing the conditions that allow the maximum isotope exchange of²³³Th and the minimum retention of the interfering radioisotopes in the resin. With this purpose, a statistical interpretation of a four variable experimental design is presented.From a thesis submitted by C. Sepúlveda Munita to the Instituto de Pesquisas Energéticas e Nucleares (CNEN/SP) University of São Paulo, in partial fulfillment of a Doctor of Science's Degree. Work supported by the Brazilian Atomic Energy Commission.     

The manganese(IV) oxide electrode as a manganese(II) sensor

Manganese(IV) oxide electrodes formed with a graphite/PTFE substrate are shown to have near-theoretical response to manganese(II) ions in pH-4 acetate medium and a sub-Nernstian response in 0.1M nitric acid medium. Lead and iron(III) ions interfere, and iron(II) ions even more so, but other bivalent transition metal ions have little effect. The main drawback of this type of electrode is its long response time (~ 20 min). Some attempts to use manganese(IV) oxide electrodes as the basis for phosphate electrodes by use of MnHPO(4).3H(2)O and MnNH(4)PO(4).H(2)O are also described.     

Some ion exchange properties of amorphous titanium (IV) phosphate

An amorphous titanium (IV) phosphate exchanger has been synthesised and characterized through elemental analysis, infrared, and thermogravimetric techniques. Divalent cations Mn, Co, Ni, Cu, Zn, Cd, Hg and Pb in bidistilled water have been exchanged with the proton of the exchanger matrix using a batch method. From these results the thermodynamic selectivity constants and distribution coefficients were calculated, whose values indicate a high selectivity for Pb and Hg. Both cations were successfully separated from a mixture containing all cations studied through column separation experiments.     

Manganese(III,IV) and manganese(III) oxide clusters trapped by copper(II) complexes

Reactions of quinquedentate Schiff base ligands with Mn and Cu ions afforded icosa- and hexadecanuclear mixed-metal clusters in which dinuclear CuII complexes trapped oxo-bridged [MnIII8MnIV4O12] and [MnIII6O6] cores, respectively. Maximum entropy method analysis for synchrotron X-ray diffraction data was used to determine the oxidation states of the Mn ions.     

Outlines of the ion exchange characteristics of hydrous oxides

This work gives a critical review of the behaviour of hydrous oxides as ion exchangers. The various physicochemical properties of this important class of adsorbents and the effect of preparation procedures are summarized. Data on the ion exchange kinetics and thermodynamics are presented and discussed. Selectivity is also discussed in terms of the different parameters. Both aqueous and mixed media are considered. In addition, the different sorption mechanisms, some relevant sorption models, and potential applications in chemical separations are given. Moreover, this review attempts to point to the experimental and theoretical confusions now alarmingly met in the literature.     

Platinum(IV) oxide catalyzed H-D exchange reactions in arylsilanes

[reaction: see text] Arylsilanes were regioselectively labeled with deuterium by treatment with platinum(IV) oxide and deuterium oxide under hydrothermal conditions. Arylsilanols were also labeled with regioselectively under the same conditions.     

Thin-layer chromatographic separation of rhodium(III) and iridium(III, IV) by anion exchange

Summary The TLC behaviour of Rh(III), Ir(III) and Ir(IV) has been investigated in the two systems consisting of DEAE-cellulose or ECTEOLA-cellulose and 5 M HCl media containing H₂O₂. These systems, especially in combination with a simple chemical pretreatment of samples (with LiCl, HCl and H₂O₂), can effectively be applied to the complete separation of mixtures of Rh(III) and Ir(III) or Ir(IV) in a wide range of ratios and amounts (Rh: Ir=1100 to 1001).

---

Dünnschicht-chromatographische Trennung von Rhodium(III) und Iridium(III, IV) durch Anionenaustausch

Zusammenfassung Das dünnschicht-chromatographische Verhalten von Rh(III), Ir(III) und Ir(IV) wurde in H₂O₂-haltiger 5 M salzsaurer Lösung auf DEAE-sowie ECTEOLA-Cellulose untersucht. In Kombination mit einer einfachen chemischen Vorbehandlung der Probe (mit LiCl, HCl, H₂O₂) kann eine wirkungsvolle Trennung von Rh(III) und Ir(III) oder Ir(IV) über einen weiten Konzentrationsbereich erzielt werden (Rh: Ir=1100 bis 1001).

     

Synthesis,composition and ion exchange properties of Sn(IV) and Cr(III) arsenophosphates: separation of metal ions

This paper deals with the synthesis of the arsenophosphates of various metals. The chemical composition, ion exchange capacity, thermal stability, concentration curves, elution curves, pH-titrations and IR studies have been performed on two materials, namely, Sn(IV) arsenophosphate and Cr(III) arsenophosphate. Their utility has been established by achieving four binary separations of industrial importance such as CuNi, FeCu, FeNi and CoNi on columns.     

Extraction chromatographic separation of thorium (IV) with tri-n-octylphosphine oxide (TOPO)

Thorium was extracted from a mixture of nitric acid and NaNO₃ of 0.01M each at pH 2.2 on a column of silica gel coated with TOPO. Thorium was separated from alkalis, alkaline earths, chromium, iron, cobalt, nickel, zinc, cadmium, mercury, lead, trivalent rare earths, platinum group metals, chloride, phosphate and acetate in binary mixtures by selective extraction of thorium. Thorium was separated from cerium (IV), zirconium, uranium and molybdenum by selective elution of thorium with 0.01M H₂SO₄. The method was extended for the analysis of thorium in monozite ore.     

The solubility of uranium(IV) hydrous oxide in sodium hydroxide solutions under reducing conditions

The solubility of hydrous UO₂ in sodium hydroxide solutions containing sodium dithionite and/or Zn metal powder as reductants has been measured. The results provide no firm evidence for any amphoteric behavior of U(IV) but do set an upper limit of K ≤ 2 x 10^?23 for the hypothetical reaction:

The results provide no evidence for such a reaction.     

Ion exchange behaviour of hydrous tin oxide: Kinetics of anion exchange

The kinetic behaviour of Cl(-), Br(-) and SCN(-) exchanges on hydrous tin oxide have been investigated under conditions of particle diffusion and the limited bath technique. Values for the diffusion coefficients, energy of activation and entropy of activation have been calculated. The data obtained have been compared with those reported for other organic and inorganic exchangers.     

Mathematical model of boron isotope separation by chemical exchange reaction

Journal of Radioanalytical and Nuclear Chemistry - In this paper, the dependence of the number of theoretical plates on temperature and reflux ratio was theoretically studied by a mathematical...     

Lithium isotope separation by chemical exchange with polymer-bound azacrown compounds

The chromatographic separation of lithium isotopes was investigated by chemical exchange with the recently synthesized polymer-bound dibenzo pyridino diamide azacrown (DBPDA) and reduced dibenzo pyridino diamide azacrown (RDBPDA). Column chromatography was employed for the determination of the effect of solvents and ligand conformation on the separation coefficients. The maximum separation coefficients, , for the DBPDA and RDBPDA at 20.0±0.02°C with acetonitrile as eluent, were found to be 0.034±0.002 and 0.035±0.002, respectively. The isotope separation coefficient and adsorption capability of the lithium ion on the DBPDA and RDBPDA were only slightly dependent on ligand structure, but strongly dependent on the solvent. DBPDA and RDBPDA appeared to have almost the same value for the isotope separation coefficient of lithium.     

The separation of mercury from gold by ion exchange

Mixtures containing large amounts of gold and small amounts of mercury (50:1) can be quantitatively separated by passing a 2N hydrochloric acid solution of the chlorides through Dowex 50 resin. Mercury behaves as a cation and is quantitatively retained. Gold behaves as an union and is not retained by the resin. The gold is obtained spcctrobcopically free from all metals. The capacity of the resin is approximately 10 nig of mercury per gram of rebin. The rcyin is freed from mercury by washing with 2N liydroclonc acid and may be used over again.