Analysis of lysergic acid amide in human serum and urine after ingestion of Argyreia nervosa seeds

The ergot alkaloid lysergic acid amide (LSA) is a secondary plant constituent in a number of plants, but it is mainly present in considerable amounts in Convolvulaceae, like Argyreia nervosa. Due to its close structural similarity to lysergic acid diethylamide, LSA is considered as psychedelic and therefore promoted as so-called “legal high” in various internet forums. During a human behavioral study with orally administered seeds of A. nervosa, blood and urine samples were obtained. The present study describes the validation of a sensitive and robust high performance liquid chromatography method with fluorescence detection, which was applied to the study samples. The limit of detection (LOD) and lower limit of quantification in human serum were 0.05 and 0.17 ng/mL, respectively, and in urine, the LOD was 0.15 ng/mL. Intra- and interday precision and accuracy were below 15 % relative standard deviation with a bias better than ±15 %. No conversion of LSA to its epimer iso-LSA was noted during analyses. The LSA concentrations in the authentic human serum samples were in the range of 0.66 to 3.15 ng/mL approximately 2 h after ingestion. In urine, LSA could be found 1–24 h after ingestion; after 48 h, no LSA could be detected. The LSA epimer iso-LSA was also detected in serum and urine in varying ratios. In conclusion, LSA serum levels in the low nanogram per milliliter range correlated with severe vegetative adverse effects (nausea, weakness, fatigue, tremor, blood pressure elevation) and a psychosis-like state, which led to study termination.     

Synthesis and separation of substituted cyclopropane carboxylic acid amide isomers

The phase-transfer-catalyzed cyclization of optically active malonic acid allylic ester amides yields bicyclic cyclopropane carboxamide lactone derivatives. The two diastereomers obtained could be separated in some cases by simple column chromatography yielding the pure isomers.     

Chromatographic separation of mercury on cellulose phosphate in sulphuric acid medium

Ohne Zusammenfassung

---

Spectrophotometric determination of bovine serum albumin with 5-isothiocyanato-1,3-dioxo-2-p-tolyl-2,3-dihydro-1h-benzo[de]isoquinoline

     

Chromatographic selectivity study of 4-fluorophenylacetic acid positional isomers separation

Unique properties of the fluorine atom stimulate widespread use and development of new organofluorine compounds in agrochemistry, biotechnology and pharmacology applications. However, relatively few synthetic methods exhibit a high degree of fluorination selectivity, which ultimately results in the presence of structurally related fluorinated isomers in the synthetic product. This outcome is undesirable from a pharmaceutical perspective as positional isomers possess different reactivity, biological activity and toxicity as compared to the desired product. It is advantageous to control positional isomers in the early stages of the synthetic process, as rejection and analysis of these isomers will likely become more difficult in later stages. The current work reports the development of a chromatographic analysis of 2- and 3-fluorophenylacetic acid positional isomer impurities in 4-fluorophenylacetic acid (4-FPAA), a building block in the synthesis of an active pharmaceutical ingredient. The method is employed as a part of a Quality by Design Approach to control purity of the starting material in order to eliminate the presence of undesirable positional isomers in the final drug substance. During method development, a wide range of chromatographic conditions and structurally related positional isomer probe molecules were exploited in an effort to gain insight into the specifics of the separation mechanism. For the systems studied it was shown that the choice of organic modifier played a key role in achieving acceptable separation. Further studies encompassed investigation of temperature influence on retention and selectivity of the FPAA isomers separation. Thermodynamic analysis of these data showed that the selectivity of the 2- and 4- fluorophenylacetic acids separation was dominated by an enthalpic process, while the selectivity of the 4- and 3-fluorophenylacetic acids separation was exclusively entropy driven (Delta(DeltaH degrees approximately 0). Studies of chromatographic behavior were complemented by solid state NMR experiments which provided valuable information regarding the relationship between stationary phase solvation and selectivity.     

Chiral separation of amide conjugates of jasmonic acid by liquid chromatography

Summary Synthetic amide conjugates of (−)-jasmonic acid and its (+)-enantiomer were resolved by means of chiral liquid chromatography. The diastereomeric pairs prepared by chemical reaction of (±)-jasmonic acid with a series of (S)- or (R)-amino acids and with some (S)-amino acid alcohols were completely separated on Chiralpak AS using a mixture of n-hexane/2-propanal as mobile phase. The retention data indicate that the (−)-jasmonic acid conjugates eluted faster than those of the (+)-enantiomer, independent on the configuration of the bound amino acid. Likewise, enantiomeric derivatives of (±)-jasmonic acid and non-chiral amino acids were completely separated on the chiral stationary phase and showed the same elution sequence. The resolution factors,Rs, were found to range between 1.13 and 6.64. The separated compounds were chiropatically analyzed by measurement of the circular dichroism. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

Chromatographic and mass spectrometric methods for determination of lysergic acid diethylamide (LSD) and metabolites in body fluids.

Continued illicit use of the potent psychedelic drug lysergic acid diethylamide (LSD) has stimulated efforts to develop effective analytical methods for detection of the drug and its metabolites in body fluids from suspected LSD users. Recently reported methods based on gas and liquid chromatography, combined with single- and multiple-stage mass spectral analysis, now permit accurate detection and quantitation of LSD at sub-nanogram/milliliter concentrations.     

Chromatographic separation of uranium

Summary A solvent mixture of methanol and saturated ammonium acetate solution (18:2) is employed for the separation of uranium in ppm quantities from iron (up to 1000 fold excess) by paper chromatography. The separation from both iron and copper can be achieved by using a solvent mixture of methyl ethyl ketone, acetic acid, and diluted nitric acid (1613).

---

Zusammenfassung Zur papierchromatographischen Trennung von ppm-Mengen Uran von Eisen (in bis zu 1000 fächem Überschuß) wird ein Laufmittel aus Methanol und gesätt. Ammoniumacetatläsung (182) benutzt. Die Trennung von Eisen und Kupfer wird mit einem Gemisch aus Methyläthylketon, Essigsäure und verd. Salpetersäure (1613) durchgeführt.

---

---

The author is highly thankful to Prof. Bh. S.V. Raghava Rao for his valuable suggestions and guidance throughout the progress of this work.Thanks are also due to the Department of Geology, Andhra University for supplying the samples and to the Counsil of Scientific and Industrial Research, New Delhi for the award of a fellowship.     

Chromatographic separation for domoic acid using a fragment imprinted polymer

A method for real-time visualisation of reactions performed in-capillary by the technique of electrophoretically mediated microanalysis (EMMA) is described, using a two dimensional imaging detection system. The UV absorbance detector is based on a complementary metal oxide semiconductor (CMOS) active pixel sensor. Imaging of analyte peaks absorbing at 200 nm and migrating over length of 14 mm in the capillary dimension allowed measurement of velocities and lengths of reactant and product zones. By contrast with use of single point detection, velocities of species generated by reaction anywhere within the capillary are readily measured with CMOS imaging: this is of particular benefit for EMMA experiments where reaction occurs during zone overlap. For the oxidation of glutathione by hydrogen peroxide, reaction times were varied over the range 0.5-20 s by changing voltages for electrokinetic injection and zone migration, and reactant and product peak areas were obtained for kinetic analysis of the reaction. The use of EMMA conditions with CMOS imaging allows the whole process of reaction, separation and quantification to be carried out in nanolitre volumes on-capillary in a single run on a time scale of less than 5 min.     

Chromatographic separation of isoflavones

The optimum ratios of the components of the solvent systems have been determined with the aid of the simplex-grid method of experimental planning and the separation of a number of isoflavones has been carried out with the aid of these systems in thin layers of silica gel (Silufol plates); in addition, the chromatographic constants of the functional groups have been determined, which makes it possible to obtain the R_f values of compounds under investigation in an analysis of plant material by a mathematical method.Pyatigorsk Pharmaceutical Institute. Translated from Khimiya Prirodnykh Soedinenii, No. 6, pp. 712–716, November–December, 1983.     

Chromatographic separation by a new chelating resin containing β-hydroxydithiocinnamic acid

Summary The distribution coefficients of Ag(I), Au(III), Cd(II), Cu(II), Fe(III), Hg(II), Ni(II), Pb(II), Pt(IV), and Zn(II) on a new chelating resin containing -hydroxydithiocinnamic acid at various acidity were studied. In the strongly acidic region, the resin shows high affinity for Ag(I), Hg(II), Au(III) and Pt(IV) and high resistance against air oxidation. The effect of diverse foreign ligands on the sorption of metal ions and the possibility of application to speciation studies with this resin were also considered. Some quantitative separations of Cd-Cu-Pb, Cu-Au and Au-Pt with this resin column were described. Detection of the chromatography system was carried out via post column derivatisation of the column effluent with PAR at 520 nm or direct UV detection of the chloride complexes at 215 nm.     

Chromatographic separation of tocopherols.

alpha-, beta-, gamma-, and delta-Tocopherols were separated by reversed-phase high-performance thin-layer chromatography (C18RP-HPTLC), normal-phase high-performance liquid chromatography (NP-HPLC), reversed-phase high-performance liquid chromatography (C18RP-HPLC), and gas chromatography (GC). The selected topological indices based on connectivity (M, 1chi(v)), on distance matrix (W, (o)B, MTI) and on information theory (I(AC), I(AC)) were calculated for these tocopherols. The observed chromatographic separations of investigated tocopherols were compared. This comparison indicated that the C18RP-HPTLC, NP-HPLC, and GC are the best techniques for the separation of these tocopherols. Topological index (o)B was the most significant. We obtained definite dependence between the numerical values of topological index (o)B and the chromatographic separation of the investigated tocopherols.     

A new synthesis of lysergic acid

[reaction: see text] (+/-)-Lysergic acid has been synthesized via an economical 8-step route from 4-bromoindole and isocinchomeronic acid without the need to protect the indole during the synthesis. Initial efforts to form the simpler 3-acylindole derivatives first and then cyclize these were unsuccessful in the cyclization step.