Adsorption behavior of VII group elements on tertiary pyridine resin in hydrochloric acid solution

We investigated the adsorption behaviors of technetium and rhenium on tertiary pyridine resin in hydrochloric acid solution. Technetium has a little larger distribution coefficient in higher concentration of hydrochloric acid region than rhenium. However, the tendency of adsorption behavior of technetium and rhenium is similar. We concluded that the rhenium can be used as the substitute for technetium. Adsorption behaviors of platinum group elements were also investigated. The separation of technetium from platinum group elements is discussed.     

Study on thermal stability of tertiary pyridine resin

The fundamental properties of tertiary pyridine resin (TPR) and its mixtures with methanol/HCl and HNO₃ were investigated in order to evaluate the thermal stability of TPR and to determine the conditions necessary to avoid runaway reactions. Based on experimental DSC results, it was found that TPR with HCl was thermally stable, but strong decomposition was possible with TPR in the presence of HNO₃. From the results of heating tests on the gram scale, TPR with HNO₃ reacted violently under high temperature regardless of HNO₃ concentration and presence or absence of methanol. However, it was considered that the violent exothermic reaction could be controlled by heating temperature.     

Chromatographic separation of trivalent actinides and rare earth elements by using pyridine type resin

Summary In order to develop the partitioning-transmutation system for the reduction of high-level radioactive wastes, the group and mutual separation of actinides and rare earth elements in spent fuels is required. In the present work, a chromatographic separation of trivalent actinides (Am and Cm) and rare earth elements was examined in hydrochloric acid/methanol mixed solvents by using a pyridine resin embedded in high-porous silica beads. In a 70 vol% hydrochloric acid (11.7 mol HCl/dm³)/30 vol% methanol mixed solvent, the elution curves of the trivalent actinides were separated completely from those of rare earth elements at room temperature. The present paper discusses the separation behavior of trivalent actinides and rare earth elements as a function of flow rate, temperature and solvent compositions.     

Adsorption of alkali and alkaline earth radionuclides on zeolite from water solutions

The adsorption of cesium and strontium ions from water solutions on zeolite has been investigated in presence of sodium, potassium, magnesium and calcium ions. Distribution ratios of cesium and strontium on the zeolite were determined in solutions of various compositions and solution volume to sorbent weight ratios (batch factor). Breakthrough curves for zeolite layers are reported.     

Ultraviolet photofragmentation spectroscopy of alkaline earth dication complexes with pyridine and 4-picoline (4-methyl pyridine)

A detailed experimental and theoretical study has been undertaken of the UV photofragmentation spectroscopy of the alkaline earth metal dications Mg(2+), Ca(2+), and Sr(2+) complexed with pyridine and 4-methyl pyridine (4-picoline). The ion complexes have been prepared using the pick-up technique and held in an ion trap where their internal temperature has been reduced to <150 K. Exposure of the trapped ions to tunable UV laser radiation leads to the appearance of photofragments with intensities that show significant variation as a function of wavelength. For all three metal dications, the resultant spectra show evidence of resolved features. Time-dependent density functional theory (TDDFT) has been used to identify possible electronic transitions that might be present in the [M(pyridine)(4)](2+) complexes (M = Mg, Ca, and Sr) within the wavelength range studied. These calculations show that the spectra are dominated by strong π* ← π and weaker π* ← n transitions localized on the pyridine ligands. The calculations correctly identify those regions of the experimental spectra where UV transitions begin to occur in the complexes and also the wavelengths at which absorption maxima are reached; however, more subtle features of the spectra are difficult to assign with confidence.     

Adsorption behaviors of trivalent actinides and lanthanides on pyridine resin in lithium chloride aqueous solution

The adsorption behaviors of trivalent actinides and lanthanides on pyridine resin in lithium chloride aqueous solution were investigated. The adsorbed amounts of lanthanides and the degree of mutual separation of lanthanides increased with an increase in the concentration of lithium chloride in aqueous solution. The group separation of the trivalent actinides and lanthanides was observed. This separation phenomenon is similar in a hydrochloric acid solution. However, the adsorption behavior of lanthanides in lithium chloride is different from their behavior in a hydrochloric acid solution. This fact shows that the adsorption mechanisms of lanthanides in a lithium chloride aqueous solution and in a hydrochloric acid solution are different; the adsorption mechanisms are attributed to the ion exchange in a hydrochloric acid solution, and to the complex formation with pyridine group in a lithium chloride solution.     

Interference of aluminum chloride and nitrate on alkaline earth elements in an air-acetylene flame

Aluminum nitrate causes a strong interference in the determination of alkaline earth elements in the air-acetylene flame by formation of mixed oxides, predominantly of the spinel-type M^IIAl₂O₄. The influence of aluminum chloride is less pronounced because the analyte chloride must be converted to the oxide before it reacts with aluminum oxide. Any compound that delays the formation of oxides hence alleviates the depressing effect of aluminum. Particle size plays a decisive role in the sensitive equilibrium between alkaline earth chloride and oxide formation. Aluminum chloride hexahydrate hydrolyzes on desolvation in the flame, giving off HCl. This way an atmosphere of HCl is generated inside larger particles that isolate the analyte from oxygen in the flame gases and favor formation of thermally less stable chlorides, and hence atomization. Addition of an excess of cesium chloride increases the average particle size further and supports that mechanism. Moreover, cesium chloride causes an early disintegration of large particles releasing analyte chlorides into the flame, thus enhancing their degree of atomization.     

Some intense sources of radiation for the alkali and alkaline earth elements

Five new methods are described for the preparation of intense narrow line sources of resonance radiation for the alkali and the alkaline earth elements. Optimum conditions for their preparation and operation are described and their suitability for atomic fluorescence spectrometric purposes has been investigated. The most successful method involves a discharge in flowing atmospheric pressure argon in a quartz tube. A small quantity of the element (or element halide) of interest is suspended in a quartz cup in the discharge stream. The resulting source is applicable to a wide range of relatively involatile elements and, although it is somewhat short lived, it may be recharged readily. Microwave excitation of hollow cathode lamps was not found to be very useful for analytical purposes.     

Separation of alkaline earth elements by cation-exchange chromatography in ammonium malonate media

Be(II), Mg(II), Ca(II), Sr(II) and Ba(II) can be separated by elution from a cation-exchange column in the ammonium form with increasing concentrations of ammonium malonate. A typical elution sequence for a 60-ml column (volume in H⁺-form) of AG₅₀-X8 resin is: 200 ml of 0.20 N ammonium malonate plus 0.10 N malonic acid for Be(II); 300 ml of 0.50 N, 450 ml of 0.70 N, 350 ml of 1.10 N ammonium malonate for Mg(II), Ca(II) and Sr(II), respectively, and 200 ml of 3.0 N nitric acid for Ba(II). Separations are sharp and quantitative for element pairs in weight ratios from 1:1000 to 1000:1. Distribution coefficients, elution curves and quantitative separations are presented.     

生物质气化过程中碱金属和碱土金属的析出特性研究

研究了固定床上生物质及热解焦CO2气化过程中碱金属及碱土金属(AAEMs)的析出特性。利用原子吸收光谱仪,考察了不同生物质种类、不同热解制焦温度对AAEMs析出的影响。不同生物质由于其挥发分含量不同引起气化失重率的差异,焦气化活性随制焦温度升高而降低。生物质及焦气化过程中Na析出率最大,其次是K,碱土金属析出率低于碱金属,这与元素在生物质中的存在形式、金属价态有关。低温段K的析出率随热解制焦温度的提高而增加,而Na在热解与气化段总的析出率与制焦温度关系不大。生物质的种类尤其是灰中的Si含量对Ca和Mg的析出影响较大,气化效率高的生物质AAEMs析出较多。热力学计算结果显示,气化过程中Na、K多以氯化物的形式存在并析出,Ca、Mg则更倾向于形成硅酸化合物而不易析出。     

Evaluation of tertiary pyridine resin for the separation of lanthanides by simulated moving‐bed chromatography

Lanthanide separation by simulated moving‐bed chromatography was studied as a model system for separating lanthanide fission products and minor actinides from used nuclear fuels. The simulated moving‐bed system was modeled for a tertiary pyridine anion‐exchange resin supported on silica particles as the stationary phase and a mixture of methanol and 1M nitric acid as the mobile phase. Pulse injection tests using a single packed column were used to obtain chromatographic parameters for mathematical modeling of the simulated moving‐bed system. Higher concentrations of methanol improved the separation, but the chromatograms showed evidence of nonlinearity of the isotherms. The mathematical model of the simulated moving‐bed process predicted a production rate of purified samarium and neodymium at 118 g solute/L resin/day and a purity of 99.5%. The optimal methanol ratio for the production rate for various product purities was determined from the model. The excellent separation of Nd and Sm suggests that the simulated moving‐bed system could be applied to the separation of minor actinides such as americium and curium.     

Thiomalates of alkaline earth metals

Solid state 1:1 complexes of divalent Mg, Ca, Sr and Ba with thiomalic acid(tma) have been isolated and characterised by elemental analysis, IR spectra and thermal studies. It is shown that tma coordinates to the metal ions through carboxylic oxygen atoms. Thermal studies of these complexes show that desulphurisation preceeds decarbonylation reaction leading to the formation of metal carbonates in all the cases except Mg where MgO is the end product. Thermal stability of the anhydrous thiomaltes follows the order Mg ∼ Ca > Sr > Ba. Structures have been proposed based on the information obtained from these studies.     

Determination of equilibrium constants of alkaline earth metal ion chelates with Dowex A-1 chelating resin

A complexation chemistry model is applied to chelating ion-exchange systems and a method is presented for the determination of equilibrium constants for metal ion chelates with these resins. Protonation constants for the iminodiacetic based chelating resin Dowex A-1 were determined from potentiometric pH-data. Equilibrium constants were determined for 1:1 beryllium, magnesium, calcium, strontium and barium chelates with the resin in a wide pH range by measuring the concentrations of respective metal ions in the aqueous phase with direct current plasma atomic emission spectrometry (DCP-AES). A batch technique was used for the equilibrium experiments. At pH below 7 protonated 1:1 species were also found to be formed with the resin. From the obtained equilibrium constants, theoretical distribution coefficients were calculated as function of pH for respective metal ion resin system.     

Determination of strontium and its relation to other alkaline earth elements in human brain samples

Strontium content of five brain regions of five control and five Alzheimer's diseased (AD) patients and eight brain regions of three Hungarian control patients was determined. Microwave-assisted and high-pressure Parr-bomb digestions were used for sample dissolution. Strontium content of the digested samples was measured by ETAAS. The optimized parameters for digested human brain samples are: T_{pyrolysis, max}: 1500 °C, T_atomization: 2500 °C, 0.4% La(NO₃)₃ as a chemical modifier. The detection limit is 0.057 ng/ml and the characteristic mass is 1.0 pg. Calcium and magnesium content of the same digested samples were measured by ICP-OES. Accuracy of the applied methods was tested by analyzing NBS SRM1577 Bovine liver reference material, digested and measured with the samples together. Recovery measurements were done to eliminate the disturbing effect of the matrix. Strontium concentrations show great individual differences (20–450 ng/g, dry weight) independent of being either control or AD values, in contrast to the Mg (c_{control,Hungarian}: 590–675 μg/g, c_{control,German}: 620–675 μg/g, c_AD,German: 640–695 μg/g) and Ca (c_{control,Hungarian}: 270–390 μg/g, c_{control,German}: 310–400 μg/g, c_AD,German: 435–515 μg/g) concentrations.     

Separations involving sulphides: Separations of alkaline earth metals from some elements that form thiosalts

It has been shown that 2N sodium sulphide reagent can be used for separating strontium, calcium or magnesium from arsenic, antimony, tellurium, selenium or molybdenum.     

Seperations involving sulphides : Separation of alkaline earth metals from some elements that form sulphides

It has been shown that 2N sodium sulphide reagent can be used efficiently for separating. 1.Barium from rhenium, platinum, gold, bismuth, palladium, lead or cadmium. 2.Strontium, calcium and magnesium from rhenium, platium, gold, mercury, bismuth, palladium, lead or cadmium